Discriminating between pore‐filling load and bed‐structure load: a new porosity‐based method,exemplified for the river Rhine     

ROY M. FRINGS  MAARTEN G. KLEINHANS  STEFAN VOLLMER 《Sedimentology》2008,55(6):1571-1593

Sediments contained in the river bed do not necessarily contribute to morphological change. The finest part of the sediment mixture often fills the pores between the larger grains and can be removed without causing a drop in bed level. The discrimination between pore‐filling load and bed‐structure load, therefore, is of practical importance for morphological predictions. In this study, a new method is proposed to estimate the cut‐off grain size that forms the boundary between pore‐filling load and bed‐structure load. The method evaluates the pore structure of the river bed geometrically. Only detailed grain‐size distributions of the river bed are required as input to the method. A preliminary validation shows that the calculated porosity and cut‐off size values agree well with experimental data. Application of the new cut‐off size method to the river Rhine demonstrates that the estimated cut‐off size decreases in a downstream direction from about 2 to 0·05 mm, covariant with the downstream fining of bed sediments. Grain size fractions that are pore‐filling load in the upstream part of the river thus gradually become bed‐structure load in the downstream part. The estimated (mass) percentage of pore‐filling load in the river bed ranges from 0% in areas with a unimodal river bed, to about 22% in reaches with a bimodal sand‐gravel bed. The estimated bed porosity varies between 0·15 and 0·35, which is considerably less than the often‐used standard value of 0·40. The predicted cut‐off size between pore‐filling load and bed‐structure load (D_c,p) is fundamentally different from the cut‐off size between wash‐load and bed‐material load (D_c,w), irrespective of the method used to determine D_c,p or D_c,w. D_c,w values are in the order of 10^?1 mm and mainly dependent on the flow characteristics, whereas D_c,p values are generally much larger (about 10⁰ mm in gravel‐bed rivers) and dependent on the bed composition. Knowledge of D_c,w is important for the prediction of the total sediment transport in a river (including suspended fines that do not interact with the bed), whereas knowledge of D_c,p helps to improve morphological predictions, especially if spatial variations in D_c,p are taken into account. An alternative to using a spatially variable value of D_c,p in morphological models is to use a spatially variable bed porosity, which can also be predicted with the new method. In addition to the morphological benefits, the new method also has sedimentological applications. The possibility to determine quickly whether a sediment mixture is clast‐supported or matrix‐supported may help to better understand downstream fining trends, sediment entrainment thresholds and variations in hydraulic conductivity.  相似文献   

新疆境内塔拉斯 费尔干纳断裂早侏罗世走滑的古地震证据     

乔秀夫  李海兵  王思恩  郭宪璞  司家亮  宗文明 《地质学报》2008,82(6):722-730

在野外考察过程中,于新疆乌恰地区早侏罗世康苏组沼泽相砂岩层中,发现并识别出软沉积物液化变形层,变形包括负载构造,球枕构造及卷曲变形构造。通过模拟试验的对比研究认为,该软沉积物变形机制与液化作用有关,触发沉积物液化的动力是古地震,并且根据地震震级与液化最大震中距的关系,推测出造成早侏罗世软沉积物变形的里氏地震震级为6相似文献   

新疆境内塔拉斯-费尔干纳断裂早侏罗世走滑的古地震证据   总被引：11，自引：2，他引：9  

乔秀夫  李海兵  王思恩  郭宪璞  司家亮  宗文明 《地质学报》2008,82(6)

在野外考察过程中,于新疆乌恰地区早侏罗世康苏组沼泽相砂岩层中,发现并识别出软沉积物液化变形层,变形包括负载构造,球-枕构造及卷曲变形构造。通过模拟试验的对比研究认为,该软沉积物变形机制与液化作用有关,触发沉积物液化的动力是古地震,并且根据地震震级与液化最大震中距的关系,推测出造成早侏罗世软沉积物变形的里氏地震震级为6相似文献   

粗颗粒悬移质测验误差分析   总被引：2，自引：0，他引：2  

韩其为 《水文》2008,28(1):1-6,20

本文根据流速与含沙量分布,研究了悬移质积点法对粗颗粒含沙量测验误差.首先指出无论从输沙率还是从悬浮高度看,粗颗粒悬移质集中于河底,致使水文测验中的一些测验方法(如一点法、二点法、三点法等)带有较大的误差.进而分析了各种测法对粗颗粒的相对误差,并且随着颗粒变粗,误差愈来愈大,以致不能接受.这种情况在水库下游河道冲刷过程中,会在一定程度上出现,必须重视研究和调整测验方法.最后通过与长江委水文局在沙市及监利两水文站试验结果对比,证明本文理论上的分析是可信的.  相似文献   

船舶受冲击力作用时的水动力试验研究     

王建平  王文富等 《海洋工程》2003,21(1):87-89,93

根据冲量相似的要求进行船舶在冲击作用下的模型试验，并将模型试验结果与理论计算及实际试验进行了对比和分析。  相似文献   

基于非期望产出的中国滨海旅游生态效率评价——以我国沿海城市为例     

狄乾斌  赵晓曼  王敏 《海洋通报》2020,39(2):160-168

旅游生态效率是反映旅游经济与旅游环境双向效应(bi-effect)的重要判断指标。本文基于非期望产出视角,采用超效率SBM模型,评价了我国东部沿海18个主要滨海旅游城市的旅游生态效率,并分析了其时空演变特征。研究结果表明:(1)中国东部沿海18市滨海旅游生态效率整体呈中等水平,平均值处于0.727～0.894,阶段特征明显,呈现前期平稳发展,中期下降,后期回升的发展趋势;(2)各城市滨海旅游生态效率水平差异显著,分为下行风险型,持续成长型,稳定型和波动型4种发展类型。平均效率值最高为天津,最低为三亚;(3)分解效率均值中纯技术效率较高,规模效率次之,技术进步是影响综合效率的主要因素;(4)投入冗余和非期望产出冗余已经成为阻碍滨海旅游生态效率进步的关键因素。  相似文献   

软粘土中插入式大直径薄壁圆筒结构的一种极限状态分析模型     

王乐芹  周锡礽  张伟 《海洋技术学报》2005,24(1):95-100

根据插入式大直径薄壁圆筒结构的工作特点建立了其合理的破坏机制，以此为基础建立了受横向荷载作用的插入式大直径薄壁圆筒结构的上限法极限分析模型，从中可以得到作用于插入式大直径薄壁圆筒结构上的横向极限荷载近似的上限解；并根据上限法模型计算结果，提出了计算受横向荷载作用的插入式大圆筒结构侧壁极限抗力的简化修正模型，利用此修正模型，基于极限平衡法，可以求解作用于插入式大直径薄壁圆筒结构上的横向极限荷载。  相似文献   

环太湖河道污染物负荷量的初步研究   总被引：5，自引：1，他引：5       下载免费PDF全文

袁静秀  黄漪平 《海洋与湖沼》1993,24(5):485-493

根据１９８７－１９８８年环太湖河道水质，水量实测资料以及环湖主要河道的流量和水质的历史资料，结合平原水网地区的水情特征，提出了环太湖河道污染物负荷量的计算方法，并分析探讨了不同设计水情下环太湖河道污染物负荷量及其时空变化。结果表明，污染物负荷量与水情关系密切，枯水年的河道入湖污染物负荷量大于丰水年。环湖２２条主要河道的入湖污染物负荷量占全部河道入湖总量的７２％－９１％，且不同污染物入湖负荷量的分布  相似文献   

Wave Loads and Protective Techniques of An On-Shore Wave Power Device     

You Yage YuZhi Associated Professor  Guangzhou Institute of Energy Conversion  Chinese Academy of Sciences  Guangzhou . Professor  Guangzhou Institute of Energy Conversion  Chinese Academy of Sciences  Guangzhou 《中国海洋工程》1995,(4)

In this paper, the extreme wave loads on an on-shore wave power device are investigated. First, boundary element method is applied to solve the three dimensional potential problem based on the small amplitude wave assumption. Then the motion of the Oscillating Water Column (OWC) inside the device and its laods on the device are calculated in time domain. Several protective techniques often applied are simulated by changing the constraint of the upper end of the chamber of the device. Numerical results are used to judge the effectiveness of these techniques. The investigation shows that damping can not effectively restrain the motion of OWC when the period of incident wave is long, which may cause dangerous loads on the structure. The shut chamber can effectively restrain the motion of OWC, but alternatively cause high pressure in the chamber. A Contracting opening with a Taper (CT) can exhaust a great amount of kinetic energy of OWC, and significantly decrease the loads. It is a promising protective tec  相似文献   

Behavior of Pile Groups under Lateral Load   总被引：2，自引：0，他引：2  

Yang Keji  Li Qixin Wang Fuyuan Associate Proferssor  Hehai University  Nanjing Engineer  Hehai University  Nanjing 《中国海洋工程》1991,(2)

Based on investigation and model tests, and in combination with the research work on group effect for pile groups under lateral loads relating to the code of fixed offshore platforms, a series of studies have been performed on the behavior and failure mechanism of laterally loaded pile groups, critical pile spacing inducing group effect, lateral bearing capacity of pile groups and its main influence factors, the stress-strain relationship for single piles and pile groups and so on. Some new laws about non-uniformity of load distribution in the longitudinal direction of pile groups and load-deflection (p - y) curves for pile groups have been discovered, and an empirical formula is presented in order to remedy the defect of current calculating methods at home and abroad. These results can be used for reference in the design of pile foundation under lateral loads.  相似文献