首页 | 本学科首页   官方微博 | 高级检索  
相似文献
 共查询到10条相似文献,搜索用时 125 毫秒
1.
2.
Two Miocene basaltic andesite pillowed sills in the Shimane Peninsula, SW Japan, were intruded into wet marine sediments, plastically deforming them. The pillows are elongated, constricted, interconnected and relatively closely packed. Individual pillows have a poorly to moderately vesiculated, somewhat crystalline rind thinner than a few centimeters and a moderately to well vesiculated, more crystalline core; contraction cracks and spreading cracks are poorly developed. The pillows in the sills morphologically resemble pillow lava flows, and during sill intrusion, the magma bifurcated into pillow lobes in a manner similar to pillow lavas. Formation of pillows in sill probably occurs when the magma is intruded into wet sediments and protrudes fingers by the instability of the magma-sediment interface with little turbulence of magma flow.  相似文献   

3.
Lava flux and a low palaeoslope were the critical factors in determining the development of different facies in the Late Permian Blow Hole flow, which comprises a series of shoshonitic basalt lavas and associated volcaniclastic detritus in the southern Sydney Basin of eastern Australia. The unit consists of a lower lobe and sheet facies, a middle tube and breccia facies, and an upper columnar-jointed facies. Close similarities in petrography and geochemistry between the basalt lavas from the three facies suggest similar viscosities at similar temperatures. Sedimentological and palaeontological evidence from the sedimentary units immediately below the Blow Hole flow suggests that the lower part of the volcanic unit was emplaced in a cold water, shallow submarine environment, but at least the top of the uppermost lava was subaerial with some palaeosol development. The lower lobe and sheet facies was emplaced on a low slope (<2°) in a lower to middle shoreface environment with water depths of 20–25 m. Lava may have transgressed from subaerial to subaqueous and was emplaced relatively passively with lava flux sufficiently high and uniform to form lobes and sheets rather than pillows. The middle unit probably originated from a subaerial vent and flowed into a shallow (10–15 m) submarine environment, and wave action probably interacted with the advancing lava front to form a lava delta. Lava flux was sufficiently high to produce well-developed, subcircular lava tubes, which lack evidence for thermal erosion. In some areas, lava ‘burrowed’ into the unconsolidated, water-saturated lava delta and sand pile to produce intrusive contacts. The upper columnar-jointed unit represents a ponded facies probably emplaced initially in water depths <5 m but whose top was subaerial.  相似文献   

4.
Well-preserved pillow lavas in the uppermost part of the Early Archean volcanic sequence of the Hooggenoeg Formation in the Barberton Greenstone Belt exhibit pronounced flow banding. The banding is defined by mm to several cm thick alternations of pale green and a dark green, conspicuously variolitic variety of aphyric metabasalt. Concentrations of relatively immobile TiO2, Al2O3 and Cr in both varieties of lava are basaltic. Compositional differences between bands and variations in the lavas in general have been modified by alteration, but indicate mingling of two different basalts, one richer in TiO2, Al2O3, MgO, FeOt and probably Ni and Cr than the other, as the cause of the banding. The occurrence in certain pillows of blebs of dark metabasalt enclosed in pale green metabasalt, as well as cores of faintly banded or massive dark metabasalt, suggest that breakup into drops and slugs in the feeder channel to the lava flow initiated mingling. The inhomogeneous mixture was subsequently stretched and folded together during laminar shear flow through tubular pillows, while diffusion between bands led to partial homogenisation. The most common internal pattern defined by the flow banding in pillows is concentric. In some pillows the banding defines curious mushroom-like structures, commonly cored by dark, variolitic metabasalt, which we interpret as the result of secondary lateral flow due to counter-rotating, transverse (Dean) vortices induced by the axial flow of lava towards the flow front through bends, generally downward, in the tubular pillows. Other pillows exhibit weakly-banded or massive, dark, variolitic cores that are continuous with wedge-shaped apophyses and veins that intrude the flow banded carapace. These cores represent the flow of hotter and less viscous slugs of the dark lava type into cooled and stiffened pillows.  相似文献   

5.
Pillow talk     
Three distinct types of pillows and pillow lava sequences with different modes of origin have been recognized in the extrusive sequences comprising the upper parts of ophiolite complexes that represent the mafic portion of the floor of an Early Cretaceous back-arc basin in southern Chile. One type of pillow formed by non-explosive submarine effusion. A second type formed by magmatic intrusion into pre-existing aquagene tuff formed by explosive eruption. The third type of pillow occurs within dikes, forming pillowed dikes, possibly as a result of vapor streaming within a cooling dike. Where studied in southern Chile, aquagene tuffs and intrusive pillows decrease and water-lain pillows increase in relative abundance from north to south. This variation corresponds with a north-to-south decrease in both the relative volume of extrusives to extensional dikes and the range and volume of differentiated rocks, suggesting a southward increase in rate of extension relative to rate of magma supply within the spreading ridges at which the ophiolites formed. In the northern part of the original basin where the rate of extension was small relative to the rate of magma supply, magma remained in magma chambers longer, resulting in a greater range and volume of differentiated rocks. The larger volume of more differentiated, cooler and more viscous magmas, in conjunction with the likelihood of more violent eruption of volatile-rich differentiates, may have been responsible for the large volume of aquagene tuff in the northern part of the original basin. These observations in southern Chile suggest that ophiolites which contain a great abundance of aquagene tuffs and intrusive pillow lavas formed in tectonic environments in which the rate of extension was small relative to the rate of magma supply (island arcs, embryonic marginal basins). Ophiolites with predominantly water-lain pillowed and massive lavas formed in tectonic environments in which the rate of extension was large relative to the rate of magma supply (mid-ocean ridges, mature back-arc basins). Thus geologic field data may supplement geochemical data as a tool in distinguishing the original igneous-tectonic environments in which ophiolites originate.  相似文献   

6.
At Rakiraki in northeastern Viti Levu, the Pliocene Ba Volcanic Group comprises gently dipping, pyroxene-phyric basaltic lavas, including pillow lava, and texturally diverse volcanic breccia interbedded with conglomerate and sandstone. Three main facies associations have been identified: (1) The primary volcanic facies association includes massive basalt (flows and sills), pillow lava and related in-situ breccia (pillow-fragment breccia, autobreccia, in-situ hyaloclastite, peperite). (2) The resedimented volcaniclastic facies association consists of bedded, monomict volcanic breccia and scoria lapilli-rich breccia. (3) The volcanogenic sedimentary facies association is composed of bedded, polymict conglomerate and breccia, together with volcanic sandstone and siltstone-mudstone facies. Pillow lava and coarse hyaloclastite breccia indicate a submarine depositional setting for most of the sequence. Thick, massive to graded beds of polymict breccia and conglomerate are interpreted as volcaniclastic mass-flow deposits emplaced below wave base. Well-rounded clasts in conglomerate were reworked during subaerial transport and/or temporary storage in shoreline or shallow water environments prior to redeposition. Red, oxidised lava and scoria clasts in bedded breccia and conglomerate also imply that the source was partly subaerial. The facies assemblage is consistent with a setting on the submerged flanks of a shoaling basaltic seamount. The coarse grade and large volume of conglomerate and breccia reflect the high supply rate of clasts, and the propensity for collapse and redeposition on steep palaeoslopes. The clast supply may have been boosted by vigorous fragmentation processes accompanying transition of lava from subaerial to submarine settings. The greater proportion of primary volcanic facies compared with resedimented volcaniclastic and volcanogenic sedimentary facies in central and northwestern exposures (near Rakiraki) indicates they are more proximal than those in the southeast (towards Viti Levu Bay). The proximal area coincides with one of two zones where NW-SE-trending mafic dykes are especially abundant, and it is close to several, small, dome-like intrusions of intermediate and felsic igneous rocks. The original surface morphology of the volcano is no longer preserved, though the partial fan of bedding dip azimuths in the south and east and the wide diameter (exceeding 20 km) are consistent with a broad shield.  相似文献   

7.
Measurements of H and V (dimensions in the horizontal and vertical directions of pillows exposed in vertical cross-section) were made on 19 pillow lavas from the Azores, Cyprus, Iceland, New Zealand, Tasmania, the western USA and Wales. The median values of H and V plot on a straight line that defines a spectrum of pillow sizes, having linear dimensions five times greater at one end than at the other, basaltic toward the small-size end and andesitic toward the large-size end. The pillow median size is interpreted to reflect a control exercised by lava viscosity. Pillows erupted on a steep flow-foot slope in lava deltas can, however, have a significantly smaller size than pillows in tabular pillowed flows (inferred to have been erupted on a small depositonal slope), indicating that the slope angle also exercised a control. Pipe vesicles, generally abundant in the tabular pillowed flows and absent from the flow-foot pillows, have potential as a paleoslope indicator. Pillows toward the small-size end of the spectrum are smooth-surfaced and grew mainly by stretching of their skin, whereas disruption of the skin and spreading were important toward the large-size end. Disruption involved increasing skin thicknesses with increasing pillow size, and pillows toward the large-size end are more analogous with toothpaste lava than with pahoehoe and are inferred from their thick multiple selvages to have taken hours to grow. Pseudo-pillow structure is also locally developed. An example of endogenous pillow-lava growth, that formed intrusive pillows between normal pillows, is described from Sicily. Isolated pillow-like bodies in certain andesitic breccias described from Iceland were previously interpreted to be pillows but have anomalously small sizes for their compositions; it is now proposed that they may lack an essential attribute of pillows, namely, the development of bulbous forms by the inflation of a chilled skin, and are hence not true pillows. Para-pillow lava is a common lava type in the flow-foot breccias. It forms irregular flow-sheets that are locally less than 5 cm thick, and failed to be inflated to pillows perhaps because of an inadequate lava-supply rate or too high a flow velocity.  相似文献   

8.
Observations in the Montgenevre Massif (French-Italian Alps) and in several other pillow basalt localities indicate that most pillowy flows are not made up of isolated spheres or sacks. In sections more or less parallel to the surface of the flow, it can be seen that pillows are in fact part of a system of interconnected fingers or tubes of lava that divide and bifurcate in the direction of flow. In transverse sections however the pillows appear to be isolated because of geometrical reasons. If this pillow lava structure seems to be the general rule, it is nevertheless likely that in the case of very fluid lavas and on a steep slope, the end of a tube or a new bud may become detached and roll down the bank in front of the flow to form an isolated spheroid.  相似文献   

9.
The well-preserved extrusive sequence of the Solund-Stavfjord Ophiolite Complex (SSOC) in the West Norwegian Caledonides enables reconstruction of the uppermost oceanic crust that developed in a marginal basin. Basaltic sheet flows, pillow lavas and volcanic breccias are the main components of the extrusive sequence and show stratigraphic and structural evidence for a cyclic development. The first stage in a volcanic cycle is characterized by high extrusion rates yielding sheet flows, commonly with the thickest flow units at the base. Sequences of sheet flows can be correlated laterally for at least 6.5 km. Pillow lavas succeed the sheet flows later in a volcanic cycle with progressively smaller pillows forming at decreasing extrusion rates. Volcanic breccias occur towards the end of a volcanic cycle, but may also occur at lower stratigraphie levels. They are made generally of pillow breccias and hyaloclastites. The extrusive sequence of the SSOC oceanic crust was constructed through seven volcanic cycles that resulted in stratigraphic units with thicknesses ranging from 40 to 225 m. This architecture is comparable to sequences in in situ oceanic crust developed along slow- to intermediate-spreading ridges.  相似文献   

10.
Multiple-rind structure is common among shallow-water pillows with diameters larger than about 1 m in Oamaru, New Zealand, on the Columbia Plateau (USA), and elsewhere. A rind consists of sideromelane, tachylyte, and tachylytic basalt. A multiple rind is a concentric set of repeated rinds in various forms, e. g., a portion of a broken rind thrust under another part, a series of short and detached subparallel rinds, or a pouch-shaped depression. Transitions and combinations of these three forms are common. Multiple-rind structure develops at any part of the pillow perimeter, but does not cover the pillow completely. It is always accompanied by a rupture in the outermost rind. Up to 13 rinds have been observed, but two to four rinds are most common. The multiple-rind structure is formed by implosion resulting from condensation of exsolved H2O. When H2O condenses, a pressure difference between the interior and exterior of a pillow is created. Above a certain threshold pressure difference, the outer skin of a pillow is torn at weak points, such as radial joints, and thrusts under the neighboring skin, buckles to form a pouch-shaped depression, or produces some variation of these. One set of multiple rinds is thus formed. Further exsolution and condensation of H2O in solidifying pillows may cause development of additional rinds. H2O exsolution and condensation and subsequent implosion are limited to low-pressure environments so that multiple-rind structure is characteristic of shallow-water pillow lava.  相似文献   

设为首页 | 免责声明 | 关于勤云 | 加入收藏

Copyright©北京勤云科技发展有限公司  京ICP备09084417号