脐带缆螺旋滑移分析及力学性能研究   总被引：1，自引：0，他引：1  

李英  吴潘  冯雅萍  曹静萱 《海洋工程》2018,36(6):58-68

针对脐带缆内部螺旋层,应用Darboux标架建立螺旋结构空间坐标系,推导弯曲载荷下螺旋结构的局部变形和滑移。考虑螺旋构件间的接触和摩擦作用,建立螺旋结构的受力平衡偏微分方程,并研究螺旋角和摩擦系数对螺旋结构滑移的影响。基于同层螺旋结构本构关系相同假设,将所有螺旋结构力学性能线性叠加,拟合脐带缆整体弯曲刚度。运用建立的理论解析方法,对某双层铠装脐带缆的力学性能进行研究,并与数值模拟结果进行对比验证。对比结果表明,理论解析得到的螺旋滑移结果与数值模拟结果一致,理论解析得到的脐带缆弯曲刚度与数值模拟结果在全滑动阶段比较接近。  相似文献   

南海风暴潮对风场和外围海水敏感性研究     

李健  刘清容  阮成卿  訚忠辉  冀承振 《海洋科学》2018,42(2):99-107

为探索来自西北太平洋台风风暴潮与南海局地生成台风风暴潮不同,本研究在假设两种台风气象条件相同情况下,研究随台风而来外围海水所形成增水对南海沿岸的影响。以0814"黑格比"强台风风暴潮为基础,使用ROMS(regional ocean modeling system)模式进行数值模拟并通过设计对比试验方法进行研究,研究发现在台风登陆时引起的增水最大,最大增水出现在台风路径右侧,其中在沿岸区域,外围海水形成增水约占总增水10%,且大约3 h后出现增水回震现象。同时,设计对比试验,研究来自西北太平洋台风风暴潮对台风路径、台风强度、台风移动速度和流入角等气象条件敏感性,并获得与前人一致的结果。  相似文献   

基于UDF的水平轴潮流能水轮机被动旋转水动力性能研究   总被引：1，自引：1，他引：0  

陈文鹏  刘胤超  陈立卫 《海洋工程》2018,36(2):119-126

针对水平轴潮流能水轮机被动旋转问题,基于Fluent 17.0,运用UDF(User Defined Function)控制滑移网格对网格进行动态调整,仿真研究水轮机在不同安放角下被动旋转的水动力特性。通过仿真分析,结果表明:潮流能水轮机随着叶片安放角度的增加,尖速比、输出功率、捕能系数都是先增大后减小,叶片安放角为6°时,叶轮前后速度差最大,对潮流能利用充分,且各项性能均达到最佳;通过分析叶片受力,叶尖叶素在安放角为2°时阻力最大,3°时升力最大,升阻比在6°时最大,此时叶尖叶素升阻比C_L/C_D=6.27、攻角α=3.06°。由仿真结果可知水平轴潮流能叶轮的自启动过程由5个阶段组成,即加速度增大的加速运动段—加速度减小的加速运动段—加速度反向增大的减速运动段—加速度反向减小的减速运动段—稳定运行段,这对潮流能水轮机的设计具有重要的指导意义。  相似文献   

三维旋转扫描测量平台设计与实现     

吴俣  叶泽田  孙立业  康永伟 《测绘科学》2009,34(6)

本设计主要用于360°旋转的三维扫描,实现角度数据的实时获取。设计中采用单片机控制交流伺服电机进行自定的角度、速度与方向的旋转并实时上传时间、角度数据至上位机进行处理,实现了对平台旋转精度的控制与检测,着重研究了该传感器误差源的产生,对实际应用中的误差进行了定量分析,利用偏心改正、4分频等方法减少了误差,提高了参数精度。角度范围为360°,角度分辨率为0.01°。  相似文献   

Bond rolling resistance and its effect on yielding of bonded granulates by DEM analyses     

M. J. Jiang  H. S. Yu  D. Harris 《国际地质力学数值与分析法杂志》2006,30(8):723-761

A discrete element modelling of bonded granulates and investigation on the bond effect on their behaviour are very important to geomechanics. This paper presents a two‐dimensional (2‐D) discrete element theory for bonded granulates with bond rolling resistance and provides a numerical investigation into the effect of bond rolling resistance on the yielding of bonded granulates. The model consists of mechanical contact models and equations governing the motion of bonded particles. The key point of the theory is that the assumption in the original bond contact model previously proposed by the authors (55th CSCE‐ASCE Conference, Hamilton, Ont., Canada, 2002; 313–320; J. Eng. Mech. (ASCE) 2005; 131 (11):1209–1213) that bonded particles are in contact at discrete points, is here replaced by a more reliable assumption that bonded particles are in contact over a width. By making the idealization that the bond contact width is continuously distributed with the normal/tangential basic elements (BE) (each BE is composed of spring, dashpot, bond, slider or divider), we establish a bond rolling contact model together with bond normal/tangential contact models, and also relate the governing equations to local equilibrium. Only one physical parameter β needs to be introduced in the theory in comparison to the original bond discrete element model. The model has been implemented into a 2‐D distinct element method code, NS2D. Using the NS2D, a total of 86 1‐D, constant stress ratio, and biaxial compressions tests have been carried out on the bonded granular samples of different densities, bonding strengths and rolling resistances. The numerical results show that: (i) the new theory predicts a larger internal friction angle, a larger yielding stress, more brittle behaviour and larger final broken contact ratio than the original bond model; (ii) the yielding stress increases nonlinearly with the increasing value of β, and (iii) the first‐yield curve (initiation of bond breakage), which define a zone of none bond breakage and which shape and size are affected by the material density, is amplified by the bond rolling resistance in analogous to that predicted by the original bond model. Copyright © 2006 John Wiley & Sons, Ltd.  相似文献   

Fluid infiltration during contact metamorphism of interbedded marble and calc-silicate hornfels, Twin Lakes area, central Sierra Nevada, California     

S. R. DAVIS  J. M. FERRY 《Journal of Metamorphic Geology》1993,11(1):71-88

Abstract In the Twin Lakes area, central Sierra Nevada, California, most contact metamorphosed marbles contain calcite + dolomite + forsterite ± diopside ± phlogopite ± tremolite, and most calc-silicate hornfelses contain calcite + diopside + wollastonite + quartz ± anorthite ± K-feldspar ± grossular ± titanite. Mineral-fluid equilibria involving calcite + dolomite + tremolite + diopside + forsterite in two marble samples and wollastonite + anorthite + quartz + grossular in three hornfels samples record P± 3 kbar and T± 630° C. Various isobaric univariant assemblages record CO₂-H₂O fluid compositions of χCO₂= 0.61–0.74 in the marbles and χCO₂= 0.11 in the hornfelses. Assuming a siliceous dolomitic limestone protolith consisting of dolomite + quartz ° Calcite ± K-feldspar ± muscovite ± rutile, all plausible prograde reaction pathways were deduced for marble and hornfels on isobaric T-XCO₂ diagrams in the model system K₂O-CaO-MgO-Al₂O₃-SiO₂-H₂O-CO₂. Progress of the prograde reactions was estimated from measured modes and mass-balance calculations. Time-integrated fluxes of reactive fluid which infiltrated samples were computed for a temperature gradient of 150 °C/km along the fluid flow path, calculated fluid compositions, and estimated reaction progress using the mass-continuity equation. Marbles and hornfelses record values in the range 0.1–3.6 × 10⁴ cm³/cm² and 4.8–12.9 × 10⁴ cm³/cm², respectively. For an estimated duration of metamorphism of 10⁵ years, average in situ metamorphic rock permeabilities, calculated from Darcy's Law, are 0.1–8 × 10^?6 D in the marbles and 10–27 × 10^?6 D in the hornfelses. Reactive metamorphic fluids flowed up-temperature, and were preferentially channellized in hornfelses relative to the marbles. These results appear to give a general characterization of hydrothermal activity during contact metamorphism of small pendants and screens (dimensions ± 1 km or less) associated with emplacement of the Sierra Nevada batholith.  相似文献   

The second order characteristic condition for plastic flow     

Graham Weir  Roger Young 《国际地质力学数值与分析法杂志》2003,27(15):1299-1316

In this paper the second order characteristic (discontinuous bifurcation) condition is derived for the granular flow (fully plastic) equations. This second order bifurcation equation is shown to be formally identical to the first order localization requirement during steady elastoplastic deformation provided the elastic compliance tensor is substituted for the product of the plastic multiplier with the flow Hessian. For isotropic yield and flow functions the invariant form of the characteristic condition is given in detail, as well as an alternative expression in adapted co‐ordinates. The characteristic condition can be regarded as defining a hardening function which is maximized to identify the critical angles. When the method is applied to 3D Coulomb flow, Mohr's 3D fracture plane conditions are obtained uniquely. Copyright © 2003 John Wiley & Sons, Ltd.  相似文献   

△T球体异常的三元解释法     

蔡家雄 《湖南地质》1994,13(3):155-162

在△Ｔ异常解释课题中，一个新的角度参量─—视磁化特征角的拟定，最大限度地简化了球体磁场表达式。从而才有可能通过特殊解法，给出了球体磁场的极值与拐点公式。作者据此建立了四种不受正常场制约、仅需异常的局部持征曲线即可全面解释三度异常的解释方法。屏障分解、叠加判别、三元迭代的设计，为解释三度体叠加异常给出了简单而易行的途径。  相似文献   

Hα Photometry of Two Contact Binaries     

Szilárd Csizmadia  Zsolt Kővári  Péter Klagyivik 《Astrophysics and Space Science》2006,304(1-4):355-357

We carried out optical and Hα photometry of two contact binaries (V861 Herculis, EQ Tauri). The light curve modeling revealed stellar spots in both contact systems and strong Hα excess in the position of the observed stellar spots. A correlation was found between the V−R and R−H_α colour indices of V861 Her.  相似文献   

On the Period Variation of the W UMa-type Contact Binary V502 Ophiuchi     

Qing-Yao Liu  Yu-Lan Yang National Astronomical Observatories/Yunnan Observatory  Chinese Academy of Sciences  Kunming   《中国天文和天体物理学报》2006,6(3):331-337

The variation in the orbital period of the W UMa type contact binary V502 Oph is analyzed. The orbital period exhibits a wavelike variation with a periodicity of 23.0 years and an amplitude of △P = 1.24×10~(-6) days superimposed on secular decrease of dP/dt = 1.68×10-7 day per year. The long-term decrease may be accompanied by the contraction of the secondary at a rate of 83 m per year and a mass transfer rate from the primary to the secondary of 4.28×10~8 M per year. The short-term oscillation may be explained by the presence of a third component. Orbital elements of the third body and its possible mass are presented.  相似文献