Co-existence of plagioclases of different compositions in some plutonic and metamorphic rocks     

Mitsuo Hunahashi  Cheoul Woo Kim  Yoshihide Ohta  Takamura Tsuchiya 《Lithos》1968,1(4):356-373

  相似文献   

Deep tow studies of the Tamayo transform fault     

Ken C. MacDonald  Kim Kastens  F. N. Spiess  S. P. Miller 《Marine Geophysical Researches》1979,4(1):37-70

The Tamayo transform fault occurs at the north end of the East Pacific Rise where it enters the Gulf of California. The two deep-tow surveys reported here show that the transform fault zone changes significantly as a function of distance from the spreading center intersections. At site 1, near the intersection, one side of the fault is young and the fault zone is narrow and well-defined. Strike slip occurs in a zone approximately 1-km wide suggesting a correspondingly narrow zone of decoupling between the Pacific and North American plates. On the young side of the strike-slip zone, normal faults occur along shear zones which are 45°–50° oblique to the transform strike. They occur parallel to the short axis of the strain ellipse for transform fault strain here, i.e., perpendicular to the least compressive stress. The transform walls are formed by normal faulting as has been pointed out in previous detailed surveys. Here, however, the age contrast of 2.5 m.y. across the transform valley is apparent in the morphology of the normal fault scarps. While the scarps are steep and well-defined on the young side, the scarps on the older side have gradual 10°–30° slopes and appear to be primarily talus ramps. Apparently, the scarps have been tectonically eroded by continued strike slip activity after the initial stages of normal faulting. Thus, transform valleys should be quite asymmetric in cross-section where there is a significant age contrast and one side is less than approximately 0.5 m.y. old. Also, along older sections of the transform valley walls, normal faulting may not be at all obvious due to degradation of the scarps by tectonic erosion. This phenomenon makes the likelihood of transform faults providing windows into the oceanic crust most unlikely except in special cases.The picture of transform deformation is more complex at site 2 in the central portion of the fault where both sides of the fault are greater than 1 m.y. old. Here the transform valley is wider (25–30 km as opposed to 2–5 km). There is no clear simple zone of strike slip tectonics. In fact, the only clear evidence for deformation is the intrusion of magmatic or serpentinite diapirs through the sediments of the transform valley floor. The diapirs have deformed the turbidite layers flooring the valley and in one carefully studied case the turbidite sequence has been uplifted, perched atop the diapir. The pattern of deformation on this outcropping diapir shows radial and concentric fractures which can be modeled by a vertical intrusion circular in plan view. Magnetic studies limit the possible composition to basalt or serpentinite. A 60-km-long median ridge is also likely to be the product of intrusion along the transform fault. The survey at site 2 pointed out the importance of vertical tectonics in the transform valley floor and in particular the importance of diapiric intrusions of either basaltic or serpentinite composition.Based on initial boundary conditions and present tectonic elements in the Tamayo fault zone, a possible history of the mouth of the Gulf of California is outlined. The median ridge was emplaced starting approximately 0.8 m.y. ago by regional extension across the transform fault, the result of leaky transform faulting. The diapirs occur along a possible relay zone of extension midway along the fault which began approximately 0.15 m.y. ago. The extension in this case is parallel to the trend of the transform fault, is still occurring at present, and may evolve into a true spreading center.Contribution of the Scripps Institution of Oceanography, new series.  相似文献   

Internal generation of waves: Delta source function method and source term addition method     

Gunwoo Kim  Changhoon Lee  Kyung-Duck Suh   《Ocean Engineering》2007,34(17-18):2251-2264

In this study, we investigate two internal wave generation methods in numerical modeling of time-dependent equations for water wave propagation, i.e., delta source function method and source term addition method, the latter of which has been called the line source method in literatures. We derive delta source functions for the Boussinesq-type equations and extended mild-slope equations. By applying the fractional step splitting method, we show that the delta source function method is equivalent to the source term addition method employing the energy velocity. This suggests that the energy velocity should be used rather than the phase velocity for the transport of incident wave energy in the source term addition method. Finally, the performance of the delta source function method is verified by accurately generating nonlinear cnoidal waves as well as linear waves for horizontally one-dimensional cases.  相似文献   

Generation of random waves in time-dependent extended mild-slope equations using a source function method     

Gunwoo Kim  Changhoon Lee  Kyung-Duck Suh   《Ocean Engineering》2006,33(14-15):2047-2066

We develop techniques of numerical wave generation in the time-dependent extended mild-slope equations of Suh et al. [1997. Time-dependent equations for wave propagation on rapidly varying topography. Coastal Engineering 32, 91–117] and Lee et al. [2003. Extended mild-slope equation for random waves. Coastal Engineering 48, 277–287] for random waves using a source function method. Numerical results for both regular and irregular waves in one and two horizontal dimensions show that the wave heights and the frequency spectra are properly reproduced. The waves that pass through the wave generation region do not cause any numerical disturbances, showing usefulness of the source function method in avoiding re-reflection problems at the offshore boundary.  相似文献   

Numerical and experimental study on hydrodynamic interaction of side-by-side moored multiple vessels   总被引：2，自引：0，他引：2  

S.Y. Hong  J.H. Kim  S.K. Cho  Y.R. Choi  Y.S. Kim 《Ocean Engineering》2005,32(7):783-801

This paper aims to investigate the basic interaction characteristics of side-by-side moored vessels both numerically and experimentally. A higher-order boundary element method (HOBEM) combined with generalized mode approach is applied to analysis of motion and drift force of side-by-side moored multiple vessels (LNG FPSO, LNGC and shuttle tankers). Model tests were carried out for the same floating bodies investigated in the numerical study in regular and irregular waves. Global and local motion responses and drift forces of three vessels are compared with those of calculations. Discussions is highlighted on applicability of numerical method to prediction of sophisticated multi-body interaction problem of which motion behavior is very important to analysis of mooring dynamics of deep sea floating bodies.  相似文献   

Mechanical Characteristics of Light-Weighted Soils Using Dredged Materials     

Gil-Lim Yoonz  Sang-Soo Jeon  Byung-Tak Kim 《Marine Georesources & Geotechnology》2004,22(4):215-229

This study investigates the mechanical characteristics of light-weighted soils (LWS) consisting of expanded polystyrene (EPS), dredged clays, and cement through both unconfined and triaxial compression tests. The mechanical characteristics of the compressive strength of LWS are analyzed with varying initial water contents of dredged clays, EPS ratio, cement ratio, and curing pressure. In the triaxial compression test, it is found that the compressive strength of LWS associated with EPS is independent on the effective confining pressure. When both EPS ratio is less than 2% and cement ratio is more than 2%, the compressive strength rapidly decreases after the ultimate value. This signifies that the compressive strength-strain behavior is quite similar to that of the cemented soil. The ground improved by LWS has the compressive strength of 200 kPa associated with the optimized EPS ratio of 3-4% and initial water content of 165-175%. The ultimate compressive strength under both triaxial and unconfined compression tests is almost constant for a cement ratio of up to 2%.  相似文献   

Fluxes and sources of suspended organic matter in an estuarine turbidity maximum region during low discharge conditions   总被引：6，自引：1，他引：6  

Miguel A. Goni  Mary W. Cathey  Yong H. Kim  George Voulgaris 《Estuarine, Coastal and Shelf Science》2005,63(4):683-700

Water column concentrations of total suspended solids (TSS), particulate organic carbon (POC) and particulate nitrogen (PN) were measured at three different depths in four different locations bracketing the estuarine turbidity maximum (ETM) along the main channel of a temperate riverine estuary (Winyah Bay, South Carolina, USA). Measurements were carried out over full tidal cycle (over 24 h). Salinity, temperature, current magnitude and direction were also monitored at the same time throughout the water column. Tidally averaged net fluxes of salt, TSS, POC and PN were calculated by combining the current measurements with the concentration data. Under the extreme low river discharge conditions that characterized the study period, net landward fluxes of salt were measured in the lower part of the study area, suggesting that the landward transport through the main channel of the estuary was probably balanced by export out through the sides. In contrast, the net fluxes of salt in the upper reaches of the study area were near zero, indicating a closed salt balance in this part of the estuary. In contrast to salt, the net fluxes of TSS, POC and PN in the deeper parts of the water column were consistently landward at all four sites in Winyah Bay indicating the non-conservative behavior of particulate components and their active transport up the estuary in the region around the ETM.The carbon contents (%POC), carbon:nitrogen ratios (org[C:N]a) and stable carbon isotopic compositions (δ¹³C_POC) of the suspended particles varied significantly with depth, location and tidal stage. Tidally averaged compositions showed a significant increase up the estuary in the %POC and org[C:N]a values of suspended particles consistent with the preferential landward transport of carbon-rich particles with higher vascular plant debris content. The combination of tidal resuspension and flood-dominated flow appeared to be responsible for the hydrodynamic sorting of particles along the estuary that resulted in denser, organic-poor particles being transported landward less efficiently. The elemental and isotopic compositions indicated that vascular C₃ plants and estuarine algae were the major sources of the particulate organic matter of all the samples, without any significant contributions from salt marsh C₄ vegetation (Spartina alterniflora) and/or marine phytoplankton.  相似文献   

Cloning of cytochrome P450 1A (CYP1A) genes from the hermaphrodite fish Rivulus marmoratus and the Japanese medaka Oryzias latipes     

Kim IC  Kim YJ  Yoon YD  Kawamura S  Lee YS  Lee JS 《Marine environmental research》2004,58(2-5):125-129

To use two small fish Rivulus marmoratus (Cyprinodontiformes, Rivulidae) and the Japanese medaka Oryzias latipes (Belloniformes) as testing models in molecular ecotoxicology, we have cloned the cytochrome P450 1A (CYP1A) gene after screening of both genomic DNA libraries, and sequenced 11,863 and 7,243 bp including all the exons and introns with promoter regions, respectively. The Rivulus and the medaka CYP1A gene consisted of seven exons (including non-coding exons) with high homology to mammals. In the promoter region, Rivulus CYP1A gene has seven xenobiotic response elements (XREs) and two metal response elements (MREs), while the Japanese medaka CYP1A gene has six XREs and four MREs. Interestingly, medaka CYP1A gene has a number of MREs at the promoter, which may affect its response on metal exposure. We describe here the gene structure of both fish CYP1A genes.  相似文献   

Freely floating-body simulation by a 2D fully nonlinear numerical wave tank     

Weoncheol Koo  Moo-Hyun Kim 《Ocean Engineering》2004,31(16):221-2046

Nonlinear interactions between large waves and freely floating bodies are investigated by a 2D fully nonlinear numerical wave tank (NWT). The fully nonlinear 2D NWT is developed based on the potential theory, MEL/material-node time-marching approach, and boundary element method (BEM). A robust and stable 4th-order Runge–Kutta fully updated time-integration scheme is used with regriding (every time step) and smoothing (every five steps). A special φ_n-η type numerical beach on the free surface is developed to minimize wave reflection from end-wall and wave maker. The acceleration-potential formulation and direct mode-decomposition method are used for calculating the time derivative of velocity potential. The indirect mode-decomposition method is also independently developed for cross-checking. The present fully nonlinear simulations for a 2D freely floating barge are compared with the corresponding linear results, Nojiri and Murayama’s (Trans. West-Jpn. Soc. Nav. Archit. 51 (1975)) experimental results, and Tanizawa and Minami’s (Abstract for the 6th Symposium on Nonlinear and Free-surface Flow, 1998) fully nonlinear simulation results. It is shown that the fully nonlinear results converge to the corresponding linear results as incident wave heights decrease. A noticeable discrepancy between linear and fully nonlinear simulations is observed near the resonance area, where the second and third harmonic sway forces are even bigger than the first harmonic component causing highly nonlinear features in sway time series. The surprisingly large second harmonic heave forces in short waves are also successfully reproduced. The fully updated time-marching scheme is found to be much more robust than the frozen-coefficient method in fully nonlinear simulations with floating bodies. To compare the role of free-surface and body-surface nonlinearities, the body-nonlinear-only case with linearized free-surface condition was separately developed and simulated.  相似文献   

Solution of an unstable axisymmetric Cauchy–Poisson problem of dispersive water waves for a spectrum with compact support     

T.S. Jang  S.H. Kwon  B.J. Kim 《Ocean Engineering》2007,34(5-6):676-684

 It has been known that the axisymmetric Cauchy–Poisson problem for dispersive water waves is well posed in the sense of stability. Thereby time evolution solutions of wave propagation depend continuously on initial conditions. However, in this paper, it is demonstrated that the axisymmetric Cauchy–Poisson problem is ill posed in the sense of stability for a certain class of initial conditions, so that the propagating solutions do not depend continuously on the initial conditions. In order to overcome the difficulty of the discontinuity, Landweber–Fridman's regularization, famous and well known in applied mathematics, are introduced and investigated to learn whether it is applicable to the present axisymmetric wave propagation problem. From the numerical experiments, it is shown that stable and accurate solutions are realized by the regularization, so that it can be applicable to the determination of the ill-posed Cauchy–Poisson problem.  相似文献