A laboratory experiment to monitor the contact state of a fault by transmission waves   总被引：1，自引：0，他引：1  

Naoto Yoshioka  Koji Iwasa 《Tectonophysics》2006,413(3-4):221-238

We performed a series of laboratory experiments in which elastic waves were transmitted across a simulated fault. Two types of experiments were carried out: (1) Normal Stress Holding Test (NSHT): normal stress was kept constant for about 3 h without shear stress and transmission waves were observed. (2) Shear Stress Increasing Test (SSIT): shear stress was gradually increased until a stick-slip event occurred. Transmission waves were continuously observed throughout the process of stress accumulation. We focused on the change in transmission waves during the application of shear stress and especially during precursory slips.It was found in NSHT that the amplitude of transmission waves linearly increased with the logarithm of stationary contact time. The increase amounted to a few percent after about 3 h. Creep at asperity contacts is responsible for this phenomenon. From a theoretical consideration, it was concluded that the real contact area increased with the logarithm of stationary contact time.We observed in SSIT a significant increase in wave amplitude with shear stress application. This phenomenon cannot be attributed to the time effect observed in NSHT. Instead, it can be explained by the mechanism of “junction growth” proposed by Tabor. Junction growth yields an increase in real contact area. It is required for junction growth to occur that the material in contact is already plastic under a purely normal loading condition. A computer simulation confirmed that this requirement was satisfied in our experiments. We also found that the rate at which the amplitude increased was slightly reduced prior to a stick-slip event. The onset time of the reduction well coincides with the onset of precursory slip. The cause of the reduction is attributed to the reset of stationary contact time due to displacement. This interpretation is supported by the result of NSHT. Taking the time of stationary contact in SSIT into account, we may expect the change in wave amplitude to be, at most, only a few percent. The observed slight reduction in increasing rate is, in this sense, reasonable. The static stiffness of the fault also decreases with precursory slip. It was also found that low frequency waves are a better indicator of precursory slip than high frequency waves. This might suggest that low frequency waves with longer wavelength are a better indicator of average behavior of faults. The problem, however, merits a further investigation. The shifts in phase were also found to be a good indicator of the change in contact state of the fault. The changes in both amplitude and phase of transmission waves are unifyingly understood through the theory of transmission coefficient presented by Pyrak-Nolte et al. Rough surfaces have a tendency to give larger stick-slips than smooth surfaces. The amount of precursory slip is larger for rough surfaces than for smooth surfaces. Although it was confirmed by a computer simulation that rough surfaces have larger contact diameters than smooth surfaces, the rigorous relationship between the surface roughness (contact diameter) and the amount of precursory slips was not established.  相似文献   

Non-volcanic deep low-frequency tremors accompanying slow slips in the southwest Japan subduction zone   总被引：5，自引：1，他引：5  

Kazushige Obara  Hitoshi Hirose 《Tectonophysics》2006,417(1-2):33

Non-volcanic deep low-frequency tremors in southwest Japan exhibit a strong temporal and spatial correlation with slow slip detected by the dense seismic network. The tremor signal is characterized by a low-frequency vibration with a predominant frequency of 0.5–5 Hz without distinct P- or S-wave onset. The tremors are located using the coherent pattern of envelopes over many stations, and are estimated to occur near the transition zone on the plate boundary on the forearc side along the strike of the descending Philippine Sea plate. The belt-like distribution of tremors consists of many clusters. In western Shikoku, the major tremor activity has a recurrence interval of approximately six months, with each episode lasting over a week. The tremor source area migrates during each episode along the strike of the subducting plate with a migration velocity of about 10 km/day. Slow slip events occur contemporaneously with this tremor activity, with a coincident estimated source area that also migrates during each episode. The coupling of tremor and slow slip in western Shikoku is very similar to the episodic tremor and slip phenomenon reported for the Cascadia margin in northwest North America. The duration and recurrence interval of these episodes varies between tremor clusters even on the same subduction zone, attributable to regional difference in the frictional properties of the plate interface.  相似文献   

大变形有限元法分析边坡稳定性     

杨涛  周德培  苏金蓉 《山地学报》2006,24(1):101-104

边坡稳定性分析的重要任务是确定边坡潜在滑面的位置及相应的安全系数,鉴于坡体位移可在现场监测中直接得到,提出边坡潜在滑面确定的位移判据,采用大变形有限元首先计算出边坡的位移场,然后在开挖面的不同高度作塑性区内的水平位移参考线,依次连接参考线上的位移突变点即得到边坡失稳的潜在滑面位置,分析滑面上的应力以及岩体抗剪强度即得到边坡的整体安全系数。  相似文献   

Fault slip and rupture velocity inversion by isochrone backprojection     

Gaetano Festa  Aldo Zollo 《Geophysical Journal International》2006,166(2):745-756

  相似文献   

考虑滑脱效应和温度场的煤层气渗流数值模拟     

肖晓春  潘一山 《中国地质灾害与防治学报》2006,17(3):91-95

由于煤层气的解吸热效应,煤层气的运移过程是一个非等温过程。因此,温度场对煤层气渗流有着重要的影响。前人在研究煤层气渗流规律的研究中并没有同时考虑滑脱效应和温度场因素的影响,而在实际的深部开采中综合考虑滑脱效应和温度场的影响对研究深部煤层气运移规律有着重要的意义。因此本文建立了考虑滑脱效应及温度场的煤层气渗流数学模型,利用有限元数值方法研究了考虑滑脱效应和温度场耦合的煤层气运移规律;研究了考虑滑脱效应和温度场对压力场分布的影响;对考虑滑脱效应及温度场因素的煤层气产量进行了预测。得出了随着温度的升高煤储层的压力在降低,温度的升高对煤层气的产量有着负面的影响这一重要结论。  相似文献   

华南下寒武统镍钼矿层中铜铅锌矿物的发现及意义     

陈益平  潘家永  夏菲  郭国林  陈少华  曹双林  严兆斌 《华东地质学院学报》2006,29(1):32-37

华南扬子地块是我国古热水沉积成矿作用最为发育的地区之一,其热水沉积特性最早引起我国学者的关注。华南下寒武统黑色岩系中赋存多个与热水沉积成矿作用相关的大型、超大型重晶石矿床与N i-Mo-U-V多金属富集层。进一步研究分布在华南扬子地块黑色岩系中的金属、非金属矿床成因及其地球化学特征,对认识华南乃至全球晚震旦—早寒武世生物与环境演化有着十分重要的意义。本文对华南下寒武统镍-钼富集层矿石进行电子探针研究,识别出黄铜矿、黝铜矿等铜的独立矿物;闪锌矿等锌的独立矿物;方铅矿、白铅矿等铅的独立矿物。研究表明,在镍-钼矿石中这些矿物的发现为镍-钼矿层是热水沉积作用产物提供了直接的矿物学证据。  相似文献   

地震属性分析中水平切片的应用   总被引：6，自引：0，他引：6  

国洪伟  陈勃  刘和芝  刘伟  张秀丽 《物探化探计算技术》2005,27(1):10-15

利用地震数据体中含有的丰富地质信息,可以有效地进行储层预测。层拉平水平切片地层学解释方法是先将地震剖面目的层段做层拉平处理,然后对切片顺地层层面追踪,勾绘出各种地层现象,并以地层学的观点加以解释。该方法在吉林探区扶新南部地区的应用中,对于识别河道的展布趋势取得了较好的效果,而且发现了多期叠置的扇型沉积体。另外,还可指导反演数据体的解释,做到对岩性体从定性到定量的描述。  相似文献   

渤南洼陷罗151块火成岩油藏特征及开发对策   总被引：2，自引：2，他引：2  

金平信  高保国  王乐超 《西北地质》2005,38(2):70-75

罗151块火成岩油藏是近年在济阳坳陷发现的中型油藏，油藏埋深3150m；在研究罗151井区火成岩成因、侵入期次、岩相学及储层非均质性的基础上，建立了火成岩储层概念模型，划分出角岩微孔隙型油藏及辉绿岩溶蚀孔隙-裂缝型油藏两个类型，纵向上分为4个带，平面上分为3个区；预测了火成岩储层发育的有利部位；部署了合理的开发井网，钻探后，完钻新井14口，平均单井日产油27t，取得了显著效果；火成岩油藏初期产能高，产量递减快，弹性产率低，依靠天然能量开采，最终采收率只有14．1％，可以进行注水开发，注水效果较好。  相似文献   

北京夏季城市热岛现状及楔形绿地规划对缓解城市热岛的作用   总被引：20，自引：2，他引：20       下载免费PDF全文

佟华  刘辉志李延明桑建国胡非 《应用气象学报》2005,16(3):357-366

通过遥感技术与地面测定相结合的方法，对北京城市热岛现状作观测研究，得到北京城市地面的温度分布特点。使用北京大学城市边界层模式从气象观点就“楔形绿地”规划对北京城市气候的影响进行研究和评价，模式通过对城市地表复杂性和多样性的特征进行细致描述，建立了一个细致模拟城市特点的城市边界层能量平衡模式，并用此能量平衡模式得到的地面温度作为下边界条件，中尺度气象模式MM5做初始场和侧边界条件，建立一个最小分辨率为500 m的城市边界层模式系统，来研究城市边界层在中尺度背景场作用下的精细结构。通过个例模拟，模式能够较准确地模拟城市边界层的风温场分布情况，可以用来对楔形绿地规划进行模拟试验。通过对规划后的气象场在特定的气象条件下进行模拟，结果显示，建造大型的楔形绿地后，绿地区域及绿地周围约1 km以内的地区温度有所降低，降低的程度由规划前后的地表类型改变的剧烈程度、风速大小及与绿地的距离决定，但是这种规划方案却会因城市的下风方向的风速减小而导致通风不畅。  相似文献   

大气边界层湍流温度序列的信息熵分析   总被引：2，自引：0，他引：2  

汪景烨  付遵涛  张霖  刘式达 《高原气象》2005,24(1):38-42

利用大气边界层内近地面的大气湍流温度时间序列，运用功率谱分析、信息熵分析等方法，分析了大气边界层内近地面的大气湍流特点，并对稳定层和不稳定层的大气湍流进行了对比。结果表明，信息熵和功率谱指数是区别稳定层结和不稳定层结大气边界层湍流特征的指标，对造成两者之间的差别做出了对应的解释。  相似文献