Water release patterns of heated speleothem calcite and hydrogen isotope composition of fluid inclusions     

Sophie Verheyden  Dominique Genty  Olivier Cattani  Martin R. van Breukelen 《Chemical Geology》2008,247(1-2):266-281

Speleothem fluid inclusions are a potential paleo-precipitation proxy to reconstruct past rainwater isotopic composition (δ¹⁸O, δD). To get a better insight in the extraction of inclusion water from heated speleothem calcite, we monitored the water released from crushed and uncrushed speleothem calcite, heated to 900 °C at a rate of 300 °C/h, with a quadrupole mass spectrometer. Crushed calcite released water in three not well individualised peaks between 25 and 360 °C, 360 and 650 °C and between 650 and 800 °C while uncrushed calcite released water in two distinct temperature intervals: between 25 and 550 °C and between 550 and 900 °C.Water from two speleothems from the Han-sur-Lesse cave was recovered using three different techniques: i) the crushing and heating to 360 °C technique, ii) the decrepitation by heating to 550 °C and iii) the decomposition by heating to 900 °C technique. Measurements of the δD of water recovered by the decomposition of Han-sur-Lesse calcite heated to 900 °C did not show a 20 to 30‰ offset as found by previous authors. However a difference of 7‰ was observed between water released before and after decomposition of the calcite. Water recovery from the Han-sur-Lesse samples suggests that a simple heating technique (up to 550 °C) without crushing could both (a) recover water with δD representative of that of the drip water and (b) double the water yield as compared to the crushing and heating method.Our study warns for possible contamination of the recovered inclusion water with hydration water of lime, responsible for the recovery of water with very negative δD values.  相似文献   

Comparison of arsenic concentrations in simultaneously-collected groundwater and aquifer particles from Bangladesh,India, Vietnam,and Nepal     

A. van Geen  K. Radloff  Z. Aziz  Z. Cheng  M.R. Huq  K.M. Ahmed  B. Weinman  S. Goodbred  H.B. Jung  Y. Zheng  M. Berg  P.T.K. Trang  L. Charlet  J. Metral  D. Tisserand  S. Guillot  S. Chakraborty  A.P. Gajurel  B.N. Upreti 《Applied Geochemistry》2008

One of the reasons the processes resulting in As release to groundwater in southern Asia remain poorly understood is the high degree of spatial variability of physical and chemical properties in shallow aquifers. In an attempt to overcome this difficulty, a simple device that collects groundwater and sediment as a slurry from precisely the same interval was developed in Bangladesh. Recently published results from Bangladesh and India relying on the needle-sampler are augmented here with new data from 37 intervals of grey aquifer material of likely Holocene age in Vietnam and Nepal. A total of 145 samples of filtered groundwater ranging in depth from 3 to 36 m that were analyzed for As (1–1000 μg/L), Fe (0.01–40 mg/L), Mn (0.2–4 mg/L) and S (0.04–14 mg/L) are compared. The P-extractable (0.01–36 mg/kg) and HCl-extractable As (0.04–36 mg/kg) content of the particulate phase was determined in the same suite of samples, in addition to Fe(II)/Fe ratios (0.2–1.0) in the acid-leachable fraction of the particulate phase. Needle-sampler data from Bangladesh indicated a relationship between dissolved As in groundwater and P-extractable As in the particulate phase that was interpreted as an indication of adsorptive equilibrium, under sufficiently reducing conditions, across 3 orders of magnitude in concentrations according to a distribution coefficient of 4 mL/g. The more recent observations from India, Vietnam and Nepal show groundwater As concentrations that are often an order of magnitude lower at a given level of P-extractable As compared to Bangladesh, even if only the subset of particularly reducing intervals characterized by leachable Fe(II)/Fe >0.5 and dissolved Fe >0.2 mg/L are considered. Without attempting to explain why As appears to be particularly mobile in reducing aquifers of Bangladesh compared to the other regions, the consequences of increasing the distribution coefficient for As between the particulate and dissolved phase to 40 mL/g for the flushing of shallow aquifers of their initial As content are explored.  相似文献   

Considerations for conducting incubations to study the mechanisms of As release in reducing groundwater aquifers     

Kathleen A. Radloff  Anya R. Manning  Brian Mailloux  Yan Zheng  M. Moshiur Rahman  M. Rezaul Huq  Kazi M. Ahmed  Alexander van Geen 《Applied Geochemistry》2008

Microbial Fe reduction is widely believed to be the primary mechanism of As release from aquifer sands in Bangladesh, but alternative explanations have been proposed. Long-term incubation studies using natural aquifer material are one way to address such divergent views. This study addresses two issues related to this approach: (1) the need for suitable abiotic controls and (2) the spatial variability of the composition of aquifer sands. Four sterilization techniques were examined using orange-colored Pleistocene sediment from Bangladesh and artificial groundwater over 8 months. Acetate (10 mM) was added to sacrificial vials before sterilization using either (1) 25 kGy of gamma irradiation, (2) three 1-h autoclave cycles, (3) a single addition of an antibiotic mixture at 1× or (4) 10× the typical dose, and (5) a 10 mM addition of azide. The effectiveness of sterilization was evaluated using two indicators of microbial Fe reduction, changes in diffuse spectral reflectance and leachable Fe(II)/Fe ratios, as well as changes in P-extractable As concentrations in the solid phase. A low dose of antibiotics was ineffective after 70 days, whereas autoclaving significantly altered groundwater composition. Gamma irradiation, a high dose of antibiotics, and azide were effective for the duration of the experiment.  相似文献   

DEM analysis of the crack propagation in brittle clays under uniaxial compression tests   总被引：2，自引：0，他引：2  

Luis F. Vesga  Luis E. Vallejo  Sebastian Lobo‐Guerrero 《国际地质力学数值与分析法杂志》2008,32(11):1405-1415

  相似文献   

Numerical estimation of REV and permeability tensor for fractured rock masses by composite element method   总被引：2，自引：0，他引：2  

S.‐H. Chen  X.‐M. Feng  S. Isam 《国际地质力学数值与分析法杂志》2008,32(12):1459-1477

The Monte Carlo method is used to generate parent stochastic discrete fracture network, from which a series of fractured rock samples of different sizes and orientations are extracted. The fracture network combined with a regular grid forms composite element mesh of the fractured rock sample, in which each composite element is composed of sub‐elements incised by fracture segments. The composite element method (CEM) for the seepage is implemented to obtain the nodal hydraulic potential as well as the seepage flow rates through the fractured rock samples. The application of CEM enables a large quantity of stochastic tests for the fractured rock samples because the pre‐process is facilitated greatly. By changing the sizes and orientations of the samples, the analysis of the seepage characteristics is realized to evaluate the variation of the permeability components, the existence of the permeability tensor and the representative element volume. The feasibility and effectiveness are illustrated in a numerical example. Copyright © 2008 John Wiley & Sons, Ltd.  相似文献   

Biaxial test simulations using a packing of polygonal particles   总被引：1，自引：0，他引：1  

A. A. Peña  A. Lizcano  F. Alonso‐Marroquin  H. J. Herrmann 《国际地质力学数值与分析法杂志》2008,32(2):143-160

The mechanical response of cohesionless granular materials under monotonic loading is studied by performing molecular dynamic simulations. The diversity of shapes of soil grains is modelled by using randomly generated convex polygons as granular particles. Results of the biaxial test obtained for dense and loose media show that samples achieve the same void ratio at large strains independent of their initial density state. This limit state resembles the so‐called critical state of soil mechanics, except for some stress fluctuations, which remain for large deformations. These fluctuations are studied at the micro‐mechanical level, by following the evolution of the co‐ordination number, force chains and the fraction of the sliding contacts of the sample. Copyright © 2007 John Wiley & Sons, Ltd.  相似文献   

The effect of naturally acidified irrigation water on agricultural volcanic soils. The case of Asembagus, Java, Indonesia     

A.M.D. van Rotterdam-Los  S.P. Vriend  M.J. van Bergen  P.F.M. van Gaans   《Journal of Geochemical Exploration》2008,96(1):53-68

Acid water from the Banyuputih river (pH  3.5) is used for the irrigation of agricultural land in the Asembagus coastal area (East Java, Indonesia), with harmful consequences for rice yields. The river water has an unusual composition which is caused by seepage from the acidic Kawah Ijen crater lake into the river. This unique irrigation setting allows the study of soil acidification in situ. This paper assesses the effects of volcanogenically contaminated irrigation water on the chemical properties of the agricultural soils.The changes in soil properties were evaluated by comparing samples taken from the topsoil and sub-soil (1–3 m depth) from areas irrigated with acid water and areas irrigated with neutral water. The field survey thus resulted in four soil categories. Bulk soil composition, organic matter content, moisture content and particle size distribution were determined. Reactive phases were quantified with the selective extractions 1 M KCl, 0.1 M Na-pyrophosphate and 0.2 M acid ammonium oxalate (AAO).By comparing the four soil categories it is shown that the use of the naturally polluted irrigation water has had a large influence on the chemical composition of the topsoil. The composition of the soil solution has changed over the entire investigated soil profile. Furthermore the acid irrigation water has strongly modified the composition of the reactive phases, extracted as KCl, pyrophosphate, and AAO extractable elements, and also the bulk soil composition has been significantly modified. Overall this has resulted in the net dissolution of some elements and the net precipitation of others. The changes in the reactive phases and bulk soil composition are only apparent in the topsoil (0–20 cm) but not in the deeper soil.  相似文献   

Flexural isostatic response of the Alps to increased Quaternary erosion recorded by foreland basin remnants,SE France     

Jean‐Daniel Champagnac  Peter Van Der Beek  Gaël Diraison  Samuel Dauphin 《地学学报》2008,20(3):213-220

We test the hypothesis that flexural isostatic compensation of the mass removed by enhanced Quaternary erosion is responsible for uplift of the Western European Alps and their forelands. We use two well‐preserved and well‐dated (1.8 Ma) abandonment surfaces of foreland basin remnants in SE France (the Chambaran and Valensole plateaux) as passive benchmarks for tilting of the foreland. Estimating their initial slope from morphometric scaling relationships, we determine bulk post‐depositional tilting of 0.5–0.8% for these surfaces. The calculated isostatic response of the Alpine lithosphere to erosional unloading, using the method recently proposed by Champagnac et al. [Geology 35 (2007) 195–198] , yields a predicted tilting of 0.3–0.4% in the considered areas, explaining approximately half of the determined post‐depositional tilting. Such long‐term deformation being insensitive to cyclic loading/unloading because of glaciations, we suspect the other half to be related to as yet undetermined long‐wavelength and long‐lived tectonic process(es).  相似文献   

Identification of chlorite and chlorite-related minerals in sediments     

H. W. van der Marel 《Contributions to Mineralogy and Petrology》1964,9(5):462-480

A scheme is presented for the identification and classification of chlorite and related minerals in sediments which is mainly based on X-ray characteristics of the orginal sample and the sample heated at 350°C and treated with K⁺ and with glycerol. Examples are given. It is emphasized that additional data about clay mineral genesis, electron microscopy, infrared spectroscopy and chemical analyses are needed for the ordening of a certain mineral in the proposed scheme. Many names of minerals so far found to occur in the clay separate of sediments proved to be synonymous (52 of a total of 88) and thus should be abandoned. They only give confusion and needlessly increase the many difficulties which already exist in the identification, classification and quantitative determination of this complicated group of minerals of about 36 well defined specimens which may be found in sediments.  相似文献   

An optimized method for automated analysis of algal pigments by HPLC   总被引：3，自引：0，他引：3  

M.A. van Leeuwe  L.A. Villerius  J. Roggeveld  R.J.W. Visser  J. Stefels 《Marine Chemistry》2006,102(3-4):267-275

A recent development in algal pigment analysis by high-performance liquid chromatography (HPLC) is the application of automation. An optimization of a complete sampling and analysis protocol applied specifically in automation has not yet been performed. In this paper we show that automation can only be successful if the various methodological aspects of the sampling and analysis protocol are considered in coherence. We introduce an optimized protocol that involves freeze-drying of the sample, subsequent extraction in 90% acetone and the application of water-packing during analysis. The method was evaluated on both natural plankton populations and a broad spectrum of microalgal cultures: Thalassiosira weisflogii (Bacillariophyceae), Emiliania huxleyi (Prymnesiophyceae), Phaeocystis globosa and Phaeocystis antarctica (Prymnesiophyceae) and Pyramimonas sp. (Prasinophyceae). Whereas pigment extracts were unstable in methanol, with recorded chlorophyll a losses from 10% to 60% per day, pigment degradation rates in acetone were generally less than 1% over 18 h storage in the autosampler (4 °C). In addition, it was found that the extraction efficiency of acetone significantly increased upon freeze-drying prior to extraction. Increases as high as 50–60% were measured in P. antarctica. The application of water-packing of the sample during injection resulted in improved peak shape and peak separation, without diluting the pigment concentrations. Automation is especially beneficial for application in the field, when mixed algal assemblages and low biomass put a high demand on the sensitivity as well as reproducibility of the method.  相似文献