利用地质成果优化3010皮带上山设计     

邱尔强 《中国煤田地质》2004,16(Z1):89-90

3010皮带上 山 建成 后将 担 负着 范各 庄 矿三 水平 、四 水平 的 煤炭 运输 任 务,服务 年 限要 求 至 少 30a。 此 皮 带上山 位于 岩 溶陷 落柱 较 发育 的井 口 区域 ,范 各庄 矿 发现 的 12个 陷落 柱 全部 位于 此 区域 。由 于 陷落 柱直 接 导通 下部 奥 灰水 ,一 旦揭 露 将有 淹没 整 个矿 井的 危 险。为 保 证矿 井安 全 ,在 工程 施工 前 ,利用 地 质手 段对 设 计区 域进 行 了探 查,发现皮 带上 山 的中 上部 发 育有 岩溶 陷 落柱 ,两 次对 设 计进 行了 修 改,为 施 工提 供了 安 全保 障。  相似文献   

黄河上游梯级水电站施工洪水优化设计方法探讨--以黄河公伯峡水电站施工洪水优化设计为例   总被引：1，自引：0，他引：1  

杨百银 《水文》2004,24(1):22-27

梯级水电站设计洪水方法一直是梯级水电站水文设计的难点．几十年来在黄河上游梯级电站设计中已总结出一套比较完整的设计洪水及施工洪水计算方法。通过黄河公伯峡水电站施工洪水优化设计过程，论述了该套方法．并就目前存在的一些观点及疑问给予了较为明确的回答。  相似文献   

探测冰盖和多年冻土层的融冰探头研发     

Norbert I. K 《冰川冻土》2004,26(Z1):310-318

The exploration of ice sheets by melting vertical holes into the ground has some tradition in terrestrial glaciology. Such probes have been used since the 1960's to investigate the vertical structure of the ice in Greenland and Antarctica and in alpine glaciers. In this paper we look into the possibility to develop similar devices for use on extraterrestrial icy bodies, like e.g. the polar areas on Mars or the icy satellites of the outer solar system. We report on some basic experiments performed in the cryo-vacuum laboratory of the Space Research Institute of the Austrian Academy of Sciences, Graz. In these experiments the penetration of a simple melting probe into compact and porous water ice (with a snow-like texture) was monitored, both under vacuum conditions and under air pressure. The observed penetration speeds for a given power supply are compared with a simple mathematical model. We conclude that a miniature melting probe with small overall dimensions and a reasonable power demand could well be part of the payload of a future planetary mission, for example to the poles of Mars. Such missions are currently under discussion in several space agencies. Moreover such probes could also e? ectively be used in terrestrial environments. A possible design is presented at the end of the paper.  相似文献   

Design Earthquakes in the U.K.     

R.M.W. Musson 《Bulletin of Earthquake Engineering》2004,2(1):101-112

Three sites in the UK are taken, representative of low, medium and high hazard levels (by UK standards). For each site, the hazard value at 10⁻⁴ annual probability is computed using a generic seismic source model, and a variety of ground motion parameters: peak ground acceleration (PGA), spectral acceleration at 10 Hz and 1 Hz, and intensity. Disaggregation is used to determine the nature of the earthquakes most likely to generate these hazard values. It is found (as might be expected) that the populations are quite different according to which ground motion parameter is used. When PGA is used, the result is a rather flat magnitude distribution with a tendency to low magnitude events (\le 4.5 ML) which are probably not really hazardous. Hazard-consistent scenario earthquakes computed using intensity are found to be in the range 5.8–5.9 ML, which is more in accord with the type of earthquake that one expects to be a worst-case event in the UK. This revised version was published online in July 2006 with corrections to the Cover Date.  相似文献   

Strain field measurements of rubber by image analysis and design criteria for laminated rubber bearings (LRB)     

Chamindalal Sujeewa Lewangamage  Masato Abe  Yozo Fujino  Junji Yoshida 《地震工程与结构动力学》2004,33(4):445-464

Although seismic isolation rubber bearings in bridges and buildings have proven to be a very effective passive method for reducing earthquake‐induced forces, a detailed mechanical modeling of the rubber that is used in bearings under large strains has not been established. Therefore, a 3D model of failure behavior and the design criteria for the safety evaluation of seismic isolation bearings have not yet been developed. This paper presents: (1) correlation‐based template‐matching algorithms to measure large strain fields of continua; (2) a failure criterion for rubber; and (3) the design criteria for the safety evaluation of laminated algorithms, data‐validation algorithms were developed and implemented to eliminate possible unrealistic displacement vectors present in the measured displacement field. The algorithms were successfully employed in the strain field measurement of LRB and rubber materials that are subjected to failure. The measured local strains for rubber material at failure were used to develop a failure criterion for rubber. The validity of the proposed criterion was evaluated by applying it to the LRB; the criterion was introduced into a 3D finite element model of LRB, compared with the experimental results of bearings failure, and verified. Finally, design criteria are proposed for LRB for the safety evaluation. Copyright © 2003 John Wiley & Sons, Ltd.  相似文献   

Optimal design of viscoelastic dampers using eigenvalue assignment   总被引：1，自引：0，他引：1  

Sang‐Hyun Lee  Dong‐In Son  Jinkoo Kim  Kyung‐Won Min 《地震工程与结构动力学》2004,33(4):521-542

In this study a procedure for determining the optimum size and location of viscoelastic dampers is proposed using the eigenvalue assignment technique. Natural frequencies and modal damping ratios, required to realize a given target response, are determined first by the convex model. Then the desired dynamic structural properties are realized by optimally distributing the damping and stiffness coefficients of viscoelastic dampers using non‐linear programming based on the gradient of eigenvalues. This optimization method provides information on the optimal location as well as the magnitude of the damper parameters. The proposed procedure is applied to the retrofit of a 10‐story shear frame, and to a three‐dimensional structure with an asymmetric plan. The analysis results confirm that the responses of model structures retrofitted by the proposed method correspond well with the given target response. Copyright © 2003 John Wiley & Sons, Ltd.  相似文献   

LBG算法对初始码书敏感的实验性能分析   总被引：5，自引：0，他引：5  

王茂芝  徐文皙 《物探化探计算技术》2004,26(4):374-378

介绍矢量量化的基本概念及其算法—LBG算法。指出LBG算法的缺陷，并针对LBG算法对初始码书敏感这一缺陷进行分析。同时还分析了LBG算法对几种不同初始码书的实验性能，得到了一种度量初始码书性能“优、劣”的方法，并提出了一种性能优良、操作简便的初始码书生成方法—等间隔法。最后，针对LBG算法对初始码书敏感这一缺陷给出了一些改进方向。  相似文献   

Evaluating accuracy for two empirical methods in predicting settlement of drilled shafts     

Azm S. Al-Homoud  T. Fouad  Ahmed Mokhtar 《Geotechnical and Geological Engineering》2004,22(2):245-267

Several theoretical, empirical and semi-empirical methods are available in the literature to predict settlement of drilled shafts in sandy soils. In the Arabian Gulf countries, specifically in the United Arab Emirates, equations and procedure from the rest of the world are being used in analysis and design of drilled shafts without proper validation. It is the aim of this study to assess the applicability and evaluate the accuracy of two well known, and commonly used methods for pile prediction in the United Arab Emirates (UAE), namely Vesic (1977) and Poulos (1979), via comparison with data from field pile load tests conducted on shafts drilled in the region. Some of these tests were conducted for the purpose of this study, while others were made available through the courtesy of International Piling Contractors who are active in the region (e.g. Bauer International and Swiss Borings). Pile load test data were analyzed to back-calculate the model parameters related to settlement under different loading stages. Geological data and soil properties were obtained from studies conducted at the relevant sites. An effort is made to correlate soil properties with the prediction models. Statistical analysis is conducted to assess the accuracy of the results obtained from the two methods at different stages of loading via those obtained from pile load tests. Moreover, a detailed parametric study is conducted to assess the effect of the related parameters on the predicted pile settlement and the estimated settlement at different stages of loading. The study concluded with a recommendation of the most appropriate models and procedures to be followed for predicting the settlement of drilled shafts in the UAE, together with useful charts and correlation relations. Results showed that settlement values predicted by Vesic (1977) and Poulos (1979) overestimates the true values. This revised version was published online in July 2006 with corrections to the Cover Date.  相似文献   

Design of backfilled thin-seam coal pillars using earth pressure theory     

James G. Donovan  Mario G. Karfakis 《Geotechnical and Geological Engineering》2004,22(4):627-642

In underground coal mining any increase in coal recovery rate is dependent on a decrease in pillar size. Backfilling is one way of reducing the required size of pillars and hence the volume of coal left underground. Therefore any comparisons made between a self-supported mine layout and backfill supported mine layout are based directly on pillar design. The most effective way to examine the effect of backfill on pillar support, and subsequently the rate of recovery, would be to incorporate the mechanisms of backfill support directly into the current design procedure for coal pillars. This paper presents a review of the mechanics of backfill support, a method of estimating the magnitude of that support based on earth pressure theory, and an example that incorporates backfill support into current coal pillar design.  相似文献   

攀西生物资源综合开发的项目设计与时序     

方一平 《山地学报》2004,(Z1)

从攀西生物资源综合开发的指导思想、设计思路和总体目标出发,对生物资源综合开发的项目和实施时序进行系统的设计。对项目实施的时间序列按照三个阶段进行划分:一是生物资源开发的起步阶段(2003-2008); 二是生物资源开发的发展阶段(2009-2015);三是生物资源开发的提高阶段(2016-2020)。生物资源综合开发项目设计按项目层次分:24个国家级项目,39个地方级项目;按资源开发类型分:木本果品类9项,纤维及造纸类3 项,木本油脂类2项,中药材开发与生物制药类8项,生活保健类10项,淀粉类1项,观赏植物及花卉产业开发类5 项,香精香料类2项,特色农业类3项,经济作物类3项,饲料类1项,真菌类3项,生物农药类2项,动物类2项,生态功能类5项,生态旅游类4项;按自然地域分:攀枝花自然地域28项,西昌-德昌自然地域35项,会理-会东自然地域7项;按项目类型分:科技攻关项目20项,科技示范与技术推广项目14项,产业化项目36项。  相似文献