高分六号宽幅相机在轨几何定标及精度验证   总被引：1，自引：0，他引：1  

王密  郭贝贝  龙小祥  薛麟  程宇峰  金淑英  周晓 《测绘学报》2020,49(2):171-180

高分六号宽幅相机能够实现单相机成像幅宽优于800 km,对大尺度地表观测和环境监测具有独特优势。在轨几何定标是光学遥感卫星几何处理的关键环节,直接影响影像的几何质量。本文充分考虑高分六号宽幅相机超大视场的畸变特性以及多谱段的成像特点,提出宽幅相机在轨几何定标方法,采用基于探元指向角的几何定标模型补偿宽幅相机系统误差,通过绝对定标和相对定标方法联合估计各波段的内外定标参数。利用Landsat 8影像、资源三号DSM为参考数据,对宽幅相机进行绝对定标处理,再利用ASTER GDEM为参考数据进行相对定标处理,其几何定标结果表明,高分六号宽幅影像绝对定位精度在3像素左右,内部几何精度能稳定在1像素,且波段间配准精度在0.3像素以内,表明在轨几何定标后高分六号宽幅影像几何质量得到了明显的提升。  相似文献   

Global Statistical Assessment and Cross-Calibration with Jason-2 for Reprocessed HY-2 A Altimeter Data     

Maofei Jiang  Ke Xu  Yalong Liu 《Marine Geodesy》2018,41(3):289-312

HY-2 A (Haiyang-2 A) satellite was launched on August 16, 2011 and radar altimeter is one of its main payloads. We reprocessed two years of HY-2 A altimeter sensor geophysical dataset records (SGDR) data. This paper presents the main results in terms of reprocessed HY-2 A altimeter data quality: verification of data availability and validity, monitoring several relevant altimeter parameters, and assessment of the HY-2 A altimeter system performances. A cross-calibration analysis of reprocessed HY-2 A altimeter data with Jason-2 was conducted. The reprocessed HY-2 A altimeter data show good quality and have a low level of noise with respect to Jason-2. The same geophysical correction methods were used to calculate the sea surface height (SSH) for the two missions. The mean standard deviations of the crossover differences for HY-2 A and Jason-2 are 5.24 cm and 5.34 cm, respectively. The mean standard deviation of the crossover differences between HY-2 A and Jason-2 is 5.37 cm. These show that HY-2 A can provide SSH measurements at almost the same level of accuracy as Jason-2. The relative SSH bias between HY-2 A and Jason-2 due to the Ultra Stable Oscillator (USO) drift is obviously observed, and it can affect the calculation of mean sea level and should be further studied and corrected.  相似文献   

基于并行计算的海洋平台谱分析疲劳筛选技术研究     

李洛东  刘成名  梁园华 《海洋工程》2018,36(5):56-64

为了得到海洋平台疲劳失效风险最大的焊接区域,提出了以有限元网格单元应力为基础的谱分析筛选方法,并开发了程序。程序采用并行计算架构,单次完成数万个单元的累积损伤度/疲劳寿命计算,并通过有限元软件以云图方式显示疲劳寿命。采用该程序计算双浮筒半潜式平台的疲劳寿命。结果表明,该型平台疲劳失效风险较高的区域为立柱与上壳体下浮体连接对角线转角区域、浮筒中纵舱壁与立柱连接区域。并行计算方法的引入,大大缩减疲劳损伤度计算的分析时间,采用22核心的CPU,时间缩短为原来的1/18.5,17小时完成全平台外壳单元谱分析计算。  相似文献   

长江口南汇湿地植被的光谱吸收特征研究   总被引：1，自引：0，他引：1       下载免费PDF全文

张雪薇  韩震  刘美君  丁如一 《海洋学研究》2018,36(2):50-54

植被的光谱吸收特征与植被生长状况密切相关,同时也受土壤湿度等外界因素影响。本文以长江口南汇湿地典型植被芦苇、互花米草和海三棱藨草为研究对象,在计算其光谱特征参数的基础上,分析了这3种植被的光谱吸收特征形变PSDI值。最后结合实测的土壤湿度,分析了3种植被的PSDI值和土壤湿度的相关性。研究结果发现:互花米草的PSDI值最大,海三棱藨草的PSDI值最小,芦苇介于两者之间,表明互花米草受外界的环境影响较大;互花米草的PSDI值与土壤湿度的相关性最大,芦苇的PSDI值与土壤湿度的相关性最小,海三棱藨草介于两者之间,表明互花米草适应湿地环境能力较强。  相似文献   

黄海典型漂浮大型藻类光谱特征分析   总被引：2，自引：0，他引：2  

安德玉  邢前国  魏振宁  李琳 《海洋与湖沼》2018,49(5):1054-1060

利用实测高光谱和多光谱相机数据对在黄海海域采集的浒苔和马尾藻样本进行光谱特征分析。结果显示:漂浮大型藻类的高光谱反射率均值(Rmean_H)与多光谱反射率均值(Rmean_M)、高光谱藻类指数(VB-FAHH)与多光谱藻类指数(VB-FAHM)之间的相对误差小于15.6%,说明这两种数据具有较好的一致性;基于光谱特征波长的反射率建立比值光谱指数,其中浒苔和马尾藻的差异最为明显的是R640/R554指数;基于多光谱相机计算反射谷深度指数(T-depth),采用阈值法来区分浒苔和马尾藻,T-depth阈值的区分精度分别为69.6%±30.0%和69.6%±24.3%,稍优于虚拟基线漂浮藻类指数(VB-FAH)阈值的区分精度。  相似文献   

基于一维综合孔径微波辐射计的海面温度反演研究   总被引：1，自引：0，他引：1  

艾未华  冯梦延  陈冠宇  陆文 《海洋学报(英文版)》2020,42(5):115-122

Due to the low spatial resolution of sea surface temperature(T_S) retrieval by real aperture microwave radiometers,in this study, an iterative retrieval method that minimizes the differences between brightness temperature(T_B)measured and modeled was used to retrieve sea surface temperature with a one-dimensional synthetic aperture microwave radiometer, temporarily named 1 D-SAMR. Regarding the configuration of the radiometer, an angular resolution of 0.43° was reached by theoretical calculation. Experiments on sea surface temperature retrieval were carried out with ideal parameters; the results show that the main factors affecting the retrieval accuracy of sea surface temperature are the accuracy of radiometer calibration and the precision of auxiliary geophysical parameters. In the case of no auxiliary parameter errors, the greatest error in retrieved sea surface temperature is obtained at low T_S scene(i.e., 0.710 6 K for the incidence angle of 35° under the radiometer calibration accuracy of0.5 K). While errors on auxiliary parameters are assumed to follow a Gaussian distribution, the greatest error on retrieved sea surface temperature was 1.330 5 K at an incidence angle of 65° in poorly known sea surface wind speed(W)(the error on W of 1.0 m/s) over high W scene, for the radiometer calibration accuracy of 0.5 K.  相似文献   

Sensitivity of soil parameters in unsaturated zone modelling and the relation between effective,laboratory and in situ estimates     

J. Mertens  H. Madsen  M. Kristensen  D. Jacques  J. Feyen 《水文研究》2005,19(8):1611-1633

Simulation of soil moisture content requires effective soil hydraulic parameters that are valid at the modelling scale. This study investigates how these parameters can be estimated by inverse modelling using soil moisture measurements at 25 locations at three different depths (at the surface, at 30 and 60 cm depth) on an 80 by 20 m hillslope. The study presents two global sensitivity analyses to investigate the sensitivity in simulated soil moisture content of the different hydraulic parameters used in a one‐dimensional unsaturated zone model based on Richards' equation. For estimation of the effective parameters the shuffled complex evolution algorithm is applied. These estimated parameters are compared to their measured laboratory and in situ equivalents. Soil hydraulic functions were estimated in the laboratory on 100 cm³ undisturbed soil cores collected at 115 locations situated in two horizons in three profile pits along the hillslope. Furthermore, in situ field saturated hydraulic conductivity was estimated at 120 locations using single‐ring pressure infiltrometer measurements. The sensitivity analysis of 13 soil physical parameters (saturated hydraulic conductivity (K_s), saturated moisture content (θ_s), residual moisture content (θ_r), inverse of the air‐entry value (α), van Genuchten shape parameter (n), Averjanov shape parameter (N) for both horizons, and depth (d) from surface to B horizon) in a two‐layer single column model showed that the parameter N is the least sensitive parameter. K_s of both horizons, θ_s of the A horizon and d were found to be the most sensitive parameters. Distributions over all locations of the effective parameters and the distributions of the estimated soil physical parameters from the undisturbed soil samples and the single‐ring pressure infiltrometer estimates were found significantly different at a 5% level for all parameters except for α of the A horizon and K_s and θ_s of the B horizon. Different reasons are discussed to explain these large differences. Copyright © 2004 John Wiley & Sons, Ltd.  相似文献   

基于光谱角匹配算法的水体信息提取研究     

齐庆超  张小磊  金江峰  金玉玲 《测绘与空间地理信息》2016,(2):93-96

针对水体信息提取时,传统算法不能较好地解决山体阴影被误提为水体的问题,引入多用于高光谱数据处理的光谱角匹配算法,以Land-sat8 OLI(band1-band7)为数据源,以黄河小浪底水库周边区域为实验区,开展水体信息提取研究,结果显示:水体指数法和波段关系提取的结果中有大量的山体阴影信息,提取精度不超过30%,而光谱角匹配法提取结果受阴影的影响较小,提取精度在99%以上。  相似文献   

高分二号卫星影像融合方法探析   总被引：2，自引：0，他引：2  

熊德峰 《测绘与空间地理信息》2016,(9)

图像融合技术是卫星影像处理过程中的一个重要步骤,它可以将全色影像的高空间分辨率特点与多光谱影像的高光谱分辨率特点有机地结合起来,使得融合后的影像更利于后续解译。由于融合处理方法的原理以及获取影像的传感器特性不同,不同的卫星影像适合于不同的融合方法。针对高分二号卫星影像的特点,本文采用Gram-Schmidt融合法、FIHS变换方法、HPF方法、Pansharp方法进行试验。实验结果表明:HPF方法所得融合结果在光谱特性保持方法性能最优,而Pansharp方法融合结果在信息量的保持以及清晰度方面效果更优,因此,在实际应用中,应根据具体需求进行方法选择。  相似文献   

国产机载LiDAR系统安置角误差检校方案研究   总被引：1，自引：0，他引：1  

谢劭峰  刘田龙 《测绘与空间地理信息》2016,(6):50-55

机载激光扫描仪(Light Detection And Ranging,LiDAR)系统是由多个子系统集成,其中,安置角误差是集成误差中最大的误差源,安置角误差检校的方法多种多样,高效率、高精度的检校方式还需要试验的支撑。本文对平差模型法和几何模型法进行了试验分析,试验结果很好地证明了不同方法的优越性,为机载LiDAR系统的安置角检校提供了参考。  相似文献