Aerosol mass loading over the marine environment of Arabian Sea during ICARB: Sea-salt and non-sea-salt components     

Susan K. George  Prabha R. Nair 《Journal of Earth System Science》2008,117(1):333-344

Mass loading and chemical composition of atmospheric aerosols over the Arabian Sea during the pre-monsoon months of April and May have been studied as a part of the Integrated Campaign for Aerosols, gases and Radiation Budget (ICARB). These investigations show large spatial variabilities in total aerosol mass loading as well as that of individual chemical species. The mass loading is found to vary between 3.5 and 69.2 μg m^?3, with higher loadings near the eastern and northern parts of Arabian Sea, which decreases steadily to reach its minimum value in the mid Arabian Sea. The decrease in mass loading from the coast of India towards west is estimated to have a linear gradient of 1.53 μg m^?3/° longitude and an e^?1 scale distance of ～2300 km. SO ₄ ^2? , Cl^? and Na⁺ are found to be the major ionic species present. Apart from these, other dominating watersoluble components of aerosols are NO ₃ ^? (17%) and Ca²⁺ (6%). Over the marine environment of Arabian Sea, the non-sea-salt component dominates accounting to ～76% of the total aerosol mass. The spatial variations of the various ions are examined in the light of prevailing meteorological conditions and airmass back trajectories.  相似文献   

A technical note on seismic microzonation in the central United States     

Zhenming Wang 《Journal of Earth System Science》2008,117(2):749

Microzonation is an effort to evaluate and map potential hazards found in an area, urban area in particular, that could be induced by strong ground shaking during an earthquake. These hazards include: ground motion amplification, liquefaction, and slope failure. The microzonation maps, depicting ground-motion amplification, liquefaction, and landslide potentials, can be produced if the ground motion on bedrock (input) and the site conditions are known. These maps, in combination with ground-motion hazard maps (on bedrock), can be used to develop a variety of hazard mitigation strategies such as seismic risk assessment, emergency response and preparedness, and land-use planning. However, these maps have certain limitations that result from the nature of regional mapping, data limitations, generalization, and computer modeling. These microzonations show that when strong ground shaking occurs, damage is more likely to occur, or be more severe, in the higher hazard areas. The zones shown on the hazard maps should not serve as a substitute for site-specific evaluations.  相似文献   

Preliminary results for a semi-automated quantification of site effects using geomorphometry and ASTER satellite data for Mozambique,Pakistan and Turkey     

Alan Yong  Susan E. Hough  Michael J. Abrams  Christopher J. Wills 《Journal of Earth System Science》2008,117(2):797

Estimation of the degree of local seismic wave amplification (site effects) requires precise information about the local site conditions. In many regions of the world, local geologic information is either sparse or is not readily available. Because of this, seismic hazard maps for countries such as Mozambique, Pakistan and Turkey are developed without consideration of site factors and, therefore, do not provide a complete assessment of future hazards. Where local geologic information is available, details on the traditional maps often lack the precision (better than 1:10,000 scale) or the level of information required for modern seismic microzonation requirements. We use high-resolution (1:50,000) satellite imagery and newly developed image analysis methods to begin addressing this problem. Our imagery, consisting of optical data and digital elevation models (DEMs), is recorded from the ASTER (Advanced Spaceborne Thermal Emission and Reflection Radiometer) sensor system. We apply a semi-automated, object-oriented, multi-resolution feature segmentation method to identify and extract local terrain features. Then we classify the terrain types into mountain, piedmont and basin units using geomorphometry (topographic slope) as our parameter. Next, on the basis of the site classification schemes from the Wills and Silva (1998) study and the Wills et al (2000) and Wills and Clahan (2006) maps of California, we assign the local terrain units with V _s 30 (the average seismic shear-wave velocity through the upper 30m of the subsurface) ranges for selected regions in Mozambique, Pakistan and Turkey. We find that the applicability of our site class assignments in each region is a good first-approximation for quantifying local site conditions and that additional work, such as the verification of the terrain’s compositional rigidity, is needed.  相似文献   

Evaluation of coal bed methane potential of coal seams of Sawang Colliery,Jharkhand, India     

Anil M. Pophare  Vinod A. Mendhe  A. Varade 《Journal of Earth System Science》2008,117(2):121-132

The coal seams of Sawang Colliery, East Bokaro Coalfields are bituminous to sub-bituminous in nature and categorized as high gaseous seams (degree II to degree III level). These seams have the potential for coal bed methane (CBM) and their maturity increases with increasing depth, as a result of enhanced pressure-temperature conditions in the underground. The vitrinite maceral group composition of the investigated coal seams ranges from 62.50–83.15%, whereas the inertinite content varies from 14.93–36.81%. The liptinite content varies from 0.66% to 3.09%. The maximum micro-pores are confined within the vitrinite group of macerals. The coal seams exhibit vitrinite reflectance values (Ro% calculated) from 0.94% (sample CG-97) to 1.21% (sample CG-119). Proximate analyses of the investigated coal samples reveal that the moisture content (M%) ranges from 1.28% to 2.98%, whereas, volatile matter (VM%) content is placed in the range of 27.01% to 33.86%. The ash content (A%) ranges from 10.92% to 30.01%. Fixed carbon (FC%) content varies from 41.53% to 55.93%. Fuel ratio variation shows a restricted range from 1.53 to 1.97. All the coal samples were found to be strongly caking and forming coke buttons. The present study is based on the adsorption isotherm experiments carried out under controlled P-T conditions for determination of actual gas adsorption capacity of the coal seams. This analysis shows that the maximum methane gas adsorbed in the coal sample CG-81 is 17 m³/t (Std. daf), at maximum pressure of 5.92 MPa and experimental temperature of 30°C. The calculated Langmuir regression parameters P_L and V_L range from 2.49 to 3.75 MPa and 22.94 to 26.88 m³/t (Std. daf), respectively.  相似文献   

Comments on ‘A comparative study of ANN and neuro-fuzzy for the prediction of dynamic constant of rockmass’     

Tarkan Erdik  Zekai Şen 《Journal of Earth System Science》2008,117(6):973-974

Singh et al (2005) examined the potential of the ANN and neuro-fuzzy systems application for the prediction of dynamic constant of rockmass. However, the model proposed by them has some drawbacks according to fuzzy logic principles. This discussion will focus on the main fuzzy logic principles which authors and potential readers should take into consideration.  相似文献   

Proposed seismic hazard maps of Sumatra and Java islands and microzonation study of Jakarta city,Indonesia     

Masyhur Irsyam  Donny T. Dangkua  Hendriyawan  Drajat Hoedajanto  Bigman M. Hutapea  Engkon K. Kertapati  Teddy Boen  Mark D. Petersen 《Journal of Earth System Science》2008,117(2):865-878

This paper presents the development of spectral hazard maps for Sumatra and Java islands, Indonesia and microzonation study for Jakarta city. The purpose of this study is to propose a revision of the seismic hazard map in Indonesian Seismic Code SNI 03-1726-2002. Some improvements in seismic hazard analysis were implemented in the analysis by considering the recent seismic activities around Java and Sumatra. The seismic hazard analysis was carried out using 3-dimension (3-D) seismic source models (fault source model) using the latest research works regarding the tectonic setting of Sumatra and Java. Two hazard levels were analysed for representing 10% and 2% probability of exceedance (PE) in 50 years ground motions for Sumatra and Java. Peak ground acceleration contour maps for those two hazard levels and two additional macrozonation maps for 10% PE in 50 years were produced during this research. These two additional maps represent short period (0.2 s) and long-period (1.0 s) spectra values at the bedrock. Microzonation study is performed in order to obtain ground motion parameters such as acceleration, amplification factor and response spectra at the surface of Jakarta. The analyses were carried out using nonlinear approach. The results were used to develop contour of acceleration at the surface of Jakarta. Finally, the design response spectra for structural design purposes are proposed in this study.  相似文献   

高能偏振能量色散X射线荧光光谱仪应用现状和进展   总被引：4，自引：2，他引：2  

吉昂  李国会  张华 《岩矿测试》2008,27(6):451-462

对高能偏振能量色散X射线荧光光谱仪基本特点及其用于环境、生物、地质样品中痕量元素的分析和RoSH检测等领域的应用现状予以介绍,并对二次靶与滤光片在痕量元素分析中的应用作了探讨。  相似文献   

火试金法测定铜精矿中金含量结果的不确定度评定   总被引：2，自引：0，他引：2  

江水英  肖化云  吴声东  吴波  秦云和 《岩矿测试》2008,27(4):299-301

对火试金法测定铜精矿中金含量的结果进行不确定度评定。分析了铜精矿样品称量、铜精矿样品的不均匀性和配料处理,以及金粒称量等因素对金含量测量结果不确定度的影响,并得出火试金法测量铜精矿中金含量的扩展不确定度。  相似文献   

印度共和国主要矿产资源及其地质特征   总被引：2，自引：0，他引：2  

张建华吴良士 《矿床地质》2008,27(4):541-542

印度共和国是南亚地区矿产资源比较丰富的国家,铁矿探明储量175.7亿吨;铝土矿探明储量26.54亿吨;锰矿探明储量1.35亿吨;铬铁矿储量5900万吨;重晶石储量3000万吨。目前,全印度已开发了89种矿产资源,其中有52种非金属矿产,11种金属矿产,22种稀有金属矿产,4种能源矿产。全国生产矿  相似文献   

Impact of land use covers upon karst processes in a typical Fengcong depression system of Nongla, Guangxi, China   总被引：2，自引：0，他引：2  

Cheng Zhang  Jianguo Pei  Yunqiu Xie  Jianhua Cao  Lanling Wang 《Environmental Geology》2008,55(8):1621-1626

The direction and intensity of karst processes can be deeply affected by soil physical and chemical variations which were resulted from land use. Taking Nongla Fengcong depression area, Mashan County, Guangxi as an example, authors discussed the impact of land use on karst processes based on the data of field limestone tablet. The results showed that the corrosional rates at varied soil depth are quite different. Corrosional rate in woodland and orchard is mostly bigger than 20 mg/a, which is much higher than that in tilled land and shrub. Generally, corrosional rate decreased from orchard, woodland, tilled land, fallow land and shrub successively, in which soil organic matter (OM) and soil pH are two major controlling factors: corrosion process is controlled remarkably by soil OM in woodland and orchard. The higher the organic matter content is and the less the pH value is, the higher the corrosional rate is. Owing to lower organic matter content, the corrosional rate is mainly affected by soil CO₂ in tilled land and shrub.  相似文献