新近沉积粉细砂层地基的试验与评价     

赵本肖  游占军 《中国煤田地质》2006,18(4):45-46,48

通过对邯郸市某车间地基的勘察．分析和探讨了新近沉积粉细砂地层的勘察手段、其物理力学性质，及其利用载荷试验确定承载力的标准取得了较为满意的结果，提出的一些分析方法，对新近沉积的粉细砂地层的勘察具有一定的借鉴作用。  相似文献   

陆相油藏中砂泥岩互层时移地震遮掩效应及其对时移地震资料解释的影响     

WANG Da-wei 《现代地质》2006,(4)

从差异波形特征的角度出发,分析时移地震差异波形特征与砂泥岩互层油藏中油层速度变化的关系。通过建立由5层地层组成的楔形地质模型,运用褶积公式及时移地震求差公式,得到泥岩速度为2 400 m/s和砂岩速度为2 700m/s条件下,互层中砂岩速度变化±150 m/s的时移地震响应。研究结果表明:砂泥岩互层的差异波形是一个多峰复合波,泥岩夹层的厚度是决定差异波形特征的一个主要因素,并且存在一个临界值,即四分之一主波长;如果泥岩夹层的厚度小于这一临界值,就会发生遮掩效应,即顶部油层的时移地震响应可以掩盖中、下部油层的时移地震响应。  相似文献   

低阻油气储层测井解释方法研究     

LI Zheng-xi 《吉林大学学报(地球科学版)》2006,(Z2)

对低阻油气储层的测井响应特征和储层物性特征进行了研究,并针对研究区域低阻储层的特点,以岩心与测井数据的相关性为依据,提出了适合地区特点的储层参数解释方法。通过应用三水导电模型,提高了低阻储层的测井解释精度。  相似文献   

微波消解-火焰原子吸收光谱法测定石英砂中的氧化钙和氧化镁     

鲁青庆 《岩矿测试》2005,24(4):314-316

采用微波消解-硼酸络合-火焰原子吸收光谱法测定石英砂中的氧化钙和氧化镁。样品在MK-Ⅲ型实验室微波炉上消解,消解压力为2.0 MPa、消解时间为5 m in,以硼酸络合消除氢氟酸的影响。方法已用于实际样品的测定,7次测定的相对标准偏差(RSD)小于5%,加标回收率为95.0%~104.2%。  相似文献   

主砂体及其构造改造样式的盆地产铀远景评价判据     

陈祖伊  郭庆银  刘红旭 《铀矿地质》2005,21(3):152-160

本文在介绍并分析美国和前苏联总结的砂岩型铀矿区域评价判据的基础上, 引入当今碎屑岩沉积学和盆地地球动力学方面的若干新进展, 提出以主砂体及其随后经历的构造改造样式相结合的盆地产铀远景评价判据和以分析区域构造活动史和原型盆地演化相结合的盆地产铀远景评价模式。最后以潮水盆地为例, 具体分析了盆地各个时代盖层容存后生铀矿化的可能性, 指出盆地中的主要找矿目标层位和远景成矿地段。  相似文献   

基于VRMap平台上的电子沙盘研制   总被引：6，自引：0，他引：6  

杨志强  沈颖  王晓鹏 《现代测绘》2005,28(2):9-11,22

通过与国内外数字沙盘制作方式及功能的比较，详细介绍了数字沙盘研究方面的一些方法，并以中原油田数字沙盘的研制为例，选择北京灵图公司的VRMap2．3软件作为平台制作中原油田数字沙盘，为油田开发提供基本资料。  相似文献   

Tests on low‐ductility RC frames under high‐ and low‐frequency excitations     

Ser‐Tong Quek  Chengmei Bian  Xilin Lu  Wensheng Lu  Haibei Xiong 《地震工程与结构动力学》2002,31(2):459-474

The response of low‐ductility reinforced concrete (RC) frames, designed typically for a non‐seismic region, subjected to two frequencies of base excitations is studied. Five half‐scaled, two‐bay, two‐storey, RC frames, each approximately 5 m wide by 3.3 m high, were subjected to both horizontal and/or vertical base excitations with a frequency of 40 Hz as well as a lower frequency of about 4 Hz (close to the fundamental frequency) using a shake table. The imposed acceleration amplitude ranged from 0.2 to 1.2g. The test results showed that the response characteristics of the structures differed under high‐ and low‐frequency excitations. The frames were able to sustain high‐frequency excitations without damage but were inadequate for low‐frequency excitations, even though the frames exhibited some ductility. Linear‐elastic time‐history analysis can predict reasonably well the structural response under high‐frequency excitations. As the frames were not designed for seismic loads, the reinforcement detailing may not have been adequate, based on the crack pattern observed. The effect of vertical excitation can cause significant additional forces in the columns and moment reversals in the beams. The ‘strong‐column, weak‐beam’ approach for lateral load RC frame design is supported by experimental observations. Copyright © 2001 John Wiley & Sons, Ltd.  相似文献   

Seismic response of self‐centring hysteretic SDOF systems     

Constantin Christopoulos  Andr Filiatrault  Bryan Folz 《地震工程与结构动力学》2002,31(5):1131-1150

The seismic response of single‐degree‐of‐freedom (SDOF) systems incorporating flag‐shaped hysteretic structural behaviour, with self‐centring capability, is investigated numerically. For a SDOF system with a given initial period and strength level, the flag‐shaped hysteretic behaviour is fully defined by a post‐yielding stiffness parameter and an energy‐dissipation parameter. A comprehensive parametric study was conducted to determine the influence of these parameters on SDOF structural response, in terms of displacement ductility, absolute acceleration and absorbed energy. This parametric study was conducted using an ensemble of 20 historical earthquake records corresponding to ordinary ground motions having a probability of exceedence of 10% in 50 years, in California. The responses of the flag‐shaped hysteretic SDOF systems are compared against the responses of similar bilinear elasto‐plastic hysteretic SDOF systems. In this study the elasto‐plastic hysteretic SDOF systems are assigned parameters representative of steel moment resisting frames (MRFs) with post‐Northridge welded beam‐to‐column connections. In turn, the flag‐shaped hysteretic SDOF systems are representative of steel MRFs with newly proposed post‐tensioned energy‐dissipating connections. Building structures with initial periods ranging from 0.1 to 2.0s and having various strength levels are considered. It is shown that a flag‐shaped hysteretic SDOF system of equal or lesser strength can always be found to match or better the response of an elasto‐plastic hysteretic SDOF system in terms of displacement ductility and without incurring any residual drift from the seismic event. Copyright © 2002 John Wiley & Sons, Ltd.  相似文献   

Numerical evaluation of the damping‐solvent extraction method in the frequency domain     

Ushnish Basu  Anil K. Chopra 《地震工程与结构动力学》2002,31(6):1231-1250

The damping‐solvent extraction method for the analysis of unbounded visco‐elastic media is evaluated numerically in the frequency domain in order to investigate the influence of the computational parameters—domain size, amount of artificial damping, and mesh density—on the accuracy of results. An analytical estimate of this influence is presented, and specific questions regarding the influence of the parameters on the results are answered using the analytical estimate and numerical results for two classical problems: the rigid strip and rigid disc footings on a visco‐elastic half‐space with constant hysteretic material damping. As the domain size is increased, the results become more accurate only at lower frequencies, but are essentially unaffected at higher frequencies. Choosing the domain size to ensure that the static stiffness is computed accurately leads to an unnecessarily large domain for analysis at higher frequencies. The results improve by increasing artificial damping but at a slower rate as the total (material plus artificial) damping ratio ζ_t gets closer to 0.866. However, the results do not deteriorate significantly for the larger amounts of artificial damping, suggesting that ζ_t≈0.6 is appropriate; a larger value is not likely to influence the accuracy of results. Presented results do not support the earlier suggestion that similar accuracy can be achieved by a large bounded domain with small damping or by a small domain with larger damping. Copyright © 2002 John Wiley & Sons, Ltd.  相似文献   

Multi‐objective optimal design of FLC driven hybrid mass damper for seismically excited structures     

A. S. Ahlawat  A. Ramaswamy 《地震工程与结构动力学》2002,31(7):1459-1479

Structural vibration control using active or passive control strategy is a viable technology for enhancing structural functionality and safety against natural hazards such as strong earthquakes and high wind gusts. Both the active and passive control systems have their limitations. The passive control system has limited capability to control the structural response whereas the active control system depends on external power. The power requirement for active control of civil engineering structures is usually quite high. Thus, a hybrid control system is a viable solution to alleviate some of the limitations. In this paper a multi‐objective optimal design of a hybrid control system for seismically excited building structures has been proposed. A tuned mass damper (TMD) and an active mass driver (AMD) have been used as the passive and active control components of the hybrid control system, respectively. A fuzzy logic controller (FLC) has been used to drive the AMD as the FLC has inherent robustness and ability to handle the non‐linearities and uncertainties. The genetic algorithm has been used for the optimization of the control system. Peak acceleration and displacement responses non‐dimensionalized with respect to the uncontrolled peak acceleration and displacement responses, respectively, have been used as the two objectives of the multi‐objective optimization problem. The proposed design approach for an optimum hybrid mass damper (HMD) system, driven by FLC has been demonstrated with the help of a numerical example. It is shown that the optimum values of the design parameters of the hybrid control system can be determined without specifying the modes to be controlled. The proposed FLC driven HMD has been found to be very effective for vibration control of seismically excited buildings in comparison with the available results for the same example structure but with a different optimal absorber. Copyright © 2002 John Wiley & Sons, Ltd.  相似文献