共查询到19条相似文献，搜索用时 155 毫秒
1.
本文采用喜马拉雅科学探测台阵四川省境内10个台站,计算了所有地震信号0.5—15 Hz的H/V谱比,分析了震级、震源距对H/V谱比的影响,并与各台站场地地脉动H/V谱比进行了比较. 结果表明: 震级对各台站地震信号的H/V谱比振幅值以及峰值频率几乎没有影响;震源距对谱峰明显的H/V谱比曲线的谱形和峰值频率影响不大,但对谱峰不明显的H/V谱比曲线的峰值频率有一定影响;H/V谱峰明显的台站,地震信号与地脉动信号的H/V谱比曲线的峰值频率具有很高的一致性,H/V谱峰不明显的台站,二者的峰值频率有一定差异. 相似文献
2.
选取了1999年9月21日台湾集集7.6级地震主震中68组断层距在20km以内的近断层台站记录和46组断层距在40~70km的东部台站记录,按台站的上下盘位置、场地条件和断层距分组,对其竖向和水平加速度反应谱比值V/H进行了统计分析。研究表明:1)断层的滑动方向和断层破裂的传播方向对断层距在3km以内的台站上的地面运动谱比值V/H有一定影响,且主要体现在中短周期范围内,例如平行断层方向的谱比值要比垂直断层方向的谱比值大。在下盘断层距3~20km的范围内,场地条件对V/H基本没有影响。2)在集集地震中长周期(>3s)部分的谱比值通常>32,且有一个较高的峰值,表明其竖向运动加速度中的长周期分量大于其它地震。3)对于下盘的台站,地面运动在短周期(<0.2s)段的谱比值不随断层距的增加而减少。与中远(>40km)距离的台站相比较,近断层台站的V/H在工程界关心的周期范围内普遍较大。4)场地条件对谱比值V/H的影响在近断层处不显著。在远离断层的东部台站上,硬土场地谱比值V/H在长周期段大于软土场地 相似文献
3.
利用地脉动数据可以确定地震动对地表介质产生的响应,传统的H/V谱比法是针对于地脉动数据而发展起来的,本文将H/V谱比法应用于处理宽频带地震数据.本研究以长江中下游地区为研究对象,对68个宽频地震台站采集到的数据去除地震波形事件后的时间序列进行H/V谱比处理,得到了长江中下游不同区域的沉积厚度.河淮盆地的沉积层厚度大于3000 m.铜陵与安庆,庐棕三个矿区及其附近邻区其卓越频率位于0.05～0.1 Hz,沉积厚度3000 m左右,由西向东逐渐减薄为2000 m左右,且矿区沉积层横向变化大.江汉盆地的沉积层较厚,其边缘沉积层厚度可达3000 m. 相似文献
4.
近年来高密度电法被广泛应用于重大水利工程场地的工程地质调查、坝基及桥墩选址、采空区及地裂缝探测等诸多工程勘察领域。本文利用高密度电法对某水库大坝坝址区的覆盖层厚度、隐伏断层等地质结构进行探测,并在结合钻探资料和区域地质资料综合分析的基础上,取得了理想的勘察结果。查明水库区存在隐伏的断层和覆盖层厚度,为水库坝址选择提供重要的地球物理依据。 相似文献
5.
6.
利用二维非均匀介质地震波传播的伪谱和有限差分混合方法,通过数值计算,讨论了松软覆盖层对隐伏断层带围陷波特征的影响.在没有覆盖层的情况下,围陷波振幅和围岩上相比明显增加,持续时间变长.覆盖层造成围岩上地面运动振幅增大,围陷波的部分能量传播到覆盖层中,使得围陷波的能量变小.随着覆盖层厚度增加,围陷波的振幅越来越小,和围岩上... 相似文献
7.
浅层地震勘探在沿海地区隐伏断层探测中的应用 总被引：22，自引：6，他引：16
中国沿海地区的第四系厚度变化较大,在大部分地区存在淤泥、黏土和砂层的多重互层情况,这种地层结构对地震波的传播十分不利,容易造成对高频信号能量的强烈耗散。沿海地区又具有人口密度大、工业干扰强烈的特点,地震波的激发、接收条件较差。文中给出了在粤东、天津和唐山覆盖层厚度变化较大的地区,利用浅层地震勘探开展隐伏断层探测的应用实例。较系统地介绍了野外工作、资料处理和解释方法。阐述了在强干扰环境下提高信噪比和分辨率的有效技术途径。所给实例中的反射波组能量强,隐伏断层的反应明显,经跨断点钻探验证,结果证实地震勘探确定的界面深度、断点位置和基岩错距等参数都是可靠的。所述技术方法对类似地区的城市活断层探测和工程物探工作都有较重要的参考价值 相似文献
8.
9.
10.
11.
A. A. Panou N.P. Theodulidis P.M. Hatzidimitriou A.S. Savvaidis C.B. Papazachos 《Pure and Applied Geophysics》2005,162(5):891-912
In the framework of an ambient noise measurement project in the downtown district of the City of Thessaloniki (Northern Greece), several tests and evaluation of noise recordings were performed in selected sites. This data set was processed and compared with previous results for the same sites in terms of horizontal-to-vertical (H/V) spectral ratio obtained from weak and strong motion earthquake data. The recording system used was tested against a reference one. Finally, systematic ambient noise measurements were performed at eight sites in the citys downtown area, to evaluate diurnal and seasonal variations. It was concluded that the recording system used was reliable and the ambient noise H/V spectral ratios were in good agreement with relevant results previously obtained. Diurnal variation of the ambient noise H/V spectral ratio showed that it is preferable to perform measurements during the calm hours of the day, when man-made noise is relatively low. However, no systematic seasonal fluctuation effect on the ambient noise H/V spectral ratio was identified. 相似文献
12.
Evaluation of the influence of experimental conditions on H/V results from ambient noise recordings 总被引：5，自引：2，他引：3
Jean-Luc Chatelain Bertrand Guillier Fabrizio Cara Anne-Marie Duval Kuvvet Atakan Pierre-Yves Bard 《Bulletin of Earthquake Engineering》2008,6(1):33-74
The H/V-noise technique is now widely used to estimate site effect parameters (fundamental frequency and sometimes the associated soil amplification), and many surveys using this technique have provided convincing results. However, a general agreement on a methodology for data acquisition, data processing and result interpretation has yet to be found. H/V measurements from ambient noise recordings imply both reliability of the results and rapidity of data collection. It is therefore important to understand which experimental conditions (1) influence data quality and reliability, and (2) can help speeding up the recording process. Within the framework of the SESAME European project, a specific task was defined to investigate the reliability of the H/V spectral ratio technique in assessing the site effects. The aim of WP02, one specific Work Package of the SESAME project, is to study the effects of experimental conditions on both stability and reproducibility of H/V results. This study has been conducted in a purely experimental way, by testing the possible influence of various experimental conditions on H/V results both on the frequency peak value and on its amplitude. WP02 results help setting up the experimental conditions under which ambient noise recordings have to be performed in order to provide reproducible, reliable and meaningful H/V results. In this paper we present the results of the WP02 SESAME project concerning the evaluation of the influence of experimental conditions of ambient noise recording on H/V results. 相似文献
13.
Empirical evaluation of microtremor H/V spectral ratio 总被引：6，自引：2，他引：4
The objective of this work is to perform a purely empirical assessment of the actual capabilities of the horizontal-to-vertical (H/V) spectral ratio technique to provide reliable and relevant information concerning site conditions and/or site amplification. This objective has been tackled through the homogeneous (re)processing of a large volume of earthquakes and ambient noise data recorded by different research teams in more than 200 sites located mainly in Europe, but also in the Caribbean and in Tehran. The original recordings were first gathered in a specific database with information on both the sites and recorded events. Then, for all sites close to an instrumented reference, average site-to-reference spectral ratios (“spectral ratio method” (SSR)) were derived in a homogeneous way (window selection, smoothing, signal-to-noise ratio threshold, averaging), as well as H/V ratios (“HVSRE–RF”) on earthquake recordings. H/V ratios were also obtained from noise recordings at each site (either specific measurements, or extracted from pre- or post-event noise windows). The spectral curves resulting from these three techniques were estimated reliable for a subset of 104 sites, and were thus compared in terms of fundamental frequency, amplitude and amplification bandwidth, exhibiting agreements and disagreements, for which interpretations are looked for in relation with characteristics of site conditions. The first important result consists in the very good agreement between fundamental frequencies obtained with either technique, observed for 81% of the analyzed sites. A significant part of the disagreements correspond to thick, low frequency, continental sites where natural noise level is often very low and H/V noise ratios do not exhibit any clear peak. The second important result is the absence of correlation between H/V peak amplitude and the actual site amplification measured on site-to-reference spectral ratios. There are, however, two statistically significant results about the amplitude of the H/V curve: the peak amplitude may be considered as a lower bound estimate of the actual amplification indicated by SSR (it is smaller for 79% of the 104 investigated sites), and, from another point of view, the difference in amplitude exhibits a questioning correlation with the geometrical characteristics of the sediment/basement interface: large SSR/HV differences might thus help to detect the existence of significant 2D or 3D effects. 相似文献
14.
Abd el-aziz Khairy Abd el-aal 《Journal of Seismology》2018,22(5):1315-1323
In this contribution, new relationship between the fundamental site frequency and the thickness of soft sediments is obtained for many sites in Egypt. The Horizontal-to-Vertical Spectral Ratio (“H/V”) technique (known as Nakamura technique) can be used as a robust tool to determine the thickness of soft sediments layers overlaying bedrock from observations and measurements of seismic ambient noise data. In Egypt, numerous seismic ambient noise measurements have been conducted in several areas to determine the dynamic properties of soft soil for engineering purposes. At each site in each studied area, the fundamental site frequency was accurately estimated from the main peak in the spectral ratio between the horizontal and vertical component. Consequently, an extensive database of microtremor measurements, well logging data, and shallow seismic refraction data have been configured and assembled for the studied areas. New formula between fundamental site frequency (f0) and thickness of soft sediments (h) is established. The new formula has been validated and compared with other formulas of earlier scientists, and the results indicate that the calculated depth and geometry of the bedrock surface using new formula are in a good agreement with well logs data and previously published seismic refraction surveys in the investigated sites. 相似文献
15.
R. Maresca M. Castellano R. De Matteis G. Saccorotti P. Vaccariello 《Pure and Applied Geophysics》2003,160(9):1745-1764
16.
《地震研究进展（英文）》2021,1(4):100035
Detecting subsurface fault structure is important for evaluating potential earthquake risks associated with active faults. In this study, we propose a new method to detect faults using reflected surface waves observed in ambient noise cross correlation functions. Ambient noise tomography using direct surface waves obtained from ambient noise interferometry has been widely used to characterize active fault zones. In cases where a strong velocity contrast exists across the fault interface, fault-reflected surface waves are expected. We test this idea using a linear array deployed in the Suqian segment of Tanlu fault zone in Eastern China. The fault-reflected surface waves can be clearly seen in the cross-correlation functions of the ambient noise data, and the spatial position of the fault on the surface is close to the stations where the reflected signals first appear. Potentially reflected surface waves could also be used to infer the dip angle, fault zone thickness and the degree of velocity contrast across the fault by comparing synthetic and observed waveforms. 相似文献
17.
18.
19.
Past and recent observations have shown that the local site conditions significantly affect the behavior of seismic waves and its potential to cause destructive earthquakes. Thus, seismic microzonation studies have become crucial for seismic hazard assessment, providing local soil characteristics that can help to evaluate the possible seismic effects. Among the different methods used for estimating the soil characteristics, the ones based on ambient noise measurements, such as the H/V technique, become a cheap, non-invasive and successful way for evaluating the soil properties along a studied area.In this work, ambient noise measurements were taken at 240 sites around the Doon Valley, India, in order to characterize the sediment deposits. First, the H/V analysis has been carried out to estimate the resonant frequencies along the valley. Subsequently, some of this H/V results have been inverted, using the neighborhood algorithm and the available geotechnical information, in order to provide an estimation of the S-wave velocity profiles at the studied sites.Using all these information, we have characterized the sedimentary deposits in different areas of the Doon Valley, providing the resonant frequency, the soil thickness, the mean S-wave velocity of the sediments, and the mean S-wave velocity in the uppermost 30 m. 相似文献