排序方式： 共有69条查询结果，搜索用时 15 毫秒
31.
Open Fissure Folds hosted by high pressure/low temperature metamorphic rocks of south Evia (Greece) are introduced, their structural and microstructural record is analysed, and a mechanical model is proposed. Open Fissure Folds are preserved as at least two parallel folded quartz–feldspar veins separated by narrow buckled rock columns. The veins originated as tensile cracks that propagated in the middle crust driven by high differential stress. Features diagnostic for Open Fissure Folds indicate that the rock columns represented the layers of high viscosity, and not the veins as consistently reported in many previous studies on folded veins. This record is taken to indicate that buckling of the rock columns initiated after arrest of the fractures and terminated prior to complete vein sealing. Accordingly, mechanical decoupling by open fissures allowed for buckling of the rock columns in response to episodic creep of the host rocks according to stress relaxation, as expected for postseismic deformation in the earthquake cycle. I propose that the parental fractures propagated in response to quasi-instantaneous coseismic loading of the middle crust. Buckling was attributed to transient postseismic creep and stress relaxation. Complete sealing of the veins occurred when stresses were largely relaxed. Each Open Fissure Fold records the stress and strain history of a single earthquake. 相似文献
32.
Considerable research has recently been undertaken to investigate the simulation of brittle fracture mechanisms using distinct element grain boundary models. However, to date, few studies have addressed the limitations of these models when used for predictive analysis. Our research suggests that mesh geometry dependencies can impart irreducible uncertainties into the method despite apparent calibration. In addition, Voronoi meshing routines can limit the kinematic freedom, and increase the degree of interlocking and localized tensile failure; whereas, more recently introduced triangular mesh geometries can have an opposite effect, increasing kinematic freedom, and predisposing models towards shear failure mechanisms. 相似文献
33.
地震b值与地应力具有密切的关系,即高应力对应低b值,研究汶川地震区b值的时空变化可以获得地震前后的应力演化过程.本文通过震源位置和速度模型联合反演的方法和双差定位法对龙门山地区汶川地震(M_s8.0)前后的地震进行了重定位工作,在此基础上精确计算了汶川地震前后不同时间段内b值大小的变化趋势及b值空间分布.结果显示:(1)b值在深度上存在明显的分层性,15 km以上b值较高,15 km以下b值较低,反映上部岩石为脆性,下部岩石为韧性的特征;(2)区域平均b值在汶川地震之后出现下降,而后有所恢复并逐渐增加,芦山地震后又降低,反映了龙门山断裂带的同震变化和震后愈合过程;(3)分时段b值空间分布结果显示,在芦山地震之后,汶川地震破裂区b值下降,即应力增加,这意味着汶川芦山地震之间的空段存在韧性变形,且芦山地震的发生促进了汶川地震破裂区的愈合;(4)映秀附近彭灌杂岩区在震前呈现低b值异常,反映该区域存在较大的差应力,可能是震后最大位错发生在该区域的根本原因. 相似文献
34.
35.
A combined finite-discrete element approach is used to simulate the complete 3D fracture process during conventional laboratory testing, including Brazilian indirect tension and uniaxial and biaxial compression. A typical granite rock type (based on the Lac du Bonnet granite) was simulated to investigate the fracture pattern and mechanical strength of brittle rock in the laboratory. Damage intensity parameters (D21 and D32) are introduced and utilized to characterize the induced damage in the models. These parameters provide an improved representation of the cumulative associated damage and facilitate a quantitative characterization of crack intensity during testing. The numerical simulations included both 3D and 2D models, and show that there is a good agreement between the strength response derived from simulations both in 3D and 2D and the considered rock material. A good correlation also exists between the fracture pattern in 3D and the equivalent 2D models. The influence of confinement on the biaxial strength and the associated damage in compression is investigated. While axial splitting is the dominant failure mode at low confinement, finite-discrete element simulations show that a shear failure mode tends to dominate as the confinement increases. The dependency of dilation upon the confining pressure is also demonstrated, the dilation angle decreasing with increased confinement. 相似文献
36.
37.
Rock fracture under upper crustal conditions is driven not only by applied stresses, but also by time-dependent, chemically activated subcritical cracking processes. These subcritical processes are of great importance for the understanding of the mechanical behaviour of rocks over geological timescales. A macroscopic manifestation of time-dependency in the brittle field is the observation that rocks can deform and fail at constant applied stresses, a phenomenon known as brittle creep. Here, we review the available experimental evidence for brittle creep in crustal rocks, and the various models developed to explain the observations. Laboratory experiments have shown that brittle creep occurs in all major rock types, and that creep strain rates are extremely sensitive to the environmental conditions: differential stress, confining pressure, temperature and pore fluid composition. Even small changes in any of these parameters produce order of magnitude changes in creep strain rates (and times-to-failure). Three main classes of brittle creep model have been proposed to explain these observations: phenomenological, statistical, and micromechanical. Statistical and micromechanical models explain qualitatively how the increasing influence of microcrack interactions and/or the increasing accumulated damage produces the observed evolution of macroscopic deformation during brittle creep. However, no current model can predict quantitatively all of the observed features of brittle creep. Experimental data are limited by the timescale over which experiments are realistically feasible. Clearly, an extension of the range of available laboratory data to lower strain rates, and the development of new modelling approaches are needed to further improve our current understanding of time-dependent brittle deformation in rocks. 相似文献
38.
39.
本文主要以郯庐断裂带现代侵蚀面上五种不同类型的断裂构造和断层岩石为例,论述大断层带中岩石变形的二相性特征,包括机械意义的“韧性相”和“脆性相”应变组分在变形过程中的作用和意义。在此基础上探讨一种可能的地震成因方式 相似文献
40.
关于八卦庙超大型金矿床成矿建造分析 总被引：7，自引：3，他引：4
陕西凤县八卦庙特大型金矿床赋存于上泥盆统星红铺组下岩段一套半深海细碎屑岩浊积岩相中, 成矿作用主要受脆—韧性剪切活动控制。通过成矿建造分析研究, 具体阐述八卦庙金矿床的形成演化、成因及成矿模式。据八卦庙金矿床的成矿特点, 将八卦庙金矿床的形成演化划分为生矿建造、含矿建造、造矿建造和容矿建造。并将控矿构造内容引入成矿建造概念中。 相似文献