首页 | 本学科首页   官方微博 | 高级检索  
相似文献
 共查询到10条相似文献，搜索用时 109 毫秒
1.
Light detection and ranging (LIDAR) is a remote sensing technique that uses light, often using pulses from a laser to measure the distance to a target. Both terrestrial- and airborne-based LIDAR techniques have been frequently used to map landslides. Airborne LIDAR has the advantage of identifying large scarps of landslides covered by tree canopies and is widely applied in identifying historical and current active landslides hidden in forested areas. However, because landslides naturally have relatively small vertical surface deformation in the foot area, it is practically difficult to identify the margins of landslide foot area with the limited spatial resolution (few decimeters) of airborne LIDAR. Alternatively, ground-based LIDAR can achieve resolution of several centimeters and also has the advantages of being portable, repeatable, and less costly. Thus, ground-based LIDAR can be used to identify small deformations in landslide foot areas by differencing repeated terrestrial laser scanning surveys. This study demonstrates a method of identifying the superficial boundaries as well as the bottom boundary (sliding plane) of an active landslide in National Rainforest Park, Puerto Rico, USA, using the combination of ground-based and airborne LIDAR data. The method of combining terrestrial and airborne LIDAR data can be used to study landslides in other regions. This study also indicates that intensity and density of laser point clouds are remarkably useful in identifying superficial boundaries of landslides.  相似文献   

2.
High-resolution digital elevation models (HRDEMs) on coastal areas, particularly cliffs, are an important asset for analyzing and quantifying the processes affecting their morphology. The Vaches-Noires coastal cliffs, located at the north-western part of the Pays-d’Auge region (Normandy, France), are an ideal site for the study of subaerial and marine erosion processes. Indeed, the coastline evolves through the accumulation of deposits resulting from rotational landslides and/or mudflows at the base of the cliff which are then undermined by the sea. The 3D modeling of a representative sector of the cliffs appears a suitable solution to monitor and quantify this evolution using HRDEMs. This paper presents the whole of a monitoring protocol, with high spatial resolution and high temporal resolution, on an original location characterized by reliefs of Badlands in coastal environments. The first results of these investigations are described with an evaluation of two methods for the creation of 3D models: a “heavy” method by Terrestrial Laser Scanning (TLS) monitoring, and a “light” method using “Structure from Motion” (SfM) terrestrial photogrammetry. The small investment of time in the field and money is an important asset of the SfM method. The textured rendering quality of the SfM model makes it a powerful tool for geomorphological analysis. According to a recurrent monitoring protocol involving both measurements, it was possible to compare the accuracy of the SfM and TLS models. The results show a high accuracy of the SfM models with an overall average error of 0.05 m. The representations of the zones of accumulation and erosion as well as their spatial succession allow to investigate the dynamics of the involved processes with both methods. Preliminary volume calculation results are conclusive for TLS models.  相似文献   

3.
《Engineering Geology》2007,89(1-2):67-87
Light detection and ranging (LIDAR) data were used to visually map landslides, headscarps, and denuded slopes in Seattle, Washington. Four times more landslides were mapped than by previous efforts that used aerial photographs. The mapped landforms (landslides, headscarps, and denuded slopes) were created by many individual landslides. The spatial distribution of mapped landforms and 1308 historical landslides show that historical landslide activity has been concentrated on the mapped landforms, and that most of the landslide activity that created the landforms was prehistoric. Thus, the spatial densities of historical landslides on the landforms provide approximations of the landforms' relative susceptibilities to future landsliding. Historical landslide characteristics appear to be closely related to landform type so relative susceptibilities were determined for landslides with various characteristics. No strong relations were identified between stratigraphy and landslide occurrence; however, landslide characteristics and slope morphology appear to be related to stratigraphic conditions.Human activity is responsible for causing about 80% of historical Seattle landslides. The distribution of mapped landforms and human-caused landslides suggests the probable characteristics of future human-caused landslides on each of the landforms. The distribution of mapped landforms and historical landslides suggests that erosion of slope-toes by surface water has been a necessary condition for causing Seattle landslides. Human activity has largely arrested this erosion, which implies that landslide activity will decrease with time as hillsides naturally stabilize. However, evaluation of glacial-age analogs of areas of recent slope-toe erosion suggests that landslide activity in Seattle will continue for the foreseeable future.  相似文献   

4.
Landslides are serious geohazards that occur under a variety of climatic conditions and can cause many casualties and significant economic losses. Centrifuge modelling, as a representative type of physical modelling, provides a realistic simulation of the stress level in a small-scale model and has been applied over the last 50 years to develop a better understanding of landslides. With recent developments in this technology, the application of centrifuge modelling in landslide science has significantly increased. Here, we present an overview of physical models that can capture landslide processes during centrifuge modelling. This review focuses on (i) the experimental principles and considerations, (ii) landslide models subjected to various triggering factors, including centrifugal acceleration, rainfall, earthquakes, water level changes, thawing permafrost, excavation, external loading and miscellaneous conditions, and (iii) different methods for mitigating landslides modelled in centrifuge, such as the application of nails, piles, geotextiles, vegetation, etc. The behaviors of all the centrifuge models are discussed, with emphasis on the deformation and failure mechanisms and experimental techniques. Based on this review, we provide a best-practice methodology for preparing a centrifuge landslide test and propose further efforts in terms of the seven aspects of model materials, testing design and equipment, measurement methods, scaling laws, full-scale test applications, landslide early warning, and 3D modelling to better understand the complex behaviour of landslides.  相似文献   

5.
Very intensive rainfall in August 2005 (>300 mm/3 days) triggered moderately deep (2–10 m) landslides of about 50'000 m3 volume each in two mountain torrent catchments above the village of Brienz (Berner Oberland, Switzerland). These landslides – originating in Trachtbach and Glyssibach catchments – transformed into extremely rapid (>5 m/s) debris flows, which caused significant damage in inhabited areas; two persons lost their lives and about twenty-five families became homeless. The Brienz case was the most damaging one among many landslide disasters occurring during those rainy days in the Swiss Alps. In this paper we study in detail the predisposition and causes of the 2005 landslides in the Brienz area, based on field mapping, analysis of high resolution images and digital terrain models, derived from LIDAR and infrared measurements taken before and after the event. The features of these landslides are compared with past and dormant landslides in the mid-slope portion of the mountain chain north of Brienz, which has been the source of many catastrophic mass wasting events during the last centuries. Detailed field mapping shows that highly weathered series of strongly overconsolidated Mesozoic marls (Diphyoides Limestone & Vitznau Marls of Valanginian age) and their residual soils form the primary source for the sliding materials. The rupture surfaces of the moderately deep landslides often run at the transition from saprolite to weathered bedrock, with a dip angle of about 40o in the landslide depletion area. These landslides transform into debris flows, where debris slides into strongly convergent hillslopes or directly into headwater channels.  相似文献   

6.
This study compares the performance of transient rainfall infiltration and grid-based regional slope stability (TRIGRS) model and time-variant slope stability (TiVaSS) model in the prediction of rainfall-induced shallow landslides. TRIGRS employs one-dimensional (1-D) subsurface flow to simulate the infiltration rate, whereas a three-dimensional (3-D) model is utilized in TiVaSS. The former has been widely used in landslide modeling, while the latter was developed only recently. Both programs are used for the spatiotemporal prediction of shallow landslides caused by rainfall. This study uses the July 2011 landslide event that occurred in Mt. Umyeon, Seoul, Korea, for validation. The performance of the two programs is evaluated by comparison with data of the actual landslides in both location and timing by using a landslide ratio for each factor of safety class (\({\text{LR}}_{\text{class}}\) index), which was developed for addressing point-like landslide locations. Moreover, the influence of surface flow on landslide initiation is assessed. The results show that the shallow landslides predicted by the two models are highly consistent with those of the observed sliding sites, although the performance of TiVaSS is slightly better. Overland flow affects the buildup of the pressure head and reduces the slope stability, although this influence was not significant in this case. A slight increase in the predicted unstable area from 19.30 to 19.93% was recorded when the overland flow was considered. It is concluded that both models are suitable for application in the study area. However, although it is a well-established model requiring less input data and shorter run times, TRIGRS produces less accurate results.  相似文献   

7.
This paper explores the use of adaptive support vector machines, random forests and AdaBoost for landslide susceptibility mapping in three separated regions of Canton Vaud, Switzerland, based on a set of geological, hydrological and morphological features. The feature selection properties of the three algorithms are studied to analyze the relevance of features in controlling the spatial distribution of landslides. The elimination of irrelevant features gives simpler, lower dimensional models while keeping the classification performance high. An object-based sampling procedure is considered to reduce the spatial autocorrelation of data and to estimate more reliably generalization skills when applying the model to predict the occurrence of new unknown landslides. The accuracy of the models, the relevance of features and the quality of landslide susceptibility maps were found to be high in the regions characterized by shallow landslides and low in the ones with deep-seated landslides. Despite providing similar skill, random forests and AdaBoost were found to be more efficient in performing feature selection than adaptive support vector machines. The results of this study reveal the strengths of the classification algorithms, but evidence: (1) the need for relying on more than one method for the identification of relevant variables; (2) the weakness of the adaptive scaling algorithm when used with landslide data; and (3) the lack of additional features which characterize the spatial distribution of deep-seated landslides.  相似文献   

8.
开发为地质灾害预测预报所需用的岩土层含水量和渗透力测试仪,并和气候雨量、地质灾害成灾规律联系起来,是我国地质灾害监测预报发展的趋势。岩土层含水量分层监测系统是采用TDR（Time Domain Refiectometry）技术原理、方法研制的仪器,通过波导棒探针发射的电磁波射入岩土层,测量电磁波脉冲从波导棒的起点传播到接收末端的反射电压值,此反射电压值与岩土体本身含水量介电常数有函数关系,经过计算转换为测点岩土体积含水量,实时测量和采集地质灾害岩土层含水量和渗透力参数。介绍了该监测系统的基本原理、主要技术参数、监测工艺技术方法以及现场应用情况。  相似文献   

9.
 Hydrological landslide-triggering thresholds separate combinations of daily and antecedent rainfall or of rainfall intensity and duration that triggered landslides from those that failed to trigger landslides. They are required for the development of landslide early warning systems. When a large data set on rainfall and landslide occurrence is available, hydrological triggering thresholds are determined in a statistical way. When the data on landslide occurrence is limited, deterministic models have to be used. For shallow landslides directly triggered by percolating rainfall, triggering thresholds can be established by means of one-dimensional hydrological models linked to the infinite slope model. In the case of relatively deep landslides located in topographic hollows and triggered by a slow accumulation of water at the soil-bedrock contact, simple correlations between landslide occurrence and rainfall can no longer be established. Therefore real-time failure probabilities have to be determined using hydrological catchment models in combination with the infinite slope model. Received: 15 October 1997 · Accepted: 25 June 1997  相似文献   

10.
The hillslopes of the Serra do Mar, a system of escarpments and mountains that extend more than 1500 km along the southern and southeastern Brazilian coast, are regularly affected by heavy rainfall that generates widespread mass movements, causing large numbers of casualties and economic losses. This paper evaluates the efficiency of susceptibility mapping for shallow translational landslides in one basin in the Serra do Mar, using the physically based landslide susceptibility models SHALSTAB and TRIGRS. Two groups of scenarios were simulated using different geotechnical and hydrological soil parameters, and for each group of scenarios (A and B), three subgroups were created using soil thickness values of 1, 2, and 3 m. Simulation results were compared to the locations of 356 landslide scars from the 1985 event. The susceptibility maps for scenarios A1, A2, and A3 were similar between the models regarding the spatial distribution of susceptibility classes. Changes in soil cohesion and specific weight parameters caused changes in the area of predicted instability in the B scenarios. Both models were effective in predicting areas susceptible to shallow landslides through comparison of areas predicted to be unstable and locations of mapped landslides. Such models can be used to reduce costs or to define potentially unstable areas in regions like the Serra do Mar where field data are costly and difficult to obtain.  相似文献   

设为首页 | 免责声明 | 关于勤云 | 加入收藏

Copyright©北京勤云科技发展有限公司  京ICP备09084417号