Land subsidence caused by compression of clay layers in Ojiya City, Japan was measured by global positioning system (GPS) between 1 April 1996 and 31 December 1998.
Three baselines were selected in and around the city, and height difference on a WGS-84 ellipsoid was measured by GPS on each baseline. The ground at the GPS station in the city subsides and rebounds 7 cm every winter and spring, respectively. Measurement accuracy was 9.5 mm standard deviation. Ground water level was observed at a well near the GPS station. Regression analysis between total strain, calculated as ratio of the height difference displacement to the total thickness of the clay layers, and the layers' effective stress change with ground water level change gave good correlation. The slope of regression line 7.0×10−11 m2/N was obtained as an average apparent coefficient of volume compressibility of the layers. 相似文献
The design of a drainage system for a roofing slate quarry was implemented by the enhancement of discharge peak estimation, and the uncertainty inevitably associated with the engineering model was reduced.
The development of a topographical, geological, and vegetation cover database developed from a Geographical Information System (GIS) allowed for the definition of the drainage network for a hydraulic system, along with the calculation of the runoff coefficient. This is applied to the digital model of accumulated flow (DMF) as a weight correction coefficient, using a matrix-based model at 5×5 m resolution. The new digital model of corrected accumulated flow (DMCF) is the result of combining the thematic maps with the map of slope <3%, which was previously created from the slope model. It is demonstrated that this new model allows to apply the “Rational Method” on cartographic units defined by the GIS.
The DMCF is compared with other traditional applications of the Rational Method based on the calculation of the discharge peak considering: (1) the drainage basin as a single watershed or (2) defining an average runoff coefficient in each sub-watershed. Both approaches have bigger discharge peaks than those obtained by the DMCF since the slope, lithology, and vegetation cover have average values, and the runoff coefficient is poorly defined, increasing the uncertainty in the discharge peak. 相似文献
Migration characteristics of dense non-aqueous phase liquids (DNAPLs) in the subsurface can be expressed as a water–DNAPL two-phase system based on mainly the k–S–p relations, which describe the relations among relative permeability (k), degree of water saturation (S), and capillary pressure head (p). The aims of this research are to develop an experimental system with new type of probes, such as the electrical conductivity probe for measuring the degree of water saturation and the hydrophilic and hydrophobic tensiometer for measuring the pore water and DNAPL pressures, and also to estimate the results obtained from the developed experimental system. From these tests, the excellent k–S–p relations were obtained and the efficiency and validity of this developed experimental system have been confirmed in terms of the concept of the scaling coefficient calculated by interfacial tensions. 相似文献
Accidental spills of hydrocarbons, such as Light Non-Aqueous Phase Liquids (LNAPLs), are one of the most common sources of subsurface contamination. Migration of LNAPL in a porous medium is influenced by various factors such as the number of fluids present in the unsaturated/saturated zones and the proportion of pores occupied by each fluid. The results for relationship between matric suction and degree of saturation are presented in this paper for water–air, water–LNAPL and LNAPL–air systems in a sand. A simple and reliable setup using Buchner funnel was designed to obtain these relations. It was found that the relationship between matric suction head and degree of saturation is hysteretic for all the fluid systems (water–air, water–LNAPL and LNAPL–air). Furthermore, the amount of hysteresis depended upon the fluid system, with the maximum hysteresis occurring for water–air system. The results suggest that the amount of trapped air depends upon the reversal degree of saturation from drying to wetting. 相似文献
Rebuilding of victims' livelihoods was a crucial issue in the restoration process in the1995 Hanshin-Awaji Earthquake Disaster. Housing damage assessment influencedmost of the rebuilding of the livelihood in the long term, because the Victim Certificatesissued by the local governments based on the results of the Housing damage assessmentwas required to receive most of the individual assistance measures. In the process ofHousing damage assessment, many complex problems arose, leading to extensivework on the part of the disaster responders. Consequently, a considerable number ofvictims were dissatisfied with the assessment and applied for a resurvey. Due to a floodof requests for resurvey, disaster responders had to work on damage assessment, leavingrelief activities aside.In order to facilitate Housing damage assessment, this paper discusses thefollowing five points: (1) the processes and the problems of assessments performedin the Hanshin-Awaji Earthquake Disaster, (2) the changes in the nature of informationneeded by the victims, (3) the improvements over the present damage assessment, (4)the housing situation in Japan, and (5) the international situation on damage assessment.It is obvious from the results that a poor damage assessment system and the size ofthe disaster produced a very large work load. Differences in appreciation among theinvestigators also contributed to unfair assessments and led to the victims beingincreasingly dissatisfied by the survey results. Finally, a design concept for acomprehensive damage assessment system, which has been derived from theabove five points, is proposed for post-disaster management. 相似文献
Fluorine, chlorine, bromine, iodine and sulfur were determined in seventeen geological reference materials after extraction by pyrohydrolysis. Fluorine, Cl and S (as sulfate ions) were determined in the extraction solution by ion chromatography with detection limits of around 0.2 mg l−1. Bromine and I were measured by ICP-MS with detection limits of 1 μg l−1 for Br and 0.1 μg l−1 for I. For rock samples, using normal extraction conditions (500 mg of sample and 100 ml of final solution) detection limits were 40 mg kg−1 for F and Cl, 15 mg kg−1 for S, 0.2 mg kg−1 for Br and 0.02 mg kg−1 for I. These detection limits may be improved by increasing the amount of sample and hence the concentration of the final solution. Water was also determined using an extraction technique based on H2O degassing, reduction on zinc at 1000 °C and H2 manometry. Our results for fluorine, chlorine, sulfur and water are in good agreement with literature data. Very few reference materials have recommended values for bromine and especially for iodine. Among the analysed samples, three are new reference materials: BHVO-2, BCR-2 and AGV-2. 相似文献
Abstract. Magnetotelluric (MT) surveys were carried out around the Muine volcano, Hokkaido, Japan, where it is expected that the heat and metal source forming the polymetallic Ag-Pb-Zn-Cu-In Toyoha deposit is present at depth. Measurements were performed at 20 sites, 18 of which were located along a WSW-ENE profile traversing the north ridge of Mt. Muine. A resistivity model obtained from 2D inversion of the MT data shows subsurface specific conductive and resistive features. Conductive layers are present at the surface of Mt. Muine. The low resistivity is probably due to the clay-rich rocks associated with the hydrothermal alteration. A high resistivity layer, which corresponds to the pre-Tertiary Usubetsu Formation, crops out east of Mt. Muine and dips westward. At the west foot of Mt. Muine, relatively high resistive layers are widely exposed. The resistivity increases with depth and exceeds 1000 ohm-m. This fact indicates that this region is not influenced by the recent hydrothermal activity. An extremely conductive zone about 3–6 km wide and 6–9 km thick exists at a depth of 2 km below Mt. Muine. This zone mostly corresponds to an elastic wave attenuation zone detected by a seismic survey. It is interpreted as a large hydrothermal reservoir or melted magma, which is a heat source of the hydrothermal system in this area. 相似文献
