GIS-based flood hazard mapping at different administrative scales: A case study in Gangetic West Bengal, India   总被引：4，自引：0，他引：4  

Joy Sanyal  X.X. Lu 《Singapore journal of tropical geography》2006,27(2):207-220

This paper addresses the need for an efficient and cost-effective methodology for preparing flood hazard maps in data poor countries, particularly those under a monsoon regime where floods pose a recurrent danger. Taking Gangetic West Bengal, India, as an example and using available historical data from government agencies, the study compiled a regional map indicating hazard prone subregional areas for further detailed investigation, thereby isolating actual high risk localities. Using a GIS (Geographical Information System), a composite hazard index was devised incorporating variables of flood frequency, population density, transportation networks, access to potable water, and availability of high ground and maximum risk zones were mapped accordingly. A digital elevation model derived from high resolution imagery available in the public domain was used to calculate elevated areas suitable for temporary shelter during a flood. Selecting administrative units of analysis at the lowest possible scales – rural development blocks (regional) and revenue villages (subregional) – also ensures that hazard mapping is prepared in line with the existing rural planning and administrative authorities responsible for remedial intervention.  相似文献   

PDC钻头在寺河煤矿瓦斯预抽放钻井中的应用   总被引：2，自引：1，他引：2  

吴小建  李新民 《中国煤田地质》2006,18(1):64-65,68

在寺河矿区一期瓦斯地面预抽放钻井施工中，使用传统的镶齿三牙轮钻头钻进，钻进速度低，仅为2.0m／h，且井斜不易控制、钻头寿命短、成本较高。通过对寺河煤矿地层特征的分析，在二期工程施工中，9#煤以上地层优选六翼内凹式PDC钻头钻进，采取一定技术措施并合理调整钻压、转速及泵量等钻进参数，钻速可达7．0m/h，井斜也得到有效控制，降低了钻井成本。  相似文献   

非等截面桩超声波成孔质量检测     

韩亮 《物探与化探》2005,29(2):185-188

分析了非等截面超声波成孔质量检测的几个主要影响因素,给出了相应得改进措施。用工程实例说明超声波反射技术是一种保证非等截面桩成孔质量和成桩质量必不可少的检测方法。  相似文献   

襄樊汉江四桥大口径灌注桩成孔施工实践     

李宏伟  侯杰董军 《中国煤田地质》2005,17(2):35-36,42

介绍了使用泥浆护壁气举反循环回转钻进工艺进行襄樊汉江四桥大口径嵌岩桩的施工实践。施工中采用下置双护简隔离卵石层，合理选用钻头类型(卵砾石层采用五翼合金刮刀钻头，基岩采用球齿滚刀钻头)和钻进参数(混合器沉没深度，尾管长度，孔内空气流量与压力)，摸索与总结出一套复杂地层成孔施工经验。  相似文献   

煤田勘查超千米深孔快速钻进技术探讨     

耿建国彭桂湘  丁仲翔 《中国煤田地质》2005,17(6):50-51,57

针对目前国内煤田勘查主要机具及工艺技术方法存在的主要问题,结合煤田勘查地层地质条件和超千米深孔施工要求,研制了液压立轴式HTJ-2000型钻机和新型绳索取心钻具,并就配套设备选型、钻进工艺、钻进参数、泥浆指标及应用效果进行了阐述.该项技术的应用,已明显提高了钻效,使钻孔深度达到1 350m.  相似文献   

DGSC—203型液动射流冲击器在地热井的试验   总被引：4，自引：0，他引：4  

菅志军  桑路等 《地质与勘探》2002,38(5):92-93

介绍了新研制的DGSC－203石油钻井液动射液冲击器的性能参数及结构设计上的创新点，测试所获得的排量与压降之间的关系曲线可指导冲击器的使用。生产性试验证明该冲击器工作稳定，可大幅度提高硬地层钻井效率，克服钻柱振动，延长钻柱的使用寿命，具有良好应用前景。  相似文献   

中生代羌塘前陆盆地充填序列及演化过程   总被引：40，自引：1，他引：40  

李勇  王成善  伊海生 《地层学杂志》2002,26(1):62-67,79

中生代羌塘前陆盆地位于青藏高原巨型造山带内 ,夹于金沙江缝合带与班公湖—怒江缝合带之间 ,是一个与两侧缝合带逆冲作用相关的沉积盆地 ,由羌北盆地 (对应于金沙江缝合带 )、羌南盆地 (对应于班公湖—怒江缝合带 )和中央隆起带构成 ,其中中央隆起是北部前陆盆地和南部前陆盆地共有的前陆隆起 ,显示为对称型复合前陆盆地 ;该盆地形成于晚三叠世 ,并持续发育至早白垩世 ,盆地中充填了巨厚的同构造期的复理石和磨拉石 ,具有总体向上变粗变浅的充填序列 ,以不整合面可将其划分为 5个由顶底不整合面限制的构造层序 ,其中晚三叠世诺利期构造层序对应于金沙江缝合带主碰撞期 ,晚三叠世瑞替期构造层序对应于金沙江缝合带碰撞闭合后冲断抬升 ,早侏罗世构造层序对应于班公湖—怒江缝合带初始逆冲推覆 ,中侏罗世—早白垩世构造层序对应于班公湖—怒江缝合带主碰撞期 ,中白垩世构造层序为班公湖—怒江缝合带碰撞闭合后冲断抬升与金沙江缝合带冲断抬升的产物 ,为中生代羌塘盆地关闭后的磨拉石建造  相似文献   

纤维素接枝丙烯酰胺/高岭土高吸水性复合材料研究   总被引：26，自引：3，他引：26  

林松柏  林建明  吴季怀  肖春妹 《矿物学报》2002,22(4):299-302

在高岭土的存在下，以N，N－亚甲基双丙烯酰胺作交联剂，以硝酸铈铵为引发剂微晶纤维素与丙烯酰胺进行接枝共聚反应，合成接枝纤维素／高岭土高吸水性复合材料。研究了纤维素与单体的配比、高岭土添加量、交联剂用量、引发剂用量及反应温度对吸水率的影响。用红外光谱表征复合材料的结构，用电子显微镜观察复合材料的表面与界面。结果表明，高岭土在接枝聚合物中能较好分散，复合材料吸水率达1166，对生理盐水溶液的吸水率达86。  相似文献   

Physical properties of ultrahigh-pressure metamorphic rocks from the Sulu terrain, eastern central China: implications for the seismic structure at the Donghai (CCSD) drilling site     

Hartmut Kern  Zhenmin Jin  Shan Gao  Till Popp  Zhiqin Xu 《Tectonophysics》2002,354(3-4)

About 30 samples representing major lithologies of Sulu ultrahigh-pressure (UHP) metamorphic rocks were collected from surface exposures and exploration wells, and compressional (Vp) and shear wave (Vs) velocities and their directional dependence (anisotropy) were determined over a range of constant confining pressures up to 600 MPa and temperatures ranging from 20 to 600 °C. Samples range in composition from acidic to ultramafic. P- and S-wave velocities measured at 600 MPa vary from 5.08 to 8.64 km/s and 2.34 to 4.93 km/s, respectively. Densities are in the range from 2.60 to 3.68 g/cm³. To make a direct tie between seismic measurements (refraction and reflection) and subsurface lithologies, the experimental velocity data (corresponding to shallow depths) were used to calculate velocity profiles for the different lithologies and profiles of reflection coefficients at possible lithologic interfaces across the projected 5000-m Chinese Continental Scientific Drilling Program (CCSD) crustal segment. Comparison of calculated in situ velocities with respective intrinsic velocities suggests that the in situ velocities at shallow depths are lowered by an increased abundance of open microcracks. The strongly reflective zone beneath the Donghai drill site can be explained by the impedance contrasts between the different lithologies. Contacts between eclogite/peridotite and felsic rocks (gt-gneiss, granitic gneiss), in particular, may give rise to strong seismic reflections. In addition, shear-induced (lattice preferred orientation (LPO)-related) seismic anisotropy can increase reflectivity. For the explanation of the high velocity bodies (>6.4 km/s) around 1000 m and below 3200-m depth, large proportions of eclogite/peridotite (about 40 and 30 vol.%, respectively) are needed.  相似文献   

交流变频调速CD-2B型岩心钻机的研制          下载免费PDF全文

宋振波  李建华  刘凡柏 《探矿工程》2002,(3):23-26

介绍了交流变频调速CD－2B型岩心钻机研制情况，技术参数，主要特点及型式检验，生产试验等情况。  相似文献