Lidar-aided analysis of boreal forest backscatter at Ku band     

《International Journal of Applied Earth Observation and Geoinformation》2020

This paper analyzes the backscatter of the microwave signal in a boreal forest environment based on a Ku -band airborne Frequency-Modulated Continuous Waveform (FMCW) profiling radar—Tomoradar. We selected a half-managed boreal forest in the southern part of Finland for a field test. By decomposing the waveform collected by the Tomoradar, the vertical canopy structure was achieved. Based on the amplitude of the waveform, the Backscattered Energy Ratio of Canopy-to-Total (BERCT) was calculated. Meanwhile, the canopy fraction was derived from the corresponding point cloud recorded by a Velodyne VLP-16 LiDAR mounted on the same platform. Lidar-derived canopy fraction was obtained by counting the number of the first/ the strongest returns versus the total amount of returns. Qualitative and quantitative analysis of radar-derived BERCT on lidar-derived canopy fraction and canopy height are investigated. A fitted model is derived to describe the Ku-band microwave backscatter in the boreal forest to numerically analyze the proportion contributed by four factors: lidar-derived canopy fraction, radar-derived canopy height, the radar-derived distance between trees and radar sensor and other factors, from co-polarization Tomoradar measurements. The Root Mean Squared Error (RMSE) of the proposed model was 0.0958, and the coefficient of determination R2 was 0.912. The fitted model reveals that the correlation coefficient between radar-derived BERCT and lidar-derived canopy fraction is 0.84, which illustrates that lidar surface reflection explains the majority of the profiling /waveform radar response. Thus, vertical canopy structure derived from lidar can be used for the benefit of radar analysis.  相似文献   

Characteristics of breaking irregular wave forces on a monopile     

《Applied Ocean Research》2019

The substructures of offshore wind turbines are subjected to extreme breaking irregular wave forces. The present study is focused on investigating breaking irregular wave forces on a monopile using a computational fluid dynamics (CFD) based numerical model. The breaking irregular wave forces on a monopile mounted on a slope are investigated with a numerical wave tank. The experimental and numerical irregular free surface elevations are compared in the frequency-domain for the different locations in the vicinity of the cylinder. A numerical analysis is performed for different wave steepness cases to understand the influence of wave steepness on the breaking irregular wave loads. The wave height transformation and energy level evolution during the wave shoaling and wave breaking processes is investigated. The higher-frequency components generated during the wave breaking process are observed to play a significant role in initiating the secondary force peaks. The free surface elevation skewness and spectral bandwidth during the wave transformation process are analysed and an investigation is performed to establish a correlation of these parameters with the breaking irregular wave forces. The role of the horizontal wave-induced water particle velocity at the free surface and free surface pressure in determining the breaking wave loads is highlighted. The higher-frequency components in the velocity and pressure spectrum are observed to be significant in influencing the secondary peaks in the breaking wave force spectrum.  相似文献   

杭州湾中部实测波浪特性分析   总被引：1，自引：0，他引：1  

杨斌  杨忠良  叶钦  张俊彪  施伟勇 《海洋工程》2018,36(3):96-103

利用杭州湾中部一年实测波浪资料,分析该地区的波参数统计变化特性,采用最小二乘法拟合得出相关参数之间的关系式,并统计分析了频谱特性。结果表明:杭州湾中部以小浪和轻浪为主,在各月分布较为均匀,年平均周期为2.97 s;最大一次波浪过程为冷空气影响所致,影响强度大于台风莫拉克;常浪向分布在东北至东南向,其中又以小浪出现较多,对应的波周期以2~4 s为主;强浪向主要分布在西北和东北方向,对应的波周期主要分布在3~5 s;多数特征波参数之间相关关系较好;由谱分析得知风浪占多数,且以单峰为主。研究结果可为相关工程和理论研究提供基础资料。  相似文献   

基于SODA资料的南海表层风能输入的空间分布与长期趋势研究     

杨倩  崔超然  张宇  刘志宇  管玉平  黄瑞新 《热带海洋学报》2018,37(6):41-48

海面风不仅是驱动上层海洋运动的主要动力, 其能量也是维持海洋表层流动的主要机械能来源。为了分析南海表层流风能输入的变化, 用SODA(Simple Ocean Data Assimilation)(1901—2010)资料估算了风向南海表层流(表层地转流+表层非地转流)的能量输入。结果表明, 风向南海表层流、表层地转流和表层非地转流输入的能量总体均呈减少趋势, 110年间分别减小了约56%、65%和49%。导致风能输入减小的最主要因素是风应力的减弱(减小了35%)。由于南海受季风系统的控制, 风向表层流及其各成分输入的能量呈现出显著的季节性变化。冬季风能输入最强, 高值区位于南海西部及北部区域, 呈一个显著的“回力镖”状结构。这些结果对深入认识南海环流具有理论意义。  相似文献   

利用超快速精密星历约束的北斗卫星实时精密定轨     

范磊  施闯  李敏 《大地测量与地球动力学》2018,38(9):937-942

以广播星历为起算轨道的北斗卫星实时滤波精密定轨往往需要较长收敛时间，针对此，提出利用超快速精密星历约束的实时精密定轨方法。通过MGEX跟踪网全球分布的51个测站连续7 d的实测数据，利用平方根信息滤波对北斗卫星实时精密轨道进行确定，并以3 d解事后轨道作为参考，评估北斗卫星实时滤波轨道精度。结果表明，利用广播星历作起算轨道时，北斗实时滤波轨道平均需要经过15 h收敛才能达到稳定，而新方法在这段时间内轨道变化较为平稳，未出现明显的收敛现象，并且7 d时间内GEO卫星在切向、法向和径向上RMS分别优于2.5 m、20 cm和30 cm，IGSO和MEO卫星在3个方向上分别优于30 cm、15 cm和10 cm。
  相似文献   

基于高斯两步移动搜寻法的村镇避难场所可达性研究     

但文羽  肖映辉  胡周灵  詹庆明 《地球信息科学学报》2018,20(10):1412-1421

避难场所可达性是指避难场所与受灾居民之间的通达性,即灾害发生时,避难人员通过避难疏散通道到达避难场所的难易程度,是评价避难场所布局合理性的重要指标。本研究结合高斯两步移动搜寻法和网络分析法,从供需双向出发对村镇地区避难场所进行可达性分析。2种方法的结合,既充分考虑了需求点与设施点的相互作用,又充分考虑了设施点的吸引力随距离的衰减关系,并基于实际道路,以步行疏散时间作为搜索半径,降低了传统研究中因忽略供需间相互作用及实际距离而引起的可达性结果的误差。最后,以神农架松柏镇区为例,验证该方法的实际应用价值。结果表明,该方法能够有效测定村镇地区避难场所的空间可达性,同时,基于GIS软件可以直观地揭示研究区域内避难场所可达性空间分布差异。该方法可为制定科学的村镇防灾减灾规划提供方法支持。  相似文献   

非线性波消波及波场分布研究   总被引：1，自引：1，他引：0  

王巧莎  李明海 《海洋科学》2018,42(6):30-38

本文基于雷诺平均N-S方程,并结合RNG k-e方程建立了粘性数值波浪水槽,对不同波陡、不同相对水深、不同相对波高的非线性规则波的阻尼消波问题和波场分布进行研究。文中提出了两种描述消波区内部阻尼变化的阻尼函数,分别适用于小波陡情形和高波陡情形。研究结果表明,小波陡组消波区可设为一个波长,阻尼系数取10~4～10~5即可满足消波要求,计算结果与实验结果及造波理论吻合良好;高波陡组消波区可设为两个波长,阻尼系数取10~4～10~5亦可满足消波要求,计算结果与实验结果吻合良好。此外,当波陡较小时,波场内反射情况的小幅改变即可对整个波场造成影响,特别是当水深较浅时这种影响极为明显,需谨慎考虑。当波陡较大时,水波能量较高,整个波场沿水波传播方向可观测到明显的衰减现象,在具体试验中需进行考虑。  相似文献   

基于GIS的石家庄市雾霾分析     

苏亚聪  史娟  徐爽 《北京测绘》2020,(2):233-237

为了得出雾霾气象成因机制、影响因素和时空分布特征,以石家庄市区与郊县为研究区域,将2013年9月至2016年12月石家庄市各市区、郊县的PM2.5历史监测数据中的有效数据进行了数据分析处理得到雾霾浓度数据,还有温度、降水、风速、地形和人口密度等数据,运用GIS分析的方法,模拟绘制石家庄雾霾的时空分布图、雾霾与各影响因子的专题对比图,得到雾霾形成机制的因子、雾霾的时空分布规律、雾霾季节变化特征、雾霾与地形间的关系等;运用数据分析软件OriginPro8.SR3分析雾霾浓度与风速数据、降雨数据、温度数据间的相关性。  相似文献   

Wave tank and bench-top control testing of a wave energy converter     

《Applied Ocean Research》2019

An increasing number of experiments are being conducted to study the design and performance of wave energy converters. Often in these tests, a real-time realization of prospective control algorithms is applied in order to assess and optimize energy absorption as well as other factors. This paper details the design and execution of an experiment for evaluating the capability of a model-scale WEC to execute basic control algorithms. Model-scale hardware, system, and experimental design are considered, with a focus on providing an experimental setup capable of meeting the dynamic requirements of a control system. To more efficiently execute such tests, a dry bench testing method is proposed and utilized to allow for controller tuning and to give an initial assessment of controller performance; this is followed by wave tank testing. The trends from the dry bench test and wave tank test results show good agreement with theory and confirm the ability of a relatively simple feedback controller to substantially improve energy absorption. Additionally, the dry bench testing approach is shown to be an effective and efficient means of designing and testing both controllers and actuator systems for wave energy converters.  相似文献   

基于MODIS数据的湖北省地级以上城市城区地表温度变化分析     

李韶颖  车风  邵军  陈涛  周婧娟 《测绘与空间地理信息》2020,(2):76-78

基于MODIS数据,以湖北省地级以上城市城区为研究对象,通过对湖北省13个地级以上城市城区边界矢量数据与地表温度因子进行套合处理,采用叠置分析方法对2000、2015、2017年湖北省地级以上城市城区的地表温度进行统计,并分析城镇化建设对城区地表温度产生的影响。  相似文献