中国西部现今地壳形变与地震活动特征     

李金平 《测绘工程》2008,17(1):6-9

以1999-2004年间中国西部地区近650个GPS站点的观测资料为基础,采用二维“高张力样条”函数内插算法获得了连续地壳形变场。结果表明,相对于稳定欧亚参考框架,中国西部现今地壳运动西强东弱,北向运动从西向东逐渐减弱,东向运动逐渐增强,青藏高原东缘及附近地区是东向运动的消减区带;主应变从西向东由压缩应变转变为拉伸应变;最大剪应变主要位于喜马拉雅地块及其东部地区;中国西部地区地震活动在空间分布上似乎集中发生在印度板块北东向挤压欧亚板块的两条共扼带内,与地壳形变场有一定对应关系,地壳形变的高应变率区为中强地震多发地带。  相似文献   

水泥粉煤灰加固有机质土的试验研究   总被引：3，自引：0，他引：3  

邵俐  刘松玉  杜广印  顾明芬 《工程地质学报》2008,16(3):408-414

对于高有机质含量的泻湖相软土,单纯采用水泥不能有效提高该软土的力学性能,因此提出了采用水泥和粉煤灰作为固化剂的加固方法。通过不同水泥掺入量、粉煤灰掺入量和龄期下水泥土的无侧限抗压强度试验,分析了水泥粉煤灰固化土的强度规律和变形规律,探讨了水泥和粉煤灰加固高有机质含量软土的机理。结果表明,粉煤灰对于水泥试块的早期强度影响较小,对后期强度影响较大;粉煤灰最佳掺入量为12％,超过此掺入量水泥土强度反而会降低,粉煤灰水泥土的破坏应变、E50也在粉煤灰掺量为12％时分别达到最低值和最大值。水泥掺加粉煤灰可有效地提高高有机质含量软土的强度。  相似文献   

Strain localization due to structural in-homogeneities in the Central European Basin System     

Mauro Cacace  Ulf Bayer  Anna Maria Marotta 《International Journal of Earth Sciences》2008,97(5):899-913

The large-scale crustal deformations observed in the Central European Basin System (CEBS) are the result of the interplay between several controlling factors, among which lateral rheological heterogeneities play a key role. We present a finite-element integral thin sheet model of stress and strain distribution within the CEBS. Unlike many previous models, this study is based on thermo-mechanical data to quantify the impact of lateral contrasts on the tectonic deformation. Elasto-plastic material behaviour is used for both the mantle and the crust, and the effects of the sedimentary fill are also investigated. The consistency of model results is ensured through comparisons with observed data. The results resemble the present-day dynamics and kinematics when: (1) a weak granite-like lower crust below the Elbe Fault System is modelled in contrast to a stronger lower crust in the area extending north of the Elbe Line throughout the Baltic region; and (2) a transition domain in the upper mantle is considered between the shallow mantle of the Variscan domain and the deep mantle beneath the East European Craton (EEC), extending from the Elbe Line in the south till the Tornquist Zone. The strain localizations observed along these structural contrasts strongly enhance the dominant role played by large structural domains in stiffening the propagation of tectonic deformation and in controlling the basin formation and the evolution in the CEBS.  相似文献   

分布式光纤传感技术在滑坡监测中的应用   总被引：5，自引：1，他引：4  

史彦新  张青  孟宪玮 《吉林大学学报(地球科学版)》2008,38(5)

将分布式光纤传感技术引入滑坡监测,既可得到整个滑坡体的概要特征,又能提高监测效率。FBG与BOTDR是两种最具代表性的分布式光纤传感技术,FBG通过测量其反射光波长的变化获得应变或温度值。BOTDR通过测定后向布里渊散射光的频移实现分布式温度、应变测量。FBG传感器灵敏度高,但只能实现离散点的准分布式测量,BOTDR可实现分布式、长距离、不间断测量,但其空间分辨率不高。笔者提出FBG与BOTDR联合监测滑坡的方案。在巫山残联滑坡,在整个滑坡体上铺设监测光纤,利用BOTDR获得整个滑坡体的概要信息;在滑坡体变形的关键部位———变形缝安装FBG传感器,获得某些关键部位的应变信息,从而实现由点到线再到面的监测,获得滑坡体较完整的应变信息。  相似文献   

高位瓦斯抽放钻孔在降低综采工作面瓦斯浓度中的应用     

王永军  刘文兰 《中国煤炭地质》2008,(9):74-75

林南仓属于低瓦斯矿井,但存在高瓦斯区域。煤层和采空区是瓦斯的主要来源,尤以采空涌出量大,给煤矿生产和安全带来了极大隐患。通过在1129综采工作面风道施工高位瓦斯孔,把钻孔打到采空区一侧煤层顶板以上冒落裂隙带内,用钻孔进行瓦斯抽放,使采空内的瓦斯通过裂隙带沿钻孔抽出,有效降低综采工作面瓦斯浓度,保证综采工作面正常回采和安全生产。  相似文献   

Strain analysis in Jurassic argillites of the Monte Sirino area (Lagonegro Zone,southern Apennines,Italy) and implications for deformation paths in pelitic rocks     

S. Mazzoli 《International Journal of Earth Sciences》1995,84(4):781-793

Analysis of strain in Jurassic argillites forming part of the folded and thrusted sedimentary succession of the Lagonegro basin (southern Italian Apennines) has been carried out using ellipsoid-shaped reduction spots as strain markers. Most of the determined finite strain ellipsoids are of oblate type and show a peculiar distribution of the maximum extension direction (X), with maxima either subparallel or subperpendicular to the local fold axes. Using the strain matrix method, two different deformation histories have been considered to assist the interpretation of the observed finite strain pattern. A first deformation history involved vertical compaction followed by horizontal shortening (occurring by a combination of true tectonic strain and volume loss), whereby all strain is coaxial and there is no change in the intermediate axis of the strain ellipsoid. By this type of deformation sequence, which produces a deformation path where total strain moves from the oblate to the prolate strain field and back to the oblate field, prolate strain ellipsoids can be generated and may be recorded where tectonic deformation has not been large enough to reverse pretectonic compaction. This type of deformation history may be of local importance within the study area (i.e. it may characterize some fold hinge regions) and, more generally, is probably of limited occurrence in deformed pelitic rocks. A second deformation sequence considered the superposition of pre-tectonic compaction and tectonic strain consisting of initial layer-parallel shortening followed by layer-parallel shear (related to flexural folding). Also in this instance, volume change during tectonic deformation and tectonic plane strain have been assumed. For geologically reasonable amounts of volume loss due to compaction and of initial layer-parallel shortening, this type of deformation history is capable of producing a deformation path entirely lying within the oblate strain field, but still characterized by a changeover, during deformation, of the maximum extension axis (X) from a position parallel to the fold axis to one perpendicular to it. This type of deformation sequence may explain the main strain features observed in the study area, where most of the measured finite strain ellipsoids, determined from the limb regions of flexural folds, display an oblate shape, irrespective of the orientation of their maximum extension direction (X) with respect to the local structural trends. More generally, this type of deformation history provides a mechanism to account for the predominance of oblate strains in deformed pelitic rocks.  相似文献   

Uniaxial compression and tension tests of anthracite and loading rate dependence of peak strength   总被引：2，自引：0，他引：2  

S. Okubo  K. Fukui  Qi Qingxin 《International Journal of Coal Geology》2006,68(3-4):196-204

The mechanical characteristics of coal under uniaxial compressive stress and uniaxial tensile stress are key factors in investigations of the stability of galleries and coal faces, and are vital considerations for the efficient design of coalmines, disaster prevention, and environmental preservation. These mechanical characteristics have long been a topic of research, but remain insufficiently understood. In this study we performed uniaxial compression tests and uniaxial tension tests on coal, with particular attention to two concerns. The first was to measure the loading rate dependence of the peak strength of coal. Coal shows high sample-to-sample scatter in strength; test methods that are successful in comparatively homogeneous rock types cannot be used for coal. We therefore used an alternative test method that was recently developed by the authors. Anthracite samples were subjected to alternating slow and fast strain rates. Measured variations in stress during this process were used to estimate the loading rate dependence of peak strength. The second objective was to obtain complete stress–strain curves for coal under uniaxial tensile stress. It is difficult to hold samples secure during a tensile test; consequently, such curves have yet to be obtained. This study presents a successful application of the authors' method to the analysis of coal samples, yielding a complete stress–strain curve under tensile stress. The two methods presented here hold promise for application not only to anthracite but also to a wide variety of coals. It is possible to derive the values of the constants used in constitutive equations from the obtained experimental results. Once these equations are determined, they can be incorporated into finite-element software to investigate various time-dependent behaviors of coal and aid in the efficient design of coalmines and the prevention of subsidence and mine disasters.  相似文献   

泥晶灰岩地层孔壁坍塌掉块现象及处理          下载免费PDF全文

杜金云 《探矿工程》2006,33(8):51-52

在灰岩地区钻探施工过程中，常见孔壁坍塌、掉块现象，尤其在含泥晶灰岩地层分布区钻进过程中，这种现象尤为突出，轻则影响钻探施工效率，重则造成钻探孔内事故。针对孔内坍塌、掉块现象的征兆及特点，提出了相对应的处理办法。  相似文献   

Experimental and numerical studies of rock salt strain hardening     

M. Hamami 《Geotechnical and Geological Engineering》2006,24(5):1271-1292

The work presented in this paper comes as part of a research program dealing with the thermomechanical behaviour of rock salt. It aims to study laboratory and in-situ long-term behaviour by means of creep tests with deviator and temperature changes. The laboratory results, using a triaxial multi-stages creep tests, highlighted the strain hardening character of rock salt. Furthermore, the in-situ results, using a borehole dilatometer multi-step creep test, have shown that the drilling is carried out in a weakly stressed pillar. The interpretation of the laboratory results, using the J.LEMAITRE law, did not indicate full agreement with all the test results. As a result a ‘double’ J.LEMAITRE model, which takes into account a double strain hardening variable, has been put forward. The validation of this model on the laboratory creep tests is very satisfactory. Furthermore, the activation energy seems satisfactory to represent the influence of the temperature. The in-situ behaviour modelling is clearly more complex than the modelization based on laboratory tests. In fact, it seems that if the rock salt behaviour is maintained by J.LEMAITRE law, it is necessary to vary with the stress, at least, one of the parameters assumed constant in the basic law.  相似文献   

Monitoring of Over Cutting Area and Lubrication Distribution in a Large Slurry Pipe Jacking Operation   总被引：1，自引：0，他引：1  

Saeid Khazaei  Hideki Shimada  Takashi Kawai  Junichi Yotsumoto  Kikuo Matsui 《Geotechnical and Geological Engineering》2006,24(3):735-755

Slurry pipe jacking was firmly established as a special method for the non-disruptive construction of the underground pipelines of sewage systems. Pipe jacking, in its traditional form, has occasionally been used for short railways, roads, rivers, and other projects. Basically the system involves the pushing or thrusting of concrete pipes into the ground by a number of jacks. In slurry pipe jacking, during the pushing process, mud slurry and lubricant are injected into the face and the over cutting area that is between the concrete pipes and the surrounding soil. Next, the slurry fills voids and the soil stabilizes due to the created slurry cake around the pipes. Fillings also reduce the jacking force or thrust during operation. When the drivage and pushing processes are finished, a mortar injection into the over cutting area is carried out in order to maintain permanent stability of the surrounding soil and the over cutting area. Successful lubrication around the pipes is extremely important in a large diameter slurry pipe jacking operation. Control of lubrication and gaps between pipes and soil can prevent hazards such as surface settlement and increases in thrust. Also, to find voids around the pipes after the jacking process, in order to inject mortar for permanent stabilizing, an investigation around the pipes is necessary. To meet these aims, this paper is concerned with the utilization of known methods such as the GPR (Ground Penetrating Radar) system and borehole camera to maintain control of the over cutting area and lubricant distribution around the pipes during a site investigation. From this point of view, experiments were carried out during a tunnel construction using one of the largest cases of slurry pipe jacking in Fujisawa city, Japan. The advantages and disadvantages of each system were clarified during the tests.  相似文献