抚顺发电厂变形规律浅析     

孙岐发  陈建国 《测绘与空间地理信息》2008,31(4)

抚顺发电厂是一座坑口发电厂,受采煤等多种复杂人为及地质因素的影响,厂区发生一系列的变形和破坏.本文基于观测成果对厂区变形规律进行了分析.  相似文献   

全站仪断面测量方法   总被引：1，自引：0，他引：1  

高斌  鹿罡  赵宝军 《测绘与空间地理信息》2008,31(4)

从野外断面测量的角度出发,主要讨论全站仪在断面测量中的野外观测方法、数据处理思路以及相应的软件研制.  相似文献   

应用综合勘查方法分析平朔安太堡三号井工矿突水原因     

陆家河 《中国煤炭地质》2008,(7):43-46

平朔公司安太堡三号井工矿2007年3月在首采工作面辅运顺槽掘进时,迎头冒顶突水,初期突水量达6000～8000m^3/d,将1289．16m标高以下淹没。在分析研究区地层、构造及水文地质条件的基础上,对沙沟河道进行了渗漏观测,对地表排污水、沟水和井下突水点的水质进行了分析化验,有针对性的布置了6条物探线,最后进行了钻孔验证,综合分析认为突水水源主要为大沙沟河道的侧向补给,突水通道为NW向的强风化带。提出了加大井下排水,地表对大沙沟河进行土工膜防渗处理的综合治理措施。  相似文献   

努力提高三维地震勘探精度，为西部煤炭工业做出新贡献     

孙升林 《中国煤炭地质》2008,(6):1-5

以国家重大产业技术开发专项“西部煤炭资源高精度三维地震勘探技术”项目的由来、意义和总体研究目标为引,概括的介绍了项目依托工程中各个专项技术研究完成情况,并对非均匀介质成像技术、高精度三维地震静校正技术、高密度采集技术、特观技术、岩性反演技术、属性体解释技术等六项重大关键技术取得的突破性进展进行了重点说明。指出随着我国煤炭生产重点的逐步西移,应加强诸如叠前、叠后深度偏移技术的研究,以解决复杂山区三维地震面元内地震反射波散射问题,提高其三维地震勘探精度,为西部煤炭工业做出新贡献!  相似文献   

On some problems of seismic crustal phase     

葛焕称 《地震学报(英文版)》1995,8(1):57-63

ＯｎｓｏｍｅｐｒｏｂｌｅｍｓｏｆｓｅｉｓｍｉｃｃｒｕｓｔａｌｐｈａｓｅＨｕａｎ－ＣｈｅｎｇＧＥ（葛焕称）（ＳｅｉｓｍｏｌｏｇｉｃａｌＢｕｒｅａｕｏｆＪｉａｎｇｓｕＰｒｏｖｉｎｃｅ,Ｎａｎｊｉｎｇ２１００１４,Ｃｈｉｎａ）Ａｂｓｔｒａｃｔ：Ｉｎｔｈｉｓ...  相似文献   

微震仪有线传输避雷研究     

陈仲范  耿大伏 《华北地震科学》1995,13(4):70-74

本文通过对雷电放电分析,研究解决微震仪有线传输的避雷问题,并介绍接收雷电信号控制传输线上电荷对地短路的“ＤＢＬ－１”避雷仪。  相似文献   

Transmission and reflection of Rayleigh waves at a thin low velocity vertical layer: A laboratory and theoretical study     

P. F. Biagi  T. S. Gegechkory  E. N. Its  P. Manjgaladze  V. Sgrigna  D. Zilpimiani 《Pure and Applied Geophysics》1990,133(2):317-327

A three-dimensional ultrasonic modelling was used to study the Rayleigh waves reflected from a thin low velocity vertical layer and those transmitted through the same zone. The reflection and transmission coefficients of the Rayleigh waves have been calculated by an approximate method based on the Green function technique. Nonrigid contact boundary conditions were used for the low velocity layer modelling. A rather good correspondence between the theoretical and experimental absolute values of the reflection and the transmission coefficients was obtained. Some discrepancies between experimental and theoretical results, in particular with regard to phase shifts, may be explained by a certain inadequacy of the theoretical model to the low velocity layer investigated by the ultrasonic modelling.  相似文献   

Thermal evolution of the orogenic lower crust during exhumation within a thickened Moldanubian root of the Variscan belt of Central Europe   总被引：4，自引：5，他引：4  

L. TAJ&#;MANOVá  J. KONOPÁSEK  K. SCHULMANN 《Journal of Metamorphic Geology》2006,24(2):119-134

At the eastern margin of the Bohemian Massif (Variscan belt of Central Europe), large bodies of felsic granulite preserve mineral assemblages and structures developed during the early stages of exhumation of the orogenic lower continental crust within the Moldanubian orogenic root. The development of an early steep fabric is associated with east–west-oriented compression and vertical extrusion of the high-grade rocks into higher crustal levels. The high-pressure mineral assemblage Grt-Ky-Kfs-Pl-Qtz-Liq corresponds to metamorphic pressures of ∼18 kbar at ∼850 °C, which are minimum estimates, whereas crystallization of biotite occurred at 13 kbar and ∼790 °C during decompression with slight cooling. The late stages of the granulite exhumation were associated with lateral spreading of associated high-grade rocks over a middle crustal unit at ∼4 kbar and ∼700 °C, as estimated from accompanying cordierite-bearing gneisses. The internal structure of a contemporaneously intruded syenite is coherent with late structures developed in felsic granulites and surrounding gneisses, and the magma only locally explored the early subvertical fabric of the felsic granulite during emplacement. Consequently, the emplacement age of the syenite provides an independent constraint on the timing of the final stages of exhumation and allows calculation of exhumation and cooling rates, which for this part of the Variscan orogenic root are 2.9–3.5 mm yr⁻¹ and 7–9.4 °C Myr⁻¹, respectively. The final part of the temperature evolution shows very rapid cooling, which is interpreted as the result of juxtaposition of hot high-grade rocks with a cold upper-crustal lid.  相似文献   

Assessment of Marine Clay Improvement Under Reclamation Fills by in-situ Testing Methods     

A. Arulrajah  H. Nikraz  M. W. Bo 《Geotechnical and Geological Engineering》2006,24(2):219-226

In ground improvement projects with prefabricated vertical drains, the duration of the preloading period is set in advance based on the predetermined time rate of consolidation of the compressible layer. If prediction is accurately done, the required degree of consolidation is met at the pre-determined preloading time. As such, there is a requirement for in-situ tests to be carried out just prior to the removal of surcharge to assess the degree of consolidation of the improved ground. In-situ tests were carried out after 23 months of surcharge loading at the In-Situ Test Site within the Changi East Reclamation Project in the Republic of Singapore. In-situ testing works in this research study comprises the use of field vane shear, piezocone, flat dilatometer and self-boring pressuremeter. The in-situ tests were carried out to determine the shear strength and degree of consolidation of the Singapore marine clay at Changi after 23 months of surcharge loading. The In-Situ Test Site consisted of a Vertical Drain Area as well as an untreated Control Area. Both areas were located adjacent to each other and were surcharged simultaneously to the same level and surcharge left in place for a period of 23 months. Comparison was made between the in-situ test results of the Vertical Drain Area and the untreated Control Area.  相似文献   

紫色丘陵区不同土地利用方式下土壤活性有机碳垂直分布特征     

《山地学报》2006,24(B10):21-26

  相似文献