Influence of wettability on interfacial area during immiscible liquid invasion into a 3D self-affine rough fracture: Lattice Boltzmann simulations     

《Advances in water resources》2013

  相似文献   

Numerical experiments for the conductive properties of saturated rock     

《中国科学D辑(英文版)》2008,(Z2)

The reservoir evaluation as a key technology in oil exploration and production is based on the electrical transport property (ETP) of saturated rock that is described in a mathematical form with Arhcie’s equa-tion. But there have been increasing cases observed in many researches indicating that the ETP is non-Archie especially for the complex reservoir with low porosity and permeability. In this paper,the numerical experiments based on the Lattice Boltzmann method (LBM) have been employed to study the effect of porous structure and fluids on the ETP for revealing the nature of non-Archie phenomenon in micro-scale. The results of numerical experiments have proved that the saturation exponent n is a function of water saturation and porosity instead of being a constant in Archie’s equation. And then,a new formula has been developed for the EPT through combining the result of numerical simulation with that of laboratory measurements. The calculations from the new formula show very good agreement with laboratory measurements to demonstrate the efficiency of the new formula over the conventional methods in non-Archie rock.  相似文献   

阿拉尔绿洲灌区棉田土壤水分扩散率的测定   总被引：1，自引：0，他引：1  

胡顺军  李修仓  田长彦  宋郁东 《干旱区地理》2009,32(6)

土壤水分扩散率是研究土壤水盐运动的重要参数之一。在室内用非稳定流水平土柱法对塔里木河流域阿拉尔绿洲灌区棉田土壤水分扩散率进行了测定。建立了Boltzmann变换参数、土壤水分扩散率与土壤含水率之间的定量关系。结果表明:土壤水分扩散率与土壤含水率呈单调递增关系。当土壤含水率趋近饱和含水率时,土壤水分扩散率趋近于无穷大。因此,用指数函数或幂函数不能很好地刻画土壤水分扩散系数与土壤的体积含水量之间的定量关系。本文建立的土壤水分扩散率与土壤含水率之间的函数关系较好地反映了土壤水分扩散系数与土壤的体积含水量之间的客观规律。  相似文献   

Pore‐scale modeling of surface erosion in a particle bed     

Y. Abdelhamid  U. El Shamy 《国际地质力学数值与分析法杂志》2014,38(2):142-166

A fully coupled transient two‐dimensional model was employed to study fundamentals of flood‐induced surface erosion in a particle bed. The interaction of the liquid and solid phases is the key mechanism related to surface erosion. The solid phase was idealized at a particle scale by using the discrete element method. The fluid phase was modeled at a mesoscale level and solved using the lattice Boltzmann method. The fluid forces applied on the particles were calculated on the basis of the momentum the fluid exchanges with the particle. The proposed approach was used to model both single particles and particle beds subjected to Couette flow conditions. The behavior of both the single particle and the particle bed depended on particle diameter and surface shear fluid velocity. The conducted simulations show that the fluid flow profile penetrates the bed for a small distance. This penetration initiates sheet‐flow and surface erosion as the fluid interacts with particles. The effect of suppressing particle rotation on the fluid‐induced forces on the particle was also examined. Suppressing particle spinning may lead to underestimated erosion rate. Results of fluid and particle velocities were compared against experimental results and appeared to agree with the observed trends.Copyright © 2013 John Wiley & Sons, Ltd.  相似文献   

A coupled 3‐dimensional bonded discrete element and lattice Boltzmann method for fluid‐solid coupling in cohesive geomaterials          下载免费PDF全文

Min Wang  Y.T. Feng  G.N. Pande  T.T. Zhao 《国际地质力学数值与分析法杂志》2018,42(12):1405-1424

This paper presents a 3D bonded discrete element and lattice Boltzmann method for resolving the fluid‐solid interaction involving complicated fluid‐particle coupling in geomaterials. In the coupled technique, the solid material is treated as an assembly of bonded and/or granular particles. A bond model accounting for strain softening in normal contact is incorporated into the discrete element method to simulate the mechanical behaviour of geomaterials, whilst the fluid flow is solved by the lattice Boltzmann method based on kinetic theory and statistical mechanics. To provide a bridge between theory and application, a 3D algorithm of immersed moving boundary scheme was proposed for resolving fluid‐particle interaction. To demonstrate the applicability and accuracy of this coupled method, a benchmark called quicksand, in which particles become fluidised under the driving of upward fluid flow, is first carried out. The critical hydraulic gradient obtained from the numerical results matches the theoretical value. Then, numerical investigation of the performance of granular filters generated according to the well‐acknowledged design criteria is given. It is found that the proposed 3D technique is promising, and the instantaneous migration of the protected soils can be readily observed. Numerical results prove that the filters which comply with the design criteria can effectively alleviate or eliminate the appearance of particle erosion in dams.  相似文献   

Raman spectroscopy, vibrational analysis, and heating of buergerite tourmaline     

David A. McKeown 《Physics and Chemistry of Minerals》2008,35(5):259-270

Polarized Raman spectra were collected for single crystal buergerite (NaFe₃Al₆(BO₃)₃Si₆O₁₈(O_0.92(OH)_0.08)₃F) from room temperature to near 1,375°C. Vibrational assignments to features in the room temperature spectra were determined by lattice dynamics calculations, where internal BO₃ motions dominate modes near 1,300 cm⁻¹, internal SiO₄ displacements dominate modes between 900 and 1,200 cm⁻¹, while less localized displacements within the isolated Si₆O₁₈ ring mix with motions within Na, Fe, Al, F, and BO₃ environments for fundamental modes below 780 cm⁻¹. At elevated temperatures, most buergerite Raman features broaden and shift to lower frequencies up to 900°C. Above this temperature, the lattice mode peaks evolve into broad bands, while OH stretch modes near 3,550 cm⁻¹ disappear. According to Raman spectroscopy, X-ray diffraction, differential thermal analysis, and scanning electron microscopy, buergerite undergoes a complex transition that starts near 700°C and extends over a 310°C interval, where initially, Al and Fe probably become disordered within the Y- and Z-sites, and most F and all OH are later liberated. A reversible crystal-to-amorphous transition is seen by Raman for buergerite fragments heated as high as 930°C. Buergerite becomes permanently altered when heated to temperatures greater than 930°C; after cooling to room temperature, these altered fragments are comprised of mullite and Fe-oxide crystals suspended in an amorphous borosilicate matrix.  相似文献   

孔隙尺度多孔介质流体流动与溶质运移高性能模拟   总被引：2，自引：0，他引：2       下载免费PDF全文

周鸿翔  郑延丰  吴劳生  陈铖  曾令藻 《水科学进展》1990,31(3):422-432

深入探究孔隙尺度下的流体流动特性和溶质运移规律对石油开采、农田养分管理、地下水污染修复有着重要意义。以人工构建的多孔介质结构和同步辐射X射线显微CT扫描的土壤团聚体（分辨率3.7 μm）为研究对象，在空间节点数多达64 000 000的情况下，基于格子Boltzmann模型和GPU并行技术计算得到多孔介质流体运动和溶质运移过程的关键参数，并据此探究多孔介质空间异质性对水力学特性的影响。通过对3组不同结构的多孔介质比较发现，结构复杂程度最高的土壤样品和不规则堆叠的圆球结构的渗透率在100 mD（即10^-13m²）量级，远低于规则堆叠的圆球结构（>20 000 mD）；土壤的迂曲度为1.40~1.60，明显高于规则堆叠的圆球结构。研究结果表明，渗透率大的样品具有较小的迂曲度，这与结构的空间异质性有较强的关系；土壤的渗透率和迂曲度呈现各向异性；在水力梯度一定的前提下，渗透率较大的样品，纵向弥散系数也较大；同时，结构的异质性也会影响溶质的穿透曲线。本研究提出的模拟方法可在土壤结构中进行高效的水流运动和溶质运移模拟，可用于土壤多孔介质在孔隙尺度下的水力学特性研究。  相似文献   

广东河台云西金矿床石英的拉曼光谱特征及其对含金性的评价   总被引：1，自引：0，他引：1  

陈伟  胡伦积 《矿物学报》1990,10(2):180-185

本文对广东河台云西金矿的石英进行了拉曼光谱研究。结果表明,含金石英与不含金石英的拉曼光谱有着本质的差异。作者通过量子理论的研究,对其差异进行了剖析,发现这种差异与它们之间成分、组构、形成温度的差异紧密联系。因此,作者得出结论:石英的拉曼光谱可以用于评价其含金性。  相似文献   

Microstructural evidence for the transition from dislocation creep to dislocation-accommodated grain boundary sliding in naturally deformed plagioclase     

《Journal of Structural Geology》2016

We use quantitative microstructural analysis including misorientation analysis based on electron backscatter diffraction (EBSD) data to investigate deformation mechanisms of naturally deformed plagioclase in an amphibolite gabbro mylonite. The sample is from lower oceanic crust exposed near the Southwest Indian Ridge, and it has a high ratio of recrystallized matrix grains to porphyroclasts. Microstructures preserved in porphyroclasts suggest that early deformation was achieved principally by dislocation creep with subgrain rotation recrystallization; recrystallized grain (average diameter ∼8 μm) microstructures indicate that subsequent grain boundary sliding (GBS) was active in the continued deformation of the recrystallized matrix. The recrystallized matrix shows four-grain junctions, randomized misorientation axes, and a shift towards higher angles for neighbor-pair misorientations, all indicative of GBS. The matrix grains also exhibit a shape preferred orientation, a weak lattice preferred orientation consistent with slip on multiple slip systems, and intragrain microstructures indicative of dislocation movement. The combination of these microstructures suggest deformation by dislocation-accommodated GBS (DisGBS). Strain localization within the recrystallized matrix was promoted by a transition from grain size insensitive dislocation creep to grain size sensitive GBS, and sustained by the maintenance of a small grain size during superplasticity.  相似文献   

宿松杂岩中白云母的矿物学特征及地质意义          下载免费PDF全文

李海龙  宋传中  李加好  任升莲  王道轩  王微  杨帆 《地质科学》2016,(4):1246-1260

大别山为印支期扬子陆块和华北陆块之间的碰撞造山带。太湖—宿松地区位于大别山东段部位,主要由扬子陆块北缘不同变质程度的变质基底和少量浅变质盖层组成。本文选择了宿松杂岩中的白云母进行探针分析以及X射线粉末衍射分析,研究结果表明宿松杂岩中的白云母都是2M₁型且均为多硅白云母。其中,多硅白云母的晶胞参数b₀平均值为9.039,显示宿松杂岩的变质压力为中压—高压。根据宿松杂岩中白云母的显微变形特征可以知道白云母至少存在着两期变形,一期是导致石榴子石压力影形成和白云母右旋的构造作用,应该对应着燕山期大别造山带中-下地壳物质发生平行造山带向东流动的地质事件。另一期是导致白云母形成涡流构造形成的构造作用,这一期构造应该对应扬子板块和华北板块碰撞事件。根据白云母中的Ti温度计和多硅白云母压力计可以得出宿松杂岩的变质条件为T=480 ℃～579 ℃,P=0.7～1.2 GPa,属于绿片岩相到角闪岩相。  相似文献