Static Spheroidal Deformation of Degree 1 - Consistency Relation, Stress Solution and Partials     

Shuhei Okubo  Takeshi Endo 《Geophysical Journal International》1986,86(1):91-102

This paper treats the static spheroidal deformation of degree 1 in detail. We give a physical interpretation of the consistency relation imposed on it. the relation serves as a guiding principle to find out all of its members. Following Okubo & Saito, we derive the partial derivatives of the degree 1 Love numbers with respect to density, bulk modulus and rigidity.  相似文献   

月际地震趋势的数值预测法   总被引：3，自引：0，他引：3       下载免费PDF全文

黎令仪  刘德富  康春丽  韩延本 《地震学报》2004,26(5):529-532

考虑到目前地震月趋势以模糊用语进行预测的缺陷,本文提出采用数值预测法能更好地适应社会需求. 这种方法是基于地震有自律现象,通过建立非线性的数学模型予以实现的. 模型试验结果表明,我国大陆地震活动存在有7~8个月左右的循环结构,逐月比较预测与实况的震级误差平均低于0.2级,因而该方法比经验性预报更适宜社会的实际利用.   相似文献   

黄山大气气溶胶微观特性的观测研究          下载免费PDF全文

银燕  陈晨  陈魁  安俊琳  王巍巍  林振毅  严家德  王静   《大气科学学报》2010,33(2):129-136

根据2008年4—7月黄山大气气溶胶观测资料,研究了气溶胶粒子的数浓度、谱分布特征及其与气象因子的关系,探讨了雾天和非雾天气溶胶颗粒物时间和尺度分布特点。分析发现,黄山光明顶春、夏季大气气溶胶数浓度的平均值分别为3.14×103个/cm3和1.80×103个/cm3,其中超细粒子(粒径小于0.1μm的粒子)在春夏季分别约占总粒子数浓度的79%和68%;高数浓度值集中在粒径0.04～0.12μm;积聚模态气溶胶粒子(0.1～1.0μm)在体积浓度分布和表面积分布中占很大比例。结合气象资料比较了雾天与非雾天气溶胶分布的差异,发现细粒子浓度非雾天大于雾天,而气溶胶数浓度与温度呈正相关,与相对湿度成反相关。结果还发现,黄山在春季以西北风和偏南风为主,西北风时气溶胶数浓度较高,在夏季主要以偏南风,特别是西南风为主,但是气溶胶数浓度的高值多发生在偏东风的条件下。  相似文献   

南京北郊冬季大气SO_2、NO_2和O_3的变化特征   总被引：4，自引：0，他引：4       下载免费PDF全文

张敏  朱彬  王东东  周毓荃   《大气科学学报》2009,32(5):695-702

利用差分吸收光谱仪DOAS(differential optical absorption spectroscopy),对2007年11月—2008年1月南京北郊大气SO2、NO2和O3进行了观测。结合Parsivel降水粒子谱仪和自动气象站的资料,对冬季大气污染气体的浓度变化规律及降水和风速风向对其的影响进行了分析。结果表明,南京北郊大气SO2浓度较高,呈明显双峰特征,分别在12时(北京时,下同)和00时达最大,受附近排放源的影响最大,东风及南风时比静风时SO2浓度更高。降水对SO2湿清除效果明显,清除系数平均为0.168 h-1。NO2气体呈明显单峰特征,在18时达最高值。南京北郊是NO2源区之一,主要受附近高速公路汽车尾气排放源的影响。静风时NO2浓度最高。O3浓度受NO2的影响较明显。O3日变化呈单峰特征,在15时达最大值,静风时O3浓度最低。降水对O3的间接影响较明显,在降水时,白天由于太阳辐射较弱,O3浓度降低;夜晚NO浓度较低,使得O3浓度升高。  相似文献   

Preliminary Results from the Magnetic Field Measurements Using MAGDAS at Ilorin, Nigeria     

A. B. Rabiu  I. A. Adimula  K. Yumoto  J. O. Adeniyi  G. Maeda 《Earth, Moon, and Planets》2009,104(1-4):173-179

MAGDAS, the Magnetic Data Acquisition System, was successfully installed at the University of Ilorin, Nigeria—an equatorial station—in August 2006. MAGDAS is an important component of the International Heliophysical Year, IHY. We examined the preliminary results obtained from the analysis of the geomagnetic data obtained from the MAGDAS measurement. Diurnal variations of the solar quiet daily variation in the three geomagnetic elements, H, D, Z were studied. The obtained signatures of the magnetic field variations were discussed in the context of the literature. The day-to-day variability of the horizontal and vertical intensities as well as the declination of the geomagnetic field were examined. The study justified the need for a partner magnetic field observatory along same meridian as Ilorin, north or south of it, to facilitate synthesis of the equatorial electrojet effect.  相似文献   

NOAA卫星沙尘暴光谱特征分析及信息提取研究   总被引：12，自引：5，他引：7  

郭铌  倾继祖 《高原气象》2004,23(5):643-647,i001,i002

通过对2000—2002年多次沙尘暴过程NOAA卫星AVHRR资料的分析,研究了沙尘、云、沙漠、戈壁、积雪、裸地、植被等不同目标物的光谱特性,发现沙尘暴在AVHRR-2中各通道均有不同程度的反映。1,2通道中沙尘的反射率较高(介于云和沙漠之间);4,5通道的亮温低于晴空地表高于云;在3通道中沙尘表现的很独特,其亮度温度为所有研究目标物中最高的,表明通道3包含较多的沙尘信息,AVHRR-3取代AVHRR-2后对监测沙尘有不利影响。在此基础上提出定量提取沙尘信息的两种沙尘判识指数,并利用沙尘判识指数成功地提取多次沙尘暴过程的沙尘信息。结果表明：利用多通道组合沙尘判识指数能够对沙尘信息进行有效提取。  相似文献   

西北地区东部冰雹云的卫星光谱特征和遥感监测模型   总被引：11，自引：0，他引：11  

张杰  张强  康凤琴  何金梅 《高原气象》2004,23(6):743-748

根据气象台站的冰雹观测记录,针对冰雹灾害多发的西北地区东部,选取2001—2004年间14次NOAA卫星过境的AVHRR资料,共88个样本数,对冰雹云和其他云的光谱特征进行对比分析。结果表明,雹云的热红外亮度温度的变化基本在245K以下,中红外波段反射率相对较低,基本变化在0.4及以下范围,可见光和近红外波段反射率>0.6。冰雹产生的两个重要条件是高的云光学厚度和大的云粒子有效半径共同发生的区域;西北地区冰雹发生的云顶高度基本在4.5～7km之间。根据雹云的光谱特征,确定雹暴指数及其模型阈值>0.35的冰雹监测方法,多普勒雷达回波和气象站观测结果说明,雹暴指数等多参数结合判别冰雹云效果显著。  相似文献   

Carbon and Noble Gas Isotopes in the Tengchong Volcanic Geothermal Area, Yunnan, Southwestern China   总被引：1，自引：0，他引：1  

Shun''ichi NAKAI  Hiroshi WAKITA 《《地质学报》英文版》2004,78(5):1122-1135

Carbon and noble gas isotope analyses are reported for bubbling gas samples from the Tengchong volcanic geothermal area near the Indo-Eurasian suture zone. All samples contain a resolvable component of mantle-derived 3He. Occurrence of mantle-derived 3He coincides with surface volcanism. However, 3He occurs over a larger geographic areathan do surface volcanics. δ13C values for CO2 and CH4 vary from -33.4‰ to 1.6 ‰ and from -52.8‰ to -2.8‰, respectively. He and C isotope systematics indicate that CO2 and CH4 in the CO2-rich gases originated predominantly from magmatic component mixed with crustal CO2 produced from carbonate. However, breakdown of organic matter and near-surface processes accounts for the CH4 and CO2 in N2-rich gases. 3He/4He ratio distribution pattern suggests that mantle-derived He and heat sources of high-temperature system in central Tengchong originate from a hidden magma reservoir at subsurface. CO2-rich gases with the highest 3He/4He ratio (5.2 Ra) may be representative of the  相似文献   

滇西兰坪盆地五茂林剖面下白垩统景星组沉积相   总被引：1，自引：0，他引：1       下载免费PDF全文

吴根耀  矢野孝雄  谭明清 《古地理学报》2004,6(3):380-384

实测了云南西部兰坪盆地东部下白垩统下部景星组的五茂林剖面,建立了曲流河、三角洲和湖泊3种沉积序列,其中三角洲序列在云南下白垩统中属首次建立。分析了粗碎屑岩的组成,将该剖面上出露的砾岩分成4类。早白垩世时兰坪盆地属丹那沙林-高黎贡弧的弧后盆地,景星组自下而上为曲流河沉积、三角洲沉积和湖泊沉积,且随湖侵发生,湖泊向西扩大。  相似文献   

A Simple Monte Carlo Method for Locating the Three-dimensional Critical Slip Surface of a Slope   总被引：2，自引：0，他引：2  

XIE Mowen Institute of Environmental Systems  Kyushu University  Hakozaki --  Higashi Ku  Fukuok  Japan College of Resource Engineering  the University of Science  Technology Beijing  Xueyuan Ro  Haidian District  Beijing  China 《《地质学报》英文版》2004,78(6):1258-1266

Based on the assumption of the plain-strain problem, various optimization or random search methods have been developed for locating the critical slip surfaces in slope-stability analysis, but none of such methods is applicable to the 3D case. In this paper, a simple Monte Carlo random simulation method is proposed to identify the 3D critical slip surface. Assuming the initial slip to be the lower part of a slip ellipsoid, the 3D critical slip surface is located by means of a minimized 3D safety factor. A column-based 3D slope stability analysis model is used to calculate this factor. In this study, some practical cases of known minimum safety factors and critical slip surfaces in 2D analysis are extended to 3D slope problems to locate the critical slip surfaces. Compared with the 2D result, the resulting 3D critical slip surface has no apparent difference in terms of only cross section, but the associated 3D safety factor is definitely higher.  相似文献