筒桩基础的地震反应分析     

董金明  刘春原  郝厉  刘平 《东北地震研究》2004,20(2):8-14

本文基于Biot动力固结方程，在BDWF模型的基础上，通过等价线性迭代不断修正土体模量以逼近土体的非线性动态响应，对建筑筒桩基础的地震反应进行了动力分析。为了分析筒桩基础的地震反应，考虑桩-土-结构的动力相互作用，将桩-土-结构地震反应分析的空间体系简化为二维问题计算。结果表明，筒桩基础桩基相对桩基于桩基有较好的抗震性能，筒桩基础的柔性改善了结构的基本周期。  相似文献   

Interactive behavior of soil–pile-superstructure system in transient state to liquefaction by means of large shake table tests     

Shintaro Yao  Koichi Kobayashi  Nozomu Yoshida  Hiroshi Matsuo 《Soil Dynamics and Earthquake Engineering》2004,24(5):572-409

Shaking table tests were conducted by means of a large-scale laminar box with 4 m in length, 2 m in width and 2 m in height in order to investigate behavior of a soil-pile-superstructure system in liquefiable ground. A model two-storey structure, supported by a pile group, was set in a saturated sand deposit, and subjected to a sinusoidal base motion with increasing amplitude. Discussions are focused on the transient behavior until soil liquefaction occurs. Main interests are characteristics of springs used in a sway-rocking model and a multi-freedom lumped mass (MFLM) model that are frequently used in soil–pile interaction analysis. The spring constant in the sway-rocking model is represented by restoring force characteristics at the pile head, and that in the MFLM system is represented by an interaction spring connecting the pile to the free field. The transient state prior to soil liquefaction is shown to be important in the design of a pile because dynamic earth pressure shows peak response in this state. The reduction of the stiffness due to excess porewater generation and strain dependent nonlinear behavior is evaluated.  相似文献   

In-plane and anti-plane strong shaking of soil systems and structures     

G. Gudehus  R. O. Cudmani  A. B. Libreros-Bertini  M. M. Bühler 《Soil Dynamics and Earthquake Engineering》2004,24(4):319-342

The concept of in-plane and anti-plane shaking is introduced with a rigid block on a plane surface with Coulomb friction. Using a hypoplastic constitutive relation to model the mechanical behaviour of the soil, numerical solutions for a rigid block on a thin dry or saturated soil layer are obtained. The coupled nature of dynamic problems involving granular materials is shown, i.e. the motion of the block changes the soil state—skeleton stresses and density—which in turn affects the block motion. Motions of the block as well as soil response can be more realistically calculated by the new model. The same constitutive equation is applied to the numerical simulation of the propagation of plane waves in homogeneous and layered level soil deposits induced by a wave coming from below. Experiments with a novel laminar shake box as well as real seismic records from well-documented sites during strong earthquakes are used to verify the adequacy of the hypoplasticity-based numerical model for the prediction of soil response during strong earthquakes. The response of a homogeneous earth dam subjected to in-plane and anti-plane shaking is investigated numerically. In-plane and anti-plane shaking is shown to cause nearly the same spreading of a sand dam under drained conditions, whereas under undrained conditions anti-plane shaking causes stronger spreading of the dam. The dynamic behaviour of a breakwater founded on rockfill and soft clay during the 1995 Kobe earthquake is back-calculated to show the good performance of the proposed numerical model also with a structure. Section 9 deals with buildings on mattresses of densified cohesionless soils or fine-grained soils with granular columns, slopes with ‘hidden’ dams and structures on piles traversing clayey slopes to show the suitability of hypoplasticity-based models for the earthquake-resistant design and safety assessment of geotechnical systems.  相似文献   

Modelling transverse dunes     

Veit Schwmmle  Hans Herrmann 《地球表面变化过程与地形》2004,29(6):769-784

Transverse dunes appear in regions of mainly unidirectional wind and high sand availability. A dune model is extended to two‐dimensional calculation of the shear stress. It is applied to simulate dynamics and morphology of three‐dimensional transverse dunes. In the simulations they seem to reach translational invariance and do not stop growing. Hence, simulations of two‐dimensional dune ?elds have been performed. Characteristic laws were found for the time evolution of transverse dunes. Bagnold's law of the dune velocity is modi?ed and reproduced. The interaction between transverse dunes led to the interesting conclusion that small dunes can travel over bigger ones. Copyright © 2004 John Wiley & Sons, Ltd.  相似文献   

大气边界层湍流能量交换特征研究进展     

李富余张宏升  陈家宜 《气象科技》2004,32(5):305-310

从一维湍流能量平衡方程出发,回顾了近几十年湍流能量平衡方程中的各项以及Karman常数k的研究成果,总结了大气边界层湍流能量交换特征的研究概况和热点问题,并对今后发展趋势做了展望。实验研究表明,湍流能量平衡方程中的各项在不同条件下有不同的形式;传统的能量产生和耗散的局地平衡假设存在不足,特别是在不稳定条件下,垂直的湍流输运和压力脉动对湍流能量收支起了非常重要的作用。Karman常数与Rossby数和Reynolds数无关,在比较光滑的下垫面上k近似等于040±001。  相似文献   

影响C₄草本植物C/N比值变化的因素与土壤有机C积累的关系   总被引：6，自引：1，他引：6       下载免费PDF全文

朴河春  朱建明  余登利  冉景丞 《第四纪研究》2004,24(6):621-629

文章对采自贵州从低海拔的东部到高海拔的西部且大致平行的石灰岩和砂岩两地带均生长的3种C₄草本植物,即巴茅(Miscanthusfloridulus)、白茅(Imperatacylindrica)和类芦(Neyraudiareynaudiana),以及相对应的土壤表层样品,进行了营养元素和C同位素组成分析;研究营养元素含量随着海拔的不同而出现的变化趋势,以及这些元素之间的相互协变作用,尤其是Ca和N之间的相互协变作用对植物的N含量、C/N比值和^δ13C值的影响,以了解植物的C/N比值(指示植物残留物质量的一种标志)与土壤有机C积累的关系。研究结果表明,植物的N含量和^δ13C值具有随海拔的上升而显著增大趋势,而植物的C/N比值在砂岩地区虽有减小的趋势,在石灰岩地带则没有。对所研究的C4草本植物来说,在土壤pH值为5.8的中性条件下显示出Ca的最大吸收,因此,Ca与其他营养元素之间的协变模式在两种土壤类型中表现出相反的倾向,并存在土壤交换性Ca的边界浓度:当土壤可交换性Ca的含量为2.24mg/g,相应土壤的pH值在5.8以下时,随着土壤可交换性Ca浓度的增大,植物的N含量上升,而植物的C/N比值会显著降低;当Ca在边界浓度以上时,随着土壤可交换性Ca浓度的增大,植物的N含量下降,而植物的C/N比值有增加的趋势。由此可见,植物残留物的N含量和C/N比值受Ca元素含量的相  相似文献   

土参数对桩基水平响应影响的研究   总被引：1，自引：3，他引：1  

王腾  董胜  冯秀丽 《岩土力学》2004,25(Z1):71-74

桩基的水平响应由桩土间的相互作用决定,通过采用p-y曲线来表示桩土间的非线性相互作用。通过算例,讨论分析了粘性土参数的变化对p-y曲线中土体的极限强度和刚度、桩基水平位移和弯矩分布及最大弯矩和水平荷载关系的影响。  相似文献   

Aeolian abrasion and modes of fine particle production from natural red dune sands: an experimental study   总被引：3，自引：0，他引：3  

Joanna E. Bullard  Grant H. McTainsh†  Christa Pudmenzky† 《Sedimentology》2004,51(5):1103-1125

A series of experiments was conducted to determine the potential for aeolian abrasion of natural dune sands to produce fine particles (< 125 µm) by (1) the release of resident fines; (2) spalling, chipping and breakage of particles; and (3) the removal of grain surface coatings. Parent samples were obtained from the surfaces of four active continental dunes and abraded using a glass ‘test tube’ chamber for up to 120 h. The fine particles produced by this abrasion process were trapped at varying time intervals and subject to detailed particle‐size analyses using a Coulter Multisizer. The abrasion of untreated parent samples produced fine particles in one of two main size classes, < 10 µm and > 50 µm, but when the parent sample was sieved to exclude particles < 250 µm, relatively more material in the range 10–50 µm was produced. For unsieved parent samples, the size range associated with the dominant mode varied according to the length of the abrasion time. The coarsest mode (> 63 µm) was dominant during the first 16 h of abrasion, then became less significant and is thought to be associated with the release of resident fines into suspension. The finest mode (< 10 µm) was absent or very weak during the first 16 h of abrasion, then became more significant and, in some instances, dominated the distribution as abrasion continued. Removal of grain surface coatings is the main source of fine material < 10 µm, and this may be a significant source of fine material in areas where sands are dominated by subrounded and rounded particles. By comparison with previous studies of aeolian particle abrasion, these natural dune sands produced very low quantities of fine material (by weight), but their spatial extent makes them potentially a significant source of dust‐sized particles at the global scale.  相似文献   

The Role of Pre-existing Structures in the Origin, Propagation and Architecture of Faults in the Main Ethiopian Rift     

Tesfaye Korme  Valerio Acocella  Bekele Abebe 《Gondwana Research》2004,7(2):467-479

Four major fault systems oriented N–S to NNE–SSW, NE–SW, E–W and NW–SE are identified from Landsat Thematic Mapper (TM) images and a high resolution digital elevation model (DEM) over the Ethiopian Rift Valley and the surrounding plateaus. Most of these faults are the result of Cenozoic - extensional reactivation of pre-existing basement structures. These faults interacted with each other at different geological times under different geodynamic conditions. The Cenozoic interaction under an extensional tectonic regime is the major cause of the actual volcano-tectonic landscape in Ethiopia. The Wonji Fault Belt (WFB), which comprises the N–S to NNE–SSW striking rift floor faults, displays peculiar propagation patterns mainly due to interaction with the other fault systems and the influence of underlying basement structures. The commonly observed patterns are: curvilinear oblique-slip faults forming lip-horsts, sinusoidal faults, intersecting faults and locally splaying faults at their ends. Fault-related open structures such as tail-cracks, releasing bends and extensional relay zones and fault intersections have served as principal eruption sites for monogenetic Plio-Quaternary volcanoes in the Main Ethiopian Rift (MER).  相似文献   

Active faulting at the Eurasian, North American and Pacific plates junction     

Andrei I. Kozhurin   《Tectonophysics》2004,380(3-4):273-285

The active faults known and inferred in the area where the major Pacific, North American and Eurasian plates come together group into two belts. One of them comprises the faults striking roughly parallel to the Pacific ocean margin. The extreme members of the belt are the longitudinal faults of islands arcs, in its oceanic flank, and the faults along the continental margins of marginal seas, in its continental flank. The available data show that all these faults move with some strike-slip component, which is always right-lateral. We suggest that characteristic right-lateral, either partially or dominantly, kinematics of the fault movements has its source in oblique convergence of the Pacific plate with continental Eurasian and North American plates. The second belt of active faults transverses the extreme northeast Asia as a continental extension of the active mid-Arctic spreading ridge. The two active fault belts do not cross but come close to each other at the northern margin of the Sea of Okhotsk marking thus the point where the Pacific, North American and Eurasian plates meet.  相似文献