Hyper Redundancy for Accuracy Enhancement in Automated Close Range Photogrammetry   总被引：1，自引：0，他引：1  

Clive S.  Fraser  Alex  Woods  Danny  Brizzi 《The Photogrammetric Record》2005,20(111):205-217

A generic network design in close range photogrammetry is one where optimal multi-ray intersection geometry is obtained with as few camera stations as practicable. Hyper redundancy is a concept whereby, once the generic network is in place, many additional images are recorded, with the beneficial impact upon object point precision being equivalent to the presence of multiple exposures at each camera position within the generic network. The effective number of images per station within a hyper redundant network might well be in the range of 10 to 20 or more. As is apparent when it is considered that a hyper redundant network may comprise hundreds of images, the concept is only applicable in practice to fully automatic vision metrology systems, where it proves to be a very effective means of enhancing measurement accuracy at the cost of minimal additional work in the image recording phase. This paper briefly reviews the network design and accuracy aspects of hyper redundancy and illustrates the technique by way of the photogrammetric measurement of surface deformation of a radio telescope of 26 m diameter. This project required an object point measurement accuracy of σ  = 0·065 mm, or 1/400 000 of the diameter of the reflector.  相似文献   

Electrical aerosol spectrometer of Tartu University     

H. Tammet  A. Mirme  E. Tamm   《Atmospheric Research》2002,62(3-4)

The electrical aerosol spectrometer (EAS) of the parallel measuring principle at Tartu University is an efficient instrument for rapid measurement of the unstable size spectrum of aerosol particles. The measuring range from 10 nm to 10 μm is achieved by simultaneously using a pair of differential mobility analyzers with two different particle chargers. The particle spectrum is calculated and measurement errors are estimated in real time by using a least-squares method. Experimental calibration ensures reliability of measurement. The instrument is well suited for continuous monitoring of atmospheric aerosol.  相似文献   

Elemental particle size distributions. Measured and estimated dry deposition in Sfax region (Tunisia)     

M. Masmoudi  I. Belghith  M. Chaabane 《Atmospheric Research》2002,63(3-4)

Mass size distribution of the crustal elements (Al, Ca, Fe, Mg, Si, Ti), anthropogenic elements (Zn, Mn, Cr, Cu, K, P, Pb) and sea elements (Na, Cl) were obtained from measurements carried out with an inertial cascade impactor in Sfax. A fitting procedure by data inversion was applied to those data. This procedure yields accurate size distributions of aerosols in the diameter range 0.1–25 μm in two different sites. In a coastal industrial site, the mass distribution of the aerosol showed a bimodal structure; and in urban area, the lower particle mode cannot be observed. The elemental dry deposition flux was calculated as a function of particle size. The element flux size distribution increased rapidly with particle size. The modelling results indicate that the majority of the crustal and anthropogenic elements flux (>90%) was due to particles larger than 3 μm in diameter.  相似文献   

上海软粘土微观特性及在土体变形与地面沉降中的作用研究   总被引：18，自引：3，他引：18  

龚士良 《工程地质学报》2002,10(4):378-384

对上海软粘土的颗粒及集合体成分、孔径分布、微结构、孔隙溶液与阳离子交换性作了分析 ,对固结前后的孔径变化与人工回灌对土体性质可能带来的影响作了探讨 ,从物理化学角度阐述了软粘土微观特性对土体固结变形及地面沉降的影响.  相似文献   

Variation in element release rate from different mineral size fractions from the B horizon of a granitic podzol     

Mark E. Hodson 《Chemical Geology》2002,190(1-4):91-112

Far-from-equilibrium batch dissolution experiments were carried out on the 2000–500, 500–250, 250–53 and 53–2 μm size fractions of the mineral component of the B horizon of a granitic iron humus podzol after removal of organic matter and secondary precipitates. The different size fractions were mineralogically and chemically similar, the main minerals present being quartz, alkali and plagioclase feldspar, biotite and chlorite. Specific surface area increased with decreasing grain size. The measured element release rates decreased in the order 53–2>>>2000–500>500–250>250–53 μm. Surface area normalised element release rates from the 2000–500, 500–250 and 250–53 μm size fractions (0.6–77×10⁻¹⁴ mol/m²/s) were intermediate between literature reported surface area normalised dissolution rates for monomineralic powders of feldspar (0.1–0.01×10⁻¹⁴ mol/m²/s) and sheet silicates (100×10⁻¹⁴ mol/m²/s) dissolving under similar conditions. Element release rates from the 53–2 μm fraction (400–3000×10⁻¹⁴ mol/m²/s) were a factor of 4–30 larger than literature reported values for sheet silicates. The large element release rate of the 53–2 μm fraction means that, despite the small mass fraction of 53–2 μm sized particles present in the soil, dissolution of this fraction is the most important for element release into the soil. A theoretical model predicted similar (within a factor of <2) bulk element release rates for all the mineral powders if observed thicknesses of sheet silicate grains were used as input parameters. Decreasing element release rates with decreasing grain size were only predicted if the thickness of sheet silicates in the powders was held constant. A significantly larger release rate for the 53–2 μm fraction relative to the other size fractions was only predicted if either surface roughness was set several orders of magnitude higher for sheet silicates and several orders of magnitude lower for quartz and feldspars in the 53–2 μm fraction compared to the other size fractions or if the sheet silicate thickness input in the 53–2 μm fraction was set unrealistically low. It is therefore hypothesised that the reason for the unpredicted large release rate from the 52–3 μm size fraction is due to one or more of the following reasons: (1) the greater reactivity of the smaller particles due to surface free energy effects, (2) the lack of proportionality between the BET surface area used to normalise the release rates and the actual reactive surface area of the grains and, (3) the presence of traces quantities of reactive minerals which were undetected in the 53–2 μm fraction but were entirely absent in the coarser fractions.  相似文献   

人工值守台数字化地震仪标定原理   总被引：1，自引：0，他引：1  

张海  张艺 《四川地震》2002,(3):45-48

推导了人工台数字化地震仪的分段标定公式，提出数字化记录系统的微分近似标定和拾震器阻尼衰减法标定的方法，并提供了不同短周期地震仪与数字化地震仪并行的藕合方式和标定计算公式。  相似文献   

A model of equilibrium bed topography for meander bends with erodible banks     

Stephen E. Darby  Ivana Delbono 《地球表面变化过程与地形》2002,27(10):1057-1085

Channel curvature produces secondary currents and a transverse sloping channel bed, along which the depth increases towards the outer bank. As a result deep pools tend to form adjacent to the outer bank, promoting bank collapse. The interaction of sediment grains with the primary and secondary flow and the transverse sloping bed also causes meanders to move different grain sizes in different proportions and directions, resulting in a consistent sorting pattern. Several models have been developed to describe this process, but they all have the potential to over‐predict pool depth because they cannot account for the influence of erodible banks. In reality, bank collapse might lead to the development of a wider, shallower cross‐section and any resulting flow depth discrepancy can bias associated predictions of flow, sediment transport, and grain‐size sorting. While bed topography, sediment transport and grain sorting in bends will partly be controlled by the sedimentary characteristics of the bank materials, the magnitude of this effect has not previously been explored. This paper reports the development of a model of flow, sediment transport, grain‐size sorting, and bed topography for river bends with erodible banks. The model is tested via intercomparison of predicted and observed bed topography in one low‐energy (5·3 W m^?2 specific stream power) and one high‐energy (43·4 W m^?2) study reach, namely the River South Esk in Scotland and Goodwin Creek in Mississippi, respectively. Model predictions of bed topography are found to be satisfactory, at least close to the apices of bends. Finally, the model is used in sensitivity analyses that provide insight into the influence of bank erodibility on equilibrium meander morphology and associated patterns of grain‐size sorting. The sensitivity of meander response to bank cohesion is found to increase as a function of the available stream power within the two study bends. Copyright © 2002 John Wiley & Sons, Ltd.  相似文献   

南北地震带强震复发间隔的估计   总被引：1，自引：0，他引：1  

任雪梅  赵卫明  柴炽章  刘秀景 《内陆地震》2002,16(1):69-75

通过对南北地震带各主要断裂带历史强震的时空特点研究 ,试图寻找出带内各主要构造带强震的复发和填充特征 ,并在此基础上研究其差异性 ,对未来各带发生强震的危险性作出估计  相似文献   

Fish zonation in a Mediterranean stream: Effects of human disturbances   总被引：7，自引：0，他引：7  

Anna Vila-Gispert  Emili García-Berthou  Ramon Moreno-Amich 《Aquatic Sciences - Research Across Boundaries》2002,64(2):163-170

  相似文献   

乌鲁木齐区域数字遥测台网各子台背景噪声分析   总被引：6，自引：3，他引：6  

刘永廷  夏爱国  赵庆 《内陆地震》2002,16(4):366-371

选取乌鲁木齐区域数字遥测台网中 1 1个子台的背景噪声数字记录 ,计算并分析其背景噪声地动速度均方根值 RMS、有效测量动态范围以及噪声功率谱 ,最后确定出各台址背景噪声相对集中的频段  相似文献