A Modeling Study of the Effects of Anomalous Snow Cover over the Tibetan Plateau upon the South Asian Summer Monsoon   总被引：1，自引：0，他引：1  

刘华强  孙照渤王举 闵锦忠 《大气科学进展》2004,21(6):964-975

The effect of anomalous snow cover over the Tibetan Plateau upon the South Asian summer monsoon is investigated by numerical simulations using the NCAR regional climate model (RegCM2) into which gravity wave drag has been introduced. The simulations adopt relatively realistic snow mass forcings based on Scanning Multi-channel Microwave Radiometer (SNINIR) pentad snow depth data. The physical mechanism and spatial structure of the sensitivity of the South Asian early summer monsoon to snow cover anomaly over the Tibetan Plateau are revealed. The main results are summarized as follows. The heavier than normal snow cover over the Plateau can obviously reduce the shortwave radiation absorbed by surface through the albedo effect, which is compensated by weaker upward sensible heat flux associated with colder surface temperature, whereas the effects of snow melting and evaporation are relatively smaller.The anomalies of surface heat fluxes can last until June and become unobvious in July. The decrease of the Plateau surface temperature caused by heavier snow cover reaches its maximum value from late April to early May. The atmospheric cooling in the mid-upper troposphere over the Plateau and its surrounding areas is most obvious in May and can keep a fairly strong intensity in June. In contrast, there is warming to the south of the Plateau in the mid-lower troposphere from April to June with a maximum value in May.The heavier snow cover over the Plateau can reduce the intensity of the South Asian summer monsoon and rainfall to some extent, but this influence is only obvious in early summer and almost disappears in later stages.  相似文献   

The role of the seismic trigger in the Calitri landslide (Italy): historical reconstruction and dynamic analysis   总被引：2，自引：0，他引：2  

Salvatore Martino  Gabriele Scarascia Mugnozza 《Soil Dynamics and Earthquake Engineering》2005,25(12):933-950

The study covered by this paper was focused on the historical case of the Calitri landslide, which was repeatedly reactivated by earthquakes, as reported since 1694. The town of Calitri (Southern Italy) is located on a ridge whose southern slope, from its top to the Ofanto river valley floor, has been historically affected by major landsliding. The last record of recurrence of the Calitri landslide leads back to the 1980 Irpinia earthquake, which caused significant damage to the town and had pervasive and visible ground effects. Based on a detailed historical reconstruction of landsliding and seismicity at Calitri, the study analysed the current static and dynamic stability of the landsliding slope by means of a finite-difference numerical analysis, taking into account the various factors of landslide initiation and kinematics. The results of the numerical analysis: (i) were consistent with the roto-translational mechanism observed upon the latest reactivation of the landslide; (ii) demonstrated that excess pore pressure redistribution caused a lag between the seismic trigger and the initiation of landsliding; and (iii) showed the impact of seismic input frequency on propagation and depth of slope instability.  相似文献   

Tetrahedral Plots of the Phase Relations for Basalts     

Sven Maal?e  Richard N. Abbott Jr. 《Mathematical Geology》2005,37(8):869-893

The phase relations of quaternary systems are generally represented by projections onto ternary compositional planes. Such projections often obscure relationships that would only be evident in a three-dimensional tetrahedral plot. The tetrahedral plot requires that compositions of the minerals and melts be transformed into Cartesian coordinates. It is shown here how this transformation is carried out. The application is demonstrated by tetrahedral plots of experimental melt compositions of partially molten lherzolite. Furthermore, the plot can be used to evaluate whether or not a particular basaltic composition represents a primary melt. The methods are applicable to any four-component system.  相似文献   

Multispecies dendroclimatic reconstructions of summer temperature in the European Alps enhanced by trees highly sensitive to temperature     

Giovanni Leonelli  Anna Coppola  Carlo Baroni  Maria Cristina Salvatore  Maurizio Maugeri  Michele Brunetti  Manuela Pelfini 《Climatic change》2016,137(1-2):275-291

  相似文献   

Spatially controlled Fe and Si isotope variations: an alternative view on the formation of the Torres del Paine pluton     

Norbert?A.?GajosEmail author  Craig?C.?Lundstrom  Alexander?H.?Taylor 《Contributions to Mineralogy and Petrology》2016,171(11):93

We present new Fe and Si isotope ratio data for the Torres del Paine igneous complex in southern Chile. The multi-composition pluton consists of an approximately 1 km vertical exposure of homogenous granite overlying a contemporaneous 250-m-thick mafic gabbro suite. This first-of-its-kind spatially dependent Fe and Si isotope investigation of a convergent margin-related pluton aims to understand the nature of granite and silicic igneous rock formation. Results collected by MC-ICP-MS show a trend of increasing δ⁵⁶Fe and δ³⁰Si with increasing silica content as well as a systematic increase in δ⁵⁶Fe away from the mafic base of the pluton. The marginal Torres del Paine granites have heavier Fe isotope signatures (δ⁵⁶Fe = +0.25 ± 0.02 2se) compared to granites found in the interior pluton (δ⁵⁶Fe = +0.17 ± 0.02 2se). Cerro Toro country rock values are isotopically light in both Fe and Si isotopic systems (δ⁵⁶Fe = +0.05 ± 0.02 ‰; δ³⁰Si = ?0.38 ± 0.07 ‰). The variations in the Fe and Si isotopic data cannot be accounted for by local assimilation of the wall rocks, in situ fractional crystallization, late-stage fluid exsolution or some combination of these processes. Instead, we conclude that thermal diffusion or source magma variation is the most likely process producing Fe isotope ratio variations in the Torres del Paine pluton.  相似文献   

封面及目录     

本刊编辑部 《岩矿测试》2016,35(4):I-IV

  相似文献   

Biogenic volatile compound emissions from a temperate forest,China: model simulation     

Jianhui?BaiEmail author  Tiffany?Duhl  Nan?Hao 《Journal of Atmospheric Chemistry》2016,73(1):29-59

Emissions of biogenic volatile organic compounds (BVOC) were measured using a relaxed eddy accumulation (REA) technique on an above-canopy tower in a temperate forest (Changbai Mountain, Jilin province, China) during the 2010 and 2011 summer seasons. Solar global radiation and photosynthetically active radiation (PAR) were also measured. Based on PAR energy dynamic balance, an empirical BVOC emission and PAR transfer model was developed that includes the processes of BVOC emissions and PAR transfer above the canopy level, including PAR absorption and consumption, and scattering by gases, liquids, and particles (GLPs). Simulated emissions of isoprene and monoterpenes were in agreement with observations. The averages of the relative estimator biases for the flux were 39.3 % for isoprene, and 27.1 % for monoterpenes in the 2010 and 2011 growing seasons, with NMSE (normalized mean square error) values of 0.133 and 0.101, respectively. The observed and simulated mean diurnal variations of isoprene and monoterpenes in the 2010 and 2011 growing seasons were evaluated for the validation of the empirical model. Under observed atmospheric conditions, the sensitivity analysis showed that emissions of isoprene and monoterpenes were more sensitive to changes in PAR than to water vapor content or to the magnitude of the scattering factor. The emissions of isoprene and monoterpenes in the 2010 and 2011 growing seasons (from June to September) were estimated using this empirical model along with hourly observational data, with mean hourly emissions of 1.71 and 1.55 mg m^?2 h^?1 for isoprene, and 0.48 and 0.47 mg m^?2 h^?1 for monoterpenes in 2010 and 2011, respectively. As formaldehyde (HCHO) is considered as the main oxidation product of isoprene and monoterpenes, it is necessary to investigate the link between HCHO and BVOC emissions. GOME-2 HCHO vertical column densities (VCDs) can be used to estimate BVOC emission fluxes in the Changbai Mountain temperate forest.  相似文献   

Projected changes of rainfall seasonality and dry spells in a high greenhouse gas emissions scenario     

Salvatore Pascale  Valerio Lucarini  Xue Feng  Amilcare Porporato  Shabeh ul Hasson 《Climate Dynamics》2016,46(3-4):1331-1350

  相似文献   

Initiation of large-volume silicic centers in the Yellowstone hotspot track: insights from H<Subscript>2</Subscript>O- and F-rich quartz-hosted rhyolitic melt inclusions in the Arbon Valley Tuff of the Snake River Plain     

Dana?L.?DrewEmail author  Ilya?N.?Bindeman  Matthew?W.?Loewen  Paul?J.?Wallace 《Contributions to Mineralogy and Petrology》2016,171(1):10

During the onset of caldera cluster volcanism at a new location in the Snake River Plain (SRP), there is an increase in basalt fluxing into the crust and diverse silicic volcanic products are generated. The SRP contains abundant and compositionally diverse hot, dry, and often low-δ¹⁸O silicic volcanic rocks produced through time during the formation of individual caldera clusters, but more H₂O-rich eruptive products are rare. We report analyses of quartz-hosted melt inclusions from pumice clasts from the upper and lower Arbon Valley Tuff (AVT) to gain insight into the initiation of caldera cluster volcanism. The AVT, a voluminous, caldera-forming rhyolite, represents the commencement of volcanism (10.44 Ma) at the Picabo volcanic field of the Yellowstone hotspot track. This is a normal δ¹⁸O rhyolite consisting of early and late erupted members (lower and upper AVT, respectively) with extremely radiogenic Sr isotopes and unradiogenic Nd isotopes, requiring that ~50 % of the mass of these elements is derived from melts of Archean upper crust. Our data reveal distinctive features of the early erupted lower AVT melt including: variable F concentrations up to 1.4 wt%, homogenous and low Cl concentrations (~0.08 wt%), H₂O contents ranging from 2.3 to 6.4 wt%, CO₂ contents ranging from 79 to 410 ppm, and enrichment of incompatible elements compared to the late erupted AVT, subsequent Picabo rhyolites, SRP rhyolites, and melt inclusions from other metaluminous rhyolites (e.g., Bishop Tuff, Mesa Falls Tuff). We couple melt inclusion data with Ti measurements and cathodoluminescence (CL) imaging of the host quartz phenocrysts to elucidate the petrogenetic evolution of the AVT rhyolitic magma. We observe complex and multistage CL zoning patterns, the most critical being multiple truncations indicative of several dissolution–reprecipitation episodes with bright CL cores (higher Ti) and occasional bright CL rims (higher Ti). We interpret the high H₂O, F, F/Cl, and incompatible trace element concentrations in the context of a model involving melting of Archean crust and mixing of the crustal melt with basaltic differentiates, followed by multiple stages of fractional crystallization, remelting, and melt extraction. This multistage process, which we refer to as distillation, is further supported by the complex CL zoning patterns in quartz. We interpret new Δ¹⁸O(Qz-Mt) isotope measurements, demonstrating a 0.4 ‰ or ~180 °C temperature difference, and strong Sr isotopic and chemical differences between the upper and lower AVT to represent two separate eruptions. Similarities between the AVT and the first caldera-forming eruptions of other caldera clusters in the SRP (Yellowstone, Heise and Bruneau Jarbidge) suggest that the more evolved, lower-temperature, more H₂O-rich rhyolites of the SRP are important in the initiation of a caldera cluster during the onset of plume impingement.  相似文献   

Recursive algorithm for fast GNSS orbit fitting   总被引：1，自引：0，他引：1  

Shuqiang?XueEmail author  Yuanxi?Yang 《GPS Solutions》2016,20(2):151-157

Gaussian elimination is an efficient and numerically stable algorithm for estimating parameters and their precision. However, before estimating the parameters, it is often prudent to perform statistical tests to achieve the best fitting model. We use Gaussian elimination to select the best fitting model among candidate models. A succinct relationship between the weighted sum of squared residuals and the previous one is revealed by a volume formula. For quick parameter estimation and determination of weighted sum of squared residuals, a recursive elimination algorithm is proposed in the context of Gaussian elimination. In order to improve the model selection efficiency, the parameter estimation and the determination of the weighted sum of squared residuals are carried out in parallel using the proposed recursive elimination algorithm in which the improvement at each recursive stage is judged by the Bayesian information criterion. Ultimately, the computational complexity and numerical stability of the recursive elimination proposed are briefly discussed, and a GNSS orbit interpolation example is used to verify the results. It shows that the proposed recursive elimination algorithm inherits the numerical stability of the Gaussian elimination, and this algorithm can be used to examine the gain from the newly introduced parameter, dynamically assess the fitting model, and fix the optimal model efficiently. The optimal fitting model with the lowest information is very close to the real situation verified by checkpoints.  相似文献