Food Deserts in the Prairies? Supermarket Accessibility and Neighborhood Need in Edmonton,Canada*     

Karen E. Smoyer‐Tomic  John C. Spence  Carl Amrhein 《The Professional geographer》2006,58(3):307-326

The U.S. and U.K. literatures have discussed “food deserts,” reflecting populated, typically urban, low‐income areas with limited access to full‐service supermarkets. Less is known about supermarket accessibility within Canadian cities. This article uses the minimum distance and coverage methods to determine supermarket accessibility within the city of Edmonton, Canada, with a focus on high‐need and inner‐city neighborhoods. The results show that for 1999 both of these areas generally had higher accessibility than the remainder of the city, but six high‐need neighborhoods had poor supermarket accessibility. We conclude by examining potential reasons for differences in supermarket accessibility between Canadian, U.S., and U.K. cities.  相似文献   

Attenuation of landfill leachate at two uncontrolled landfills     

Jin-Yong Lee  Jeong-Yong Cheon  Hyung-Pyo Kwon  Hee-Sung Yoon  Seong-Sun Lee  Jong-Ho Kim  Joung-Ku Park  Chang-Gyun Kim 《Environmental Geology》2006,51(4):581-593

Attenuation characteristics of landfill leachate were examined for two uncontrolled landfills in Korea. The two landfills containing municipal wastes without appropriate bottom liner and leachate treatment system have different landfill age, waste volume, and most importantly different hydrogeologic settings. One landfill (Cheonan landfill) is situated in an open flat area while the other (Wonju landfill) is located in a valley. Variations of various parameters including dissolved organic carbon (DOC), dissolved oxygen (DO), alkalinity, pH, electrical conductivity (EC), redox potential (ORP), ammonia (NH₃), nitrate (NO₃⁻), sulfate (SO₄²⁻), and chloride (Cl⁻) were examined along groundwater flow path. All these parameters were analyzed every month for a year. In the interior of the landfills, typical anaerobic conditions revealed by low DO and NO₃ concentrations, negative ORP values, high NH₃, alkalinity, and Cl⁻ concentrations were observed. Generally, higher levels of contaminants (DOC, NH₃, and Cl⁻) were detected in the dry season while they were greatly lowered in the wet season. Significantly, large decrease of Cl^- concentration in the wet season indicates that the dilution or mixing is one of dominant attenuation mechanisms of leachate. But detailed variation behaviors in the two landfills are different and they were largely dependent on permeability of surface and subsurface layers. The intermediately permeable surface of the landfills receives part of direct rainfall infiltration but most rainwater is lost to fast runoff. The practically impermeable surface of clayey silt (paddy field) at immediately adjacent to the Cheonan landfill boundary prevented direct rainwater infiltration and hence redox condition of the ground waters were largely affected by that of the upper landfill and the less permeable materials beneath the paddy fields prohibited dispersion of the landfill leachate into down gradient area. In the Wonju landfill, there are three different permeability divisions, the landfill region, the sandy open field and the paddy field. Roles of the landfill and paddy regions are very similar to those at the Cheonan. The very permeable sandy field receiving a large amount of rainwater infiltration plays a key role in controlling redox condition of the down gradient area and contaminant migration. This paper reports details of the attenuation and redox conditions of the landfill leachates at the two uncontrolled landfills.  相似文献   

Modelling Korean extreme rainfall using a Kappa distribution and maximum likelihood estimate   总被引：6，自引：0，他引：6  

J.-S. Park  H.-S. Jung 《Theoretical and Applied Climatology》2002,72(1-2):55-64

Summary Attempts to use the 4-parameter Kappa distribution (K4D) with the maximum likelihood estimates (MLE) on the summer extreme daily rainfall data at 61 gauging stations over South Korea have been made to obtain reliable quantile estimates for several return periods. A numerical algorithm for searching MLE of K4D by minimizing the negative log-likelihood function with penalty method has been described. The isopluvial maps of estimated design values corresponding to selected return periods have been presented. The highest return values are centered at sites in the south-western part of the Korean peninsula. The distribution of return values for annual maxima of 2-day precipitation (AMP2) is more similar to the climatological features of annual total precipitation of Korea than that of annual maxima of daily precipitation (AMP1). Our results of return values delineate well the horizontal patterns of the heavy precipitation over the Korean peninsula. Received January 15, 2001 Revised October 8, 2001  相似文献   

Structural damage detection using the optimal weights of the approximating artificial neural networks     

Shih‐Lin Hung  C. Y. Kao 《地震工程与结构动力学》2002,31(2):217-234

This work presents a novel neural network‐based approach to detect structural damage. The proposed approach comprises two steps. The first step, system identification, involves using neural system identification networks (NSINs) to identify the undamaged and damaged states of a structural system. The partial derivatives of the outputs with respect to the inputs of the NSIN, which identifies the system in a certain undamaged or damaged state, have a negligible variation with different system errors. This loosely defined unique property enables these partial derivatives to quantitatively indicate system damage from the model parameters. The second step, structural damage detection, involves using the neural damage detection network (NDDN) to detect the location and extent of the structural damage. The input to the NDDN is taken as the aforementioned partial derivatives of NSIN, and the output of the NDDN identifies the damage level for each member in the structure. Moreover, SDOF and MDOF examples are presented to demonstrate the feasibility of using the proposed method for damage detection of linear structures. Copyright © 2001 John Wiley & Sons, Ltd.  相似文献   

A mathematical hysteretic model for elastomeric isolation bearings     

J. S. Hwang  J. D. Wu  T.‐C. Pan  G. Yang 《地震工程与结构动力学》2002,31(4):771-789

An analytical model for high damping elastomeric isolation bearings is presented in this paper. The model is used to describe mathematically the damping force and restoring force of the rubber material and bearing. Ten parameters to be identified from cyclic loading tests are included in the model. The sensitivity of the ten parameters in affecting the model is examined. These ten parameters are functions of a number of influence factors on the elastomer such as the rubber compound, Mullins effect, scragging effect, frequency, temperature and axial load. In this study, however, only the Mullins effect, scragging effect, frequency and temperature are investigated. Both material tests and shaking table tests were performed to validate the proposed model. Based on the comparison between the experimental and the analytical results, it is found that the proposed analytical model is capable of predicting the shear force–displacement hysteresis very accurately for both rubber material and bearing under cyclic loading reversals. The seismic response time histories of the bearing can also be captured, using the proposed analytical model, with a practically acceptable precision. Copyright © 2002 John Wiley & Sons, Ltd.  相似文献   

Tests on low‐ductility RC frames under high‐ and low‐frequency excitations     

Ser‐Tong Quek  Chengmei Bian  Xilin Lu  Wensheng Lu  Haibei Xiong 《地震工程与结构动力学》2002,31(2):459-474

The response of low‐ductility reinforced concrete (RC) frames, designed typically for a non‐seismic region, subjected to two frequencies of base excitations is studied. Five half‐scaled, two‐bay, two‐storey, RC frames, each approximately 5 m wide by 3.3 m high, were subjected to both horizontal and/or vertical base excitations with a frequency of 40 Hz as well as a lower frequency of about 4 Hz (close to the fundamental frequency) using a shake table. The imposed acceleration amplitude ranged from 0.2 to 1.2g. The test results showed that the response characteristics of the structures differed under high‐ and low‐frequency excitations. The frames were able to sustain high‐frequency excitations without damage but were inadequate for low‐frequency excitations, even though the frames exhibited some ductility. Linear‐elastic time‐history analysis can predict reasonably well the structural response under high‐frequency excitations. As the frames were not designed for seismic loads, the reinforcement detailing may not have been adequate, based on the crack pattern observed. The effect of vertical excitation can cause significant additional forces in the columns and moment reversals in the beams. The ‘strong‐column, weak‐beam’ approach for lateral load RC frame design is supported by experimental observations. Copyright © 2001 John Wiley & Sons, Ltd.  相似文献   

Optimal design of passive energy dissipation systems based on H∞ and H2 performances     

J. N. Yang  S. Lin  J‐H. Kim  A. K. Agrawal 《地震工程与结构动力学》2002,31(4):921-936

Passive energy dissipation devices (EDDs), such as viscous dampers, viscoelastic dampers, etc., have been used to effectively reduce the dynamic response of civil infrastructures, such as buildings and bridges, subject to earthquakes and strong winds. The design of these passive energy dissipation devices (EDDs) involves the determination of the optimal locations and the corresponding capacities. In this paper, we present two optimal design methodologies for passive EDDs based on active control theories, including H_∞ and H₂ performances, respectively. The optimal design methodologies presented are capable of determining the optimal locations and the corresponding capacities of EDDs. Emphasis is placed on the application of linear matrix inequality (LMI) for the effective design of passive EDDs using the popular MATLAB toolboxes. One important advantage of the proposed approaches is that the computation of the structural response is not needed in the design process. The proposed optimal design methodologies have been applied to: (i) a 10‐storey building and a 24‐storey building both subject to earthquake excitations, and (ii) a 76‐storey wind‐excited benchmark building, to demonstrate the advantages of the proposed design methodologies over the conventional equal capacity design. Copyright © 2002 John Wiley & Sons, Ltd.  相似文献   

Study on effects of damping in laminated rubber bearings on seismic responses for a ⅛ scale isolated test structure     

Bong Yoo  Yang‐Hann Kim 《地震工程与结构动力学》2002,31(10):1777-1792

The effects of damping in various laminated rubber bearings (LRB) on the seismic response of a ?‐scale isolated test structure are investigated by shaking table tests and seismic response analyses. A series of shaking table tests of the structure were performed for a fixed base design and for a base isolation design. Two different types of LRB were used: natural rubber bearings (NRB) and lead rubber bearings (LLRB). Three different designs for the LLRB were tested; each design had a different diameter of lead plug, and thus, different damping values. Artificial time histories of peak ground acceleration 0.4g were used in both the tests and the analyses. In both shaking table tests and analyses, as expected, the acceleration responses of the seismically isolated test structure were considerably reduced. However, the shear displacement at the isolators was increased. To reduce the shear displacement in the isolators, the diameter of the lead plug in the LLRB had to be enlarged to increase isolator damping by more than 24%. This caused the isolator stiffness to increase, and resulted in amplifying the floor acceleration response spectra of the isolated test structure in the higher frequency ranges with a monotonic reduction of isolator shear displacement. Copyright © 2002 John Wiley & Sons, Ltd.  相似文献   

Use of Chemotaxonomy To Study the Influence of Benzalkonium Chloride on Bacterial Populations in Biodegradation Testing     

Klaus Kümmerer  Ali Al‐Ahmad  Almut Henninger 《洁净——土壤、空气、水》2002,30(4):171-178

Contradictory results are reported for the behaviour of quaternary ammonium compounds (QACs) in sewage treatment plants (STPs). QACs may sorb onto activated sludge. Only little information is available with respect to effects of QACs against bacteria in STPs. Only 5 to 15 % of bacteria present in sewage sludge can be detected by means of culture dependent microbiological methods. The shift of the bacterial populations due to effects of test compounds have not been studied up to now with culture independent methods. The microbial populations shift was studied in situ using culture independent chemotaxonomy profiling ubiquinones and polyamines. Additionally, toxic effects of QACs against bacteria present in the test vessels of the Zahn‐Wellens test (OECD 302 B) were assessed with a toxicity control in the test. The ubiquinone profiles representing changes in Gram‐negative populations mainly showed that the activated sludge was affected only in test vessels containing benzalkonium chloride. According to chemotaxonomy Acinetobacter or/and some members of Pseudomonas spp. have been selected by benzalkonium chloride after some adaptation period (8 to 12 days).  相似文献   

Sediment yield and storage variations in the Négron River catchment (south western Parisian Basin,France) during the Holocene period     

Jean‐Jacques Macaire  Saïda Bellemlih  Christian Di‐Giovanni  Patrick De Luca  Lionel Visset  Jacques Bernard 《地球表面变化过程与地形》2002,27(9):991-1009

In the Négron River catchment area (162 km²), surface‐sediment stores are composed of periglacial calcareous ‘grèze’ (5 × 10⁶ t) and loess (21 × 10⁶ t), and Holocene alluvium (12·6 × 10⁶ t), peat (0·6 × 10⁶ t) and colluvium (18·5 × 10⁶ t). Seventy‐five per cent of the Holocene sediments is stored along the thalwegs. Present net sediment yield, calculated from solid discharge at the Négron outlet, is low (0·6 t km^?2 a^?1) due to the dominance of carbonate rocks in the catchment. Mean sediment yield during the Holocene period is 7·0 t km^?2 a^?1 from alluvium stores and 7·6 t km^?2 a^?1 from colluvium stores. Thus, the gross sediment yield during the Holocene period is about 18·7 t km^?2 a^?1 and the sediment delivery ratio 3 per cent. The yield considerably varies from one sub‐basin to another (3·9 to 24·5 t km^?2 a^?1) according to lithology: about 25 per cent and 50 per cent of initial stores of periglacial grèze and loess respectively were reworked during the Holocene period. Sediment yield has increased by a factor of 6 in the last 1000 years, due to the development of agriculture. The very high rate of sediment storage on the slope during that period (88 per cent of the yield) can be accounted for by the formation of cultivation steps (‘rideaux’). It is predicted that the current destruction of these steps will result in a sediment wave reaching the valley floors in the coming decades. Subboreal and Subatlantic sediments and pollen assemblages in the Taligny marsh, where one‐third of the alluvium is stored, show the predominant influence of human activity during these periods in the Négron catchment. Copyright © 2002 John Wiley & Sons, Ltd.  相似文献