共查询到20条相似文献，搜索用时 31 毫秒
1.
A laboratory study on the undrained dynamic behavior of saturated clays in cyclic triaxial tests with a variable confining pressure (VCP tests) is presented. Tests were performed on remolded clayey samples using a dynamic triaxial device where the deviatoric stress and confining pressure can be varied simultaneously. Various cyclic stress paths have been applied on the specimens through varying the ratios or phase differences between the cyclic deviatoric stress and cyclic confining pressure. Specifically, the stress paths used in the present study were designed to simulate the coupling effects of simultaneously varying shear and normal stresses in clays due to earthquakes and other vibration sources. Test results obtained from this study show that the undrained response of saturated clays is strongly influenced by the variation of confining pressure, in terms of pore water pressure, development speed of cyclic strain and magnitude of cyclic strength. It is found that when strong P-waves are propagating in soil layers, VCP tests are more appropriate for the simulation of in situ stress fields than the conventional cyclic triaxial tests with a constant confining pressure (CCP tests). 相似文献
2.
3.
除饱和砂土液化外,饱和粉土地震液化问题也是岩土地震工程中一个重要的研究课题。饱和粉土地基的地震液化及变形可以采用多种地基加固方法防治,碎石桩技术是常用方法之一。碎石桩复合地基的抗液化效应,主要是增加桩周土体的密度、利于桩体的排水以及由桩体分担地震水平剪应力（桩体减震作用）。但由于粉土的土质特性,粉土-碎石桩复合地基的抗液化特性与砂土有着明显的差异。本文结合目前国内外碎石桩复合地基抗液化研究的最新进展,对粉土-碎石桩的密实、排水减压和减震作用做了较详细的评述,最后提出了关于碎石柱复合地基抗液化特性需要进一步研究的问题。 相似文献
4.
地基土单元体在地震荷载作用下将产生主应力轴连续旋转,不同的应力耦合模式对土的强度、孔压以及变形等特性影响显著。利用GCTS空心圆柱扭剪仪,对天津滨海软土场地饱和黏性土进行K0固结下的不同应力耦合模式的循环剪切试验。着重对比相同应力路径下竖向和扭剪双向耦合加载模式,内外围压和扭剪的三向耦合加载模式以内外围压、竖向和扭剪的四向耦合加载模式条件下饱和黏性土的变形特性、循环软化特性。试验结果表明:在相同的动强度下,四向耦合应力模式更容易破坏且变形特性以及软化特性较双向、三向耦合下发展更加迅速;剪应力分量对试样软化变形特性的影响更加显著。 相似文献
5.
Neural network model for liquefaction potential in soil deposits using Turkey and Taiwan earthquake data 总被引：9，自引：0，他引：9
Adel M. Hanna Derin Ural Gokhan Saygili 《Soil Dynamics and Earthquake Engineering》2007,27(6):521-540
Simplified methods have been practiced by researchers to assess nonlinear liquefaction potential of soil. Derived from several field and laboratory tests, various simplified procedures such as stress-based, strain-based, Chinese criteria, etc. have been developed by utilizing case studies and undisturbed soil specimens. In order to address the collective knowledge built up in conventional liquefaction engineering, an alternative general regression neural network model is proposed in this paper.To meet this objective, a total of 620 sets of data including 12 soil and seismic parameters are introduced into the model. The data includes the results of field tests from the two major earthquakes that took place in Turkey and Taiwan in 1999 and some of the desired input parameters are obtained from correlations existing in the literature.The proposed GRNN model was developed in four phases, mainly: identification phase, collection phase, implementation phase, and verification phase. An iterative procedure was followed to maximize the accuracy of the proposed model. The case records were divided randomly into testing, training, and validation datasets.Generating a model that takes into account of 12 soil and seismic parameters is not feasible by using simplified techniques; however, the proposed GRNN model effectively explored the complex relationship between the introduced soil and seismic input parameters and validated the liquefaction decision obtained by simplified methods. The proposed GRNN model predicted well the occurrence/nonoccurrence of soil liquefaction in these sites. The model provides a viable tool to geotechnical engineers in assessing seismic condition in sites susceptible to liquefaction. 相似文献
6.
7.
Evaluation of the cyclic shear modulus of soils is a crucial but challenging task for many geotechnical earthquake engineering and soil dynamic issues. Improper determination of this property unnecessarily drives up design and maintenance costs or even leads to the construction of unsafe structures. Due to the complexities involved in the direct measurement, empirical curves for estimating the cyclic shear modulus have been commonly adopted in practice for simplicity and economical considerations. However, a systematic and robust approach for formulating a reliable model and empirical curve for cyclic shear modulus prediction for clayey soils is still lacking. In this study, the Bayesian model class selection approach is utilized to identify the most significant soil parameters affecting the normalized cyclic shear modulus and a reliable predictive model for normally to moderately over-consolidated clays is proposed. Results show that the predictability and reliability of the proposed model out performs the well-known empirical models. Finally, a new design chart is established for practical usage. 相似文献
8.
9.
Mele Lucia Chiaradonna Anna Lirer Stefania Flora Alessandro 《Bulletin of Earthquake Engineering》2021,19(10):3865-3893
In engineering practice, the liquefaction potential of a sandy soil is usually evaluated with a semi-empirical, stress-based approach computing a factor of safety in free field conditions, defined as the ratio between the liquefaction resistance (capacity) and the seismic demand. By so doing, an estimate of liquefaction potential is obtained, but nothing is known on the pore pressure increments (often expressed in the form of normalized pore pressure ratio ru) generated by the seismic action when the safety factor is higher than 1. Even though ru can be estimated using complex numerical analyses, it would be extremely useful to have a simplified procedure to estimate them consistent with the stress-based approach adopted to check the safety conditions. This paper proposes such a procedure with reference to both saturated and unsaturated soils, considering the latter as soils for which partial saturation has been artificially generated with some ground improvement technology to increase cyclic strength and thus tackle liquefaction risk. A simple relationship between the liquefaction free field safety factor FS, and ru(Sr) is introduced, that generalizes a previous expression proposed by Chiaradonna and Flora (Geotech Lett, 2020. https://doi.org/10.1680/jgele.19.00032) for saturated soils. The new procedure has been successfully verified against some experimental data, coming from laboratory constant amplitude cyclic tests and from centrifuge tests with irregular acceleration time histories for soils having different gradings and densities.
相似文献10.
An automatically adaptive element free method is presented to analyze the seismic response of liquefiable soils.The method is based on the element free Galerkin method (EFGM) and the fission procedure that is part of h-refinement,indicated by error estimation. In the proposed method, a posteriori error estimate procedure that depends on the energy normof stress and the T-Belytschko (TB) stress recovery scheme is incorporated. The effective cyclic elasto-plastic constitutivemodel is used to describe the nonlinear behavior of the saturated soil. The governing equations are established by u-pformulation. The proposed method can effectively avoid the volumetric locking due to large deformation that usually occursin numerical computations using the finite element method (FEM). The efficiency of the proposed method is demonstratedby evaluating the seismic response of an embankment and comparing it to results obtained through FEM. It is shown that theproposed method provides an accurate seismic analysis of saturated soil that includes the effects of liquefaction 相似文献
11.
12.
Hideo Nagase 《Soil Dynamics and Earthquake Engineering》1987,6(4):239-249
In an effort to investigate the effects of irregular nature of load application on the behaviour of soils during earthquakes, a series of uni-directional irregular loading tests were performed on saturated Fuji river snad under undrained condition using a simple shear test apparatus. The samples prepared to three different densities in this test device were subjected to twelve irregular time histories of shear stress alteration. For comparison purposes, the conventional type of constant amplitude cyclic simple shear tests were also conducted on samples prepared under identical conditions. On the basis of the test results, values of coefficients allowing for the effect of load irregularity were elucidated for the samples with three different densities. It was then suggested that the values of coefficient thus determined be used to facilitate the evaluation of the soil strength under actual seismic loading conditions, on the basis of the cyclic shear strength obtained from the conventional type of constant-amplitude triaxial tests. 相似文献
13.
Softening and strength loss of sands with increasing excess pore water pressure under repeated loads is well-known. However, extensive damage to the built environment also occurs at the sites underlain by fine grained soils during seismic shaking. The primary objective of this study is to investigate the factors affecting cyclic behavior of saturated low-plastic silt through laboratory testing. For this purpose, an extensive laboratory testing program including conventional monotonic and cyclic triaxial tests was carried out over reconstituted silt samples. The effects of the inherent soil properties and the effects of loading characteristics on the cyclic response of saturated low-plastic reconstituted silt samples were examined separately. Based on the test results, a model was introduced to estimate the effect of initial shear stress on the cyclic response. Besides, liquefaction susceptibility of the samples was examined via current liquefaction susceptibility criteria. 相似文献
14.
Through an energy approach, a model is proposed to predict the cyclic liquefaction strength of saturated sands in terms of their static shear strengths. Plots of cyclic liquefaction strength versus relative density and also versus modified standard penetration resistance are presented for various uniformity coefficients and different numbers of stress cycles. The predicted cyclic liquefaction strength values are converted to cyclic stress ratios and compare favourably with Seed's empirical correlations. 相似文献
15.
Dynamic instability of clays: an energy approach 总被引：1，自引：0，他引：1
The dynamic instability of any soil is based on the ability to accumulate from cycle to cycle a part of the energy to be dissipated. Using the general thermodynamic approach in combination with high resolution experiments it is possible to analyze the transformations of energy in soil under dynamic loading. Undisturbed specimens of two Norwegian clays, sufficiently different in their engineering properties, were used in a number of undrained cyclic triaxial tests to study the influence of confining stress, coefficient of earth pressure at rest (K0), dynamic stress amplitude and frequency of loading in the development of instability in the clays. This paper discusses the unit dissipated energy and the unit activation energy as possible energy criteria for evaluation of dynamic instability in soils. 相似文献
16.
The estimation of cyclic deformation demand resulting from earthquake loads is crucial to the core objective of performance‐based design if the damage and residual capacity of the system following a seismic event needs to be evaluated. A simplified procedure to develop the cyclic demand spectrum for use in preliminary seismic evaluation and design is proposed in this paper. The methodology is based on estimating the number of equivalent cycles at a specified ductility. The cyclic demand spectrum is then determined using well‐established relationships between seismic input energy and dissipated hysteretic energy. An interesting feature of the proposed procedure is the incorporation of a design spectrum into the proposed procedure. It is demonstrated that the force–deformation characteristics of the system, the ductility‐based force‐reduction factor Rμ, and the ground motion characteristics play a significant role in the cyclic demand imposed on a structure during severe earthquakes. Current design philosophy which is primarily based on peak response amplitude considers cyclic degradation only in an implicit manner through detailing requirements based on observed experimental testing. Findings from this study indicate that cumulative effects are important for certain structures, classified in this study by the initial fundamental period, and should be incorporated into the design process. Copyright © 2003 John Wiley & Sons, Ltd. 相似文献
17.
Lateral deformation of liquefiable soil is a cause of much damage during earthquakes, reportedly more than other forms of liquefaction-induced ground failures. Researchers have presented studies in which the liquefied soil is considered as viscous fluid. In this manner, the liquefied soil behaves as non-Newtonian fluid, whose viscosity decreases as the shear strain rate increases. The current study incorporates computational fluid dynamics to propose a simplified dynamic analysis for the liquefaction-induced lateral deformation of earth slopes. The numerical procedure involves a quasi-linear elastic model for small to moderate strains and a Bingham fluid model for large strain states during liquefaction. An iterative procedure is considered to estimate the strain-compatible shear stiffness of soil. The post-liquefaction residual strength of soil is considered as the initial Bingham viscosity. Performance of the numerical procedure is examined by using the results of centrifuge model and shaking table tests together with some field observations of lateral ground deformation. The results demonstrate that the proposed procedure predicts the time history of lateral ground deformation with a reasonable degree of precision. 相似文献
18.
Yan-Guo Zhou Kai Liu Dao-Sheng Ling Tao Shen Yun-Min Chen 《Bulletin of Earthquake Engineering》2018,16(11):5151-5170
Estimating the possible region of liquefaction occurrence during a strong earthquake is highly valuable for economy loss estimation, reconnaissance efforts and site investigations after the event. This study identified and compiled a large amount of liquefaction case histories from the 2008 Wenchuan earthquake, China, to investigate the relationship between the attenuation of seismic wave energy and liquefaction distance limit during this earthquake. Firstly, we introduced the concept of energy absorption ratio, which is defined as the absorbed energy of soil divided by the imparted energy of seismic waves at a given site, and the relationship between the energy absorption ratio and the material damping ratio was established based on shear stress–strain loop of soil element and the seismic wave propagation process from the source to the site. Secondly, the threshold imparted seismic energy of liquefaction was obtained based on existing researches of absorbed energy required to trigger liquefaction of sandy soils and the ground motion attenuation characteristics of the 2008 Wenchuan earthquake, and the liquefaction distance limit of this earthquake was estimated according to the proposed magnitude–energy–distance relationship. Finally, the field liquefaction database of 209 sites of the 2008 Wenchuan earthquake was used to validate such an estimation, and the field observed threshold imparted seismic energy to cause liquefaction in recent major earthquakes worldwide was back-analyzed to check the predictability of the present method, and several possible mechanisms were discussed to explain the discrepancy between the field observations and the theoretical predictions. This study indicates that seismic energy attenuation and liquefaction distance limit are regional specific and earthquake dependent, and 382 J/m3 is the average level of threshold imparted seismic energy to cause liquefaction for loose saturated sandy soils, and the corresponding liquefaction distance limit is approximately 87.4 km in fault distance for a Mw?=?7.9 event in the Chengdu Plain. The proposed regional energy attenuation model and threshold imparted seismic energy may be considered as an approximate tool in evaluating the liquefaction hazard during potential earthquakes in this area. 相似文献
19.