Structural similarity and variety at the tips in a wide range of strike–slip faults: a review     

Young‐Seog Kim  David J. Sanderson 《地学学报》2006,18(5):330-344

Strike–slip faults are often accompanied by a variety of structures, particularly at their tips. The zones of additional fracturing are classified as tip‐damage zones. These zones can be subdivided into several different damage patterns based on the nature and orientation of faults and fractures developed. Damage zones at the ends of small strike–slip faults (mode II tips) develop wing cracks, horsetail splays, antithetic faults, synthetic branch faults and solution surfaces. Similar tip‐damage patterns are also commonly observed at larger (regional) scales, but with a dominance of faulting over tensile cracks and solution surfaces. Wing cracks and horsetail splays developed at small‐scale faults are replaced by normal faults in large‐scale faults. Antithetic faults and synthetic branch faults are observed at small and large scales. Thrust faults are developed at large scales, in a similar pattern to solution surfaces at a small scale. All these structures may show slightly different angular relationships to the master fault at small and large scale, but develop in response similar stress distribution and mechanics around the fault. Thus, mode II tip‐damage zones show similar patterns over a wide range of fault scales.  相似文献   

The vulnerability of karst springs—a case study of the Hubelj spring (SW Slovenia)   总被引：3，自引：0，他引：3  

B. Trček  M. Veselič  J. Pezdič 《Environmental Geology》2006,49(6):865-874

The hydraulic behaviour of the karst aquifer in the Hubelj spring catchment area (SW Slovenia) was studied by using an indirect research method based on natural tracers. The variations of natural tracers (in precipitation and in groundwater) during the storm event made possible the separation of the Hubelj spring storm hydrograph by the three-component separation technique. The results produced information on the aquifer recharge, storage and discharge processes, as well as on the mechanisms that affected them. They verified the so-called epikarst hypothesis presuming that an important part of a karst aquifer recharge reaches rapidly and intensively from the epikarst zone. It was demonstrated that epikarst water could occupy up to 50% of the spring discharge during precipitation events. This phenomenon could have important consequences on protection and management of the problems of karst aquifers, including engineering problems in karst areas. With this respect the results could give way to new engineering ideas.  相似文献   

Food Deserts in the Prairies? Supermarket Accessibility and Neighborhood Need in Edmonton,Canada*     

Karen E. Smoyer‐Tomic  John C. Spence  Carl Amrhein 《The Professional geographer》2006,58(3):307-326

The U.S. and U.K. literatures have discussed “food deserts,” reflecting populated, typically urban, low‐income areas with limited access to full‐service supermarkets. Less is known about supermarket accessibility within Canadian cities. This article uses the minimum distance and coverage methods to determine supermarket accessibility within the city of Edmonton, Canada, with a focus on high‐need and inner‐city neighborhoods. The results show that for 1999 both of these areas generally had higher accessibility than the remainder of the city, but six high‐need neighborhoods had poor supermarket accessibility. We conclude by examining potential reasons for differences in supermarket accessibility between Canadian, U.S., and U.K. cities.  相似文献   

Geometry and accuracy of reflecting points in bistatic satellite altimetry     

J. Kostelecký  J. Klokočník  C.A. Wagner 《Journal of Geodesy》2005,79(8):421-430

The analysis of the time and space distribution of specular (reflecting) points in bistatic altimetry between GPS and CHAMP satellites or SAC-C (taken as examples) is extended from Wagner and Klokočník (2003 J. Geod 77: 128–138). We demonstrate a significantly higher number and density of reflecting points in bistatic altimetry in comparison with traditional monostatic altimetry. After an outline of our older accuracy assessment for the vertical position of the reflecting point, we add a new independent derivation and compare both approaches. We account for orbit errors of both the transmitters (GPS) and receiver (CHAMP) satellites, and the measurement (delay) error. We found that the accuracy of the vertical position of the reflecting point decreases only slowly with increasing off-nadir angle and that the orbit errors must be accounted for if decimeter and better accuracy is required. In this paper, we do not study errors such as state of the ocean, technical parameters of the receiving system, and atmospheric corrections.  相似文献   

Structural damage detection using the optimal weights of the approximating artificial neural networks     

Shih‐Lin Hung  C. Y. Kao 《地震工程与结构动力学》2002,31(2):217-234

This work presents a novel neural network‐based approach to detect structural damage. The proposed approach comprises two steps. The first step, system identification, involves using neural system identification networks (NSINs) to identify the undamaged and damaged states of a structural system. The partial derivatives of the outputs with respect to the inputs of the NSIN, which identifies the system in a certain undamaged or damaged state, have a negligible variation with different system errors. This loosely defined unique property enables these partial derivatives to quantitatively indicate system damage from the model parameters. The second step, structural damage detection, involves using the neural damage detection network (NDDN) to detect the location and extent of the structural damage. The input to the NDDN is taken as the aforementioned partial derivatives of NSIN, and the output of the NDDN identifies the damage level for each member in the structure. Moreover, SDOF and MDOF examples are presented to demonstrate the feasibility of using the proposed method for damage detection of linear structures. Copyright © 2001 John Wiley & Sons, Ltd.  相似文献   

A mathematical hysteretic model for elastomeric isolation bearings     

J. S. Hwang  J. D. Wu  T.‐C. Pan  G. Yang 《地震工程与结构动力学》2002,31(4):771-789

An analytical model for high damping elastomeric isolation bearings is presented in this paper. The model is used to describe mathematically the damping force and restoring force of the rubber material and bearing. Ten parameters to be identified from cyclic loading tests are included in the model. The sensitivity of the ten parameters in affecting the model is examined. These ten parameters are functions of a number of influence factors on the elastomer such as the rubber compound, Mullins effect, scragging effect, frequency, temperature and axial load. In this study, however, only the Mullins effect, scragging effect, frequency and temperature are investigated. Both material tests and shaking table tests were performed to validate the proposed model. Based on the comparison between the experimental and the analytical results, it is found that the proposed analytical model is capable of predicting the shear force–displacement hysteresis very accurately for both rubber material and bearing under cyclic loading reversals. The seismic response time histories of the bearing can also be captured, using the proposed analytical model, with a practically acceptable precision. Copyright © 2002 John Wiley & Sons, Ltd.  相似文献   

Tests on low‐ductility RC frames under high‐ and low‐frequency excitations     

Ser‐Tong Quek  Chengmei Bian  Xilin Lu  Wensheng Lu  Haibei Xiong 《地震工程与结构动力学》2002,31(2):459-474

The response of low‐ductility reinforced concrete (RC) frames, designed typically for a non‐seismic region, subjected to two frequencies of base excitations is studied. Five half‐scaled, two‐bay, two‐storey, RC frames, each approximately 5 m wide by 3.3 m high, were subjected to both horizontal and/or vertical base excitations with a frequency of 40 Hz as well as a lower frequency of about 4 Hz (close to the fundamental frequency) using a shake table. The imposed acceleration amplitude ranged from 0.2 to 1.2g. The test results showed that the response characteristics of the structures differed under high‐ and low‐frequency excitations. The frames were able to sustain high‐frequency excitations without damage but were inadequate for low‐frequency excitations, even though the frames exhibited some ductility. Linear‐elastic time‐history analysis can predict reasonably well the structural response under high‐frequency excitations. As the frames were not designed for seismic loads, the reinforcement detailing may not have been adequate, based on the crack pattern observed. The effect of vertical excitation can cause significant additional forces in the columns and moment reversals in the beams. The ‘strong‐column, weak‐beam’ approach for lateral load RC frame design is supported by experimental observations. Copyright © 2001 John Wiley & Sons, Ltd.  相似文献   

Optimal design of passive energy dissipation systems based on H∞ and H2 performances     

J. N. Yang  S. Lin  J‐H. Kim  A. K. Agrawal 《地震工程与结构动力学》2002,31(4):921-936

Passive energy dissipation devices (EDDs), such as viscous dampers, viscoelastic dampers, etc., have been used to effectively reduce the dynamic response of civil infrastructures, such as buildings and bridges, subject to earthquakes and strong winds. The design of these passive energy dissipation devices (EDDs) involves the determination of the optimal locations and the corresponding capacities. In this paper, we present two optimal design methodologies for passive EDDs based on active control theories, including H_∞ and H₂ performances, respectively. The optimal design methodologies presented are capable of determining the optimal locations and the corresponding capacities of EDDs. Emphasis is placed on the application of linear matrix inequality (LMI) for the effective design of passive EDDs using the popular MATLAB toolboxes. One important advantage of the proposed approaches is that the computation of the structural response is not needed in the design process. The proposed optimal design methodologies have been applied to: (i) a 10‐storey building and a 24‐storey building both subject to earthquake excitations, and (ii) a 76‐storey wind‐excited benchmark building, to demonstrate the advantages of the proposed design methodologies over the conventional equal capacity design. Copyright © 2002 John Wiley & Sons, Ltd.  相似文献   

Study on effects of damping in laminated rubber bearings on seismic responses for a ⅛ scale isolated test structure     

Bong Yoo  Yang‐Hann Kim 《地震工程与结构动力学》2002,31(10):1777-1792

The effects of damping in various laminated rubber bearings (LRB) on the seismic response of a ?‐scale isolated test structure are investigated by shaking table tests and seismic response analyses. A series of shaking table tests of the structure were performed for a fixed base design and for a base isolation design. Two different types of LRB were used: natural rubber bearings (NRB) and lead rubber bearings (LLRB). Three different designs for the LLRB were tested; each design had a different diameter of lead plug, and thus, different damping values. Artificial time histories of peak ground acceleration 0.4g were used in both the tests and the analyses. In both shaking table tests and analyses, as expected, the acceleration responses of the seismically isolated test structure were considerably reduced. However, the shear displacement at the isolators was increased. To reduce the shear displacement in the isolators, the diameter of the lead plug in the LLRB had to be enlarged to increase isolator damping by more than 24%. This caused the isolator stiffness to increase, and resulted in amplifying the floor acceleration response spectra of the isolated test structure in the higher frequency ranges with a monotonic reduction of isolator shear displacement. Copyright © 2002 John Wiley & Sons, Ltd.  相似文献   

Thermal expansion and crystal structure of FeSi between 4 and 1173 K determined by time-of-flight neutron powder diffraction     

L. Vočadlo  K. S. Knight  G. D. Price  I. G. Wood 《Physics and Chemistry of Minerals》2002,29(2):132-139

The thermal expansion and crystal structure of FeSi has been determined by neutron powder diffraction between 4 and 1173?K. No evidence was seen of any structural or magnetic transitions at low temperatures. The average volumetric thermal expansion coefficient above room temperature was found to be 4.85(5)?×?10^?5?K^?1. The cell volume was fitted over the complete temperature range using Grüneisen approximations to the zero pressure equation of state, with the internal energy calculated via a Debye model; a Grüneisen second-order approximation gave the following parameters: θ_D=445(11)?K, V ₀=89.596(8)?ų, K ₀′=4.4(4) and γ′=2.33(3), where θ_D is the Debye temperature, V ₀ is V at T=0?K, K ₀′ is the first derivative with respect to pressure of the incompressibility and γ′ is a Grüneisen parameter. The thermodynamic Grüneisen parameter, γ_th, has been calculated from experimental data in the range 4–400?K. The crystal structure was found to be almost invariant with temperature. The thermal vibrations of the Fe atoms are almost isotropic at all temperatures; those of the Si atoms become more anisotropic as the temperature increases.  相似文献