大湾铀矿田铀-镭平衡系数及迁移富集特征研究     

刘红兵 《华南地质与矿产》2006,(1):34-37

从分析大湾铀矿田各矿床(点)的铀镭平衡系数变化特征出发,结合放射性同位素比值特征分析铀镭迁移富集行为,指出了各矿床(点)氧化带的深度,以了解各铀矿床(点)潜在的工业价值.  相似文献   

库车坳陷侏罗系煤成气动力学模拟研究   总被引：1，自引：0，他引：1  

周强  李贤庆  杨园园  田辉  申家贵 《中国煤田地质》2006,18(1):24-27

应用黄金管—高压釜封闭体系热模拟实验与GC、GC-IRMS分析技术,结合KINETICS专用软件,对库车坳陷侏罗系煤成气进行了动力学模拟研究。库车坳陷侏罗系煤具有高的产气性,在高演化阶段主要产甲烷气;侏罗系煤热解气甲烷碳同位素为-36‰～-25‰,乙烷碳同位素为-28‰～-16‰;甲烷、C2-C5气态烃的生成活化能分别为(47～64k)calm/ol、(55～72k)calm/ol,频率因子各为5.265×1013s-1、5.388×1018s-1。在此基础上,进一步探讨了克拉2气田天然气的成因。研究认为,克拉2气田天然气属阶段捕获的煤成气,主要聚集了5～1Ma时期的天然气,其成熟度Ro分布范围为1.3%～2.5%。  相似文献   

检波器尾锥与地表耦合阻尼研究   总被引：1，自引：0，他引：1  

ZHANG Feng-jiao HAN Li-guo DONG Shi-xue College of GeoExploration Scinece  Technology  Jilin University  Changchun  China 《吉林大学学报(地球科学版)》2006,(Z2)

结合检波器与松散地表耦合的实际,设计了双自由度耦合模型,从理论上分析了检波器与地表耦合系统的特性,并结合野外实验定性地分析了在不同表土情况下,检波器尾锥与地表耦合系统中尾锥与地表之间的阻尼变化时对耦合系统特性及地震资料的影响,揭示了合理的选择检波器尾锥与地表之间的阻尼在地震信号采集中的意义。  相似文献   

生物去除地下水中硫酸盐的实验研究   总被引：1，自引：0，他引：1  

张宏涛  翟辉 《地下水》2005,27(1):19-22

使用平皿夹层厌氧法分离得到纯化的硫酸盐还原菌,通过对比封口、敞口两种情况下细菌培养过程中产生的现象和细菌的生长曲线,表明SRB并非严格的厌氧菌,能耐受一定浓度的环境溶解氧.将该菌用于去除溶液中的SO42-,发现SRB在还原SO42-的过程中,随着SO42-去除率的增加,溶液的pH值会减小,而当SO42-去除率降低时,溶液的pH有增加的趋势;COD/SO42-比值对SO42-的去除率有很重要的影响,在封口情况下,COD/SO42-=0.75时SO42-的最大去除率约为48.60%,COD/SO42比值增加至2.5时,SO42-最大去除率可以达到89.72%,要达到SO42-高去除率,必须增加COD/SO42-比值.  相似文献   

旋转流地转适应过程与能量转换规律     

Fang Juan  Wu Rongsheng 《大气科学进展》2002,19(5):845-854

利用一维线性浅水模式从一个比较普遍的角度对地转适应过程中能量转换的特点进行分析。中首先考虑了两类不同的初始不平衡流的适应问题。一个是Gill所采用的质量不平衡模型，即初始场是静止的，只有水面扰动；另一个是Rossby中所考虑的动量不平衡模型，其初始不平衡流中只有风场的扰动，对这两个模型的适应过程而言，一个显的 特点就是能量转换率始终不会大于1／2或小于0，即适应过程中有位（动）能的释放和向动（位）能的转换，但释放出的能量最多只有其中的一半可以保留在最后的平衡场中。另外，本对任意初始不平衡流适应过程中的能量学特征也进行了分析，指出对于偏差场（相对于一定基本态）的动能和位能而言，上述能量转换关系依然成立。  相似文献   

隧道塌方的尖点灾变模型及应用   总被引：8，自引：0，他引：8  

刘贵应  刘新喜  魏新颜 《地质灾害与环境保护》2002,13(2):59-62

针对隧道塌方失稳问题，运用灾变理论建立隧道塌方失稳的尖点灾变模型。基于平衡曲面方程，可求得隧道围岩体内承载区介质刚度与对应的松驰区弱化介质本构曲线拐点处理刚度之比值K，并给出了塌方与否的判据，当K≤1时，隧道将发生塌方失稳；当K＞1时，隧道将不会发生塌方失稳。根据此模型，笔者解释了隧道中几种常见的灾变破坏机理，并提出了相应的治理方案。  相似文献   

Numerical evaluation of the damping‐solvent extraction method in the frequency domain     

Ushnish Basu  Anil K. Chopra 《地震工程与结构动力学》2002,31(6):1231-1250

The damping‐solvent extraction method for the analysis of unbounded visco‐elastic media is evaluated numerically in the frequency domain in order to investigate the influence of the computational parameters—domain size, amount of artificial damping, and mesh density—on the accuracy of results. An analytical estimate of this influence is presented, and specific questions regarding the influence of the parameters on the results are answered using the analytical estimate and numerical results for two classical problems: the rigid strip and rigid disc footings on a visco‐elastic half‐space with constant hysteretic material damping. As the domain size is increased, the results become more accurate only at lower frequencies, but are essentially unaffected at higher frequencies. Choosing the domain size to ensure that the static stiffness is computed accurately leads to an unnecessarily large domain for analysis at higher frequencies. The results improve by increasing artificial damping but at a slower rate as the total (material plus artificial) damping ratio ζ_t gets closer to 0.866. However, the results do not deteriorate significantly for the larger amounts of artificial damping, suggesting that ζ_t≈0.6 is appropriate; a larger value is not likely to influence the accuracy of results. Presented results do not support the earlier suggestion that similar accuracy can be achieved by a large bounded domain with small damping or by a small domain with larger damping. Copyright © 2002 John Wiley & Sons, Ltd.  相似文献   

Pseudodynamic tests on rubber base isolators with numerical substructuring of the superstructure and strain‐rate effect compensation     

F. J. Molina  G. Verzeletti  G. Magonette  Ph. Buchet  V. Renda  M. Geradin  A. Parducci  M. Mezzi  A. Pacchiarotti  L. Federici  S. Mascelloni 《地震工程与结构动力学》2002,31(8):1563-1582

A pseudodynamic testing procedure has been applied by which the seismic response of a base‐isolated building is obtained by using as specimen the isolators, while the superstructure is numerically simulated. The procedure also takes advantage of the continuous pseudodynamic testing capabilities of the ELSA laboratory, which increase the accuracy of the results and reduce the strain‐rate effect of the rubber bearings. A simple proportional correction of the measured forces compensates the remaining strain‐rate effect due to the unrealistic speed of the test. The correction factor is obtained by means of a characterizing test on the specific rubber isolators. The developed method has been successfully applied to the prediction of the seismic response of a base‐isolated four‐storey building submitted to several specified accelerograms. The results for those earthquakes as well as the effects of some changes of the parameters of the system are discussed. Copyright © 2002 John Wiley & Sons, Ltd.  相似文献   

Study on effects of damping in laminated rubber bearings on seismic responses for a ⅛ scale isolated test structure     

Bong Yoo  Yang‐Hann Kim 《地震工程与结构动力学》2002,31(10):1777-1792

The effects of damping in various laminated rubber bearings (LRB) on the seismic response of a ?‐scale isolated test structure are investigated by shaking table tests and seismic response analyses. A series of shaking table tests of the structure were performed for a fixed base design and for a base isolation design. Two different types of LRB were used: natural rubber bearings (NRB) and lead rubber bearings (LLRB). Three different designs for the LLRB were tested; each design had a different diameter of lead plug, and thus, different damping values. Artificial time histories of peak ground acceleration 0.4g were used in both the tests and the analyses. In both shaking table tests and analyses, as expected, the acceleration responses of the seismically isolated test structure were considerably reduced. However, the shear displacement at the isolators was increased. To reduce the shear displacement in the isolators, the diameter of the lead plug in the LLRB had to be enlarged to increase isolator damping by more than 24%. This caused the isolator stiffness to increase, and resulted in amplifying the floor acceleration response spectra of the isolated test structure in the higher frequency ranges with a monotonic reduction of isolator shear displacement. Copyright © 2002 John Wiley & Sons, Ltd.  相似文献   

Active viscous damping system with amplifying braces for control of MDOF structures     

J. Gluck  Y. Ribakov 《地震工程与结构动力学》2002,31(9):1735-1751

The development and the applications of an active controlled viscous damping device with amplifying braces are described. The system of the dampers, defined as active viscous damping system (AVDS), connected to an amplifying brace (AB) is presented herein. Instantaneous control theory with velocity and acceleration feedback is used to obtain the control forces at each time step during an excitation. Control of the damping forces is possible due to the mechanical structure of the proposed AVDS, and the connection to the AB. The proposed system can be efficiently used to enhance the damping of a structure without modifying its stiffness. The added damping forces can be adjusted in a wide range. The efficiency of the presented system is demonstrated by a numerical simulation of a seven‐storey building subjected to earthquakes. The simulation shows a considerable reduction of control forces required for control to the AVDS with AB, compared to the same system without AB. Copyright © 2002 John Wiley & Sons, Ltd.  相似文献