A laboratory experiment to monitor the contact state of a fault by transmission waves   总被引：1，自引：0，他引：1  

Naoto Yoshioka  Koji Iwasa 《Tectonophysics》2006,413(3-4):221-238

We performed a series of laboratory experiments in which elastic waves were transmitted across a simulated fault. Two types of experiments were carried out: (1) Normal Stress Holding Test (NSHT): normal stress was kept constant for about 3 h without shear stress and transmission waves were observed. (2) Shear Stress Increasing Test (SSIT): shear stress was gradually increased until a stick-slip event occurred. Transmission waves were continuously observed throughout the process of stress accumulation. We focused on the change in transmission waves during the application of shear stress and especially during precursory slips.It was found in NSHT that the amplitude of transmission waves linearly increased with the logarithm of stationary contact time. The increase amounted to a few percent after about 3 h. Creep at asperity contacts is responsible for this phenomenon. From a theoretical consideration, it was concluded that the real contact area increased with the logarithm of stationary contact time.We observed in SSIT a significant increase in wave amplitude with shear stress application. This phenomenon cannot be attributed to the time effect observed in NSHT. Instead, it can be explained by the mechanism of “junction growth” proposed by Tabor. Junction growth yields an increase in real contact area. It is required for junction growth to occur that the material in contact is already plastic under a purely normal loading condition. A computer simulation confirmed that this requirement was satisfied in our experiments. We also found that the rate at which the amplitude increased was slightly reduced prior to a stick-slip event. The onset time of the reduction well coincides with the onset of precursory slip. The cause of the reduction is attributed to the reset of stationary contact time due to displacement. This interpretation is supported by the result of NSHT. Taking the time of stationary contact in SSIT into account, we may expect the change in wave amplitude to be, at most, only a few percent. The observed slight reduction in increasing rate is, in this sense, reasonable. The static stiffness of the fault also decreases with precursory slip. It was also found that low frequency waves are a better indicator of precursory slip than high frequency waves. This might suggest that low frequency waves with longer wavelength are a better indicator of average behavior of faults. The problem, however, merits a further investigation. The shifts in phase were also found to be a good indicator of the change in contact state of the fault. The changes in both amplitude and phase of transmission waves are unifyingly understood through the theory of transmission coefficient presented by Pyrak-Nolte et al. Rough surfaces have a tendency to give larger stick-slips than smooth surfaces. The amount of precursory slip is larger for rough surfaces than for smooth surfaces. Although it was confirmed by a computer simulation that rough surfaces have larger contact diameters than smooth surfaces, the rigorous relationship between the surface roughness (contact diameter) and the amount of precursory slips was not established.  相似文献   

Non-volcanic deep low-frequency tremors accompanying slow slips in the southwest Japan subduction zone   总被引：5，自引：1，他引：5  

Kazushige Obara  Hitoshi Hirose 《Tectonophysics》2006,417(1-2):33

Non-volcanic deep low-frequency tremors in southwest Japan exhibit a strong temporal and spatial correlation with slow slip detected by the dense seismic network. The tremor signal is characterized by a low-frequency vibration with a predominant frequency of 0.5–5 Hz without distinct P- or S-wave onset. The tremors are located using the coherent pattern of envelopes over many stations, and are estimated to occur near the transition zone on the plate boundary on the forearc side along the strike of the descending Philippine Sea plate. The belt-like distribution of tremors consists of many clusters. In western Shikoku, the major tremor activity has a recurrence interval of approximately six months, with each episode lasting over a week. The tremor source area migrates during each episode along the strike of the subducting plate with a migration velocity of about 10 km/day. Slow slip events occur contemporaneously with this tremor activity, with a coincident estimated source area that also migrates during each episode. The coupling of tremor and slow slip in western Shikoku is very similar to the episodic tremor and slip phenomenon reported for the Cascadia margin in northwest North America. The duration and recurrence interval of these episodes varies between tremor clusters even on the same subduction zone, attributable to regional difference in the frictional properties of the plate interface.  相似文献   

大变形有限元法分析边坡稳定性     

杨涛  周德培  苏金蓉 《山地学报》2006,24(1):101-104

边坡稳定性分析的重要任务是确定边坡潜在滑面的位置及相应的安全系数,鉴于坡体位移可在现场监测中直接得到,提出边坡潜在滑面确定的位移判据,采用大变形有限元首先计算出边坡的位移场,然后在开挖面的不同高度作塑性区内的水平位移参考线,依次连接参考线上的位移突变点即得到边坡失稳的潜在滑面位置,分析滑面上的应力以及岩体抗剪强度即得到边坡的整体安全系数。  相似文献   

Fault slip and rupture velocity inversion by isochrone backprojection     

Gaetano Festa  Aldo Zollo 《Geophysical Journal International》2006,166(2):745-756

  相似文献   

考虑滑脱效应和温度场的煤层气渗流数值模拟     

肖晓春  潘一山 《中国地质灾害与防治学报》2006,17(3):91-95

由于煤层气的解吸热效应,煤层气的运移过程是一个非等温过程。因此,温度场对煤层气渗流有着重要的影响。前人在研究煤层气渗流规律的研究中并没有同时考虑滑脱效应和温度场因素的影响,而在实际的深部开采中综合考虑滑脱效应和温度场的影响对研究深部煤层气运移规律有着重要的意义。因此本文建立了考虑滑脱效应及温度场的煤层气渗流数学模型,利用有限元数值方法研究了考虑滑脱效应和温度场耦合的煤层气运移规律;研究了考虑滑脱效应和温度场对压力场分布的影响;对考虑滑脱效应及温度场因素的煤层气产量进行了预测。得出了随着温度的升高煤储层的压力在降低,温度的升高对煤层气的产量有着负面的影响这一重要结论。  相似文献   

Source inversion for estimating the continuous slip distribution on a fault—introduction of Green's functions convolved with a correction function to give moving dislocation effects in subfaults     

Haruko Sekiguchi  Kojiro Irikura  Tomotaka Iwata 《Geophysical Journal International》2002,150(2):377-391

  相似文献   

2001年昆仑山口西8.1级地震地表破裂带   总被引：30，自引：8，他引：30       下载免费PDF全文

陈杰  陈宇坤  丁国瑜  田勤俭  王赞军  单新建  任金卫  赵瑞斌  王志才 《第四纪研究》2003,23(6):629-639

2001年11月14日昆仑山口西8.1级地震是近50年来在我国大陆发生的震级最大、地表破裂最长的地震事件.地震地表破裂带全长426km,宽数米至数百米,总体走向90°～110°,具有明显的破裂分段特征,自西向东由5条次级破裂段组成.各破裂段又由若干更次级左阶或右阶斜列的破裂组成,具有自相似的分形结构特征.地震破裂带以左旋走滑为主,倾滑量很小.宏观震中区位于库赛湖东北93.0°～93.5°E一带的昆仑山南麓断层谷地内.最大地表同震左旋水平位移6.4m,最大垂直位移为4m.地表水平位移沿地震破裂带走向出现6个峰值,各峰值之间存在相对独立的衰减序列,这表明此地震具有多点破裂特征.  相似文献   

基于小波变换的GPS周跳探测   总被引：5，自引：0，他引：5  

岳建平  席广永 《测绘工程》2003,12(4):33-35

概述了GPS周跳产生的原因及其探测周跳的重要性，总结了用来进行检测的常用方法，重点讨论了用小波分析来检查周跳的基本思想。并用实际的工程算例验证了该方法的可行性和有效性。  相似文献   

Surface effects of triggered fault slip on Reykjanes Peninsula, SW Iceland     

Amy E. Clifton  Carolina Pagli  Jna Finndís Jnsdttir  Kristjana Eythorsdttir  Kristin Vogfjr 《Tectonophysics》2003,369(3-4):145-154

Three large earthquakes (M_w>4.5) were triggered within 5 min, 85 km west of a M_w 6.5 earthquake in the South Iceland Seismic Zone (SISZ). We report on surface effects of these triggered earthquakes, which include fresh rupture, widespread rockfall, disrupted rockslides and block slides. Field data confirm that the earthquakes occurred along N-striking right-lateral strike-slip faults. Field data also support the conclusion from modeling of InSAR data that deformation from the second triggered event was more significant than for the other two. A major hydrological effect was the draining of water through an open fissure on a lake bed, lowering the lake level by greater than 4 m. Field relationships suggest that a component of aseismic slip could have been facilitated by water draining into the fault zone.  相似文献   

Regional Fault Systems of Qaidam Basin and Adjacent Orogenic Belts   总被引：4，自引：0，他引：4  

ZhangBingshan TangLiangjie JinZhijun DaiJunsheng ZhangMingli ZhangBingshan 《中国地质大学学报(英文版)》2003,14(1):65-72

The purpose of this paper is to analyze the regional fault systems of Qaidam basin and ad-jacent orogenic belts. Field investigation and seismic interpretation indicate that five regional fault sys-tans occurred in the Qaidam and adjacent nment.qin belts, controlling the development and evolution of the Qaidam basin. These fault systems are: (1)north Qaidam-Qilian Mountain fault system; (2) south Qaidam-East Kunhm Mountain fault system;（3）Altun strike-slip fault system; (4) Elashan strike-slip fault system, and (5) Gansen-Xiaochaidan fault system. It is indicated that the fault systems controlled the orientation of the Qaidam basin, the formation and distribution of secondary faults within the basin,the migration of depocenters and the distribution of hydrocarbon accmnulation belt.  相似文献