共查询到19条相似文献，搜索用时 109 毫秒
1.
淹没矩形防波堤透反射系数特性研究 总被引：2，自引：1，他引：2
采用解析方法研究了斜向入射波作用下淹没矩形防波堤的透反射系数特性.首先利用特征函数展开法导出了绕射势函数的分析解和透反射系数的计算公式,然后利用边界元方法验证了解析解,在此基础上利用解析解分析了若干工况下的防波堤透反射特性.计算结果表明,淹没矩形防波堤截面的宽度、高度和相对位置以及入射角的改变都不同程度影响反射系数和透射系数.在中等深度条件下,对于一定频率的波浪,位置和尺寸适当的淹没矩形堤可以反射大部分斜向入射波.研究结果对设计淹没的矩形防波堤具有重要的参考价值. 相似文献
2.
3.
4.
为研究恒定均匀流对直立潜堤波浪反射系数的影响,采用了高阶边界元方法和混合欧拉-拉格朗日时间步进方法更新瞬时自由水面,运用基于二次形状函数的网格重分方案结合四阶龙格库塔方法更新时间积分,并运用两点法得到淹没潜体前的反射系数。将数值模拟得到的波面数据与物理模型试验结果进行对比,两者吻合良好。通过数值模拟研究给出了入射波周期、水流流速、潜堤相对宽度和相对淹没深度对反射系数的影响。结果表明,水流流速和潜堤相对淹没深度对反射系数影响较大,潜堤相对宽度的影响相对较小;水流的存在会使入射波周期等参数对反射系数的影响程度发生改变,在实际工程设计时应考虑水流对潜堤防浪效果的影响。 相似文献
5.
6.
多消浪室局部开孔沉箱防波堤反射特性的迭代解析研究 总被引：1，自引：0，他引：1
基于势流理论，对多消浪室局部开孔沉箱防波堤的反射特性进行解析研究。研究中采用开孔墙处的二次压力损失边界条件，可以直接考虑波高对于开孔墙处能量损失的影响。利用匹配特征函数展开法和迭代方法得到当前问题的解析解。收敛性验证表明，迭代计算和级数解均具有良好的收敛性。该解析解的计算结果与分区边界元的数值计算结果一致，并且与已有的试验结果符合良好。通过算例分析，研究开孔沉箱防波堤反射系数的主要影响因素。结果表明：与单消浪室开孔沉箱防波堤相比，多消浪室开孔沉箱防波堤可以在更宽的波浪频率范围内保持低反射；增大开孔墙的开孔率，有利于降低多消浪室开孔沉箱防波堤的反射系数；当开孔墙的开孔率沿着入射波方向依次递减时，多消浪室开孔沉箱防波堤的反射系数较小。本文所建立的解析模型简单可靠，可用于工程初步设计中分析开孔沉箱防波堤的水动力性能。 相似文献
7.
针对声学覆盖层脱落问题,首先以均匀分层介质理论建立覆盖层脱落模型,在垂直入射和斜入射条下,将解析解与数值计算结果进行相互验证,并计算脱落介质和脱落层厚度以及入射角度对复合结构反射和透射性能的影响。计算结果表明：脱落层介质对结构的透声性能影响较大,脱落层为空气时频响曲线变化显著,透射系数趋于 0。就反射系数而言,不同入射角度下,脱落后反射系数有所增大;水层较空气层而言对入射角度的变化敏感。 相似文献
8.
双消浪室局部开孔沉箱防波堤具有低反射、结构受力小、适宜较大水深和工程造价低等优点。为明确双消浪室局部开孔沉箱水动力特性的主要影响因素,采用理论分析和物理模型试验相结合的方法,对规则波和不规则波作用下双消浪室局部开孔沉箱防波堤的反射特性进行研究。基于势流理论,建立规则波和不规则波对局部开孔沉箱防波堤作用的三维解析解,采用二次压力损失边界条件考虑沉箱开孔墙对波浪运动的影响,利用周期性边界条件考虑防波堤结构沿长度方向的周期性变化。开展相应规则波和不规则波物理模型试验,验证理论模型的合理性。通过算例分析,研究不同波浪要素和结构参数对防波堤反射特性的影响。研究表明:双消浪室局部开孔沉箱相对消浪室宽度取值为0.08~0.20,沉箱前墙开孔率大于后墙开孔率时,防波堤在较大波浪频率范围内消波效果显著;当前后墙的开孔率相等时,防波堤反射系数的最小值随着开孔率增大而减小。 相似文献
9.
10.
11.
An analytic method is used to study the reflection and transmission coefficients of the double submerged rectangular blocks (DSRBs) in oblique waves. The scattering potentials are obtained by means of the eigenfunction expansion method, and expressions for the reflection and transmission coefficients are determined. The boundary element method is employed to verify the correctness of the present analytical method. The DSRBs have better performance than the single submerged rectangular block (SSRB) in certain cases. The reflection and transmission properties of the DSRBs are investigated for some specific cases, and the influences of the geometric parameters are also presented. 相似文献
12.
On the radiation and diffraction of linear water waves by an infinitely long rectangular structure submerged in oblique seas 总被引：1，自引：0，他引：1
The radiation and diffraction of linear water waves by an infinitely long rectangular structure submerged in oblique seas of finite depth is investigated. The analytical expressions for the radiated and diffracted potentials are derived as infinite series by use of the method of separation of variables. The unknown coefficients in the series are determined by the eigenfunction expansion matching method. The expressions for wave forces, hydrodynamic coefficients and reflection and transmission coefficients are given and verified by the boundary element method. Using the present analytical solution, the hydrodynamic influences of the angle of incidence, the submergence, the width and the thickness of the structure on the wave forces, hydrodynamic coefficients, and reflection and transmission coefficients are discussed in detail. 相似文献
13.
Transmissions of oblique incident wave from a row of rectangular piles are analyzed theoretically. The incident angle of plane wave is taken as , there then is the transmission coefficient (This is a paradox). In this paper, by means of the approximate relation between the transmitted and incident wave angle found from the shape of a slit, the paradoxical phenomenon is removed. On the basis of the continuality of the pressure and flux and the analysis of flow resistance at the row of rectangular piles, formulas of reflection and transmission coefficients are obtained. The transmission and reflection coefficients predicted by the present model quite agree with those of laboratory experiments in previous references 相似文献
14.
Experimental results are reported on the wave reflection from and transmission through one row or two rows of closely spaced rectangular cylinders. An empirical expression is proposed for the friction factor which models the head loss due to closely spaced rectangular cylinders. Algebraic expressions are presented to calculate the reflection and transmission coefficients of regular waves for a single slotted wall or double slotted walls. The model is validated by the published and present experimental results. The proposed method can be used for the preliminary design of slotted-wall breakwaters. 相似文献
15.
A parametric experimental study is conducted to compare the reflection and transmission characteristics of submerged hemi-cylindrical and rectangular rigid and water-filled flexible breakwater models. The results show that, for the rigid breakwaters, rectangular models are more effective than hemi-cylindrical ones in terms of reduction of transmitted waves. As for the flexible breakwaters, the hemi-cylindrical models may give better wave reflection than rectangular ones. However, the energy loss induced by the rectangular breakwaters is much larger and more significant to result in an overall better efficiency in terms of reduction in wave transmission. The effects of internal pressure show that the lowest pressurized flexible models considered in this work are the most effective in the reduction of the transmitted wave height. Higher wave reflection, lower wave transmission and higher energy loss are obtained consistently at the lower submergence depth ratio. 相似文献
16.
Bragg reflection of water waves by multiple floating horizontal flexible membranes is investigated based on the linear wave theory and the assumption of small membrane response. Under the floating horizontal membranes, periodical submerged rectangular bars are arranged on the flat seabed. The total reflection and transmission coefficients are obtained by using the eigenfunction expansion method and the wide spacing approximation. The calculated coefficients are validated with the results available in the literature, which shows that the present method is applicable. The characteristics of Bragg reflection are systematically investigated by changing various parameters including the height of the rectangular bars, the number, the tension, the spacing, and the length of the flexible membranes. The results can help designing multiple floating horizontal flexible membranes as effective floating breakwaters by taking advantage of Bragg reflection. 相似文献
17.
Jie Cui Xin Chen Xiaokang Deng Chunyan Ji Qian Li 《Marine Georesources & Geotechnology》2020,38(3):266-276
AbstractIn this paper, series of experimental studies under regular wave actions to investigate the hydrodynamic performance of the rectangular floating breakwater (FB) affected by reefs with different slopes were carried out in a wave flume. The wave transmission coefficients, motion responses and mooring forces can be calculated on the basis of the data obtained from the experiments. A comparative experiment of the only rectangular FB is also conducted. The experimental results reveal that the rectangular FB with different reefs can make more positive effects on wave energy dissipation than that of the only rectangular FB, especially for short-period waves. The characteristics of three degrees of freedom of the rectangular FB affected by reefs are also observed, which can be used to further explain the variation tendency appeared in transmission coefficients. The roll motion of the FB influenced by reefs is intenser than that of the only FB and the changes of slopes have limited effects on the sway motion of the FB. Furthermore, the heave motion of the only rectangular FB is intenser than that of the FB affected by reefs for short-period waves and vice versa for long-period waves. 相似文献
18.
The present paper extends the impedance analytical method to the study of the interaction of regular plane waves with a row of rectangular piles. The dissipative energy is estimated from the flow resistance for the row of piles. Formulas of wave reflection and transmission coefficients and the wave force for the row of piles are derived. Predictions obtained using the present model agree with experimental data in the literature. 相似文献
19.
The scaled boundary finite element method （SBFEM） is a novel semi-analytical technique combining the advantage of the finite element method （FEM） and the boundary element method （BEM） with its unique properties. In this paper, the SBFEM is used for computing wave passing submerged breakwaters, and the reflection coeffcient and transmission coefficient are given for the case of wave passing by a rectangular submerged breakwater, a rigid submerged barrier breakwater and a trapezium submerged breakwater in a constant water depth. The results are compared with the analytical solution and experimental results. Good agreement is obtained. Through comparison with the results using the dual boundary element method （DBEM）, it is found that the SBFEM can obtain higher accuracy with fewer elements. Many submerged breakwaters with different dimensions are computed by the SBFEM, and the changing character of the reflection coeffcient and the transmission coefficient are given in the current study. 相似文献