PDC钻头在寺河煤矿瓦斯预抽放钻井中的应用   总被引：2，自引：1，他引：2  

吴小建  李新民 《中国煤田地质》2006,18(1):64-65,68

在寺河矿区一期瓦斯地面预抽放钻井施工中，使用传统的镶齿三牙轮钻头钻进，钻进速度低，仅为2.0m／h，且井斜不易控制、钻头寿命短、成本较高。通过对寺河煤矿地层特征的分析，在二期工程施工中，9#煤以上地层优选六翼内凹式PDC钻头钻进，采取一定技术措施并合理调整钻压、转速及泵量等钻进参数，钻速可达7．0m/h，井斜也得到有效控制，降低了钻井成本。  相似文献   

非等截面桩超声波成孔质量检测     

韩亮 《物探与化探》2005,29(2):185-188

分析了非等截面超声波成孔质量检测的几个主要影响因素,给出了相应得改进措施。用工程实例说明超声波反射技术是一种保证非等截面桩成孔质量和成桩质量必不可少的检测方法。  相似文献   

襄樊汉江四桥大口径灌注桩成孔施工实践     

李宏伟  侯杰董军 《中国煤田地质》2005,17(2):35-36,42

介绍了使用泥浆护壁气举反循环回转钻进工艺进行襄樊汉江四桥大口径嵌岩桩的施工实践。施工中采用下置双护简隔离卵石层，合理选用钻头类型(卵砾石层采用五翼合金刮刀钻头，基岩采用球齿滚刀钻头)和钻进参数(混合器沉没深度，尾管长度，孔内空气流量与压力)，摸索与总结出一套复杂地层成孔施工经验。  相似文献   

煤田勘查超千米深孔快速钻进技术探讨     

耿建国彭桂湘  丁仲翔 《中国煤田地质》2005,17(6):50-51,57

针对目前国内煤田勘查主要机具及工艺技术方法存在的主要问题,结合煤田勘查地层地质条件和超千米深孔施工要求,研制了液压立轴式HTJ-2000型钻机和新型绳索取心钻具,并就配套设备选型、钻进工艺、钻进参数、泥浆指标及应用效果进行了阐述.该项技术的应用,已明显提高了钻效,使钻孔深度达到1 350m.  相似文献   

在局域网中如何实现共享上网     

蓝设华 《气象研究与应用》2002,23(3):48-49

在局域网中 ,通过代理服务器等一些软件或者 Internet连接共享路由器此类的硬件来实现在只有一条电话线或者是一个 ADSL接入的条件下共享上网  相似文献   

DGSC—203型液动射流冲击器在地热井的试验   总被引：4，自引：0，他引：4  

菅志军  桑路等 《地质与勘探》2002,38(5):92-93

介绍了新研制的DGSC－203石油钻井液动射液冲击器的性能参数及结构设计上的创新点，测试所获得的排量与压降之间的关系曲线可指导冲击器的使用。生产性试验证明该冲击器工作稳定，可大幅度提高硬地层钻井效率，克服钻柱振动，延长钻柱的使用寿命，具有良好应用前景。  相似文献   

Study on effects of damping in laminated rubber bearings on seismic responses for a ⅛ scale isolated test structure     

Bong Yoo  Yang‐Hann Kim 《地震工程与结构动力学》2002,31(10):1777-1792

The effects of damping in various laminated rubber bearings (LRB) on the seismic response of a ?‐scale isolated test structure are investigated by shaking table tests and seismic response analyses. A series of shaking table tests of the structure were performed for a fixed base design and for a base isolation design. Two different types of LRB were used: natural rubber bearings (NRB) and lead rubber bearings (LLRB). Three different designs for the LLRB were tested; each design had a different diameter of lead plug, and thus, different damping values. Artificial time histories of peak ground acceleration 0.4g were used in both the tests and the analyses. In both shaking table tests and analyses, as expected, the acceleration responses of the seismically isolated test structure were considerably reduced. However, the shear displacement at the isolators was increased. To reduce the shear displacement in the isolators, the diameter of the lead plug in the LLRB had to be enlarged to increase isolator damping by more than 24%. This caused the isolator stiffness to increase, and resulted in amplifying the floor acceleration response spectra of the isolated test structure in the higher frequency ranges with a monotonic reduction of isolator shear displacement. Copyright © 2002 John Wiley & Sons, Ltd.  相似文献   

Physical properties of ultrahigh-pressure metamorphic rocks from the Sulu terrain, eastern central China: implications for the seismic structure at the Donghai (CCSD) drilling site     

Hartmut Kern  Zhenmin Jin  Shan Gao  Till Popp  Zhiqin Xu 《Tectonophysics》2002,354(3-4)

About 30 samples representing major lithologies of Sulu ultrahigh-pressure (UHP) metamorphic rocks were collected from surface exposures and exploration wells, and compressional (Vp) and shear wave (Vs) velocities and their directional dependence (anisotropy) were determined over a range of constant confining pressures up to 600 MPa and temperatures ranging from 20 to 600 °C. Samples range in composition from acidic to ultramafic. P- and S-wave velocities measured at 600 MPa vary from 5.08 to 8.64 km/s and 2.34 to 4.93 km/s, respectively. Densities are in the range from 2.60 to 3.68 g/cm³. To make a direct tie between seismic measurements (refraction and reflection) and subsurface lithologies, the experimental velocity data (corresponding to shallow depths) were used to calculate velocity profiles for the different lithologies and profiles of reflection coefficients at possible lithologic interfaces across the projected 5000-m Chinese Continental Scientific Drilling Program (CCSD) crustal segment. Comparison of calculated in situ velocities with respective intrinsic velocities suggests that the in situ velocities at shallow depths are lowered by an increased abundance of open microcracks. The strongly reflective zone beneath the Donghai drill site can be explained by the impedance contrasts between the different lithologies. Contacts between eclogite/peridotite and felsic rocks (gt-gneiss, granitic gneiss), in particular, may give rise to strong seismic reflections. In addition, shear-induced (lattice preferred orientation (LPO)-related) seismic anisotropy can increase reflectivity. For the explanation of the high velocity bodies (>6.4 km/s) around 1000 m and below 3200-m depth, large proportions of eclogite/peridotite (about 40 and 30 vol.%, respectively) are needed.  相似文献   

交流变频调速CD-2B型岩心钻机的研制          下载免费PDF全文

宋振波  李建华  刘凡柏 《探矿工程》2002,(3):23-26

介绍了交流变频调速CD－2B型岩心钻机研制情况，技术参数，主要特点及型式检验，生产试验等情况。  相似文献   

挑战地球科学的新前沿 21世纪大洋综合钻探计划(OD21)          下载免费PDF全文

刘广志 《探矿工程》2002,(3):55-57

简要介绍即将实施的“21世纪大洋综合钻探计划”的目的、要求、设施等。  相似文献