华夏地块: 一个由古老物质组成的年轻陆块   总被引：26，自引：3，他引：26  

于津海  魏震洋  王丽娟  舒良树  孙涛 《高校地质学报》2006,12(4):440-447

对华夏地块三个主要前寒武纪地质体出露区变质岩的详细锆石年代学的综合分析显示，华夏地块大致可以被分成武夷山区和南岭-云开区。武夷山区由古元古代核和新元古代（形成于730-820 Ma）的盖层组成，构成华夏地块最老的古陆，在其深部很可能还存在一个新太古代基底。新元古代的沉积物主要来自武夷微古陆本身。南岭与云开具有相似的前寒武纪地壳组成，它们主要是由新元古代形成的沉积物夹少量火山岩组成。这些沉积物质中包含了非常古老的中太古代和新太古代组分，甚至古太古代组成。Grenville期和中元古代组分是其中最丰富的。这些组分在华夏没有对应出露的岩石，说明它们主要来自另外一个曾经与华夏相邻的陆块。该陆块很可能是东印度－东南极大陆。南岭－云开区最初可能是Rodinia超大陆裂解时形成的一个裂谷盆地，加里东的造山运动使盆地中的沉积物挤压、褶皱和隆起，与武夷陆块共同构成了一个新的年轻的大陆  相似文献   

东南沿海地震活动特征量     

周峥嵘  林树  鲍挺 《福建地震》2006,(Z2)

1970年以来,东南沿海地区经历了上世纪末以来明显的第Ⅴ活跃幕(或轮回)平静和活跃时段,本文通过分析研究这两个时段地震活动在时空强上的差异性,定量提取其活动演化过程参量,为该区未来地震活动期判定提供相对定量的参考依据。  相似文献   

多时相组合分类法在土地利用动态监测中的应用   总被引：16，自引：0，他引：16  

张红  舒宁  刘刚 《武汉大学学报(信息科学版)》2005,30(2):131-134

介绍了土地利用遥感动态监测的基本概念，简述了遥感土地利用变化信息提取等遥感监测方法．重点探讨了多时相组合分类方法的相关技术。对广西2002年和2003年两个时相的MODIS数据．采用多时相直接分类法对土地利用变化状况进行了遥感动态监测。对不同方式波段组合的试验表明。经过差值、比值处理的波段组合具有较差的试验效果(总体精度只有30％～40％)，而经过PCA变换的波段组合则具有相对较好的试验效果(总体精度超过70％)。  相似文献   

基于小波统计特性的遥感图像像素与特征联合最优融合方法   总被引：8，自引：0，他引：8  

肖刚  敬忠良  HenryLeung  王淑 《遥感学报》2005,9(4):381-386

遥感影像的IHS融合方法由于匹配误差导致光谱畸变和退化,而小波变换在变换域具有良好的分频特性,小波系数的统计特性反映了遥感影像的边缘、线和区域等显著特征。提出了基于小波统计特性的遥感影像的像素和特征联合最优融合方法,在IHS空间,对强度分量I的高频部分利用多分辨率小波融合方法进行影像的高频细节特征融合,低频部分选取光谱信息和空间分辨率评价指标作为融合权系数求优指标,进行像素级最优融合,实验结果证明了该方法的有效性。  相似文献   

三峡工程库区巴东县赵树岭滑坡稳定性与防治对策研究   总被引：16，自引：2，他引：16  

唐辉明  马淑芝等 《地球科学》2002,27(5):621-625

赵树岭滑坡是三峡工程库区的重要滑坡，其稳定性直接关系到巴东新县城沿江大道的安全，并对新县城土地利用意义重大。在阐述赵树岭滑坡基本特征的基础上，运用水岩耦合三维有限元数值方法模拟了滑坡稳定性，预测了三峡水库蓄水后滑坡稳定性发展趋势和渗流特征。研究表明，水库蓄水及水位波动是影响滑坡稳定性的主要因素，三峡水库蓄水后，滑坡将发生局部失稳，必须加以治理，提出了滑坡防治的原则与对策。  相似文献   

Structural damage detection using the optimal weights of the approximating artificial neural networks     

Shih‐Lin Hung  C. Y. Kao 《地震工程与结构动力学》2002,31(2):217-234

This work presents a novel neural network‐based approach to detect structural damage. The proposed approach comprises two steps. The first step, system identification, involves using neural system identification networks (NSINs) to identify the undamaged and damaged states of a structural system. The partial derivatives of the outputs with respect to the inputs of the NSIN, which identifies the system in a certain undamaged or damaged state, have a negligible variation with different system errors. This loosely defined unique property enables these partial derivatives to quantitatively indicate system damage from the model parameters. The second step, structural damage detection, involves using the neural damage detection network (NDDN) to detect the location and extent of the structural damage. The input to the NDDN is taken as the aforementioned partial derivatives of NSIN, and the output of the NDDN identifies the damage level for each member in the structure. Moreover, SDOF and MDOF examples are presented to demonstrate the feasibility of using the proposed method for damage detection of linear structures. Copyright © 2001 John Wiley & Sons, Ltd.  相似文献   

A mathematical hysteretic model for elastomeric isolation bearings     

J. S. Hwang  J. D. Wu  T.‐C. Pan  G. Yang 《地震工程与结构动力学》2002,31(4):771-789

An analytical model for high damping elastomeric isolation bearings is presented in this paper. The model is used to describe mathematically the damping force and restoring force of the rubber material and bearing. Ten parameters to be identified from cyclic loading tests are included in the model. The sensitivity of the ten parameters in affecting the model is examined. These ten parameters are functions of a number of influence factors on the elastomer such as the rubber compound, Mullins effect, scragging effect, frequency, temperature and axial load. In this study, however, only the Mullins effect, scragging effect, frequency and temperature are investigated. Both material tests and shaking table tests were performed to validate the proposed model. Based on the comparison between the experimental and the analytical results, it is found that the proposed analytical model is capable of predicting the shear force–displacement hysteresis very accurately for both rubber material and bearing under cyclic loading reversals. The seismic response time histories of the bearing can also be captured, using the proposed analytical model, with a practically acceptable precision. Copyright © 2002 John Wiley & Sons, Ltd.  相似文献   

Tests on low‐ductility RC frames under high‐ and low‐frequency excitations     

Ser‐Tong Quek  Chengmei Bian  Xilin Lu  Wensheng Lu  Haibei Xiong 《地震工程与结构动力学》2002,31(2):459-474

The response of low‐ductility reinforced concrete (RC) frames, designed typically for a non‐seismic region, subjected to two frequencies of base excitations is studied. Five half‐scaled, two‐bay, two‐storey, RC frames, each approximately 5 m wide by 3.3 m high, were subjected to both horizontal and/or vertical base excitations with a frequency of 40 Hz as well as a lower frequency of about 4 Hz (close to the fundamental frequency) using a shake table. The imposed acceleration amplitude ranged from 0.2 to 1.2g. The test results showed that the response characteristics of the structures differed under high‐ and low‐frequency excitations. The frames were able to sustain high‐frequency excitations without damage but were inadequate for low‐frequency excitations, even though the frames exhibited some ductility. Linear‐elastic time‐history analysis can predict reasonably well the structural response under high‐frequency excitations. As the frames were not designed for seismic loads, the reinforcement detailing may not have been adequate, based on the crack pattern observed. The effect of vertical excitation can cause significant additional forces in the columns and moment reversals in the beams. The ‘strong‐column, weak‐beam’ approach for lateral load RC frame design is supported by experimental observations. Copyright © 2001 John Wiley & Sons, Ltd.  相似文献   

Optimal design of passive energy dissipation systems based on H∞ and H2 performances     

J. N. Yang  S. Lin  J‐H. Kim  A. K. Agrawal 《地震工程与结构动力学》2002,31(4):921-936

Passive energy dissipation devices (EDDs), such as viscous dampers, viscoelastic dampers, etc., have been used to effectively reduce the dynamic response of civil infrastructures, such as buildings and bridges, subject to earthquakes and strong winds. The design of these passive energy dissipation devices (EDDs) involves the determination of the optimal locations and the corresponding capacities. In this paper, we present two optimal design methodologies for passive EDDs based on active control theories, including H_∞ and H₂ performances, respectively. The optimal design methodologies presented are capable of determining the optimal locations and the corresponding capacities of EDDs. Emphasis is placed on the application of linear matrix inequality (LMI) for the effective design of passive EDDs using the popular MATLAB toolboxes. One important advantage of the proposed approaches is that the computation of the structural response is not needed in the design process. The proposed optimal design methodologies have been applied to: (i) a 10‐storey building and a 24‐storey building both subject to earthquake excitations, and (ii) a 76‐storey wind‐excited benchmark building, to demonstrate the advantages of the proposed design methodologies over the conventional equal capacity design. Copyright © 2002 John Wiley & Sons, Ltd.  相似文献   

Study on effects of damping in laminated rubber bearings on seismic responses for a ⅛ scale isolated test structure     

Bong Yoo  Yang‐Hann Kim 《地震工程与结构动力学》2002,31(10):1777-1792

The effects of damping in various laminated rubber bearings (LRB) on the seismic response of a ?‐scale isolated test structure are investigated by shaking table tests and seismic response analyses. A series of shaking table tests of the structure were performed for a fixed base design and for a base isolation design. Two different types of LRB were used: natural rubber bearings (NRB) and lead rubber bearings (LLRB). Three different designs for the LLRB were tested; each design had a different diameter of lead plug, and thus, different damping values. Artificial time histories of peak ground acceleration 0.4g were used in both the tests and the analyses. In both shaking table tests and analyses, as expected, the acceleration responses of the seismically isolated test structure were considerably reduced. However, the shear displacement at the isolators was increased. To reduce the shear displacement in the isolators, the diameter of the lead plug in the LLRB had to be enlarged to increase isolator damping by more than 24%. This caused the isolator stiffness to increase, and resulted in amplifying the floor acceleration response spectra of the isolated test structure in the higher frequency ranges with a monotonic reduction of isolator shear displacement. Copyright © 2002 John Wiley & Sons, Ltd.  相似文献