共查询到19条相似文献，搜索用时 203 毫秒
1.
2.
堤前远破波运动与冲淤形态 总被引：1，自引：0，他引：1
利用数值波浪水槽,对远破波作用下堤前波浪运动进行了数值模拟。分析了堤前速度场的变化,指出堤前波浪运动在一个波周期内可分为向堤波和离堤波。波浪在距堤约L/2处破碎后向堤冲击并沿堤面爬升,称为向堤波;波浪从堤面最高处回落与向堤波相遇并破碎,称为离堤波。堤前远破波的前半个周期的向堤波速度场大于后半个周期的离堤波速度场,且堤前波浪运动在一个波周期内的前半个周期和后半个周期完全不同。床面某点(L/4,3L/4)的速度在一个波浪周期内随时间呈向堤和离堤变化,向堤速度最大值大于离堤速度的最大值。利用堤前速度场的研究成果,进一步分析了远破波作用下堤前海床冲淤形成过程,完善了冲淤机理。 相似文献
3.
4.
基于1987年和1988年夏季在古镇口港直立堤前的实测资料,对波浪和波压力连续记录进行了统计分析和谱估计,研究了在堤前海浪不发生破碎条件下,堤前波浪和堤面不同高程上压力波的波面高度概率分布、堤前波浪波高和周期与波压力幅度和周期的概率分布特征、入射波行近提前过程中的谱变化及堤面不同高程上压力谱的变化特征。主要结果总结在本文最后一节。 相似文献
5.
为了研究波浪与抛石潜堤相互作用过程中大自由表面变形和堤内渗流等强非线性紊流运动问题,利用改进的MPS法,建立了模拟波浪与抛石潜堤相互作用的MPS法数值计算模型。模型将抛石潜堤假定为均质多孔介质,采用Drew的二相流运动方程描述多孔介质内外的流体运动;通过在动量方程中增加非线性阻力项,并引入亚粒子尺度紊流模型,模拟波浪与可渗结构物相互作用过程中的紊流运动。选取“U”型管中多孔介质内渗流过程和孤立波与可渗潜堤相互作用两个典型的渗流问题,通过将数值计算结果与理论解和实测值的对比分析,对所提出的MPS法紊流渗流模型的模拟精度进行验证。结果表明:基于改进的MPS法构建的垂向二维紊流渗流模型可以很好地再现“U”型管中多孔介质内渗流以及波浪作用下可渗潜堤内外的复杂流场,显著缓解流-固界面处的压力震荡与粒子分布不均匀问题,实现了较高的模拟精度。 相似文献
6.
不同结构形式潜堤上的随机波浪运动 总被引：3，自引：0，他引：3
潜堤在海岸保护和促潍保淤中具有重要的意义。工程效益和经济投入受到潜堤结构形式和高度的影响。基于RANS方程和流体体积（VOF）方法的模型,计算不同潜堤上的波浪运动。潜堤形式包括矩形结构、梯形结构、半圆结构和槽形结构。模拟了不规则波越堤时波浪的破碎特征、破波类型以及波高的变化。通过分析流场和波高分布的变化,得到潜堤上波能散耗的规律,并且得出最优潜堤结构形式。讨论了相对堤顶高度、破碎点位置、相对堤顸宽度、波陡和潜堤结构形式等对波能耗散的影响。 相似文献
7.
8.
畸形波生成、演化过程时频能量结构研究 总被引：1，自引：0，他引：1
基于流体体积(VOF)方法建立完全非线性波浪数值模型,控制方程采用雷诺时均方程和k-ε方程,使用该模型模拟了畸形波的生成、演化过程.在此基础上,使用小波分析法重点研究了畸形波生成、演化过程中波浪序列的时频能量结构.研究结果表明,畸形波生成前、后出现的过渡大波虽然不满足畸形波定义的所有指标,但其能量瞬时集中程度仍然很高,包含大量高频能量,内部结构和畸形波完全类似,应该引起重视. 相似文献
9.
10.
波浪谱形对不规则波数值模拟的影响 总被引：1，自引：0，他引：1
通过数值模拟分析了波浪谱形对不规则波浪数值模拟结果的影响.采用不同参数的JONSWAP谱模拟入射波要素,基于抛物型缓坡方程模拟不规则波浪的传播,分析了波浪谱形状对波浪数值模拟结果的影响.结果表明,采用抛物型缓坡方程模拟不规则波浪时,入射波浪谱形对模拟结果影响不明显;但由于模型中非线性项的影响,采用不规则波模拟的波高分布和采用规则波模拟的结果略有差别. 相似文献
11.
The form of Boussinesq equation derived by Nwogu （1993） using velocity at an arbitrary distance and surface elevation as variables is used to simulate wave surface elevation changes. In the numerical experiment, water depth was divided into five layers with six layer interfaces to simulate velocity at each layer interface. Besides, a physical experiment was carried out to validate numerical model and study solitary wave propagation.“Water column collapsing”method （WCCM） was used to generate solitary wave. A series of wave gauges around an impervious breakwater were set-up in the flume to measure the solitary wave shoaling, run-up, and breaking processes. The results show that the measured data and simulated data are in good agreement. Moreover, simulated and measured surface elevations were analyzed by the wavelet transform method. It shows that different wave frequencies stratified in the wavelet amplitude spectrum. Finally, horizontal and vertical velocities of each layer interface were analyzed in the process of solitary wave propagation through submerged breakwater. 相似文献
12.
13.
Li Chunzhu Shi Hongda Yu Dingyong Wang Aiqun
Professor Engineering College Ocean University of Qingdao Qingdao
Lecturer Engineering College Ocean University of Qingdao Qingdao
Senior Engineer Engineering College Ocean University of Qingdao Qingdao 《中国海洋工程》1997,(1)
Standing waves are formed due to the reflection when waves meet vertical wall,thereforestrong structures are needed to keep the wall stability under the serious wave attack.For the improvementof the working condition and increase of the stability of the wall,the lower reflecting breakwaters have at-tracted close attention Reports mostly from Japanese researchers are often concerned with the wall ofcaisson equipped with open windows.In this paper a kind of hollow-pipe perforated breakwater is exam-ined which waves may partially perforate into the harbour basin.The wave in front of the wall can onlyform partial standing wave and wave force is reduced obviously.And the theoretical calculation of waveforce and analysis of wave force spectrum are all derived.Comparison between the results from theoreticalcalculation and hydraulic modeling shows reasonable agreement. 相似文献
14.
《Coastal Engineering》2001,44(2):117-139
In this paper, laboratory data for free surface displacements and velocity fields in front of a caisson breakwater covered with wave-dissipating blocks, together with wave pressures acting on the caisson, are presented and discussed. The core of the breakwater is made of a concrete caisson with a vertical front wall. The caisson is protected by a thick layer of tetrapods and is supported by a rubble mound. The breakwater is placed on the 1/25 impermeable slope. Two types of incident waves are used in the experiments: nonbreaking waves and spilling-type breaking waves. In the breaking wave case, the incident wave breaks offshore before it reaches the breakwater. The velocity data are obtained by using both the Laser Doppler Velocimeter (LDV) and the Electromagnetic Current Meter (EMCM). The raw data are analyzed using a numerical-filtering scheme so that turbulent fluctuations are separated from the phase-dependent wave motions. The vertical profiles of the time-averaged (over a wave period) turbulent velocity components at several vertical cross-sections in front of the breakwater are then analyzed. The spatial variations of the time-averaged turbulence velocity suggest that turbulence is generated inside the protective armor layer and transported into the flow region in front of the breakwater. The wave pressures on the vertical face and on the bottom of the caisson are also reported. 相似文献
15.
Quarter circular breakwater （QCB） is a new-type breakwater developed from senti-circular breakwater （SCB）. The superstructure of QCB is composed of a quarter circular front wall, a horizontal base slab and a vertical rear wall. The width of QCB＇ s base slab is about half that of SCB, which makes QCB suitable to be used on relatively finn soil foundation. The numerical wave flume based on the Reynolds averaged Navier-Stokes equations for impressible viscosity fluid is adopted in this paper to simulate the hydraulic performances of QCB. Since the geometry of both breakwaters is similar and SCB has been studied in depth, the hydraulic performances of QCB are given in comparison with those of SCB. 相似文献
16.
Liu Liping Engineer The Investigation Design Institute of The Second Navigation Engineering Bureau Ministry of Communications P. R. of China Wuhan 《中国海洋工程》1991,(4)
Through numerical modeling, a kind of simplified calculating method for standing wave pressure on vertical face breakwater have been put forward. Not only the formulas proposed in this paper are simple in form and very easy in use, but also they possess continuity on the full range of standing wave. And more, the precision requiremennts of calculation can be satisfied to a certain extent in engineering practice. 相似文献
17.
Based on a parallel SPH-LES model, a three dimensional numerical wave basin is developed to study wave interaction with coastal structures. The OpenMP programming technology combined with an existing MPI program contained in the parallel version of SPHysics code has been implemented to enable the simulation of hundred millions of particles running on a computer cluster. As part of the numerical basin development work an active absorbing wave maker and a sponge layer are introduced. The dynamic boundary conditions are also corrected to reduce the spurious effects. Wave generation and propagation in the numerical wave basin is first tested and confirmed with analytical results. Then, the model is applied to simulate wave interactions with a vertical breakwater and a vertical cylinder in order to further assess the capability of the numerical wave basin. The predicted free surface elevation near the vertical breakwater is compared with the experimental data while the horizontal forces and overturning moments acting on the vertical cylinder are verified with the analytical results. In all these cases the model results show excellent agreement with the validation data. 相似文献
18.
为使防波堤同时具有良好的掩护效果和水体交换能力,提出了两种带有透浪通道的新型直立式防波堤。基于Fluent求解器建立了三维数值波浪水槽,通过与试验结果对比,验证了该数值水槽求解波浪与透空堤作用具有较高的精度。对两种防波堤在规则波作用下的透浪特性进行了研究,结果表明:透射系数K_t与透空率呈正线性相关,且可通过调整透浪通道间距,使相同透空率下K_t降低20%～30%。对同一结构,K_t随相对波长的增大而显著增大,但受相对波高的影响较小。在透空率大于0.16后,异型沉箱防波堤的消浪性能明显优于错位沉箱。基于数值计算结果,给出了以上两种透空堤波浪透射系数的经验公式。 相似文献
19.
基于水槽实验,研究植物对孤立波作用下直立堤局部冲刷的影响。通过改变实验入射波高、植物带的宽度和密度,分析各要素对直立堤局部冲刷的影响。实验对波高沿程变化、孤立波越堤、回落过程以及地形演变进行全程的测量和记录,并进行有无植物带保护的直立堤局部冲刷对比分析。结果表明,植物带的存在,使得堤后相对最大冲刷深度显著减小,堤前冲刷形态由单峰式"L"型变为双峰式淤积沙坝形态,且冲刷位置由原堤脚前移至植物带所在位置,冲刷范围大幅增加。减小植物带密度或者植物带宽度会使近岸侧或是离岸侧的相对最大冲刷深度和相对最大淤积高度有增大的趋势,但是当入射波高增大时,二者的影响不显著。该研究对实际工程中植物带的合理布置提出了具有参考性的建议,对减少堤防工程的冲刷和损失有一定现实意义。 相似文献