The aquatic macrofauna of the Guadalquivir estuary were sampled (1 mm mesh persiana net) at 5 sampling sites located along the entire (except the tidal freshwater region) estuarine gradient of salinity (outer 50 km). A total of 134 fish and macroinvertebrate species was collected but only 62 were considered common or regularly present in the estuary. Univariate measures of the community structure showed statistically significant differences among sampling sites: species richness, abundance, and biomass decreased in the upstream direction, being positively correlated with the salinity. Temporal differences of these three variables were also statistically significant. While a clear seasonal pattern (minimum densities in winter and maximum in spring-summer) was observed for abundance and biomass, no such pattern existed for the number of species. Mysids was the most dominant group throughout the estuary (96% to 99% of abundance; 49% to 85% of biomass), although fish biomass was also important at the outer estuary (36% to 38%). Multivariate analyses indicated highly significant spatial variation in the macrofaunal communities observed along the salinity gradient. These analyses suggest that the underlying structure was a continuum with more or less overlapping distributions of the species dependent on their ability to tolerate different physicochemical conditions. There were also significant temporal (intermonthly + interannual) variation of the estuarine community; the relative multivariate dispersion indicated that monthly variation was more considerable (relative multivariate dispersion >1) at the outer part of the estuary during the wet year (last 20 km) and was higher in the inner stations during the dry year (32 to 50 km from the river mouth). Since a clear negative exponential relationship was observed between the freshwater input (from a dam located 110 km upstream) and water salinity at all sampling stations, it is concluded that the human freshwater management is probably affecting the studied estuarine communities. While the higher seasonal (long-term) stability of the salinity gradient, due to the human control of the freshwater input, may facilitate the recruitment of marine species juveniles during the meteorologically unstable early-spring, the additional (short-term) salinity fluctuations during the warm period may negatively affect species that complete their lifecycle within the estuary. 相似文献
The Granada Basin (Central Betic Cordillera), one of the most seismically active areas of the Iberian Peninsula, is currently subjected to NW-SE compression and NE-SW extension. The present day extension is accommodated by normal faults with various orientations but particularly with a NW-SE strike. At the surface, these active NW-SE normal faults are mainly concentrated on the NE part of the Basin. In this part we have selected a 15-km long segment where several active normal faults crop out. Using the marine Tortonian rocks as a reference, we have calculated a minimum extensional rate of 0.15-0.30 mm/year. The observed block rotation, the listric geometry of faults at depth and the distribution of seismicity over the whole Basin, indicate that this rate is a minimum value. In the framework of an interdisciplinary research project a non-permanent GPS-network has been established in the central sector of Betic Cordillera to monitor the crustal deformations. The first two observation campaigns were done in 1999 and 2000. 相似文献
The Portil lagoon is a natural freshwater reservoir located at the southwest of Spain, near the coast. In its surroundings an important tourist complex has been developed since the earlier 1970s. This has resulted in increased loads of nutrients, specially during summer months. In order to evaluate the impact from humans on the lagoon caused by anthropogenic activities, we have determined vertical profiles of excess 210Pb and 137Cs in a sediment core taken from its bottom. Vertical profile of excess 210Pb seems to indicate that the sediment core was affected by large-scale mixing processes. Nevertheless this possibility was ruled out based on the shape of the 137Cs vertical distribution after modelling the 137Cs profile considering large-scale mixing. The chronology developed from 210Pb and 137Cs has allowed us to calculate the temporal evolution of the mass sedimentation rate during the last century. This mass sedimentation rate increased in 1973: from 0.08(2) g cm-2 a-1 in the period 1900-1973 to 0.17(5) g cm-2 a-1 in the period 1973-1995. This increase could be related to land-movements in the drainage area and to permitted sewage inputs into the lagoon, both with its origin in the growing/running of the surrounding tourist complex. 相似文献
ABSTRACT In situ measurements of lakebed sediment erodibility were made on three sites in Hamilton Harbour, Lake Ontario, using the benthic flume Sea Carousel. Three methods of estimating the surface erosion threshold (τc(0)) from a Carousel time series were evaluated: the first method fits measures of bed strength to eroded depth (the failure envelope) and evaluates threshold as the surface intercept; the second method regresses mean erosion rate (Em) with bed shear stress and solves for the floc erosion rate (Ef) to derive the threshold for Em = Ef = 1 × 10?5 kg m?2 s?1; the third method extrapolates a regression of suspended sediment concentration (S) and fluid transmitted bed shear stress (τ0) to ambient concentrations. The first field site was undisturbed (C) and acted as a control; the second (W) was disturbed through ploughing and water injection as part of lakebed treatment, whereas the third site (OIP) was disturbed and injected with an oxidant used for remediation of contaminated sediment. The main objectives of this study were: (1) to evaluate the three different methods of deriving erosion threshold; (2) to compare the physical behaviour of lacustrine sediments with their marine estuarine counterparts; and (3) to examine the effects of ploughing and chemical treatment of contaminated sediment on bed stability. Five deployments of Sea Carousel were carried out at the control site. Mean erosion thresholds for the three methods were: τc(0) = 0·5 (±0·06), 0·27 (±0·01) and 0·34 (±0·03) Pa respectively. Method 1 overpredicted bed strength as it was insensitive to effects in the surface 1–2 mm, and the fit of the failure envelope was also highly subjective. Method 2 exhibited a wide scatter in the data (low correlation coefficients), and definition of the baseline erosion rate (Ef) is largely arbitrary in the literature. Method 3 yielded stable (high correlation coefficients), reproducible and objective results and is thus recommended for evaluation of the erosion threshold. The results of this method correlated well with sediment bulk density and followed the same trend as marine counterparts from widely varying sites. Mass settling rates, expressed as a decay constant, k, of S(t), were strongly related to the maximum turbidity at the onset of settling (Smax) and were also in continuity with marine counterparts. Thus, it appears that differences in salinity had little effect on mass settling rates in the examples presented, and that biological activity dominated any effects normally attributable to changes in salinity. Bedload transport of eroded aggregates (2–4 mm in diameter) took place by rolling below a mean tangential flow velocity (Uy) of 0·32 ms?1 and by saltation at higher velocities. Mass transport as bedload was a maximum at Uy = 0·4 ms?1, although bedload never exceeded 1% of the suspended load. The proportion of material moving as bedload was greatest at the onset of erosion but decreased as flow competence increased. Given the low bulk density and strength of the lakebed sediment, the presence of a bedload component is notable. Bedload transport over eroding cohesive substrates should be greater in estuaries, where both sediment density and strength are usually higher. Significant differences between the ploughed and control sites were apparent in both the erosion rate and the friction coefficient (φ), and suggest that bed recovery after disruption is rapid (< 24 h). τc(0) increased linearly with time after ploughing and recovered to the control mean value within 3 days. The friction coefficient was reduced to zero by ploughing (diagnostic of fluidization), but increased linearly with time, regaining control values within 6 days. No long‐term reduction in bed strength due to remediation was apparent. 相似文献
The Malpica–Tui complex (NW Iberian Massif) consists of a Lower Continental Unit of variably deformed and recrystallized granitoids, metasediments and sparse metabasites, overridden by an upper unit with rocks of oceanic affinities. Metamorphic minerals dated by the 40Ar/39Ar method record a coherent temporal history of progressive deformation during Variscan metamorphism and exhumation. The earliest stages of deformation (D1) under high-pressure conditions are recorded in phengitic white micas from eclogite-facies rocks at 365–370 Ma. Following this eclogite-facies peak-metamorphism, the continental slab became attached to the overriding plate at deep-crustal levels at ca. 340–350 Ma (D2). Exhumation was accompanied by pervasive deformation (D3) within the continental slab at ca. 330 Ma and major deformation (D4) in the underlying para-autochthon at 315–325 Ma. Final tectonothermal evolution included late folding, localized shearing and granitic intrusions at 280–310 Ma.
Dating of high-pressure rocks by the 40Ar/39Ar method yields ages that are synchronous with published Rb–Sr and Sm–Nd ages obtained for both the Malpica–Tui complex and its correlative, the Champtoceaux complex in the French Armorican Massif. The results indicate that phengitic white mica retains its radiogenic argon despite been subjected to relatively high temperatures (500–600 °C) for a period of 20–30 My corresponding to the time-span from the static, eclogite-facies M1 peak-metamorphism through D1-M2 eclogite-facies deformation to amphibolite-facies D2-M3. Our study provides additional evidence that under certain geological conditions (i.e., strain partitioning, fluid deficiency) argon isotope mobility is limited at high temperatures, and that 40Ar/39Ar geochronology can be a reliable method for dating high pressure metamorphism. 相似文献
Separate lead isotope analyses of leachate and residue fractions are applied to a broad spectrum of rocks commonly investigated in metallogenic studies. Resulting data highlight a systematic behavior of leachate and residue fractions with respect to lead isotope compositions, which essentially depends on the mineralogical composition of the rock. Granitoid and high-grade metamorphic rocks have residue compositions virtually identical to common lead. In contrast, low-grade metasedimentary rocks may have residue compositions swamped by radiogenic lead of leach-resistant zircons. Mafic magmatic rocks have residues that are often more radiogenic than leachates, depending on the ratio of leach-refractory zircons to common lead in the residual fraction of these rocks. Separate leachate and residue analyses of source rocks provide two lead isotope end members whose mixture may represent lead with the appropriate ore fluid composition. Our leaching experiments indicate that hot acid solutions (and by inference hydrothermal fluids) preferentially leach radiogenic lead from medium- to high-grade metamorphic and granitoid rocks, whereas they preferentially leach common lead from low-grade metasedimentary and mafic magmatic rocks. The method presented in this study provides a reliable alternative to other methods (i.e., age-correction of bulk-rock compositions) for the determination of the common lead signature of felsic to intermediate magmatic rocks. This may be preferable to age-corrected bulk-rock analyses, where ages to apply for corrections of bulk-rock data are not known or where moderately to highly altered rocks must be used. Case studies of orogenic gold and MVT districts of Peru (Pataz and San Vicente, respectively) show that separate leachate and residue lead isotope analyses carried out systematically on whole rocks allow a more thorough evaluation of metal source reservoirs than does the standard method of age-corrected or uncorrected bulk-rock analyses. 相似文献
Rockfall susceptibility has been analysed in mountain cliffs of the Cantabrian Range, North Spain. The main aim of this analysis has been to build a predictive model of rockfall activity from a low number of environmental and geological variables. The rockfall activity has been quantified in a GIS. The cartographic information used shows the spatial distribution of all the recent talus screes as well as their associated source areas in the rock-slopes. The area relation At/Ar (recent talus scree polygon/source basins) in the rock slopes has been used as the rockfall activity indicator. This relation has been validated in 50 pilot rock-slopes and compared with the relation number of recent rock fragments/source basin, obtained from field work. The environmental factors causing rockfall depend on the rock slope situation, and these are: altitude and sun radiation on the rock cliff. The geological factors considered are: lithology, relative position of the main discontinuities with respect to the topographic surface and two morphologic parameters: the roughness and slope gradient. A logistic regression analysis has been applied to a population of 442 limestone and quartzite rock cliffs. The dependent variable is the rockfall activity indicator, which allows the definition of two classes of rock cliff units: low and high activity. The independent variables are altitude, sun radiation (equinox radiation, summer solstice radiation, winter solstice radiation), slope roughness, slope gradient,anisotropy and lithology. Results suggest that it is possible tobuild a valid cartographic predictive model for rockfall activity in mountain rock cliffs from a limited number of easily obtainable variables. The method is especially applicable in massive rock slopes or in regions with uniform rock mass characteristics. 相似文献