冲击凿岩钎杆的瞬态动力学分析          下载免费PDF全文

周晔  张国榉 《探矿工程》2006,33(9):46-48

以ANSYS为平台，按照真实工作状态对凿岩钎杆进行了瞬态动力学分析，并对不同活塞形状下分析结果数据进行了比较，为冲击凿岩系统设计提供了理论依据。  相似文献   

Weathering characteristics of arctic islands in northern Norway     

yvind Paasche  Jrund Raukleiv Strmse  Svein Olaf Dahl  Henriette Linge 《Geomorphology》2006,82(3-4):430-452

The arctic islands of the Lofoten-Vesterålen archipelago in northern Norway have a wide distribution of weathered land surfaces commonly located above 250 m with several apparent similarities. In order to investigate the characteristics of (deep) weathering in this region, northern Langøya and Hadseløya were chosen for in-depth analyses. Eight weathering profiles were excavated from various surfaces, and the stratigraphies were logged in detail. Material was collected throughout the weathering horizons, and all samples were subsequently analysed for clay mineralogy (< 63 μm fraction) and grain size distribution. The sampling strategy was complemented by samples from additional saprolites and other landforms such as moraines and rock glaciers. The XRD results indicate that the presence of secondary minerals, such as gibbsite (Al(OH)₃) and kaolinite (Al₂Si₂O₅(OH)₄), are very common throughout the profiles. Gibbsite is an extreme end product of silicate weathering and usually associated with a warmer and more humid climate, as found in Scandinavia during the Tertiary. The grain size analyses (< 63 μm) show that the finer silt fractions (< 8 μm) tend to be high in the profiles (20–40%), with significant amounts of clay (5–15%) demonstrating that the regolith itself is susceptible to frost sorting mechanisms.¹⁰Be exposure dates from in situ quartz knobs on tors and boulders of local origin suggest > 40,000 years of subaerial conditions. Considering the steady surface erosion, this figure should be viewed as an absolute minimum age estimate. Mapping of the superficial sediments and geomorphological features of the study areas has revealed several common morphological features, which indicate dominance of glacial and periglacial processes in the areas lying below the lower boundary of blockfields (c. 250 m). The weathering mantles are not a periglacial end product, but rather a relict tertiary landform that were modulated by permafrost processes as well as biological processes at later stages. The regolith cover constrain the vertical extension of warm-based Quaternary ice sheets challenging the notion of a parabolic ice mass consuming every mountain top of Lofoten and Vesterålen.  相似文献   

PDC钻头在寺河煤矿瓦斯预抽放钻井中的应用   总被引：2，自引：1，他引：2  

吴小建  李新民 《中国煤田地质》2006,18(1):64-65,68

在寺河矿区一期瓦斯地面预抽放钻井施工中，使用传统的镶齿三牙轮钻头钻进，钻进速度低，仅为2.0m／h，且井斜不易控制、钻头寿命短、成本较高。通过对寺河煤矿地层特征的分析，在二期工程施工中，9#煤以上地层优选六翼内凹式PDC钻头钻进，采取一定技术措施并合理调整钻压、转速及泵量等钻进参数，钻速可达7．0m/h，井斜也得到有效控制，降低了钻井成本。  相似文献   

非等截面桩超声波成孔质量检测     

韩亮 《物探与化探》2005,29(2):185-188

分析了非等截面超声波成孔质量检测的几个主要影响因素,给出了相应得改进措施。用工程实例说明超声波反射技术是一种保证非等截面桩成孔质量和成桩质量必不可少的检测方法。  相似文献   

青藏高原东缘缅萨洼金矿成矿流体地质地球化学特征   总被引：3，自引：0，他引：3  

李晓峰毛景文  刘娅铭徐庆鸿　朱和平 《岩石学报》2005,21(1):189-200

缅萨洼金矿位于中国中轴构造带的中南段,青藏高原的东缘,赋存于金河-箐河断裂带次级断裂羊坪子韧性剪切带中本文根据对该矿床硫化物流体包裹体的氦氩同位素、硫化物的硫同位素以及与硫化物共生的石英的流体包裹体特征、成分以及氢氧同位素组成的测定,讨论了缅萨洼金矿的成矿流体来源及其矿床成因。结果显示,该矿床硫化物流体包裹体中的3He/4He变化较小,为0.69-0.82,显示了地幔流体参与成矿作用的可能性。而4He的含量变化范围较大,一般在2.19-10.62×10-6cm3STP/g(方铅矿除外)与3He/4He相比,40Ar/36Ar的比值则变化较小,一般为251-509。而硫化物的δ34S同位素变化范围在-1.8-2.2‰,平均值为0.5‰,说明硫的地幔来源。与硫化物共生的石英的流体包裹体的类型主要有富液相的盐水溶液包裹体、富气相的盐水溶液包裹体、三相CO2包裹体、纯液相CO2包裹体以及有机流体包裹体。成矿流体的氢氧同位素则显示成矿流体来源于岩浆水(或地幔流体)与大气降水的混合流体,本文认为,缅萨洼金矿的成矿流体为地幔流体与大气降水的混合流体,是渐新世印度大陆与亚洲大陆碰撞之后,该地区大规模走滑与剪切作用过程中,局部伸展作用的产物。  相似文献   

襄樊汉江四桥大口径灌注桩成孔施工实践     

李宏伟  侯杰董军 《中国煤田地质》2005,17(2):35-36,42

介绍了使用泥浆护壁气举反循环回转钻进工艺进行襄樊汉江四桥大口径嵌岩桩的施工实践。施工中采用下置双护简隔离卵石层，合理选用钻头类型(卵砾石层采用五翼合金刮刀钻头，基岩采用球齿滚刀钻头)和钻进参数(混合器沉没深度，尾管长度，孔内空气流量与压力)，摸索与总结出一套复杂地层成孔施工经验。  相似文献   

煤田勘查超千米深孔快速钻进技术探讨     

耿建国彭桂湘  丁仲翔 《中国煤田地质》2005,17(6):50-51,57

针对目前国内煤田勘查主要机具及工艺技术方法存在的主要问题,结合煤田勘查地层地质条件和超千米深孔施工要求,研制了液压立轴式HTJ-2000型钻机和新型绳索取心钻具,并就配套设备选型、钻进工艺、钻进参数、泥浆指标及应用效果进行了阐述.该项技术的应用,已明显提高了钻效,使钻孔深度达到1 350m.  相似文献   

DGSC—203型液动射流冲击器在地热井的试验   总被引：4，自引：0，他引：4  

菅志军  桑路等 《地质与勘探》2002,38(5):92-93

介绍了新研制的DGSC－203石油钻井液动射液冲击器的性能参数及结构设计上的创新点，测试所获得的排量与压降之间的关系曲线可指导冲击器的使用。生产性试验证明该冲击器工作稳定，可大幅度提高硬地层钻井效率，克服钻柱振动，延长钻柱的使用寿命，具有良好应用前景。  相似文献   

Physical properties of ultrahigh-pressure metamorphic rocks from the Sulu terrain, eastern central China: implications for the seismic structure at the Donghai (CCSD) drilling site     

Hartmut Kern  Zhenmin Jin  Shan Gao  Till Popp  Zhiqin Xu 《Tectonophysics》2002,354(3-4)

About 30 samples representing major lithologies of Sulu ultrahigh-pressure (UHP) metamorphic rocks were collected from surface exposures and exploration wells, and compressional (Vp) and shear wave (Vs) velocities and their directional dependence (anisotropy) were determined over a range of constant confining pressures up to 600 MPa and temperatures ranging from 20 to 600 °C. Samples range in composition from acidic to ultramafic. P- and S-wave velocities measured at 600 MPa vary from 5.08 to 8.64 km/s and 2.34 to 4.93 km/s, respectively. Densities are in the range from 2.60 to 3.68 g/cm³. To make a direct tie between seismic measurements (refraction and reflection) and subsurface lithologies, the experimental velocity data (corresponding to shallow depths) were used to calculate velocity profiles for the different lithologies and profiles of reflection coefficients at possible lithologic interfaces across the projected 5000-m Chinese Continental Scientific Drilling Program (CCSD) crustal segment. Comparison of calculated in situ velocities with respective intrinsic velocities suggests that the in situ velocities at shallow depths are lowered by an increased abundance of open microcracks. The strongly reflective zone beneath the Donghai drill site can be explained by the impedance contrasts between the different lithologies. Contacts between eclogite/peridotite and felsic rocks (gt-gneiss, granitic gneiss), in particular, may give rise to strong seismic reflections. In addition, shear-induced (lattice preferred orientation (LPO)-related) seismic anisotropy can increase reflectivity. For the explanation of the high velocity bodies (>6.4 km/s) around 1000 m and below 3200-m depth, large proportions of eclogite/peridotite (about 40 and 30 vol.%, respectively) are needed.  相似文献   

交流变频调速CD-2B型岩心钻机的研制          下载免费PDF全文

宋振波  李建华  刘凡柏 《探矿工程》2002,(3):23-26

介绍了交流变频调速CD－2B型岩心钻机研制情况，技术参数，主要特点及型式检验，生产试验等情况。  相似文献