Evaluation of slope stability, especially in the absence of a proper bed such as marine soils, is one of the most important issues in geotechnical engineering. Using geogrid layers to enhance the strength and stability of embankments is regarded as a commendable stabilization method. On the other hand, groundwater level erratically fluctuates in coastal areas. Therefore, the aim of this research is to study the effects of groundwater level changes on stability of a geogrid-reinforced slope on loose marine soils in Qeshm Island, Iran. At first, geotechnical properties of the site were obtained by comprehensive series of geotechnical laboratory and in situ tests. Then, by simultaneous changes of groundwater level and several parameters such as embankment slope, loading, geogrid length, geogrid number, and tensile strength of geogrid, different characteristics such as embankment safety factor (SF), vertical and horizontal displacements at embankment top and embankment base were studied. It was observed that groundwater level had significant effects on behavior of the embankment. For most of the observations, by decreasing the groundwater level, the displacements decreased and consequently safety factor increased. Increasing the length, number, and tensile strength of geogrid led to the reduction of displacements and an increase in the safety factor. 相似文献
Settling velocity is one of the important parameters in sediment transport modeling of estuaries. The methods adopted for its determination vary from theoretical equations to experimental methods. The theoretical equation generally adopted in the 1DV model include assumptions in order to simplify the solution. It is generally assumed that either the condition is steady or the vertical diffusion is negligible. This study evaluated the relative importance of the two assumptions made for the estimation of settling velocity. Two approaches were adopted: unsteady and negligible vertical diffusion (NS-NVD) and steady with vertical diffusion (S-VD) to estimate the settling velocity. The Muthupet Estuary in the Coromandal coast of India was selected for the study. The S-VD approach estimated settling velocity fairly well at the two locations with appreciable vertical diffusion. The NS-NVD approach was observed to be superior for estimating settling velocity at shallow reaches of the estuary having low flow velocity. The calculated settling velocity was further applied in 1DV model to predict the suspended sediment concentration. The S-VD approach predicted suspended sediment concentration at those locations with appreciable vertical diffusion with an R2 value of 0.82 against 0.67 for the NS-NVD approach. At the other shallow reach of the estuary with low flow velocity, the NS-NVD approach gave an R2 value of 0.822 against 0.71 for the S-VD approach. The vertical diffusion was observed to play a secondary role at those locations which are shallow with a water depth of 0.6 m and with a low flow velocity of the order of 0.01 m/s. The study demonstrated that localized hydrodynamic conditions influence the method adopted for the estimation of settling velocity. 相似文献
Studying relativistic compact objects is important in modern astrophysics to understand several astrophysical issues. It is therefore natural to ask for an internal structure and physical properties of specific classes of compact stars from astrophysical observations. We obtain a class of new relativistic solutions with anisotropic distribution of matter for compact stars. More specifically, stellar models, described by an anisotropic fluid, establishing a relation between metric potentials and generating a specific form of mass function, are explicitly constructed within the framework of General Relativity. New solutions can be used to model compact objects, which adequately describe compact strange star candidates like SMC X-1, Her X-1 and 4U 1538-52, with observational data taken from Gangopadhyay et al. (Mon. Not. R. Astron. Soc. 431:3216, 2013). As a possible astrophysical application the obtained solutions could explain the physics of selfgravitating objects, and might be useful for strong-field regimes where data are currently inadequate. 相似文献
Sustainable fuels legislation and volatility in energy prices have put additional pressures on the forestry sector to intensify the harvesting of biomass for “advanced biofuel” production. To better understand how residual biomass removal after harvest affects forest hydrology in relatively low slope terrain, a Before-After-Control-Impact (BACI) study was conducted in the USDA Forest Service's Marcell Experimental Forest, Minnesota, USA. Hydrological measurements were made from 2010–2013 on a forested hillslope that was divided into three treatment blocks, where one block was harvested and residual biomass removed (Biomass Removed), the second was harvested and residual biomass left (Biomass Left), and the last block was left as an Unharvested Control. The pre-harvest period (2 years) was 2010–11 and post-harvest (2 years) was 2012–13. Water table elevation at the upslope and downslope position, subsurface runoff, and soil moisture were measured between May–November. Mixed effect statistical models were used to compare both the before-after and “control” treatment ratios (ratios between harvested hillslopes and the Unharvested Control hillslope). Subsurface runoff significantly increased (p < .05) at both harvested hillslopes but to a greater degree on the Biomass Left hillslope. Greater subsurface runoff volumes at both harvested hillslopes were driven by substantial increases during fall, with additional significant increases during summer on the Biomass Left hillslope. The hydrological connectivity, inferred from event runoff ratios, increased due to harvesting at both hillslopes but only significantly on the Biomass Left hillslope. The winter harvest minimized soil disturbance, resulting in no change to the effective hydraulic conductivity distribution with depth. Thus, the observed hydrological changes were driven by increased effective precipitation and decreased evapotranspiration, increasing the duration that both harvested hillslopes were hydrologically active. The harvesting of residual biomass appears to lessen hydrological connectivity relative to leaving residual biomass on the hillslope, potentially decreasing downstream hydrological impacts of similar forestry operations. 相似文献
Atlantic salmon reared in recirculating aquaculture system (RAS) may lead to inappropriately high stocking density, because fish live in a limited space. Finding the suitable stocking density of Atlantic salmon reared in RAS is very important for RAS industry. In this paper, the influence of stocking density on growth and some stress related physiological factors were investigated to evaluate the effects of stocking density. The fish were reared for 220 days at five densities (A: 24 kg/m3; B: 21 kg/m3; C: 15 kg/m3; D: 9 kg/ m3 and E: 6 kg/m3 ). The results show that 30 kg/m3 might be the maximum density which RAS can afford in China. The stocking densities under 30 kg/m3 have no effect on mortality of Atlantic salmon reared in RAS. However, the specific growth rate (SGR), final weight and weight gain in the high density group were significantly lower than the lower density groups and middle density groups. Moreover, feed conversion rate (FCR) had a negative correlation with density. Plasma hormone T3 and GH showed significant decrease with the increase of the stocking density of the experiment. Furthermore, thyroid hormone (T3), GH (growth hormone) activities were decreased with stocking density increase. However, plasma cortisol, GOT (glutamic oxalacetic transaminase) and GPT (glutamic pyruvic transaminase) activities were increase with stocking density increase. And the stocking density has no effects on plasma lysozyme of Atlantic salmon reared in RAS. These investigations would also help devise efficient ways to rear adult Atlantic salmon in China and may, in a way, help spread salmon mariculture in China.
The International Maritime Organization has developed the second-generation intact stability criteria. Thus, damage stability criteria can be established in the future. In order to identity the capsizing probability of damaged ship under dead ship condition, this paper investigates two methods that can be used to research the capsizing probability in time domain, which mainly focus on the nonlinear righting lever GZ curve solution. One method subjects the influence of damaged tanks on the hull shape down to the wind and wave, and the other method is consistent with the real-time calculation of the GZ curve. On the basis of one degree of freedom rolling equation, the solution is Monte Carlo method, and a damaged fishery bureau vessel is taken as a sample ship. In addition, the results of the time-domain capsizing probability under different loading conditions are compared and analyzed. The relation of GM and heeling angle with the capsizing probability is investigated, and its possible reason is analyzed. On the basis of combining the time-domain flooding process with the capsizing probability calculation, this research aims to lay the foundation for the study of capsizing probability in time domain under dead ship condition, as well as provide technical support for capsizing mechanism of dead ship stability and damage stability criteria establishment in waves. 相似文献