规则波在缓坡上变形与破碎数值分析     

李玉成  肖辉 《海洋工程》2007,25(1):27-34

通过在二维数值水槽内用边界元法直接求解Laplace方程,对规则波在缓坡上的变形及破碎进行了数值计算。分析了不同底坡及采用不同底摩阻系数时规则波的破碎特征,并对规则波破碎的极限坡度进行了研究。重点分析了规则波破碎时海底坡度、底摩阻系数及波形不对称性对破碎指标的影响。  相似文献   

4D seismic time-lapse monitoring of an active cold vent,northern Cascadia margin   总被引：1，自引：1，他引：1  

Michael Riedel 《Marine Geophysical Researches》2007,28(4):355-371

Two single-channel seismic (SCS) data sets collected in 2000 and 2005 were used for a four-dimensional (4D) time-lapse analysis of an active cold vent (Bullseye Vent). The data set acquired in 2000 serves as a reference in the applied processing sequence. The 4D processing sequence utilizes time- and phase-matching, gain adjustments and shaping filters to transform the 2005 data set so that it is most comparable to the conditions under which the 2000 data were acquired. The cold vent is characterized by seismic blanking, which is a result of the presence of gas hydrate in the subsurface either within coarser-grained turbidite sands or in fractures, as well as free gas trapped in these fracture systems. The area of blanking was defined using the seismic attributes instantaneous amplitude and similarity. Several areas were identified where blanking was reduced in 2005 relative to 2000. But most of the centre of Bullseye Vent and the area around it were seen to be characterized by intensified blanking in 2005. Tracing these areas of intensified blanking through the three-dimensional (3D) seismic volume defined several apparent new flow pathways that were not seen in the 2000 data, which are interpreted as newly generated fractures/faults for upward fluid migration. Intensified blanking is interpreted as a result of new formation of gas hydrate in the subsurface along new fracture pathways. Areas with reduced blanking may be zones where formerly plugged fractures that had trapped some free gas may have been opened and free gas was liberated.  相似文献   

Numerical modelling of deformation of multi-directional random waves over a varying topography     

Filipa Simes Brito Ferreira Oliveira 《Ocean Engineering》2007,34(2):337-342

Two numerical formulations of the breaking phenomenon were implemented in a numerical model for random wave propagation based on the elliptic formulation of the mild-slope equation. The randomness of the wave field was simulated based on a spectral component method, in which the 3-D spectrum is discretised in components of equal energy. One of the breaking process formulations is based on the concept of breaking each independent spectral component. The other is based on the distribution of the local amount of energy dissipated through the independent spectral components. The model based on the concept of breaking each independent spectral component produces the best estimates of the wave field, when the numerical results are compared with laboratory data.  相似文献   

完全非线性波浪破碎模型沿岸流数值模拟     

李绍武  连怡贞 《海洋工程》2007,25(3):46-52

探讨一种基于完全非线性Boussinesq方程的波浪破碎模型在沿岸流计算中的应用问题。针对控制方程中的完全非线性项对沿岸流成长过程的影响进行了深入讨论。数学模型计算结果表明,完全非线性项有使平均流局部化的作用;通过数模实验还发现,垂向高阶涡度项可以有效抑制破波区外回流;运用Visser的实验室沿岸流实测资料从沿岸流速度、波高和平均水位几方面对所提模型进行了验证,并给出了紊动参数的计算结果。  相似文献   

浪流作用下系泊船舶撞击力和系缆力试验研究     

李焱  郑宝友  高峰  孟祥玮 《海洋工程》2007,25(2):57-63

以某25万吨矿石码头工程为例,分别进行了单流、单浪和浪流共同作用下,系泊船舶撞击力和系缆力试验。研究了不同水位、不同船舶载度、不同浪流夹角,单流、单浪和浪流共同作用时对船舶撞击力和系缆力的影响。分析了该码头工程护舷和缆绳的布置情况,为工程设计提供了依据。  相似文献   

The Huelva (Spain) Tsunami-Ready Station and Its Interaction with Storm Emma (March 2018)     

Jue Lin-Ye  Begoña Pérez-Gómez  Enrique Álvarez-Fanjul  Javier García-Valdecasas 《Marine Geodesy》2020,43(5):509-539

Abstract

The sea level station operating since 1996 at Mazagón (Huelva, Spain) has been progressively upgraded to fit tsunami warning requirements, due to its location in one of the main regions at risk. Its radar water level sensor was complemented in 2017, with the addition of a pressure sensor. The performance of both sea level sensors and their response to sea level oscillations, at different frequencies, is assessed. Particular emphasis is put on the effect of extreme events, such as Storm Emma, when alternative methods to obtain 1-min data are tested, in contrast to the one based on arithmetic means. The overall differences are small, for the whole period of study (centered-root-mean-square-error below 1?cm, for 5-min, and hourly data; similar tidal parameters and sea level oscillations with periods between 30?s and 5?min). However, during Storm Emma, the pressure sensor presents sensibly lower readings than the radar, with the centered-root-mean-square-error rising to 80?mm on the March 2^nd 2018. A new method to compute 1-min data, based on medians, reduced this value to 10?mm for the same day.  相似文献   

Strength Analysis of Turret Mooring Productive/Storage Tanker     

Zhang Shilian Jin Dexian Associate Professor 《中国海洋工程》1997,(3)

The longitudinal strength of turret mooring productive/storage tanker is studied.A numeri-cal example has been implemented according to the method presented in this paper to give practical il-lustration.From the results of the numerical example,it is concluded that the turret hole located near theforward of the amidships has small effect on the longitudinal strength of the ship hull.As for design ex-treme value of wave bending moment of storage tanker,statistic method is a more reasonablemethodology,especially with the consideration of the servere environmental conditions.The primary esti-mation of design section modulus of turret storage tanker can be determined by this design bending mo-ment.  相似文献   

Fast static correction methods for high-frequency multichannel marine seismic reflection data: A high-resolution seismic study of channel-levee systems on the Bengal Fan     

Martin Gutowski  Monika Breitzke  Volkhard Spieß 《Marine Geophysical Researches》2002,23(1):57-75

Very high-frequency marine multichannel seismic reflection data generated by small-volume air- or waterguns allow detailed, high-resolution studies of sedimentary structures of the order of one to few metres wavelength. The high-frequency content, however, requires (1) a very exact knowledge of the source and receiver positions, and (2) the development of data processing methods which take this exact geometry into account. Static corrections are crucial for the quality of very high-frequency stacked data because static shifts caused by variations of the source and streamer depths are of the order of half to one dominant wavelength, so that they can lead to destructive interference during stacking of CDP sorted traces. As common surface-consistent residual static correction methods developed for land seismic data require fixed shot and receiver locations two simple and fast techniques have been developed for marine seismic data with moving sources and receivers to correct such static shifts. The first method – called CDP static correction method – is based on a simultaneous recording of Parasound sediment echosounder and multichannel seismic reflection data. It compares the depth information derived from the first arrivals of both data sets to calculate static correction time shifts for each seismic channel relative to the Parasound water depths. The second method – called average static correction method – utilises the fact that the streamer depth is mainly controlled by bird units, which keep the streamer in a predefined depth at certain increments but do not prevent the streamer from being slightly buoyant in-between. In case of calm weather conditions these streamer bendings mainly contribute to the overall static time shifts, whereas depth variations of the source are negligible. Hence, mean static correction time shifts are calculated for each channel by averaging the depth values determined at each geophone group position for several subsequent shots. Application of both methods to data of a high-resolution seismic survey of channel-levee systems on the Bengal Fan shows that the quality of the stacked section can be improved significantly compared to stacking results achieved without preceding static corrections. The optimised records show sedimentary features in great detail, that are not visible without static corrections. Limitations only result from the sea floor topography. The CDP static correction method generally provides more coherent reflections than the average static correction method but can only be applied in areas with rather flat sea floor, where no diffraction hyperbolae occur. In contrast, the average static correction method can also be used in regions with rough morphology, but the coherency of reflections is slightly reduced compared to the results of the CDP static correction method.  相似文献   

Parameterization of Wave Breaking Probability and Whitecap Coverage     

李晶于定勇  刘华兴 《中国海洋工程》2006,20(3):411-418

1 .Introduction Wave breaking and associated whitecapping have long beeninteresting due totheir close relationto many fields of ocean study,including air-sea interaction,remote sensing,ocean engineering,aswell as wave dynamics .The breaking probabilityBan…  相似文献   

Three-dimensional numerical simulation of obfique wave action on vertical walls     

LI Benxia YU Xiping YU Yuxiu 《海洋学报(英文版)》2006,25(1):147-153

A three-dimensional numerical model based on the potential theory was developed to study the oblique wave action on vertical walls. A source term inside the domain was used to generate incident waves and outgoing waves were dissipated by sponge layers and transmitted by radiation boundaries. The finite difference method was used to solve the governing equations and boundary conditions in the regular transformed domain in σ-coordinate. Satisfactory agreements between the numerical predictions and experimental results of wave force were obtained. It is concluded that the maximum wave force acting on the vertical walls is induced by the obliquely incident waves rather than the normally incident waves.  相似文献