内蒙古"宝音图隆起"的归属讨论   总被引：5，自引：0，他引：5  

沈存利  陈志勇  常忠耀 《华北地质》2004,27(1):18-23

对比研究表明，内蒙古“宝音图隆起”和狼山地区的古元古代宝音图岩群与新太古代色尔腾山岩群都是由中低级变质的各种片岩、大理岩组成，一致的岩石组合和变质相暗示二者可能是等同物而不是两个岩群。以物探资料为据的构造研究也证实，“宝音图隆起”与狼山地区之间并无槽一台级的大型断裂构造分开，二者实为统一的构造整体而不是分属槽台，只因两侧被两条近于平行的NE向断裂围限，使其总构造线方向呈NE或NNE向而与色尔腾山的构造线不同。结论认为，“宝音图隆起”仍是华北陆块的一部分，不属于内蒙古一大兴安蛉地槽褶皱系。  相似文献   

Geological controls on rock mass classification of coal from Huntly East Mine, New Zealand     

Vicki Moon  Trisha Roy 《Engineering Geology》2004,75(2):201-213

Rock Mass Rating (RMR) measurements from 65 sites within Huntly East underground coal mine are presented. All measurements are in coal, for which the dominant discontinuities are vertical cleat. Basic RMR values using two discontinuity spacings are presented: overall RMR based on the average spacing of all individual discontinuities; and cleat zone RMR based on the average spacing between zones of cleat. Cleat orientations are highly variable, but on average approximately parallel horizontal stress axes (face cleat follows maximum horizontal stress axis, butt cleat follows minimum horizontal stress axis).Contours of RMR variations throughout the mine are used to compare rock mass conditions with geological structure. It is apparent that: (1) RMR is least within downthrown fault blocks, and particularly immediately on the downthrown sides of faults, and greatest in upthrown fault blocks; and (2) RMR contours parallel horizontal stress axes within fault-bounded blocks, and bend to parallel faults at block boundaries. From similar contours for parameters contributing to RMR, the Rock Quality Designation (RQD), groundwater rating, and discontinuity condition rating create most of the observed variations in RMR. RQD is determined from the measured discontinuity frequency and hence is a measure of the degree of fracturing of the rock mass. This is interpreted as influencing the groundwater and condition parameters directly by allowing greater water ingress. Discontinuity frequency is greatest (least spacing) in the immediate vicinity of faults, and in downthrown fault blocks, generating low RMR values. Within fault blocks RQD varies little, so RMR contours align with cleat orientations.As RMR contours, faults, stress field and cleat orientation are clearly interrelated, there is unequivocally a connection between RMR and structural geology; this allows some predictive capacity in terms of ground conditions. If geological features can be accurately defined through either drilling programs or seismic surveys, then ground conditions may be predicted before panels are driven.  相似文献   

Magnetic fabrics and rock magnetism of Proterozoic dike swarm from the southern São Francisco Craton, Minas Gerais State, Brazil     

Maria Irene Bartolomeu Raposo  Alexandre O. Chaves  Paulo Lojkasek-Lima  Manoel Souza D'Agrella-Filho  Wilson Teixeira   《Tectonophysics》2004,378(1-2):43-63

Magnetic fabric and rock magnetism studies were performed on 32 mafic dikes of a Proterozoic dike swarm from the southern São Francisco Craton (SFC; Minas Gerais State, SE Brazil). Magnetic anisotropies were determined by applying anisotropy of low-field magnetic susceptibility (AMS) and anisotropy of remanent magnetization (ARM). The latter was performed imposing both anhysteretic (total (AAR) and partial pAAR)) and isothermal remanence magnetizations (AIRM). Partial anhysteretic remanence anisotropy was performed based on remanent coercivity spectra from a pilot specimen of each site. In most sites, AMS is dominantly carried by ferromagnetic minerals, however, in some sites, the paramagnetic contribution exceeds 70% of bulk susceptibility. Rock magnetism and thin section analysis allow classifying the dikes as non-hydrothermalized and hydrothermalized. Magnetic measurement shows that the mean magnetic susceptibility is usually lower than 5×10⁻³ (SI). Ti-poor titanomagnetites up to pure magnetite pseudo-single-domain (PSD) grain sizes carry the majority of magnetic fabrics for non-hydrothermalized dikes whereas coarse to fine grained Ti-poor titanomagnetites carry the majority of magnetic fabrics for hydrothermalized dikes.Three primary AMS fabrics are recognized which are coaxial with ARM fabric, except for two dikes, from both non-hydrothermalized and hydrothermalized dikes. Normal AMS fabric surprisingly is not dominant (31%). The parallelism between AMS, pAAR_0–30, pAAR_30–60 and pAAR_60–90 fabrics in the hydrothermalized dikes indicates that magnetic grains formed due to late-stage crystallization or to remobilization of iron oxides due to hydrothermal alteration after dike emplacement have acquired a mimetic fabric coaxial with the primary fabric given by coarse-grained early crystallized Ti-poor titanomagnetites. This fabric is interpreted as magma flow in which the analysis of K_max inclination permitted the inference that the dikes were fed by horizontal or subhorizontal fluxes (K_max<30°). Intermediate AMS fabric is the most important (41%) in the investigated swarm. It is interpreted as due to vertical compaction of a static magma column with the minimum stress along the dike strike. ARM determinations for these sites also remained intermediate except for two dikes. In one of them, AIRM fabric resulted in normal AMS fabric while for the other AAR fabric resulted in inverse AMS fabric. A combination of AMS and ARM fabrics suggest that magmatic fabric for both dikes were overprinted by some late local event, probably related to Brasiliano orogenic processes after dike emplacement. InverseInverse AMS fabric is a minority (four dikes). ARM determinations also remained inverse suggesting a primary origin for inverse AMS fabric.  相似文献   

Groundwater and geotechnical aspects of deep excavations in Hong Kong     

R. A. Forth   《Engineering Geology》2004,72(3-4):253-260

Consideration of groundwater is a key element in almost every construction project. The design of deep excavations for basements or underground railway station concourses below the water table require that the water pressures are taken into account. Whilst these can be considered to be hydrostatic in soil, the decreasing permeability of rock with depth and the fact that groundwater flow is invariably along discrete fractures means that the water pressure is unlikely to be hydrostatic at depth.

Groundwater control for deep excavations can be achieved by a number of methods such as grouting, pumping or structural walls or a combination of these. For tunnelling projects grouting is extensively used, but the development of sophisticated tunnelling machines has led in many cases to the demise of compressed air as a means of groundwater control.  相似文献   

Fuzzy set approaches to classification of rock masses   总被引：6，自引：0，他引：6  

A. Aydin   《Engineering Geology》2004,74(3-4):227-245

Rock mass classification is analogous to multi-feature pattern recognition problem. The objective is to assign a rock mass to one of the pre-defined classes using a given set of criteria. This process involves a number of subjective uncertainties stemming from: (a) qualitative (linguistic) criteria; (b) sharp class boundaries; (c) fixed rating (or weight) scales; and (d) variable input reliability. Fuzzy set theory enables a soft approach to account for these uncertainties by allowing the expert to participate in this process in several ways. Hence, this study was designed to investigate the earlier fuzzy rock mass classification attempts and to devise improved methodologies to utilize the theory more accurately and efficiently. As in the earlier studies, the Rock Mass Rating (RMR) system was adopted as a reference conventional classification system because of its simple linear aggregation.

The proposed classification approach is based on the concept of partial fuzzy sets representing the variable importance or recognition power of each criterion in the universal domain of rock mass quality. The method enables one to evaluate rock mass quality using any set of criteria, and it is easy to implement. To reduce uncertainties due to project- and lithology-dependent variations, partial membership functions were formulated considering shallow (<200 m) tunneling in granitic rock masses. This facilitated a detailed expression of the variations in the classification power of each criterion along the corresponding universal domains. The binary relationship tables generated using these functions were processed not to derive a single class but rather to plot criterion contribution trends (stacked area graphs) and belief surface contours, which proved to be very satisfactory in difficult decision situations. Four input scenarios were selected to demonstrate the efficiency of the proposed approach in different situations and with reference to the earlier approaches.  相似文献   

A rippability classification system for marls in lignite mines   总被引：1，自引：0，他引：1  

H. Basarir  C. Karpuz   《Engineering Geology》2004,74(3-4):303-318

  相似文献   

沐川地震成因探讨     

徐泽奎  苟健 《四川地震》2005,(2):45-48

通过对沐川沙湾间地质、地貌、水文地质和地震活动特征分析，认为该区3级以上地震活动与铜街子电站水库畜水有关。1993～1995年沐川西部连续发生的3次5．0级以上地震属水库诱发的构造性地震。  相似文献   

大桥水库MS4.6级诱发地震的初步研究     

胡先明  叶有清 《四川地震》2005,(4):25-31

2002年3月3日大桥水库诱发了Ms4．6级水库地震，其发震构造是安宁河东支断裂近傍具有正断层性质的一个分支断裂。据大桥台网7年多库区地震观测事件记录，地震空间分布上水体附近有一个明显的活跃过程，大坝上游发生小震群，大坝下游发生主震序列。地震的震源深度在蓄水前后有明显变化。4．6级地震的震源机制解的主压应力轴方位和倾角与大多数活动断裂上的地震有明显的差别，主压应力轴的倾角与其它的水库地震相比也存在较大差别。  相似文献   

大功率激电测深法寻找焦家式深部金矿床的试验应用研究     

牛如宝  陈长峰  宋海平  王友芳  王轮吉 《应用地球物理》2005,2(1):51-55

利用大功率的激电测深法可以寻找焦家式深部金 矿。首先,由物理和数学推导建立多层极化体的数 理模型,其数理模型产生的极化场可由多层若干 个极化单元场相叠加而成。由多次去除极化单元 场的原理而导出大功率激电测深资料进行消除浅 部强激电干扰异常的数据处理公式,从而突出了 深部矿床的激电异常。并利用处理后的激电测深 曲线,定量求取了深部金矿蚀变矿化带的顶界面 埋深。  相似文献   

Induced seismicity around the Tous New Dam (Spain)   总被引：2，自引：0，他引：2  

Federico Torcal  Inmaculada Serrano  Jens Havskov  José Luis Utrillas  José Valero 《Geophysical Journal International》2005,160(1):144-160

  相似文献