共查询到20条相似文献，搜索用时 31 毫秒
1.
2.
《Ocean Modelling》2011,39(3-4):267-279
Near-surface enhancement of turbulent mixing and vertical mixing coefficient for temperature owing to the effect of surface wave breaking is investigated using a two-dimensional (2-D) ocean circulation model with a tidal boundary condition in an idealized shelf sea. On the basis of the 2-D simulation, the effect of surface wave breaking on surface boundary layer deepening in the Yellow Sea in summer is studied utilizing a 3-D ocean circulation model. A well-mixed temperature surface layer in the Yellow Sea can be successfully reconstructed when the effect of surface wave breaking is considered. The diagnostic analysis of the turbulent kinetic energy equation shows that turbulent mixing is enhanced greatly in the Yellow Sea in summer by surface wave breaking. In addition, the diagnostic analysis of momentum budget and temperature budget also show that surface wave breaking has an evident contribution to the turbulent mixing in the surface boundary layer. We therefore conclude that surface wave breaking is an important factor in determining the depth of the surface boundary layer of temperature in the Yellow Sea in summer. 相似文献
3.
4.
Plastic-coated paper is shown to possess reflectivity characteristics quite similar to those of the surface of water. This correspondence has been used with a conversion factor to model a sea surface by means of plastic-coated paper. Such a paper model is then suitably illuminated and photographed, yielding physically simulated daylight imagery of the sea surface under controlled conditions. A simple example of sinusoidal surface simulation is described 相似文献
5.
6.
A.M Davies 《Progress in Oceanography》1985,15(2):71-128
The solution of the linear three dimensional hydrodynamic equations describing wind induced flow in a sea region is developed using the Galerkin method through the vertical. A basis set of B-splines is shown to have some computational advantages over a set of eigenfunctions (vertical modes). However, a basis set of modes leads to a system of essentially uncoupled equations and current profiles can be interpreted in terms of vertical modes.The influence of wind induced surface turbulence and turbulence at depth due to tidal motion upon current profiles in both deep (260 m) and shallow (35 m) sea regions is examined. The variation in the angle between surface current and surface wind for different viscosity profiles, and the effect of bottom friction upon it is considered.The magnitude and direction of the surface current is significantly influenced by surface eddy viscosity. However, viscosity at depth due to tidal motion also has an important effect upon the surface current.The time evolution of current structure following the sudden onset of a wind is examined using the modal model. Calculations show that the rate of damping of the internal modes is inversely proportional to the square of the depth. Consequently wind induced current structure takes longer to reach a steady state in a deep sea region than a shallow area.The influence of sea surface elevation gradients in determining the direction of surface current is also considered. 相似文献
7.
Heat content change in the surface isothermal layer of a typical warm core ring in the sea east of Japan is described based
on approximately 90 CTD profiles obtained by one profiling float. Erosion of the seasonal thermocline and development of a
surface isothermal layer from the mid-summer to the early winter of 1999 are clearly seen. While heat content change between
two consecutive profiles with a 35-hour time interval is much noisier, its 10-day running mean is consistent with net surface
heat flux, indicating that surface heat flux dominates the temporal heat content change in the surface isothermal layer in
the warm core ring. 相似文献
8.
The purpose of the present paper is to develop a potential-based panel method for determining the steady potential flow about three-dimensional hydrofoil under free surface. The method uses constant-strength doublets and source density distribution over the foil body surface and thereby Dirichlet-type boundary condition is used instead of Neumann-type condition. On the undisturbed free surface source density is used to meet the free surface condition that is linearised in terms of double-body model approach and is discretised by a one-side, upstream, four-point finite difference operator. After solving the doublets on the foil and sources on the free surface, the numerical results of pressure, lift and resistance coefficients and also wave profiles can then be calculated for different Froude number and depth of submergence to demonstrate the influence of free surface and aspect ratio effects on performance of the hydrofoil. 相似文献
9.
1 Introduction Interfacial waves travelling along the interface between two fluids of different densities can be often observed in subsurface layers of the ocean since the upper subsurface layer is warmer over much of the o- cean (Umeyama, 2002). They are… 相似文献
10.
When a bubble plume exists beneath a free surface, such as after a subsea gas well blowout, a generally horizontal flow occurs in the vicinity of the surface and this flow is influenced by the fact that the surface is free. Two very different theories for such surface flows have been developed in the past and the bases of these theories are reviewed here. The results of measurements of surface flows above plumes of relatively large scale are given. These are compared with both of the existing theories. One theory is found to be accurate at small radii from the plume centre and the other theory is found to be accurate at large radii. The needed boundary condition for the theory that is accurate at large radii is supplied by the results of the theory that is accurate at small radii. 相似文献
11.
The blade frequency noise of non-cavitation propeller in a uniform flow is analyzed in time domain. The unsteady loading (dipole source) on the blade surface is calculated by a potential-based surface panel method. Then the time- dependent pressure data is used as the input for Ffowcs Williams-Hawkings formulation to predict the acoustics pressure. The integration of noise source is performed over the true blade surface rather than the nothickness blade surface, and the effect of hub can be considered. The ... 相似文献
12.
Described is an application of surface projection calculations of array beam patterns. An example is presented showing how the surface patch illuminated by the transmitted pulse from a monostatic active sonar system intersects the surface projection of the beam pattern as a function of time. 相似文献
13.
海面粗糙度对于海洋工程和海洋军事都非常重要,但对海面粗糙度的现场观测资料非常少, 这大大制约了对海面粗糙度的认识。利用 TOPEX 高度计风速资料实现了对海面粗糙度的反演,并利用 1993 年和1998 年两年的资料对西北太平洋海域的海面粗糙度进行了研究。 相似文献
14.
K. A. Shmirko O. G. Konstantinov Yu. N. Kul’chin S. Yu. Stolyarchuk A. N. Pavlov M. Yu. Korenskii 《Izvestiya Atmospheric and Oceanic Physics》2017,53(3):373-381
A continuation of the work dedicated to the study of slicks and film formations on the sea surface is presented. A vector model for the calculation of reflected radiation by the wavy sea surface with respect to the contribution of upwelling radiation from under the sea surface (the second type of waters) is described briefly in [5]. This work contains an analysis of numerical calculations according to the developed procedure and the search for optimal conditions of slick detection. The best conditions for detecting slicks on the sea surface are reached when a P-polarization component of reflected radiation is recorded. In this case, the value of contrast between a slick and a clean surface is 30% higher on average than in recording a contrast without using a polarization filter and is 50% higher than in the case of recording a contrast with a filter oriented to the maximum transmission of S polarization component of reflected radiation. It is shown that, under clear sky conditions, the optimal condition for recording slicks on a sea surface is videotaping in the plane of solar vertical at viewing angles sliding towards the sea surface and when a polarization filter that identifies the Р polarization component of sea radiation is used. In contrast, under overcast sky conditions, it is best to perform observations in the plane that has a wind velocity vector. 相似文献
15.
A surface panel method treating a boundary-value problem of the Dirichlet type with the free surface is presented to design a three-dimensional body corresponding to a prescribed pressure distribution. The free surface boundary condition is linearized with respect to the oncoming flow, and computed by four-point finite difference scheme. Sample designs for submerged spheroids and Wigley hull are carried out to demonstrate the stable convergence, the effectiveness and the robustness of the method. The design of a 5500TEU container carrier is performed with respect to reduction of the wave resistance. To reduce the wave resistance, calculated pressure on the hull surface is modified to have the lower fluctuation, and is applied as a Dirichlet type dynamic boundary condition on the hull surface. The designed hull form is verified to have the lower wave resistance than the initial one not only by computation but also by experiment. 相似文献
16.
Bang-Fuh Chen 《Ocean Engineering》1999,26(1):47
A finite-differnece method was used to calculate the nonlinear hydrodynamic pressures acting on the coastal embankment faces by seismic-wave actions. The nonlinearity of free surface flow, convective acceleration, viscosity and surface tension of fluid are included in the analysis. The kinematic and dynamic free surface boundary conditions are employed for calculating the horizontal fluid velocity, pressure at the free surface and the surface profile of the fluid. The time-dependent water surface is transformed to the horizontal plane, and the flow field is mapped onto a rectangular, making it convenient to model the complex sea bottom geometry and the wavy water surface by the finite-difference method. Fully nonlinear and weakly nonlinear dynamic free surface conditions are used and compared. The effects of surface tension of fluid are also discussed. The nonslip boundary condition is applied on the most part of the interface between fluid and solid face, except the region near the intersection between free surface and wall face. The numerical results are presented for various water depths and ground motion intensities, and their associate viscous effects on coastal embankment hydrodynamics are discussed. 相似文献
17.
Numerical simulation of sloshing with large deforming free surface by MPS-LES method 总被引：1，自引：1，他引：0
Moving particle semi-implicit (MPS) method is a fully Lagrangian particle method which can easily solve problems with violent free surface. Although it has demonstrated its advantage in ocean engineering applications, it still has some defects to be improved. In this paper, MPS method is extended to the large eddy simulation (LES) by coupling with a sub-particle-scale (SPS) turbulence model. The SPS turbulence model turns into the Reynolds stress terms in the filtered momentum equation, and the Smagorinsky model is introduced to describe the Reynolds stress terms. Although MPS method has the advantage in the simulation of the free surface flow, a lot of non-free surface particles are treated as free surface particles in the original MPS model. In this paper, we use a new free surface tracing method and the key point is "neighbor particle". In this new method, the zone around each particle is divided into eight parts, and the particle will be treated as a free surface particle as long as there are no "neighbor particles" in any two parts of the zone. As the number density parameter judging method has a high efficiency for the free surface particles tracing, we combine it with the neighbor detected method. First, we select out the particles which may be mistreated with high probabilities by using the number density parameter judging method. And then we deal with these particles with the neighbor detected method. By doing this, the new mixed free surface tracing method can reduce the mistreatment problem efficiently. The serious pressure fluctuation is an obvious defect in MPS method, and therefore an area-time average technique is used in this paper to remove the pressure fluctuation with a quite good result. With these improvements, the modified MPS-LES method is applied to simulate liquid sloshing problems with large deforming free surface. Results show that the modified MPS-LES method can simulate the large deforming free surface easily. It can not only capture the large impact pressure accurately on rolling tank wall but also can generate all physical phenomena successfully. The good agreement between numerical and experimental results proves that the modified MPS-LES method is a good CFD methodology in free surface flow simulations. 相似文献
18.
The blade frequency noise of non-cavitation propeller in a uniform flow is analyzed in time domain. The unsteady loading (dipole source) on the blade surface is calculated by a potential-based surface panel method. Then the time- dependent pressure data is used as the input for Ffowcs Williams-Hawkings formulation to predict the acoustics pressure. The integration of noise source is performed over the true blade surface rather than the nothickness blade surface, and the effect of hub can be considered. The noise characteristics of the non-cavitation propeller and the numerical discretization forms are discussed. 相似文献
19.
Using the recently developed expansion formulae for wave structure interaction problems, the scattering of surface water waves by a semi-infinite floating membrane due to abrupt change in bottom topography is analyzed. Both the cases of finite and infinite steps are analyzed. In the present paper, the analysis is based on the linearized theory of water waves and small amplitude membrane response. Combining the linearized kinematic and dynamic surface conditions on the water surface with the dynamic pressure condition on the membrane, a third order differential equation is derived to describe the membrane covered free surface condition. General wave energy relation for wave scattering by floating horizontal membrane is derived by the application of law of conservation of energy flux and alternately by the direct application of Green's second identity. In the floating membrane covered region, the wave energy density is a combination of the kinetic and potential energy density due to the surface gravity waves, and the surface energy density which is due to the existence of the floating membrane on the free surface. Gravity wave transformations due to an abrupt change in bottom topography in the presence of a floating membrane in finite water depth are analyzed based on shallow water approximation. Numerical results are computed and analyzed to understand the wave transformation due to the floating membrane when there is an abrupt change in topography in different cases. 相似文献
20.
210Pb测年法的数据处理问题 总被引：3，自引：0，他引：3
~(210)Pb是天然放射性铀系的一个子体成员,半衰期为22.3年,可用来测定冰川、积雪、湖泊及海洋沉积物的年龄和堆积速率。由于化学分析和物理测量方法的日臻成熟,它已成为最可靠的近百年左右的测年法。这对于沿海海洋工程的建设、海洋开发、海洋地质学和海洋生物 相似文献