Application of the Ti-in-quartz thermobarometer to rutile-free systems. Reply to: a comment on: ‘TitaniQ under pressure: the effect of pressure and temperature on the solubility of Ti in quartz’ by Thomas et al.   总被引：2，自引：1，他引：1  

Jay B. Thomas  E. Bruce Watson 《Contributions to Mineralogy and Petrology》2012,164(2):369-374

The premise of the Wilson et al. comment is that the Ti-in-quartz solubility calibration (Thomas et al. in Contrib Mineral Petrol 160:743–759, 2010) is fundamentally flawed. They reach this conclusion because P–T estimates using the Ti-in-quartz calibration differ from their previous interpretations for crystallization conditions of the Bishop and Oruanui rhyolites. If correct, this assertion has far-reaching implications, so a careful assessment of the Wilson et al. reasoning is warranted. Application of the Ti-in-quartz calibration as a thermobarometer in rutile-free rocks requires an estimation of TiO₂ activity in the liquid ( (liquid–rutile); referenced to rutile saturation) and an independent constraint on either P or T to obtain the crystallization temperature or pressure, respectively. The foundation of Wilson et al.’s argument is that temperature estimates obtained from Fe–Ti oxide thermometry accurately reflect crystallization conditions of quartz in the two rhyolites discussed. We maintain that our experimental approach is sound, the thermodynamic basis of the Ti-in-quartz calibration is fundamentally correct, and our experimental results are robust and reproducible. We suggest that the reason Wilson et al. obtain implausible pressure estimates is because estimates for T and they used as input values for the Ti-in-quartz calibration are demonstrably too high. Numerous studies show that Fe–Ti oxide temperature estimates of some rhyolites are substantially higher than those predicted by well-constrained phase equilibria. In this reply, we show that when reasonable input values for T and (liquid–rutile) are used, pressure estimates obtained from the Ti-in-quartz calibration are well aligned with phase equilibria and essentially identical to melt inclusion volatile saturation pressures.  相似文献   

Overview and Assessment of Antarctic Ice-Sheet Mass Balance Estimates: 1992�C2009     

H. Jay Zwally  Mario B. Giovinetto 《Surveys in Geophysics》2011,32(4-5):351-376

Mass balance estimates for the Antarctic Ice Sheet (AIS) in the 2007 report by the Intergovernmental Panel on Climate Change and in more recent reports lie between approximately +50 to ?250 Gt/year for 1992 to 2009. The 300 Gt/year range is approximately 15% of the annual mass input and 0.8 mm/year Sea Level Equivalent (SLE). Two estimates from radar altimeter measurements of elevation change by European Remote-sensing Satellites (ERS) (+28 and ?31 Gt/year) lie in the upper part, whereas estimates from the Input-minus-Output Method (IOM) and the Gravity Recovery and Climate Experiment (GRACE) lie in the lower part (?40 to ?246 Gt/year). We compare the various estimates, discuss the methodology used, and critically assess the results. We also modify the IOM estimate using (1) an alternate extrapolation to estimate the discharge from the non-observed 15% of the periphery, and (2) substitution of input from a field data compilation for input from an atmospheric model in 6% of area. The modified IOM estimate reduces the loss from 136 Gt/year to 13 Gt/year. Two ERS-based estimates, the modified IOM, and a GRACE-based estimate for observations within 1992?C2005 lie in a narrowed range of +27 to ?40 Gt/year, which is about 3% of the annual mass input and only 0.2 mm/year SLE. Our preferred estimate for 1992?C2001 is ?47 Gt/year for West Antarctica, +16 Gt/year for East Antarctica, and ?31 Gt/year overall (+0.1 mm/year SLE), not including part of the Antarctic Peninsula (1.07% of the AIS area). Although recent reports of large and increasing rates of mass loss with time from GRACE-based studies cite agreement with IOM results, our evaluation does not support that conclusion.  相似文献   

Late Holocene Neoglacial conditions from the Lesotho highlands, southern Africa: phytolith and stable carbon isotope evidence from the archaeological site of Likoaeng     

Adrian G. Parker  Julia Lee-Thorp  Peter J. Mitchell 《Proceedings of the Geologists' Association. Geologists' Association》2011,122(1):201-211

The late Holocene environmental history of the Lesotho highlands, southern Africa, is poorly understood with few detailed studies to date. At Likoaeng, Senqu Valley, Lesotho, a 3 m stratified sedimentary sequence from an open-air archaeological site records vegetation development for the period 3400-1070 cal. BP. Phytolith analyses and bulk sediment organic matter δ¹³C indicate that C₄ grassland dominated the lower part of the sequence until approximately 2960 cal. BP when there was a switch to C₃ Pooid grassland (2960-2160 cal. BP). Also noted was a change from hunting mainly bovids to a dominance of fishing at the site. The change in grassland type and archaeological subsistence strategies corresponds with an episode of neoglacial cooling and the expansion of Alpine sourgrasses into lower altitudes. From 2160 to 1600 cal. BP grassland became a mix of C₃ and C₄ types and by 1600-1070 cal. BP there was a return to C₄ dominated grassland. During this latter phase there was a reversal from fishing to hunting again (and eventually some keeping of domestic livestock) at the site. These data outline the vegetation response to latitudinal shifts of frontal systems, and relatively strong atmospheric circulation variability, perhaps underpinned by variations of polar water into the Benguela Current during the late Holocene.  相似文献   

Evolution of a Carboniferous carbonate-hosted sphalerite breccia deposit,Isle of Man     

Kevin L. Shelton  Justin M. Beasley  Jay M. Gregg  Martin S. Appold  Stephen F. Crowley  James P. Hendry  Ian D. Somerville 《Mineralium Deposita》2011,46(8):859-880

A newly discovered, extensive sphalerite-bearing breccia (~7.5 wt.% Zn) is hosted in dolomitised Carboniferous limestones overlying Ordovician–Silurian metasedimentary rocks on the Isle of Man. Although base metal sulphide deposits have been mined historically on the island, they are nearly all quartz vein deposits in the metamorphic basement. This study investigates the origin of the unusual sphalerite breccia and its relationship to basement-hosted deposits, through a combination of petrographic, cathodoluminescence, fluid inclusion, stable isotope and hydrogeologic modelling techniques. Breccia mineralisation comprises four stages, marked by episodes of structural deformation and abrupt changes in fluid temperature and chemistry. In stage I, high-temperature (T _h > 300°C), high-salinity (20–45 wt.% equiv. NaCl) fluid of likely basement origin deposited a discontinuous quartz vein. This vein was subsequently dismembered during a major brecciation event. Stages II–IV are dominated by open-space filling sphalerite, quartz and dolomite, respectively. Fluid inclusions in these minerals record temperatures of ~105–180°C and salinities of ~15–20 wt.% equiv. NaCl. The δ³⁴S values of sphalerite (6.5–6.9‰ Vienna-Canyon Diablo troilite) are nearly identical to those of ore sulphides from mines in the Lower Palaeozoic metamorphic rocks. The δ¹⁸O values for quartz and dolomite indicate two main fluid sources in the breccia’s hydrothermal system, local Carboniferous-hosted brines (~0.5–6.0‰ Vienna standard mean ocean water) and basement-involved fluids (~5.5–11.5‰). Ore sulphide deposition in the breccia is compatible with the introduction and cooling of a hot, basement-derived fluid that interacted with local sedimentary brines.  相似文献   

Chronostratigraphy and lake-level changes of Laguna Cari-Laufquén, Río Negro, Argentina     

Alyson Cartwright  Jay Quade  Scott Stine  Kenneth D. Adams  Wallace Broecker  Hai Cheng 《Quaternary Research》2011,76(3):430-440

Evidence from shoreline and deep-lake sediments show Laguna Cari-Laufquén, located at 41°S in central Argentina, rose and fell repeatedly during the late Quaternary. Our results show that a deep (> 38 m above modern lake level) lake persisted from no later than 28 ka to 19 ka, with the deepest lake phase from 27 to 22 ka. No evidence of highstands is found after 19 ka until the lake rose briefly in the last millennia to 12 m above the modern lake, before regressing to present levels. Laguna Cari-Laufquén broadly matches other regional records in showing last glacial maximum (LGM) highstands, but contrasts with sub-tropical lake records in South America where the hydrologic maximum occurred during deglaciation (17–10 ka). Our lake record from Cari-Laufquén mimics that of high-latitude records from the Northern Hemisphere. This points to a common cause for lake expansions, likely involving some combination of temperature depression and intensification of storminess in the westerlies belt of both hemispheres during the LGM.  相似文献   

Isotopic tracers of paleohydrologic change in large lakes of the Bolivian Altiplano   总被引：2，自引：0，他引：2  

Christa J. Placzek  Jay Quade 《Quaternary Research》2011,75(1):231-244

We have developed an ⁸⁷Sr/⁸⁶Sr, ²³⁴U/²³⁸U, and δ¹⁸O data set from carbonates associated with late Quaternary paleolake cycles on the southern Bolivian Altiplano as a tool for tracking and understanding the causes of lake-level fluctuations. Distinctive groupings of ⁸⁷Sr/⁸⁶Sr ratios are observed. Ratios are highest for the Ouki lake cycle (120-95 ka) at 0.70932, lowest for Coipasa lake cycle (12.8-11.4 ka) at 0.70853, and intermediate at 0.70881 to 0.70884 for the Salinas (95-80 ka), Inca Huasi (~ 45 ka), Sajsi (24-20.5 ka), and Tauca (18.1-14.1 ka) lake cycles. These Sr ratios reflect variable contributions from the eastern and western Cordilleras. The Laca hydrologic divide exerts a primary influence on modern and paleolake ⁸⁷Sr/⁸⁶Sr ratios; waters show higher ⁸⁷Sr/⁸⁶Sr ratios north of this divide. Most lake cycles were sustained by slightly more rainfall north of this divide but with minimal input from Lake Titicaca. The Coipasa lake cycle appears to have been sustained mainly by rainfall south of this divide. In contrast, the Ouki lake cycle was an expansive lake, deepest in the northern (Poópo) basin, and spilling southward. These results indicate that regional variability in central Andean wet events can be reconstructed using geochemical patterns from this lake system.  相似文献   

Comment to Shepard, C.C., Agostini, V.N., Gilmer, B., Allen, T., Stone, J., Brooks, W., Beck, M.W.: Assessing future risk: quantifying the effects of sea level rise on storm surge risk for the southern shores of Long Island     

Albert Parker 《Natural Hazards》2013,65(1):977-980

  相似文献   

The Reaction Kinetics between CO2-bearing Fluid and Olivines/Hawaiian Picrites     

WANG Zhengrong  QIU Lin  ZHANG Shuang  KARATO Shun-ichiro  Kevin JOHNSON  Jay AGUE  Michael ORISTAGLIO  Edward BOLTON  David BERCOVICI 《《地质学报》英文版》2013,87(Z1):967-968

  相似文献   

Comparison of alternative upscaled model formulations for simulating DNAPL source dissolution and biodecay     

Jack C. Parker  Ronald W. Falta 《Advances in water resources》2008

This paper compares the performance of analytical and numerical approaches for modeling DNAPL dissolution with biodecay. A solution derived from a 1-D advective transport formulation (“Parker” model) is shown to agree very closely with high resolution numerical solutions. A simple lumped source mass balance solution in which with decay is assumed proportional to DNAPL mass (“Falta1” model) over- or underpredicts aqueous phase biodecay depending on the magnitude of the exponential factor governing the relationship between dissolution rate and DNAPL mass. A modification of the Falta model that assumes decay proportional to the source exit concentration is capable of accurately simulating source behavior with strong aqueous phase biodecay if model parameters are appropriately selected or calibrated (“Falta2” model). However, parameters in the lumped models exhibit complex interdependencies that cannot be quantified without consideration of transport processes within the source zone. Combining the Falta2 solution with relationships derived from the Parker model was found to resolve these limitations and track the numerical model results. A method is presented to generalize the analytical solutions to enable simulation of partial mass removal with changes in source parameters over time due to various remedial actions. The algorithm is verified by comparison with numerical simulation results. An example application is presented that demonstrates the interactions of partial mass removal, enhanced biodecay, enhanced mass transfer and source zone flow reduction applied at various time periods on contaminant flux reduction. Increasing errors that arise in numerical solutions with coarse discretization and high decay rates are shown to be controlled by using an adjusted decay coefficient derived from the Parker analytical solution.  相似文献   

Geophysical Finite-Element Simulation Tool (GeoFEST): Algorithms and Validation for Quasistatic Regional Faulted Crust Problems     

Jay Parker  Gregory Lyzenga  Charles Norton  Cinzia Zuffada  Margaret Glasscoe  John Lou  Andrea Donnellan 《Pure and Applied Geophysics》2008,165(3-4):497-521

GeoFEST (Geophysical Finite Element Simulation Tool) is a two- and three-dimensional finite element software package for the modeling of solid stress and strain in geophysical and other continuum domain applications. It is one of the featured high-performance applications of the NASA QuakeSim project. The program is targeted to be compiled and run on UNIX systems, and is running on diverse systems including sequential and message-passing parallel systems. Solution to the elliptical partial differential equations is obtained by finite element basis sampling, resulting in a sparse linear system primarily solved by conjugate gradient iteration to a tolerance level; on sequential systems a Crout factorization for the direct inversion of the linear system is also supported. The physics models supported include isotropic linear elasticity and both Newtonian and power-law viscoelasticity, via implicit quasi-static time stepping. In addition to triangular, quadrilateral, tetrahedral and hexahedral continuum elements, GeoFEST supports split-node faulting, body forces, and surface tractions. This software and related mesh refinement strategies have been validated on a variety of test cases with rigorous comparison to analytical solutions. These include a box-shaped domain with imposed motion on one surface, a pair of strike slip faults in stepover arrangement, and two community-agreed benchmark cases: a strike slip fault in an enclosing box, and a quarter-domain circular fault problem. Scientific applications of the code include the modeling of static and transient co- and post-seismic earth deformation, Earth response to glacial, atmospheric and hydrological loading, and other scenarios involving the bulk deformation of geologic media.  相似文献