全文获取类型
收费全文 | 516篇 |
免费 | 105篇 |
国内免费 | 218篇 |
专业分类
测绘学 | 115篇 |
大气科学 | 70篇 |
地球物理 | 80篇 |
地质学 | 323篇 |
海洋学 | 146篇 |
天文学 | 16篇 |
综合类 | 39篇 |
自然地理 | 50篇 |
出版年
2024年 | 7篇 |
2023年 | 19篇 |
2022年 | 35篇 |
2021年 | 38篇 |
2020年 | 31篇 |
2019年 | 41篇 |
2018年 | 29篇 |
2017年 | 15篇 |
2016年 | 19篇 |
2015年 | 27篇 |
2014年 | 38篇 |
2013年 | 41篇 |
2012年 | 43篇 |
2011年 | 59篇 |
2010年 | 46篇 |
2009年 | 45篇 |
2008年 | 43篇 |
2007年 | 38篇 |
2006年 | 38篇 |
2005年 | 35篇 |
2004年 | 30篇 |
2003年 | 25篇 |
2002年 | 27篇 |
2001年 | 21篇 |
2000年 | 14篇 |
1999年 | 7篇 |
1998年 | 6篇 |
1997年 | 1篇 |
1996年 | 2篇 |
1995年 | 3篇 |
1994年 | 7篇 |
1993年 | 2篇 |
1991年 | 3篇 |
1990年 | 1篇 |
1986年 | 1篇 |
1957年 | 2篇 |
排序方式: 共有839条查询结果,搜索用时 62 毫秒
31.
The compliant vertical access riser(CVAR) is a new riser concept with good compliance; it can significantly reduce operating costs by eliminating the need for additional machines to operate wells directly on the platform. In this study, we determined the optimal riser parameters in terms of the stress and riser weight by optimizing the CVAR, and we compared the optimization results. A two-dimensional nonlinear static CVAR model was deduced according to the principles of virtual work and variation, and the model was verified using MATLAB. Design of experiments and Kriging method were used to reduce the number of sample calculations and improve the modeling accuracy. An appropriate selection of the multi-objective optimization problem(MOP) and the non-dominated sorting genetic algorithm helped to optimize the CVAR design. The non-dominated sorting genetic algorithm II was used to solve the Pareto frontier of the optimization model in order to provide decision makers with more choices for the optimization results. After optimizing the riser parameters, the geometry of the riser was smoother, and the stress and stress differences were greatly reduced; the maximum equivalent stresses at the top and bottom were reduced by 36.6% and 44%, respectively. In addition, the stress difference in the buoyancy block area was reduced by 20.9%, and the weight of the riser was increased significantly by 28.1%. 相似文献
32.
研究东日本地震、汶川地震和玉树地震震中及其附近区域在地震前后的水汽时间序列变化。首先分析震中MODIS水汽序列和震中附近探空站点水汽序列在地震前后的变化;然后基于GNSS ZTD与水汽之间的高相关性,以GNSS ZTD代替GNSS水汽,讨论震源区周围IGS站点的ZTD序列变化。研究发现,震后震中及其附近区域水汽值变化出现异常,且距离越近所受影响越大;水汽不断聚积,达到峰值后发生降水。 相似文献
33.
在基于精密单点定位(PPP)的授时方法中,卫星钟差产品的高精度时间基准至关重要.针对实时卫星钟差产品时间基准不够稳定的问题,本文采用一组具有原子钟外部输入的国际全球卫星导航系统(GNSS)服务(IGS)跟踪站建立了顾及原子钟变化特性的基准精化方法.该方法首先采用阿伦方差对不同的IGS跟踪站外接原子钟进行稳定度分析,挑选出一组稳定度高的原子钟用以精化时间基准.在此基础上,利用阿伦方差分析各台原子钟的噪声参数特征,并确定不同原子钟之间的权比关系.最终,建立时间基准改正量的随机模型,并计算出精化后的时间基准.通过实例验证表明:与IGS事后精密钟差产品定义的时间基准比较,改正后的实时钟差基准单天内的标准差(STD)优于0.1 ns,相比于改正前最高提升了93%.同时,基准改正后的天内万秒稳达到10-15量级,实现了一个量级的提高.此外,通过相对钟差精度的分析,表明钟差基准修正不影响PPP的定位精度. 相似文献
34.
中国锂资源的分布具有卤水型与硬岩型相伴相随、若即若离的特点。“多旋回深循环内外生一体化”成锂理论,在多年三稀金属矿产找矿实践和理论研究的基础上不断丰富完善。中国锂矿的形成与“多旋回”构造运动密切相关,从前寒武纪到新生代均有成矿潜力,可构成一个完整的多旋回成矿谱系。锂的“深循环”,一是锂深度参与成岩成矿的物质循环;二是需要一个“圈闭”的构造背景将锂“捕获”以避免其过度分散,锂从开始加入到岩浆与最终定位的深度之差,是硬岩型锂矿成矿的关键之一,压差越大越有利于伟晶岩型锂矿的形成。大量锂矿实例显示锂的物质循环是“内外生一体化”的统一过程,高海拔地区(山上)的含锂地质体(花岗岩类甚至直接就是含锂矿床)经风化剥蚀之后,可能成为沉积型锂矿的物质来源之一;而富含锂的沉积岩经过埋藏、变质、深熔也可以形成含锂的岩浆岩、伟晶岩。我国西部塔里木盆地、四川盆地、扎布耶盆地及东部的江汉盆地、吉泰盆地、周田盆地等大小不一的盆地均含锂,而其周边造山带中也不同程度发育硬岩型锂矿,这就为区域找矿指明了方向。“多旋回深循环内外生一体化”成锂理论是三稀矿产成矿理论的重要组成部分,为我国锂矿找矿工作提供了指导和借鉴,在甲基卡、可尔因、阿尔金、幕阜山等锂矿矿集区的找矿实践中发挥了积极作用。 相似文献
35.
结合工程实例具体阐述当测斜管不能正常使用情况下运用全站仪代替测斜仪进行深基坑围护结构的倾斜测量,同时运用岩土工程相关知识对所得监测数据表现的变形及突变原因作了深入分析,获得了预期的安全监测成果,确保了深基坑工程的顺利实施。为今后类似情况的处理提供借鉴。 相似文献
36.
37.
38.
Experimental Study on Coupled Cross-Flow and in-Line Vortex-Induced Vibration of Flexible Risers 总被引:1,自引:1,他引:0
In this work, we study the coupled cross-flow and in-line vortex-induced vibration (VIV) of a fixedly mounted flexible pipe, which is free to move in cross-flow ( Y- ) and in-line ( X- ) direction in a fluid flow where the mass and natural frequencies are precisely the same in both X- and Y-direction. The fluid speed varies from low to high with the corresponding vortex shedding frequency varying from below the first natural frequency to above the second natural frequency of the flexible pipe. Particular emphasis was placed on the investigation of the relationship between in-line and cross-flow vibration. The experimental results analyzed by using these measurements exhibits several valuable features. 相似文献
39.
InSAR技术是近年来在SAR基础上发展起来的一种新技术,机载InSAR系统在国外已得到广泛应用.根据InSAR测量原理,在系统中需装有高精度的DGPS/IMU系统,测量雷达天线位置和基线倾角,用于求解地面目标点高程,但如何求解目标点平面坐标研究不多.在介绍了InSAR高程求解的基础上,结合SAR成像原理,使用高精度DGPS/IMU系统获取的数据,提出了平面坐标的求解方法,并使用实际的机载InSAR数据进行了试验.结果表明,利用提出的方法可以满足其精度要求. 相似文献
40.
基于AJAX的数据分页的设计与实现 总被引:3,自引:0,他引:3
针对传统数据分页存在用户等待时间较长的问题,提出一种基于AJAX的数据分页方法,并成功地在设备管理系统的查询模块上得到应用,实际应用的结果表明,在现有的Web应用中采用AJAX技术,能减轻服务器压力,提高系统的响应速度,减少用户的等待时间。首先对比了传统Web和标准AJAX的交互过程,接着介绍了A-JAX概念及核心技术,同时给出了结合AJAX和J2EE技术实现数据分页的例子。 相似文献