Borehole pressure correction equation     

R. R. Britton  J. S. Gozon 《Geotechnical and Geological Engineering》1986,4(1):67-71

Conclusion A method of calculation for borehole pressure has been developed and compared to measured data for PETN. The results show that by adjusting the ratio of the specific heats using an equation derived from a curve fit of a pressure as a function of decoupling ratio graph, the plot shifts to a position within the ranges of the measured data. Also, at this point the proper specific heat may be obtained for a given gaseous mixture. Although other mixtures have been considered the results are not yet conclusive, but preliminary values seem to hold for the methodology used.  相似文献   

Investigation of electrical anisotropy in the deep borehole KTB     

Armin Rauen  Marcela Lastovickova 《Surveys in Geophysics》1995,16(1):37-46

Information about electrical anisotropy in and around the deep borehole of the German Continental Deep Drilling Program (KTB) has been acquired using three different methods: (1) Under surface temperature and pressure conditions, the azimuthal dependence of resistivity has been measured in horizontal planes perpendicular to the axes of drill cores. (2) Simulated in-situ conditions (high temperature and pressure) have been applied to mini cores drilled at different orientations to structural features such as foliation. The resistivity was then measured in the direction of the mini cores' long axes. (3) Under quasi-in-situ (downhole) conditions, the azimuthal dependence of resistivity has been measured in horizontal planes using the Azimuthal Resistivity Imager (ARI), a down hole logging tool.These investigations have shown that electrical anisotropy is strongly related to structural features. The anisotropy of gneisses is the highest due to the strong foliation (averaged anisotropy factor 2.8). Lamprophyres are most isotropic (factor 1.2). Most rocks from KTB are amphibolites with intermediate anisotropies (factor 1.3). The anisotropies measured under surface temperature and pressure conditions and quasi-in-situ conditions on amphibolites are approximately the same, whereas anisotropies under simulated in-situ conditions are partially higher.Furthermore, the anisotropies measured on the cm to m scale using the various methods outlined above shall be compared with large scale anisotropies of the km scale measured around KTB using Magneto Tellurics.  相似文献   

Acceleration response modification factors for nonstructural components attached to inelastic moment‐resisting frame structures     

Ragunath Sankaranarayanan  Ricardo A. Medina 《地震工程与结构动力学》2007,36(14):2189-2210

A statistical analysis of the peak acceleration demands for nonstructural components (NSCs) supported on a variety of stiff and flexible inelastic regular moment‐resisting frame structures with periods from 0.3 to 3.0 s exposed to 40 far‐field ground motions is presented. Peak component acceleration (PCA) demands were quantified based on the floor response spectrum (FRS) method without considering dynamic interaction effects. This study evaluated the main factors that influence the amplification or decrease of FRS values caused by inelasticity in the primary structure in three distinct spectral regions namely long‐period, fundamental‐period, and short‐period region. The amplification or decrease of peak elastic acceleration demands depends on the location of the NSC in the supporting structure, periods of the component and building, damping ratio of the component, and level of inelasticity of the supporting structure. While FRS values at the initial modal periods of the supporting structure are reduced due to inelastic action in the primary structure, the region between the modal periods experiences an increase in PCA demands. A parameter denoted as acceleration response modification factor (R_acc) was proposed to quantify this reduction/increase in PCA demands. Copyright © 2007 John Wiley & Sons, Ltd.  相似文献   

北京昌平地震台TJ-1体积钻孔应变仪潮汐参数动态特征及其稳定性研究     

唐九安  王勇  刘福生 《华北地震科学》2001,19(4):34-40

介绍了北京昌平地震台 TJ- 1型钻孔体积应变仪 1 989年 7月～ 2 0 0 0年 1 2月期间的观测结果 ,分析了潮汐响应函数的动态特征及其稳定性。由全序列观测数据调和分析所得 :O1波潮汐因子 VO1=0 .791 6± 0 .0 1 2 8、相位滞后 ΔΦ0 1=1 .9°;K1波潮汐因子 Vk1=0 .6 4 42±0 .0 0 88、相位滞后ΔΦk1=- 4.2°;M2 波潮汐因子 VM2 =0 .6 5 0 0± 0 .0 0 3 8、相位滞后ΔΦM2 =-2 .9°。液态地核振荡因子 A=VO1/VK1=1 .2 2 8,比理论值小 6 .5 %。  相似文献   

浅谈野外岩心地质编录工作     

阿种明  李细根  王成  王果  谭洪赞  王乐民 《铀矿地质》2001,17(5):314-320

岩心地质编录是收集和观察研究岩心中所赋存的各种地质信息和地质现象的一项重要的基础性地质工作。本文根据具体实践经验，简要介绍了岩心地质编录工作的3个阶段以及贯穿于编录工作始终的取样工作。  相似文献   

Strain and tilt changes measured during a water injection experiment at the Nojima Fault zone, Japan   总被引：2，自引：0，他引：2  

Kunio Fujimori  Hiroshi Ishii  Atsushi Mukai  Shigeru Nakao  Shigeo Matsumoto  Yasuhiro Hirata 《Island Arc》2001,10(3-4):228-234

Abstract In order to make geophysical and geological investigations of the Nojima Fault on Awaji Island, Japan, three boreholes measuring 1800 m, 800 m and 500 m deep were drilled into the fault zone. The fault is one of the seismic source faults of the 1995 Hyogo-ken Nanbu earthquake of M 7.2. A new multicomponent borehole instrument was installed at the bottom of the 800 m borehole and continuous observations of crustal strain and tilt have been made using this instrument since May 1996. A high-pressure water injection experiment within the 1800 m borehole was done in February and March 1997 to study the geophysical response, behavior, permeability, and other aspects of the fault zone. The injection site was located approximately 140 m horizontally and 800 m vertically from the instrument. Associated with the water injection, contraction of approximately 0.7 × 10⁻⁷ str (almost parallel to the fault) and tilt of approximately 1 × 10^-7 rad in the sense of upheaval toward the injection site were observed. In addition to these controlled experiments, the strainmeter and tiltmeter also recorded daily variations. We interpret strain and tilt changes to be related to groundwater discharge and increased ultra-micro seismicity induced by the injected water.  相似文献   

Research on Practicability and Feasibility for a New-Type Tuned Mass Damper System-TMD     

Zhang Yaoting Lei Ping''''an Liu Zaihua Lin Ning Department of Civil Engineering  Huazhong University of Science  Technology  Wuhan 《中国地质大学学报(英文版)》2001,12(4)

lNTRODUCTIONThe theories and applications of structural contr()l tlcveloped rapidly in the last 20 years. As one of the additiona1 I)asslve control technologY' TMD is used in practice and can suppress the vibration caused by wind or machinery shake (Ayorinde and Warburton, 1980; Den Hartog, l956 ). The TMDsystem has been used in the industrial and civil buildlngs t() rc-duce structural vibration in some European and American ()o[lntries (Ayorinde and Warburton, l980; Warburton. ] f)…  相似文献   

Propagation of tube waves generated by an external source in layered permeable rocks     

A. M. Ionov  G. A. Maximov 《Geophysical Journal International》1996,124(3):888-906

  相似文献   

ENCORE钻孔导斜系统     

谈耀麟 《矿产与地质》1992,6(6):487-491

ENCORE钻孔导斜系统由设计先进的MOLE型固定楔、MULE型活楔、RATTY型扩孔导向矛和DOLPHIN型定向仪组成。可在40－96mm钻孔中进行定向钻进，解决钻孔纠斜或分支孔钻进问题。在分析研究其、工作原理和操作方法基础上进行对比分析，指出优点并介绍了使用效果。  相似文献   

煤层构造破碎度及其在水文地质中的应用     

张孝文  朱春笙 《煤田地质与勘探》1993,21(6):34-38

断块构造区域内煤层及其周围岩层在构造应力作用下的形变具有很好的协调性和密切的相关性。利用煤层构造破碎率，能预测底板隔水层的构造破坏程度。经过几年的现场试验研究，证明该方法简便，结果直观。  相似文献