应变软化在甘肃红柳河辉长质糜棱岩形成中的作用   总被引：4，自引：0，他引：4  

谢艳霞  刘瑞Xun 《矿物岩石》1996,16(2):34-39

本文论述的辉长质糜棱岩发现于甘肃北山红柳河蛇绿岩套中。在简单说明了糜棱岩的地质背景及特征、描述了变形岩石的显微构造特征之后，重点对糜棱岩形成过程中的应变软化机制作了论述。探讨了软化岩的存在、组构调整、粒度缩小，长石的动态重结晶，水以及主导变形机制的不断调整与转化等应变软化机制，在应力作用下使岩石逐步软化过程中所起的作用，得出这种糜棱岩是在拆离剪切作用下，应力在蛇绿岩中的软化岩石辉长岩中集中，从而形  相似文献   

Influence of gas production induced volumetric strain on permeability of coal   总被引：10，自引：0，他引：10  

Satya Harpalani  Guoliang Chen 《Geotechnical and Geological Engineering》1997,15(4):303-325

Summary The gas permeability of a coalbed, unlike that of conventional gas reservoirs, is influenced during gas production not only by the simultaneous changes in effective stress and gas slippage, but also by the volumetric strain of the coal matrix that is associated with gas desorption. A technique for conducting laboratory experiments to separate these effects and estimate their individual contribution is presented in this paper. The results show that for a pressure decrease from 6.2 to 0.7 MPa, the total permeability of the coal sample increased by more than 17 times. A factor of 12 is due to the volumetric strain effect, and a factor of 5 due to the gas slippage effect. Changes in permeability and porosity with gas depletion were also estimated using the measured volumetric strain and the matchstick reservoir model geometry for flow of gas in coalbeds. The resulting variations were compared with results obtained experimentally. Furthermore, the results show that when gas pressure is above 1.7 MPa, the effect of volumetric strain due to matrix shrinkage dominates. As gas pressure falls below 1.7 MPa, both the gas slippage and matrix shrinkage effects play important roles in influencing the permeability. Finally, the change in permeability associated with matrix shrinkage was found to be linearly proportional to the volumetric strain. Since volumetric strain is linearly proportional to the amount of gas desorbed, the change in permeability is a linear function of the amount of desorbing gas.  相似文献   

观测应变阶在地震应力触发研究中的应用   总被引：17，自引：2，他引：17       下载免费PDF全文

邱泽华  石耀霖 《地震学报》2004,26(5):481-488

对中国钻孔应变台网观测到的昆仑山口西MS8.1大地震的应变阶资料的研究结果表明:① 很多观测值与静力位错理论计算值不符合；② 北方地震较活跃地区的很多台站观测到异常大的应变阶，而南方构造运动较不活跃地区的台站虽然也观测到地震波动，但是应变阶不明显. 由此推断，地震的触发（可能是动态触发）作用对远场的实际地震应变变化具有重要影响. 也就是说，远场的构造活动（可能是断层活动）是否曾被地震触发，可能决定当地的应变场变化的主要特征. 进一步对昌平台1999年3月11日张北地震与1999年11月1日大同地震的观测资料对比分析表明:断裂带的分布情况对实际地震应变变化有直接影响. 这证明观测到的异常大的地震应变阶可能是地震触发了当地的断层活动的表现.   相似文献   

3-D rheologic model of earthquake preparation (II): Strain field and its applications     

宋治平  尹祥础  梅世蓉 《地震学报(英文版)》2004,17(2):131-143

Introduction Based on the elastic theory of the hard inclusion (Dobrovolskii, 1991), we developed an inclusion theory of rheologic medium, and applied the results of bulk-strain field of a rheologic inclusion model to explain the spatial-temporal evolution process of earthquake precursors (SONG, et al, 2000). In the former paper (SONG, et al, 2003), we derived the viscoelastic displacement field of the rheologic inclusion model on the basis of the analytic expression of displacement field o…  相似文献   

Developments of borehole strain observa- tion outside China     

邱泽华  石耀霖 《地震学报(英文版)》2004,17(Z1)

Introduction The Earth′s crust deforms in the regional tectonic stress field. Borehole strain observation isone important means for studies on the crustal deformation and the stress field. QIU and ZHANG(2002) have introduced the current situation of borehole strain observation in China. OutsideChina, early in September of 1968, Sacks of Carnegie Institution of Washington and Evertson ofUniversity of Texas firstly invented a borehole dilatometer in the world (Sacks, Evertson, 197…  相似文献   

Strain field measurements of rubber by image analysis and design criteria for laminated rubber bearings (LRB)     

Chamindalal Sujeewa Lewangamage  Masato Abe  Yozo Fujino  Junji Yoshida 《地震工程与结构动力学》2004,33(4):445-464

Although seismic isolation rubber bearings in bridges and buildings have proven to be a very effective passive method for reducing earthquake‐induced forces, a detailed mechanical modeling of the rubber that is used in bearings under large strains has not been established. Therefore, a 3D model of failure behavior and the design criteria for the safety evaluation of seismic isolation bearings have not yet been developed. This paper presents: (1) correlation‐based template‐matching algorithms to measure large strain fields of continua; (2) a failure criterion for rubber; and (3) the design criteria for the safety evaluation of laminated algorithms, data‐validation algorithms were developed and implemented to eliminate possible unrealistic displacement vectors present in the measured displacement field. The algorithms were successfully employed in the strain field measurement of LRB and rubber materials that are subjected to failure. The measured local strains for rubber material at failure were used to develop a failure criterion for rubber. The validity of the proposed criterion was evaluated by applying it to the LRB; the criterion was introduced into a 3D finite element model of LRB, compared with the experimental results of bearings failure, and verified. Finally, design criteria are proposed for LRB for the safety evaluation. Copyright © 2003 John Wiley & Sons, Ltd.  相似文献   

Seismic tests on reinforced concrete and steel frames retrofitted with dissipative braces     

F. J. Molina  S. Sorace  G. Terenzi  G. Magonette  B. Viaccoz 《地震工程与结构动力学》2004,33(15):1373-1394

Seismic tests have been conducted on two 3‐storey structures protected with pressurized fluid‐viscous spring damper devices. One of the structures was a reinforced concrete frame with clay elements in the slabs, while the other one was a steel frame with steel/concrete composite slabs. The spring dampers were installed through K bracing in between the floors. The tests were performed by means of the pseudodynamic method, which allowed the use of large and full‐size specimens, and by implementing a specific compensation strategy for the strain‐rate effect at the devices. The test results allowed the verification of the adequacy of the attachment system as well as the comparison of the behaviour of the unprotected buildings with several protected configurations, showing the benefits of the application of the devices and the characteristics of their performance. The response of the protected structures was always safer than that of the unprotected ones mainly due to a significant increase of equivalent damping. The increase in the damping ratio depends on the level of deformation. Copyright © 2004 John Wiley & Sons, Ltd.  相似文献   

A Physical and Numerical Investigation on the Stability of Shallow Tunnels in Strain Softening Media   总被引：11，自引：0，他引：11  

D. Sterpi  A. Cividini 《Rock Mechanics and Rock Engineering》2004,37(4):277-298

Summary The behaviour up to failure of shallow underground openings is discussed on the basis of some laboratory, small-scale model tests and of finite element simulation. The experimental results are first illustrated. They were obtained from two-dimensional (plane strain) and three-dimensional tunnel models tested under standard gravity conditions. Then, the phenomenon of strain localisation that characterizes the medium surrounding the model tunnels is discussed, recalling two alternative approaches for its numerical interpretation. On this basis, a finite element procedure for strain softening analyses is outlined and applied to the simulation of the tests in both two- and three-dimensional conditions. The comparison between experimental and numerical results leads to some conclusions on the influence of strain localisation on the overall behaviour of shallow tunnels and on the stability of their headings.  相似文献   

Laboratory and case studies of thermal cycling and stored strain on the stability of selected marbles     

John M. Logan 《Environmental Geology》2004,46(3-4):456-467

Studies of marble panels from the exterior of two buildings document the processes leading to bowing of the material. Bowing of panels is most extensive in those areas that are exposed to direct or reflected thermal energy. The thermal anisotropic behavior of calcite results in grain-boundary separation, grain sliding and microfracturing. The resulting loss of strength is one factor leading to bowing. The development of bows further reduces the panel strength as the outer portions elongate by inelastic deformation mechanisms. Laboratory experiments cycling marble samples for over 200 cycles at three temperatures up to 107°C above room conditions show similar strength losses as the natural situation. The second factor contributing to the bowing process is the release of residual elastic strain. The strain is in part stored in the marble from its geologic history, but may also be accumulated during thermal cycling due to the properties of calcite. Marble panels have been found to bow when stored outside, but not attached to any framework, indicating that the release of residual strain is a critical factor in producing the bows.  相似文献   

The Shape and Volume of the Skaergaard Intrusion, Greenland: Implications for Mass Balance and Bulk Composition   总被引：6，自引：0，他引：6  

NIELSEN  TROELS F. D. 《Journal of Petrology》2004,45(3):507-530

Re-examination of the Skaergaard intrusion in the context ofits regional setting, combined with new data from explorationdrilling, has resulted in a revised structural model for theintrusion. It is modelled as an irregular box, c. 11 km fromnorth to south, up to 8 km from east to west, and 3·4–4km from the lower to the upper contact. The walls of the intrusionare inferred to follow pre-existing and penecontemporaneoussteep faults, and the floor and roof seem largely controlledby bedding planes in the host sediments and lavas, similar toregional sills. The suggested shape and volume are in agreementwith published gravimetric modelling. Crystallization alongall margins of the intrusion concentrated the evolving meltin the upper, central part of the intrusion, best visualizedas an ‘onion-skin’ structure inside the box. Thetotal volume is estimated to c. 280 ± 23 km³, of which13·7% are referred to the Upper Border Series (UBS),16·4% to the Marginal Border Series (MBS) and 69·9%to the Layered Series (LS). In the LS, the Lower Zone (LZ) isestimated to constitute 66·8%, the Middle Zone (MZ) 13·5%and the Upper Zone (UZ) 19·7%. The new volume relationshipsprovide a mass balance estimate of the major and trace elementbulk composition of the intrusion. The parental magma to theSkaergaard intrusion is similar to high-Ti East Greenland tholeiiticplateau basalts with Mg number c. 0.45. The intrusion representsthe solidification of contemporary plateau basalt magma trappedand crystallized under closed-system conditions in a crustalreservoir at the developing East Greenland continental margin. KEY WORDS: bulk composition; emplacement; mass proportions; Skaergaard intrusion; structure  相似文献