共查询到10条相似文献，搜索用时 156 毫秒
1.
The TiO2--Mn--TiO2 multilayers are successfully grown on glass and silicon substrates by alternately using radio frequency reactive magnetron sputtering and direct current magnetron sputtering. The structures and the magnetic behaviours of these films are characterised with x-ray diffraction, transmission electron microscope (TEM), vibrating sample magnetometer, and superconducting quantum interference device (SQUID). It is shown that the multi-film consists of a mixture of anatase and rutile TiO2 with an embedded Mn nano-film. It is found that there are two turning points from ferromagnetic phase to antiferromagnetic phase. One is at 42 K attributed to interface coupling between ferromagnetic Mn3O4 and antiferromagnetic Mn2O3, and the other is at 97 K owing to the interface coupling between ferromagnetic Mn and antiferromagnetic MnO. The samples are shown to have ferromagnetic behaviours at room temperature from hysteresis in the M--H loops, and their ferromagnetism is found to vary with the thickness of Mn nano-film. Moreover, the Mn nano-film has a critical thickness of about 18.5 nm, which makes the coercivity of the multi-film reach a maximum of about 3.965times 10 - 2 T. 相似文献
2.
This paper reports that stoichiometric, amorphous, and uniform Er2O3 films are deposited on Si(001) substrates by a radio frequency magnetron sputtering technique. Ellipsometry measurements show that the refractive index of the Er2O3 films is very close to that of a single layer antireflection coating for a solar cell with an air surrounding medium during its working wavelength. For the 90-nm-thick film, the reflectance has a minimum lower than 3% at the wavelength of 600 nm and the weighted average reflectances (400--1000 nm) is 11.6%. The obtained characteristics indicate that Er2O3 films could be a promising candidate for antireflection coatings in solar cells. 相似文献
3.
4.
用水热合成法在掺氟氧化锡(SnO2: F, FTO)导电玻璃上合成了ZnO 纳米线并用原子力显微镜(AFM)和扫描电镜(SEM)对其进行了表征。利用LB 膜技术将高等植物菠菜(Spinacia oleracea)和海洋绿藻石莼(Ulva lactuca)的类囊体膜分别固定在纳米ZnO 上组装成光电池, 用太阳能测试系统检测比较了其光电性质。研究表明, 由两种植物的类囊体膜LB 膜组成的光电池都能产生光生电流; 蛋白LB 膜的层数显著影响了光电池的光电转化效率, 随着层数的增加, 光电转化效率大大增加。此外, 石莼类囊体膜组装的光电池光电转化效率明显高于菠菜类囊体膜。 相似文献
5.
6.
利用等离子体增强化学气相沉积技术,在高氢稀释条件下,研究不同激发频率对纳米晶硅薄膜生长特性的影响.剖面透射电子显微镜(TEM)分析结果显示,不同激发频率下制备的纳米晶硅薄膜晶化区均呈锥状结构生长,但13.56 MHz激发频率下制备的纳米晶硅薄膜最初生长阶段存在非晶态孵化层,即纳米晶硅薄膜的形成经历了由非晶态孵化层到晶态结构层的转变.而高激发频率(40.68 MHz)下硅纳米晶则能直接在非晶态衬底上生长形成.Raman谱和红外吸收谱测量结果表明高激发频率(40.68 MHz)下制备的纳米晶硅薄膜不但具有较高 相似文献
7.
掺铝氧化锌厚膜制备及其对三甲胺和海产品鲜度的敏感性 总被引：2，自引：0，他引：2
用烧结法制备掺铝氧化锌厚膜，把氧化锌粉末分别同０％，１％，３％，５％的Ａｌ２Ｏ３粉末机械研磨混合均匀，在１１００℃下烧３ｈ，再同粘合剂，有机溶剂混合制成浆料，用刮刀法在氧化铝基片上浆料制成膜，在１００℃下烘干后再经１１００℃烧结２ｈ。膜的灵敏度的测量方法是将膜放在玻璃管内加热到测量温度，测量膜暴露在一定浓度ＴＭＡ气体或由牡蛎放出的气体时电阻值的变化。测量温度为２００，２５０，３００℃和４００℃，Ｔ 相似文献
8.
This paper investigates the high frequency behaviours and magnetic anisotropy of rapidly solidified FINEMET (Fe73.5Si13.5B9Nb3Cu1) alloy ribbons annealed in an applied magnetic field. It finds that the ribbons annealed with the applied magnetic field show much higher resonance frequencies and have even higher permeability at higher frequencies than the samples annealed without the magnetic field and the non-annealed ribbons. M?ssbauer spectroscopy had been employed to study the spatial distribution of the magnetic moments of five selected FINEMET alloy ribbons in different heat-treated conditions. The results show that an easy plane has been established after annealling in the magnetic field, while for the other ribbons this effect is not significant. Hence, the relationship between magnetic field annealing and high frequency property has been bridged by the bianisotropic theory. 相似文献
9.
10.
The mechanism of lithium intercalation/deintercalation for phase Al0.8Ni3Sn0.2 as anode material used in lithium ion battery was studied carefully based on the first-principle plane wave pseudo-potential method. The calculated results indicated that Sn--Ni--Al alloy had high theoretical capacity when used as anode material, however, there was high initial irreversible capacity loss because of the large volume expansion. Therefore the technological parameters during preparing the Sn-Ni-Al anode should be controlled strictly to make the content of Al0.8Ni3Sn0.2 phase as low as possible and to make the anode consist of promising Sn--Ni and Al--Ni phases. For comparison, an experiment based on magnetron sputtering was done. The result showed that the calculation is in good agreement with the experiment. We found that the first-principle investigation method is of far-reaching significance in synthesising new commercial anode materials with high capacity and good cycle performance. 相似文献