甲醛前处理对提取海带褐藻胶质与量的影响     

范晓  张燕霞  陈正霖  齐桂兰 《海洋科学集刊》1986,(26):65-72

褐藻胶(Na-alginate)工业在国外已有半个多世纪的历史,其工艺流程及生产设备等都日趋标准化,产品的种类及其在工业上的用途也走向多样化。我国在五十年代初期曾呈奎和纪明侯就用野生的马尾藻作为原料进行了褐藻胶的提取研究,井确立了褐藻胶的生产工艺,从而诞生了我国的褐藻胶工业。六十年代以来,由于海带的大量人工栽培，褐藻胶生产便采用海带作为原料,由此,这个新兴工业迅猛发展。目前,中国的褐藻胶生产的规模和产量在世界上已名列前矛,除了主产品褐藻胶以外,还同时生产甘露醇、碘等联产品。但这个工业还存在不少问题,特別是褐藻胶的粘度、透明度及色泽等质量指标是人们极为关切的问题。本文拟就海藻原料的前处理工艺对胶的质量和产量的影响做一系统的研究。  相似文献   

我国东部邻海恶劣天气的时空分布及其成因初探   总被引：2，自引：0，他引：2  

陈乾金  王伯民 《海洋预报》1993,10(1):10-19

本文利用1930～1979年NCDC海洋船舶观测的气象资料,分析了中国东部邻海恶劣天气的时空分布。结果表明,海区恶劣天气的分布在冬季和夏季是不同的;在东北和西南季风期间,台湾东北和西南海区也有差异。影响恶劣天气条件的分布因子非常复杂,主要是季风和极锋、天气系统、冷暖洋流及地形等因子。  相似文献   

McCreary和Fickian湍扩散形式差异的分析     

吴德星  李国璋  李宝辉  陈峰 《中国海洋大学学报(自然科学版)》1993,(Z2)

用矩阵方法,求解McCreary和Fickian铅垂向湍扩散形式下,无界海洋条件时在风应力和深层浮力作用下的线性解。得出不同的湍扩散系数A情况下McCreary与Fickian湍扩散形式的流场结构。指出随湍扩散系数的增加,McCreary和Fickian湍扩散形式下u分量结构及其量值差异增大。在Fickian湍扩散形式下,能量穿越密度跃层的传递能力较强。当A=0.1cm~2s~(-3)时,在风应力和深层浮力作用下两种湍扩散形式造成流场的差异很小。提出在小湍扩散系数下,用McCreary湍扩散形式研究热带海洋环流,其结果和Fickian形式应相当一致。  相似文献   

中国对虾镰刀菌病的细胞病理研究   总被引：2，自引：0，他引：2  

吴友吕  陈波 《海洋学研究》1992,10(4):21-26

本文报导中国对虾养成期病原体茄类镰刀菌Fusarium solani(Mart)的细微结构及其引起宿主的细胞病理变化,以便为该病的正确诊断和有效防治提供依据。  相似文献   

西沙群岛龙介虫科两新种   总被引：1，自引：0，他引：1  

陈木  吴宝玲 《海洋科学集刊》1978,(12):141-148

龙介虫科Serpulidae的盘管虫Hydroides栖于石灰质管内,又名石灰虫,营附着生活，是有害附着生物之一。它们大量附着在船底,影响航行速度;附着在软体动物的重要养殖种类(珍珠贝、鲍、牡蛎等)的贝売上面,影响贝类生长,危害贝类养殖事业。因此,进行龙介虫科分类,生态的研究,可为有害生物的防除工作提供基本资料。 1956年和1975年,中国科学院海洋研究所在我国西沙群岛考察时,在永兴岛和珊瑚岛采到龙介虫科,盘管虫属两个新种,描述如下：  相似文献   

Optimum design of filament-wound multilayer-sandwich submersible pressure hulls     

Cho-Chung Liang  Hung-Wen Chen  Chan-Yung Jen 《Ocean Engineering》2003,30(15):1941-1967

Submersible pressure hulls with fiber-reinforced multilayer-sandwich constructions have been developed in recent years as substitutes for classical metallic ring-stiffened pressure hulls. This study aims to optimize the design of filament-wound multilayer-sandwich submersible pressure hulls, taking into consideration the shell buckling strength constraint, the angle-ply laminated facing failure strength constraint and the low-density isotropic core yielding strength constraint under hydrostatic pressure using the hybrid genetic algorithm (HGA). The thickness of the facing, the thickness of the core layer, the orientation angle of the fibers in the facings and the shear modulus of the core material are taken as design variables. A sensitivity analysis is performed to study the effects of the operational depths and the hull shell geometry parameter, the length-to-diameter ratio (L/D), on the optimal design of filament-wound multilayer-sandwich submersible pressure hulls with graphite/epoxy, glass/epoxy and boron/epoxy composite facings. The results reveal that the optimal weight of various sandwich pressure hulls increases linearly with the operational depth, but it is almost unchanged as the geometry paramter. Furthermore, Graphite/Epoxy is the best choice for the material of the facings in a light-weight design. With reference to wall design, Boron/Epoxy is the best choice for the material of the facing at shallow depths, but Graphite/Epoxy is the best choice at extreme depths. Results of this study provide a valuable reference for designers of underwater vehicles.  相似文献   

中国南极长城湾及附近海区1993/1994年夏季表层水样无机氮、磷酸盐的浓度及其分布状况     

陈皓文  朱明远  洪旭光  陆华  袁峻峰 《海洋湖沼通报》1996,(4)

1993／1994年南极夏季对中国南极长城湾及附近海区表层海水四种营养盐浓度及其分布状况作了调查。结果表明，NH4－N、NO3－N、NO2－N及PO4－P的大致浓度分别是2．13、7．07、0．74和1．12μg·dm-3。一般来说，湾内高于湾外氮盐于12月份常出现高值。四种形态的无机盐类之最高、最低浓度出现的时间和站位不尽一致。∑N／P递减次序大致是12月，2月，1月。水温变化与NH4－N、PO4－P浓度和∑N／P的变化常较一致，而与NO2－N则常不一，一些站位上营养盐浓度偏低可能与浮游植物摄取有关。结果显示了调研海区的浅水内湾特征。浮游植物所需营养充分。该湾仍维持正常状态。  相似文献   

Regression Formulations for the Stress at Hot Spot of Multiplanar Tubular DT Joints     

Chen Tieyun Zhang Huiyuan Professor  Shanghai Jiao Tong University  Shanghai Doctor of Engineering  Shenzhen Shipbuilding Trading Co. LTD. 《中国海洋工程》1993,(1)

- Stress concentration analysis of multiplanar tubular DT joints plays an important role in the fatigue design of offshore platforms. A semi-analytic method for stress analysis under the condition of any loads is briefly introduced in the paper. Nineteen multiplanar tubular DT joints with one of two braces of the same dimension subjected to axial loads and out- of- plane bending moments are computed for parametric stress analysis by using the present method. The influence of geometrical parameters on the stresses of multiplanar tubular DT joints is discussed and compared with corresponding uniplanar T joints. The regression formulae for the stress at hot spot of multiplanar DT joints are found by modification of SCF of corresponding uniplanar T joints. The parametric formulae for the maximum stress by superposition. Finally, the influences of stiffening effect and load-interaction effect on the maximum stress of DT joints are discussed.  相似文献   

Distribution of chlorophyll a and diatom in the sea ice of the Weddell Sea, Antarctica     

Chen Xingqun  Gerhard Dieckmann 《海洋学报(英文版)》1991,10(1):161-166

Diatoms are major primary producers of microbial biomass in the Antarctica. They are found in the water and sea ice. The distribution, abundance of the ice diatoms and their relation to the environmental factors inside and outside the ice have been studied for its special role in the Antarctic Ocean ecology. In this paper we describe the abundance, distribution and composition of diatom assemblages in  相似文献   

对虾暴发性流行病及其预防研究   总被引：1，自引：0，他引：1  

吴友吕  王方国 《海洋学研究》1995,13(2):1-8

１９９３～１９９４年我国沿海养殖对虾发生了特大的暴发性流行病，损失惨重。本文报道该病的特点、症状及危害，并在患病的中国对虾、日本对虾、长毛对虾的中肠、肝胰腺的上皮细胞核和细胞质及腹肌纤维间质中发现大量具有囊膜的杆状病毒。通过病毒引起宿主靶组织细胞的病理变化、无包涵体等特性分析，认为该病毒属于有囊膜杆状病毒科Ｃ亚群，不同于已知的对虾所有杆状病毒，为对虾的一类新致病病毒。文中还分析了主要致病原因，通过调查和试验提出８条有针对性的预防措施。  相似文献