Syntectonic plutons emplaced in shallow crust often contain intermediate-to low-temperature deformation microstructures but
lack a high-temperature, subsolidus deformation fabric, although the relict magmatic fabric is preserved. The Proterozoic
Vellaturu granite emplaced at the eastern margin of the northern Nallamalai fold belt, south India during the late phase of
regional deformation has a common occurrence of intermediate-to low-temperature deformation fabric, superimposed over magmatic
fabric with an internally complex pattern. But high-T subsolidus deformation microstructure and fabric are absent in this
pluton. The main crystal plastic deformation and fluid enhanced reaction softening was concentrated along the margin of the
granite body. Resulting granite mylonites show Y-maximum c-axis fabric in completely recrystallized quartz ribbonds, dynamic recrystallization of perthites, and myrmekite indicative
of fabric development under intermediate temperature (∼ 500–400°C). The weakly-deformed interior shows myrmekite, feldspar
microfracturing and limited bulging recrystallization of quartz. The abundance of prism subgrain boundaries is indicative
of continuing deformation through low-temperature (∼ 300°C). The relative rates of cooling influenced by advective heat transfer
and deformation of the pluton seem to control the overall subsolidus fabric development. The rapid advective heat transfer
from the interior in the early stages of subsolidus cooling was followed by slow cooling through intermediate temperature
window as a well-developed phyllosilicate rich mylonitic skin around the granite body slowed down conductive heat loss. Low-T
crystal plastic deformation of quartz was effected at a late stage of cooling and deformation of the shallow crustal granite
body emplaced within the greenschist facies Nallamlai rocks. 相似文献
Clayey sand can be considered as a composite matrix of coarse and fine grains. The interaction between coarser and finer grain matrices affects the overall stress–strain behavior of these soils. Intergranular void ratio, es (which is the void ratio of the coarser grain matrix) can be utilized as an alternative parameter to express the compressive response of such soils. Oedometer tests conducted on reconstituted kaolinite–sand mixtures indicate that initial conditions, percentage of fines, and stress conditions influence the compression characteristics evidently. Tests showed that, up to a fraction of fines, which is named as transition fines content (FCt), compression behavior of the mixtures is mainly controlled by the sand grains. When concentration of fines exceeds FCt, kaolinite controls the compression. It was found that FCt varies between 19% and 34% depending on the above mentioned factors. This range of fines content is also consistent with various values reported in literature regarding the strength alteration. Performed direct shear tests revealed that there is also a close relationship between transition fines content and shear strength, which is harmonic with the oedometer test results. 相似文献
The influence of rock fabric on physical weathering due to the salt crystallization of selected brecciated dolostones is discussed. These dual-porosity dolostones are representative of heterogeneous and anisotropic building rocks, and present highly complex and heterogeneous rock fabric features. The pore structure of the matrix and clasts is described in terms of porosity and pore size distribution, whereas the relative strength for each textural component is assessed using the Knoop hardness test. The whole characterisation process was carried out using the same samples as those used in the standard salt durability test (EN-12370), including connected porosity, the water saturation coefficient, fissure density, compressional wave velocity and waveform energy.
Results show the most important rock fabric elements to be considered are the matrix and clast properties and the nature of fissures. Firstly, a relatively weak matrix was the focus of major granular disintegration as it presents high porosity, low pore radius and reduced strength. Secondly, narrow micro-fissures appear to be important in the decay process due to the effectiveness of crystallization pressure generated by salt growth. On the contrary, macro-fissures do not contribute greatly to rock decay since they act as sinks to consume the high supersaturations caused by growth of large crystals. Additionally, an analysis of stress generated by crystallization was carried out based on the general situation of a lenticular crystal geometry. Finally, the relationships between whole petrophysical properties and durability were established using a principal component analysis. This analysis has clearly established that the durability of rocks affected by salt crystallization mechanisms diminishes in weaker and anisotropic rocks with high porosity and fissure density. 相似文献
Eclogite plays an important role in mantle convection and geodynamics in subduction zones. An improved understanding of processes in the deeper levels of subduction zones and collision belts requires information on eclogite rheology. However, the deformation processes and associated fabrics in eclogite are not well understood. Incompatible views of deformation mechanism have been proposed for both garnet and omphacite. We present here deformation behaviour of eclogite at temperatures of 1027–1427 °C, confining pressures of 2.5–3.5 GPa, and strain rates of 1 × 10?5 s?1 to 5 × 10?4 s?1. We obtained a power‐law creep for the high temperature and pressure deformation of a ‘dry’ eclogite (50 vol.% garnet, 40% omphacite and 10% quartz) with A = 103.3 ± 1.0, n = 3.5 ± 0.4, ΔE =403 ± 30 KJ mol?1 and ΔV = 27.2 cm3 mol?1. The two principal minerals of eclogite have greatly different strengths. Progressive increase of garnet results in a smooth increase in strength. Analysis by electron back‐scattered diffraction shows that: (1) garnet displays pole figures with near random distributions of misorientation angle under both dry and wet conditions; (2) omphacite shows pronounced lattice preferred orientations (LPOs), suggesting a dominant dislocation creep mechanism. Further investigation into the water effects on eclogite show: (3) water content does not influence the style of omphacite fabric but increases slightly the fabric strength; (4) grain boundary processes dominate the deformation of garnet under high water fugacity or high shear‐strain conditions, yielding a random LPO similar to that of non‐deforming garnet, despite the strong shape preferred orientation (SPO) observed. {110} [001] slip may dominate the deformation of rutile. Quartz displays complicated and inconsistent LPOs in eclogite. These results are remarkably similar to observations from deformed eclogites in nature. 相似文献