Potential of the VLTI for linking stellar frames to ICRF     

Gérard Daigne  Patrick Charlot  Christine Ducourant  Jean-François Lestrade 《Astrophysics and Space Science》2003,286(1-2):255-260

The question of positioning the optical counterparts of the ICRF quasars is outlined in the perspective of future space astrometry missions, which ultimately will bring a new realization of the ICRS in the optical range. Ground-based interferometry with a dual-field observing mode (PRIMA/VLTI),together with the missions DIVA and FAME, will have a key role in building an extragalactic reference frame in the optical/near-IR range with about the same accuracy as that of the present (VLBI) primary frame. This revised version was published online in July 2006 with corrections to the Cover Date.  相似文献   

Tests on low‐ductility RC frames under high‐ and low‐frequency excitations     

Ser‐Tong Quek  Chengmei Bian  Xilin Lu  Wensheng Lu  Haibei Xiong 《地震工程与结构动力学》2002,31(2):459-474

The response of low‐ductility reinforced concrete (RC) frames, designed typically for a non‐seismic region, subjected to two frequencies of base excitations is studied. Five half‐scaled, two‐bay, two‐storey, RC frames, each approximately 5 m wide by 3.3 m high, were subjected to both horizontal and/or vertical base excitations with a frequency of 40 Hz as well as a lower frequency of about 4 Hz (close to the fundamental frequency) using a shake table. The imposed acceleration amplitude ranged from 0.2 to 1.2g. The test results showed that the response characteristics of the structures differed under high‐ and low‐frequency excitations. The frames were able to sustain high‐frequency excitations without damage but were inadequate for low‐frequency excitations, even though the frames exhibited some ductility. Linear‐elastic time‐history analysis can predict reasonably well the structural response under high‐frequency excitations. As the frames were not designed for seismic loads, the reinforcement detailing may not have been adequate, based on the crack pattern observed. The effect of vertical excitation can cause significant additional forces in the columns and moment reversals in the beams. The ‘strong‐column, weak‐beam’ approach for lateral load RC frame design is supported by experimental observations. Copyright © 2001 John Wiley & Sons, Ltd.  相似文献   

Proportioning earthquake‐resistant RC frames in central/eastern U.S.     

JoAnn Browning 《地震工程与结构动力学》2002,31(6):1267-1280

A maximum allowable period criterion is used to determine reasonable stiffness requirements for reinforced concrete frames with the seismicity associated with central and eastern U.S. A general relationship is developed to describe the displacement demand expected for central and eastern U.S. based on a survey of available ground motions, opinions of seismologists, and code‐based provisions. A series of hypothetical reinforced concrete frames is proportioned using a maximum allowable period criterion and evaluated for expected maximum displacement response using non‐linear dynamic analyses and a suite of ground motions. Results indicate that for the reinforced concrete structural systems considered in the study, proportioning for gravity loads will provide sufficient stiffness in central and eastern U.S. Copyright © 2002 John Wiley & Sons, Ltd.  相似文献   

Towards a direct collapse–load method of design for concrete frames subjected to severe ground motions     

M. C. Griffith  A. Kawano  R. F. Warner 《地震工程与结构动力学》2002,31(10):1879-1888

Most current methods of design for concrete structures under earthquake loads rely on highly idealized ‘equivalent’ static representations of the seismic loads and linear‐elastic methods of structural analysis. With the continuing development of non‐linear methods of dynamic analysis for the overload behaviour and collapse of complete concrete structures, a more direct and more accurate design procedure becomes possible which considers conditions at system collapse. This paper describes an evaluation procedure that uses non‐linear dynamic collapse–load analysis together with global safety coefficients. A back‐calibration procedure for evaluating the global safety coefficients is also described. The aim of this paper is to open up discussion of alternative methods of design with improved accuracy which are necessary to move towards a direct collapse–load method of design. Copyright © 2002 John Wiley & Sons, Ltd.  相似文献   

考虑轴向变形、双轴弯曲耦合效应的钢筋混凝土柱的弹塑性分析   总被引：6，自引：2，他引：6  

姬守中  江欢成 《地震工程与工程振动》2002,22(4):74-80

在实际地震作用下，高层，特别是高宽比较大的高层结构中，由于倾覆力矩的作用、柱子、特别是外边柱所受轴力的变化将不可忽略。轴向变形与双轴弯曲的耦合作用，将是柱子塑性变形的显著特征。基于材料本构关系的“纤维模型”，能较精确地反映轴向变形，双轴弯曲三者之间的耦合作用。一组钢筋混凝土柱子双轴压弯的计算结果与试验结果的比较，证明了“纤维模型”的有效性和精确性。  相似文献   

An experimental study on seismic responses of multifunctional vibration‐absorption reinforced concrete megaframe structures     

Zongjian Lan  Yuji Tian  Liang Fang  Shuting Liang  Xinde Wang 《地震工程与结构动力学》2004,33(1):1-14

Two models are tested on a shake‐table. One of the models is a normal reinforced concrete megaframe structure and the other is a multifunctional vibration‐absorption reinforced concrete megaframe structure in which the laminated rubber bearings are placed between the major frame and the minor frames. Two earthquake motions (the El Centro wave and the Taft wave) are used during the test. This paper presents the dynamic characteristic, the seismic responses and the failure mechanism of these two models under varying peak acceleration levels for each of the earthquake motions. The test results demonstrate that the aseismic behavior of a multifunctional vibration‐absorption reinforced concrete megaframe structure is much better than that of a normal reinforced concrete megaframe structure. Copyright © 2003 John Wiley & Sons, Ltd.  相似文献   

落石冲击混凝土板与缓冲层组合结构的动力响应          下载免费PDF全文

吴建利  胡卸文  梅雪峰  许泽鹏  罗刚  韩玫 《水文地质工程地质》2021,48(1):78-87

钢筋混凝土（RC）板与一定厚度的土颗粒缓冲层组合结构被广泛用于山区高位单体及群发性崩塌落石的防治,为研究此类防护结构在落石作用下的冲击力衰减规律及RC板的破坏模式,开展了室外系列落石冲击试验。结果表明,增大缓冲层厚度能够有效减小最大冲击力,峰值加速度随缓冲层厚度减小而增大,尤其在缓冲层厚度为0.1 m及0.2 m时,最大值急剧增大,峰值加速度与缓冲层厚度的变化满足指数函数关系;根据量纲分析原理得到缓冲层最大冲击深度与动能的平方成正比、与最大入射冲击力成反比的计算公式,且与实测值较吻合;入射冲击力在缓冲层内的衰减率随缓冲层厚度的增加以指数函数递增,在0.6 m缓冲层厚度下可使峰值冲击力衰减70%左右;随累积冲击能级的增大,RC板经历了弯曲起裂及扩展、次级弯曲裂纹和剪裂纹产生及跨中弯曲裂纹贯通的过程,试验结束时RC板整体表现出典型的弯曲破坏特征。  相似文献   

SEISMIC IMPACT LOADING IN INELASTIC TENSION-ONLY CONCENTRICALLY BRACED STEEL FRAMES: MYTH OR REALITY?     

R. TREMBLAY  A. FILIATRAULT 《地震工程与结构动力学》1996,25(12):1373-1389

Tension-Only Concentrically Braced Frames (TOCBF) exhibit deteriorating pinched hysteretic behaviour during strong earthquakes. Slender braces transit between an elastic buckling state, a restraightening state, in which they carry almost no load, an elastic tensile loading state as they are suddenly taut and, finally, a tensile yielding state. It has long been suspected that the sudden increase in tensile forces in the braces of TOCBSF creates detrimental impact loading on the connections and other structural elements. No experimental evidence, however, has been provided so far to confirm, or to quantify, this impact phenomenon. This paper addresses this issue through shake table tests of half scale, two-storey, TOCBF models. By normalizing the hysteresis loops of braces obtained from shake table tests to the yield strength of steel obtained from quasi-static tests, the increase in tensile forces in the braces was obtained. Results of dynamic tensile tests on steel coupons under similar strain rates as observed during the shake table tests showed that this increase in tensile forces is not the result of impact, but is rather caused by a yield strength increase of the steel under high strain rate. A procedure is proposed to estimate and account for this increase in tensile forces in the braces at the design stage.  相似文献   

钢筋混凝土柱考虑损伤累积的反复荷载-位移关系分析   总被引：7，自引：0，他引：7  

顾祥林  黄庆华  吴周偲 《地震工程与工程振动》2006,26(4):68-74

为能在反复荷载作用下钢筋混凝土柱的荷载-位移关系分析中考虑柱低周疲劳性能,提出了一损伤模型,对柱中纵向受力钢筋和混凝土的损伤状态作评估与记录。将这一记录材料性能信息的损伤指标带入材料各自的恢复力模型以考虑产生损伤后材料的强度和刚度退化。基于多弹簧模型对不同变幅加载路径下及等幅低周疲劳加载下钢筋混凝土柱的空间反应进行了数值计算模拟。与已有试验结果比较表明,所提材料层次上的损伤累积模型以及考虑损伤累积效应的柱构件空间荷载-位移关系分析方法具有一定的精度,为钢筋混凝土柱的抗震性能分析提供了一个辅助工具。  相似文献   

COSMO-SkyMed颜色变换强度RC法南京建设用地变化检测     

张涛  王源  陈富龙  周伟  胡祺 《测绘通报》2019,(11):74-78,84

基于非局部滤波的SAR强度RC合成变化检测法对小图斑、线型地物等动态监测灵敏,且对数据获取无时空基线要求,在多云多雨城市地表要素变化检测中具备潜力。本文研究以多时相SAR强度RC合成图为数据源,提出一种基于色彩空间变换的变化图斑半自动提取方法,即通过色彩空间转换、训练样本选取、监督分类影像分割、变化区域提取4步骤,可实现基于SAR强度图的城市建设用地动态监测与图斑高效更新。选取南京河西新城与江北新区为示范,以最优参数配置（3特征向量与10样本类别）进行试验,实现了优于88%的建设用地查准率指标。  相似文献