共查询到20条相似文献，搜索用时 125 毫秒
1.
2.
湘西铅锌矿找矿前景分析 总被引：2，自引：0，他引：2
湘西地区是我国重要的铅锌矿产基地之一．2001年国土资源大调查取得显著的找矿成果．湘西铅锌矿属层控改造型低温热液矿床，含矿层位分布既广泛又稳定，区内构造简单，地域广阔，具有良好的寻找大型—超大型铅锌矿床的找矿前景；湘西铅锌矿的矿物成份简单，主要矿物闪锌矿粒度均匀，杂质少，纯度高，易采、易选冶，矿石采选成本低，锌选矿回收率高，具有较高的开发利用价值． 相似文献
3.
本文提出了在pH9的0.10mol/L NH_3·H_2O-0.23mol/L NH_4Cl缓冲溶液中,用EDTMP滴定Zn,以Zn在交流示波极谱dE/dt-E曲线上切口消失直接指示终点。所研究的方法已用于测定一些铅锌矿和锌铝合金中的Zn,结果满意。Zn量分析范围为0.900—12.00mg,方法回收率为98.65—101.3％。对于含Zn xx％的试样分析10次相对标准偏差为0.26—1.27％。 相似文献
4.
本文研究确定了利用铅锌矿废渣——双旋灰制取工业氯化锌的最佳工艺技术条件。选用1+1盐酸为锌的浸出剂,锌的浸出率高达82%以上。铁、铅、铜、锰、硫等杂质元素采用氯酸钾氧化、锌粉还原和钡盐沉淀等方法、从浸出液中分离除去,将溶液蒸发、浓缩后即得氯化锌产品。经扩大试验验证,工艺流程可行,锌的回收率为80%,产品质量符合国家标准(GB1625—79)规定的二级产品各项指标的要求。 相似文献
5.
6.
通过对甘沟铅锌矿的地质矿产勘查,已初步查明区内铅锌矿含矿层位为下志留统梅子垭组,圈定了4条铅锌矿体,已获铅锌矿资源量9.78×10^4t。该含矿层矿体单个长180-580 m,平均厚度1.22-1.79 m,平均锌品位5.42%-8.37%,平均铅品位1.93%-11.04%。认为该矿床成因属沉积-变形变质热液改造型矿床。 相似文献
7.
针对某湿法炼锌厂锌浸出渣采用粉煤富氧侧吹熔炼-烟化处理工艺存在有价金属走向分散、富集率低的问题,开展工业试验,考察温度、粉煤率、富氧浓度、钙硅比及反应时间对侧吹熔炼炉、烟化炉金属挥发率以及有价金属走向的影响。结果表明,在粉煤率21%、富氧浓度65%、炉温1 250℃、时间150 min的最佳条件下,侧吹熔炼炉的铅、银挥发率分别达到90.3%、86.5%,铅、银主要富集在侧吹熔炼炉烟尘中;在粉煤率13%、钙硅比0.6、吹炼时间120 min的最佳条件下,锌挥发率达到86.9%,锌主要富集在烟化炉烟尘中。 相似文献
8.
实验以大洋多金属结核浸出渣(66%,质量分数)为主要原料、高岭土(21%)为粘结剂、蛭石(13%)为膨胀剂,研制出用于动态吸附废水中重金属离子的浸出渣颗粒。以造粒后的颗粒为吸附剂动态处理含Cu2 的模拟废水,研究发现溶液浓度、流速、pH值对动态吸附效果的影响,选定浸出渣颗粒动态处理重金属废水的工艺参数:造粒后浸出渣颗粒的比表面积为18.61 m2/g,当模拟废水中Cu2 溶液的初始浓度为27 mg/L、pH=5.35、出口流速为10 ml/h时,每克浸出渣颗粒可动态处理模拟废水114.3 ml,处理后溶液中阳离子的浓度≤0.5 mg/L,实验效果明显。 相似文献
9.
根据河北某难选冶金银多金属原生矿的矿石基本特点,经多种选冶技术方案对比及试验研究,采用全泥氰化工艺流程提取金、银,氰化浸渣采用浮选法分离铜、铅、锌、硫,从而达到就地产出金、银和分别综合利用铜、锌、硫的目的。尤其是对该类型含铜高的矿石采用碱预处理浸出工艺,收到良好的效果,最终取得了一个技术上可行、经济效益显著的选冶工艺流程,为建厂提供了可靠依据。 相似文献
10.
江山铅锌金矿选矿试验研究 总被引：1，自引：0，他引：1
针对江山铅锌金矿品位低,矿物组成复杂的特点,采用"铅-锌-硫优先浮选,硫(金)精矿氧化焙烧预处理-焙砂氰化浸金"的工艺,金在铅(金)精矿、锌精矿、硫(金)精矿中的总回收率为81.25%。可使硫(金)精矿中96.89%的硫以二氧化硫的形式得到回收,对原矿的回收率为73.25%;金的作业浸出率达84.76%,对原矿的回收率为31.91%;浸渣中的铁品位达57.99%,对原矿的回收率为26.71%。通过试验研究与分析,确定适宜的选矿工艺及药剂制度,为今后合理开发该区矿石提供技术依据。 相似文献
11.
12.
The paper identifies and discusses potential adverse environmental impacts, and regulatory concerns, that could arise from piling or penetrative ground improvement techniques, when used on land affected by contamination.
A common generic classification of piling and penetrative ground improvement methods is considered and six cases are identified where potential adverse environmental impacts may be created by piling or penetrative ground improvement techniques.
A lack of published data on the scale of impacts caused by piling makes inevitable the application of the “Precautionary Principle” by environmental regulators, but it has been recognised that a rigid application of this principle may lead to unnecessarily restrictive requirements or prohibitions being placed on designers and developers. The need for guidance for designers and developers on how to consider the potential environmental impacts of piling works has also been recognised.
The paper outlines the decision-making framework presented in recent Environment Agency guidance. It assists the foundation designer to assess the environmental risks, select an appropriate piling or penetrative ground improvement method, develop mitigation measures, define quality assurance/quality control and monitoring measures, and justify and document this choice in a format acceptable to the regulator. 相似文献
13.
Summary Ground vibration data, originating from impact hammers and vibrodrivers and compiled by different research workers, have been plotted in scaled distance form and statistically analysed. A quadratic regression curve rather than a linear regression curve provides a better visual fit to the several data sets. In each case, superimposed on the graphical data points are also the one-half standard deviation and the one standard deviation curves. It is argued that the quadratic one-half standard deviation curves, generated from an analysis of all the reliable vibration information compiled by the authors from impact hammers and vibrodrivers, be used for design of piling operations in order to mitigate excessive environmental vibration. 相似文献
14.
本文通过南市区西陵高层打桩施工的实例,分析了各种打桩防护措施的作用和效果。认为打桩对周围环境产生的公害是一个动态过程。因而,根据场地的工程地质条件和打桩的进程,配以适当的防护工作量,并根据打桩过程中场地孔隙水压力和地基土变形的规律及时调整打桩流水的情报化施工方法,降低了防护费用,并可大大减少对周围环境的影响。 相似文献
15.
The influence of Zn speciation on Zn transport by drainage from different soils to surface water is examined in a stream catchment
in an agricultural area. Drainage waters were collected from two types of soils, a mineral soil (MS) and a soil rich in organic
matter (OS) by means of artificial drainage pipes. The speciation of dissolved Zn in the stream and the drainage waters was
determined using ligand-exchange and voltammetry. About 50–95% of dissolved Zn is bound in strong complexes, and the free
Zn2+ ion concentration is in the range of 1–16% of dissolved Zn. A substantial part of Zn is present in weaker organic or inorganic
complexes. The simulated Zn speciation using the WHAM VI model is compared to the determined speciation. Free Zn2+ concentrations predicted by the WHAM VI model are generally higher than the analytically determined free Zn2+, but are mostly within the same order of magnitude. Effects of different soil organic matter content on Zn speciation and
transport are discussed. Zn speciation in the drainage at the OS site is influenced by the distribution of organic matter
between the solid and solution phase. The abundant organic Zn complexes in solution contribute to facilitate Zn transport
from soil into surface waters, through the drainage at the OS site. Drainage from the OS site contributes about twice as much
Zn input to the receiving water as the MS soil, as related to specific area. The mineral soil contains much lower organic
matter, and a part of Zn bound with inorganic phases can hardly be released by dissolved organic ligands, leading to much
higher Zn retention at the MS site. 相似文献
16.
17.
针对某工程桩基采用设计与施工一起投标且施工中出现了一部分断桩,对该静压桩工程中的静载荷试验和对施工中出现的问题进行了分析,提出了解决问题的方法,并对如何保证静压桩的质量提出了具体的看法.工程实践表明,采用静压桩这种方法处理软地基,不仅造价低、工期短,而且对整个建筑物的质量有保障. 相似文献
18.
19.
针对淮盐高速公路淮安段高含水量软土地基的工程地质特性，依据设计文件进行水泥土搅拌桩成桩质量的现场试验研究，提出采用增强剂(石膏)和减水剂(木钙)作为水泥土搅拌桩的外加剂，以保证水泥土桩的成桩质量。提出了保证成桩质量的控制管理措施。 相似文献
20.
刘丽 《中国地质灾害与防治学报》2009,20(4):121-123,129
需要多大的压桩力才能将桩压入设计预定的标高,获得最大的单桩承载力,这是工程上最实际、最有价值的问题之一。本文通过静力压桩及静载试验求取适合于工程实际情况的终止压桩力与单桩极限承载力的关系,并通过钢弦式应力计在预应力管桩中的应用,论述了由测应力计频率到求取单桩极限侧阻力标准值及极限端阻力标准值的过程和原理。 相似文献