共查询到20条相似文献，搜索用时 171 毫秒
1.
《地震地质》2016,(4)
一般认为土层剪切波速与埋深关系的回归公式主要用于对当地土层剪切波速值的初步估计。为了提高钻孔波速测试数据的应用价值,基于土层剪切波速与埋深关系的主要数学模型及其拟合参数,推导了场地覆盖层厚度计算公式、等效剪切波速计算公式和时深转换中反射波组埋深计算公式。以河南省长垣县场地为例,采用上述新公式计算获得的场地覆盖层厚度值、等效剪切波速值可满足工程需要。并提出应用这些新公式的步骤为:1)依据场地相关资料划分地震工程地质单元;2)对同一个地震工程地质单元内的钻孔波速测试数据进行统计分析,综合判别和选择土层波速与埋深统计关系的数学模型及其拟合参数;3)将选择的数学模型的拟合参数分别代入上述的新公式,即可分别获得场地覆盖层厚度、等效剪切波速或地层反射波组埋深。 相似文献
2.
中硬场地对华北地区不同地震环境地震动反应谱的影响 总被引：1，自引：0，他引：1
《国际地震动态》2015,(9)
<正>以华北地区典型中硬工程场地为研究对象,运用一维等效线性方法进行土层地震反应分析计算,研究中硬场地对不同地震环境地震动反应谱的影响。采用地震危险性确定性分析方法得到的基岩反应谱作为输入地震动,收集华北地区中硬场地的钻孔资料、剪切波速及动三轴土样试验资料,并挑选典型的钻孔建立土层模型,进行大量的土层地震反应分析计算,从而得到多种地震环境下不同周期反应谱值的土层反应分 相似文献
3.
4.
苏州城区深软场地土剪切波速与土层深度的经验关系 总被引：9，自引：0，他引：9
苏州地处长江下游冲湖积平原,第4系沉积土层发育,土层深厚、松软,远震、大震的长周期地震动对苏州城区的重大工程有可能造成严重震害.结合海侵地质成因,分析了苏州城区深软场地52个钻孔剖面的剪切波速资料,发现剪切波速与土层深度的关系:40m以上浅土层基本符合线性函数分布,40m以下深土层基本符合幂函数分布;依据考虑和不考虑土体分类2种情况,给出了采用线性函数、幂函数分段形式拟合的苏州城区深软场地剪切波速随土层深度变化的经验关系,为苏州城区深软场地重大工程建设的场地地震效应评价提供了有益的基础性资料. 相似文献
5.
6.
7.
剪切波速对场地地表地震动参数的影响 总被引：3，自引：2，他引：1
本文以江淮地区典型场地资料为原型,将土层剪切波速实测值按照一定比例进行增减,构造多种场地土层地震反应分析模型,选择Taft、E1centro和Kobe三条强震记录作为地震输入,采用一维频域等效线性化波动方法进行了土层地震反应分析.研究结果表明,剪切波速的变异性与场地地表地震动的影响程度与输入基岩地震动的频谱特性、幅值、土层结构等因素有关.地表峰值加速度随着剪切波速的增大而逐渐增大,地表加速度反应谱的特征周期随着剪切波速的增大而逐渐减小. 相似文献
8.
9.
10.
本文选取山东地区2个Ⅲ类场地的工程地质勘探及土层剪切波速等资料,将土层厚度按5个深度段,每个分段给出了4个土层剪切波速的改变量,通过改变不同深度段土层剪切波速,建立了19种土层地震反应分析模型,分析了不同深度段,不同概率水平下土层剪切波速的变化对场地地震动参数的影响。研究表明,不同深度段土层剪切波速的变化对场地地震动参数的影响有差异。具体表现为,土层剪切波速的改变在1—10m、11—40m和地震输入界面处三个深度段对地震动加速度峰值影响较大;其中,41—70m和71—100m两个深度段剪切波速的改变对地震动加速度峰值影响小;在土层深度1—10m时,剪切波速降低,峰值变大,剪切波速的改变与峰值的改变呈负相关;在其它深度段,剪切波速降低,峰值变小,剪切波速的改变与峰值的改变呈正相关。剪切波速的改变在1—10m和11—40m两个深度段对地震加速度反应谱影响较大;在41—70m、71—100m和地震输入界面三个深度段对地震加速度反应谱影响很小。 相似文献
11.
12.
土层的剪切波速是描述土动力学特性的重要参数之一。利用金银岛岩土台阵记录的8次浅源地方震的弱震动数据,使用解卷积的地震干涉测量法识别的剪切波走时,评估了该台阵两个水平方向的原位剪切波速剖面。结果表明:在44.2m深度以上,估计与实测的平均剪切波速剖面基本一致,而在44.2m到103.6m深度范围前者大于后者;本研究估计的平均剪切波速剖面比MEHTA等（2007）估计的平均剪切波速剖面更接近实测结果,在44.2m到103.6m深度范围,本研究估计的平均剪切波速与MEHTA等（2007）估计的平均剪切波速相近,二者均大于实测的平均剪切波速。 相似文献
13.
J. A. Hunter B. Benjumea J. B. Harris R. D. Miller S. E. Pullan R. A. Burns R. L. Good 《Soil Dynamics and Earthquake Engineering》2002,22(9-12):931-941
Shear wave velocity–depth information is required for predicting the ground motion response to earthquakes in areas where significant soil cover exists over firm bedrock. Rather than estimating this critical parameter, it can be reliably measured using a suite of surface (non-invasive) and downhole (invasive) seismic methods. Shear wave velocities from surface measurements can be obtained using SH refraction techniques. Array lengths as large as 1000 m and depth of penetration to 250 m have been achieved in some areas. High resolution shear wave reflection techniques utilizing the common midpoint method can delineate the overburden-bedrock surface as well as reflecting boundaries within the overburden. Reflection data can also be used to obtain direct estimates of fundamental site periods from shear wave reflections without the requirement of measuring average shear wave velocity and total thickness of unconsolidated overburden above the bedrock surface. Accurate measurements of vertical shear wave velocities can be obtained using a seismic cone penetrometer in soft sediments, or with a well-locked geophone array in a borehole. Examples from thick soil sites in Canada demonstrate the type of shear wave velocity information that can be obtained with these geophysical techniques, and show how these data can be used to provide a first look at predicted ground motion response for thick soil sites. 相似文献
14.
通过统计地震小区划及一些单体工程场地地震安全性评价工程所积累的资料,对江门市城区各种土类的剪切波速进行了回归分析,得到各类土剪切波速随深度变化的统计规律,并进一步分析了场地土层其它特征,如各类土层的组合模式、厚度以及地面脉动分布特征等,最后给出了建筑场地类别的分区。 相似文献
15.
An investigation to systematize empirical equations for the shear wave velocity of soils was made in terms of four characteristic indexes. The adopted indexes are the N-value of the Standard Penetration Test, depth where the soil is situated, geological epoch and soil type. As some of these indexes are variates belonging to interval scales while others belong to nominal or ordinal scales, the technique known as a multivariate analysis cannot be employed. A new approach to the theory of quantification, after C. Hayashi, was introduced and developed for solving this difficulty. Fifteen sets of empirical equations to estimate low strain shear wave velocity theoretically may be obtained by combining the above four indexes. All of these sets were derived by use of about 300 data, and their accuracies were evaluated by means of correlation coefficients between the measured and estimated shear wave velocities. The best equation was found to be the one which included all the indexes, and its correlation coefficient was 0.86. The empirical equation relating the standard penetration N-value to the shear wave velocity provided a correlation of only 0.72, and is one of the lowest ranking among the 15 sets of equations. 相似文献
16.
This study analyzes liquefaction in the Kumluca/Antalya residential area and surroundings, using seismic velocities of soil deposits and the predominant period of the earthquake wave. The liquefaction analysis calculates shear–stress ratio, shear–resistance ratio and safety factor. Shear wave velocity used in liquefaction analysis was determined through surface waves. Moreover, the dynamic parameters of the ground were calculated through seismic velocities. Distributions of groundwater, shear wave velocity, adjusted shear wave velocity, predominant period of vibration, soil amplification and ground acceleration of the research area were mapped. In addition, the liquefied and non-liquefied areas as a result of liquefaction analysis in Kumluca were determined and presented as maps. Examining these maps, among all these maps, the limits of the lagoon sandbar and the old lake area were determined using only the liquefaction map. 相似文献
17.
Osman Uyanık 《Journal of Applied Geophysics》2011,73(1):16-24
This study devises a new analytical relationship to determine the porosity of water-saturated soils at shallow depth using seismic compressional and shear wave velocities. Seismic refraction surveys together with soil sample collection were performed in selected areas containing water-saturated clay–silt, sand and gravely soils. Classification of clay–silt, sand and gravel dense soils provided the coefficient of experimental equation between the data sets, namely, Poisson's ratio, shear modulus and porosity values. This study presents a new analytical relationship between Poisson's ratio and shear modulus values, which are obtained from seismic velocities and porosity values of water-saturated material computed from water content and grain densities, which are determined by laboratory analysis of disturbed samples. The analytical relationship between data sets indicates that when the shear modulus of water-saturated loose soil increases, porosity decreases logarithmically. If shear modulus increases in dense or solid saturated soils, porosity decreases linearly. 相似文献
18.
During an earthquake, the amplitudes of seismic wave may amplify significantly as it propagates through the soil layers near the ground surface. Analysis of site amplification potential is strongly influenced by the uncertainty associated to the definition of soil thickness and its properties. In this paper, the non-recursive algorithm is used in linear and nonlinear Hybrid Frequency Time Domain (HFTD) approaches for stochastic analysis of site amplification. The non-recursive algorithm causes time reduction of analysis that is the essential base of stochastic analysis. The selected soil stochastic parameters are shear wave velocity, density, damping and thickness. The results of sensitivity analysis also show that the damping ratio is the most effective parameter in PGA at ground surface. The stochastic peak ground acceleration, response spectrum and amplification factor at the ground surface are determined by the two approaches for four sites with different average shear wave velocities. Comparison of the results shows that the nonlinear HFTD approach predicts closer response to real recorded data with respect to linear HFTD. 相似文献
19.
利用双平面波干涉面波层析成像方法研究山西断陷盆地及鄂尔多斯地台三维速度结构 总被引：4，自引：1，他引：3
本文利用了北京大学在山西地堑的34个台站以及中国地震局台网中心在鄂尔多斯地区46个台站的远震波形数据,运用双平面波干涉的面波层析成像方法,提取瑞利面波相速度频散曲线,开展台阵覆盖区三维速度结构反演,据此分析了研究区地壳和上地幔的结构特征。结果表明,瑞利面波相速度分区特征显著,山西断陷盆地和渭河断陷盆地的相速度整体偏低。鄂尔多斯块体在莫霍面以下有明显高速异常,表明该地块为构造稳定的克拉通块体,鄂尔多斯块体的岩石圈下界面在120～140km的深度左右。与此相反,山西断陷盆地和渭河断陷盆地地下70～120km左右均有低速异常,显示这两个地区构造活动活跃,这也与该区域历史上多次发生强震是相符的。 相似文献
20.
通过对山西长治市区41个钻孔柱状和剪切波速资料的整理分析,利用剪切波速与深度的指数式经验公式,对土层剪切波速Vs与土层深度H间的关系进行统计回归。经对比检验得出,土层Vs-H统计关系符合本地岩性特征。 相似文献