A mathematical hysteretic model for elastomeric isolation bearings     

J. S. Hwang  J. D. Wu  T.‐C. Pan  G. Yang 《地震工程与结构动力学》2002,31(4):771-789

An analytical model for high damping elastomeric isolation bearings is presented in this paper. The model is used to describe mathematically the damping force and restoring force of the rubber material and bearing. Ten parameters to be identified from cyclic loading tests are included in the model. The sensitivity of the ten parameters in affecting the model is examined. These ten parameters are functions of a number of influence factors on the elastomer such as the rubber compound, Mullins effect, scragging effect, frequency, temperature and axial load. In this study, however, only the Mullins effect, scragging effect, frequency and temperature are investigated. Both material tests and shaking table tests were performed to validate the proposed model. Based on the comparison between the experimental and the analytical results, it is found that the proposed analytical model is capable of predicting the shear force–displacement hysteresis very accurately for both rubber material and bearing under cyclic loading reversals. The seismic response time histories of the bearing can also be captured, using the proposed analytical model, with a practically acceptable precision. Copyright © 2002 John Wiley & Sons, Ltd.  相似文献   

Comparative response analysis of conventional and innovative seismic protection strategies     

S. Bruno  C. Valente 《地震工程与结构动力学》2002,31(5):1067-1092

The paper presents a numerical investigation aimed at evaluating the improvements achievable through devices for passive seismic protection of buildings based on the use of shape memory alloys (SMA) in place of conventional steel or rubber devices. To get some generality in the results, different resisting reinforced concrete plane frames were analysed, either protected or not. ‘New’ and ‘existing’ buildings were considered depending on whether seismic provisions are adopted in the building design or not. Base isolation and energy dissipation were equally addressed for both conventional and innovative SMA‐based devices. Fragility analyses were performed using specific damage measures to account for comparisons among different damage types; the results were then used to estimate quantitatively the effectiveness of the various protection systems. More specifically, the assessment involved a direct comparison of the damage reduction provided by each protection system with respect to the severe degradation experienced by the corresponding non‐protected frame. Structural damage, non‐structural damage and damage to contents were used on purpose and included in a subsequent phase of cost analysis to evaluate the expected gains also in terms of economic benefits and life loss prevention. The results indicate that base isolation, when applicable, provides higher degrees of safety than energy dissipation does; moreover, the use of SMA‐based devices generally brings about better performances, also in consideration of the reduced functional and maintenance requirements. Copyright © 2002 John Wiley & Sons, Ltd.  相似文献   

Seismic response of self‐centring hysteretic SDOF systems     

Constantin Christopoulos  Andr Filiatrault  Bryan Folz 《地震工程与结构动力学》2002,31(5):1131-1150

The seismic response of single‐degree‐of‐freedom (SDOF) systems incorporating flag‐shaped hysteretic structural behaviour, with self‐centring capability, is investigated numerically. For a SDOF system with a given initial period and strength level, the flag‐shaped hysteretic behaviour is fully defined by a post‐yielding stiffness parameter and an energy‐dissipation parameter. A comprehensive parametric study was conducted to determine the influence of these parameters on SDOF structural response, in terms of displacement ductility, absolute acceleration and absorbed energy. This parametric study was conducted using an ensemble of 20 historical earthquake records corresponding to ordinary ground motions having a probability of exceedence of 10% in 50 years, in California. The responses of the flag‐shaped hysteretic SDOF systems are compared against the responses of similar bilinear elasto‐plastic hysteretic SDOF systems. In this study the elasto‐plastic hysteretic SDOF systems are assigned parameters representative of steel moment resisting frames (MRFs) with post‐Northridge welded beam‐to‐column connections. In turn, the flag‐shaped hysteretic SDOF systems are representative of steel MRFs with newly proposed post‐tensioned energy‐dissipating connections. Building structures with initial periods ranging from 0.1 to 2.0s and having various strength levels are considered. It is shown that a flag‐shaped hysteretic SDOF system of equal or lesser strength can always be found to match or better the response of an elasto‐plastic hysteretic SDOF system in terms of displacement ductility and without incurring any residual drift from the seismic event. Copyright © 2002 John Wiley & Sons, Ltd.  相似文献   

A recursive decomposition algorithm for network seismic reliability evaluation     

Jie Li  Jun He 《地震工程与结构动力学》2002,31(8):1525-1539

A new probabilistic analytical approach to evaluate seismic system reliability of large lifeline systems is presented in this paper. The algorithm takes the shortest path from the source to the terminal of a node weight or edge weight network as decomposition policy, using the Boolean laws of set operation and probabilistic operation principal, a recursive decomposition process then could be constructed. For a general weight network, the modified Torrieri method (NTR/T method) is introduced to combine with the suggested algorithm. Therefore, the recursive decomposition algorithm may be applied to evaluate the seismic reliability of general lifeline systems. A series of case studies, including a practical district electric power network system and a large urban water supply system, show that the suggested algorithm supplies a useful probabilistic analysis means for the seismic reliability evaluation of large lifeline systems. Copyright © 2002 John Wiley & Sons, Ltd.  相似文献   

A response‐based decoupling criterion for multiply‐supported secondary systems     

Samit Ray Chaudhuri  Vinay K. Gupta 《地震工程与结构动力学》2002,31(8):1541-1562

It is often infeasible to carry out coupled analyses of multiply‐supported secondary systems for earthquake excitations. ‘Approximate’ decoupled analyses are then resorted to, unless the response errors due to those are significantly high. This study proposes a decoupling criterion to identify such cases where these errors are likely to be larger than an acceptable level. The proposed criterion is based on the errors in the primary system response due to decoupling and has been obtained by assuming (i) the input excitation to be an ideal white noise process, (ii) cross‐modal correlation to be negligible, and (iii) the combined system to be classically damped. It uses the modal properties of the undamped combined system, and therefore, a perturbation approach has been formulated to determine the combined system properties in case of light to moderately heavy secondary systems. A numerical study has been carried out to illustrate the accuracy achieved with the proposed perturbation formulation. The proposed decoupling criterion has been validated with the help of two example primary‐secondary systems and four example excitation processes. Copyright © 2002 John Wiley & Sons, Ltd.  相似文献   

Pseudodynamic tests on rubber base isolators with numerical substructuring of the superstructure and strain‐rate effect compensation     

F. J. Molina  G. Verzeletti  G. Magonette  Ph. Buchet  V. Renda  M. Geradin  A. Parducci  M. Mezzi  A. Pacchiarotti  L. Federici  S. Mascelloni 《地震工程与结构动力学》2002,31(8):1563-1582

A pseudodynamic testing procedure has been applied by which the seismic response of a base‐isolated building is obtained by using as specimen the isolators, while the superstructure is numerically simulated. The procedure also takes advantage of the continuous pseudodynamic testing capabilities of the ELSA laboratory, which increase the accuracy of the results and reduce the strain‐rate effect of the rubber bearings. A simple proportional correction of the measured forces compensates the remaining strain‐rate effect due to the unrealistic speed of the test. The correction factor is obtained by means of a characterizing test on the specific rubber isolators. The developed method has been successfully applied to the prediction of the seismic response of a base‐isolated four‐storey building submitted to several specified accelerograms. The results for those earthquakes as well as the effects of some changes of the parameters of the system are discussed. Copyright © 2002 John Wiley & Sons, Ltd.  相似文献   

Study on effects of damping in laminated rubber bearings on seismic responses for a ⅛ scale isolated test structure     

Bong Yoo  Yang‐Hann Kim 《地震工程与结构动力学》2002,31(10):1777-1792

The effects of damping in various laminated rubber bearings (LRB) on the seismic response of a ?‐scale isolated test structure are investigated by shaking table tests and seismic response analyses. A series of shaking table tests of the structure were performed for a fixed base design and for a base isolation design. Two different types of LRB were used: natural rubber bearings (NRB) and lead rubber bearings (LLRB). Three different designs for the LLRB were tested; each design had a different diameter of lead plug, and thus, different damping values. Artificial time histories of peak ground acceleration 0.4g were used in both the tests and the analyses. In both shaking table tests and analyses, as expected, the acceleration responses of the seismically isolated test structure were considerably reduced. However, the shear displacement at the isolators was increased. To reduce the shear displacement in the isolators, the diameter of the lead plug in the LLRB had to be enlarged to increase isolator damping by more than 24%. This caused the isolator stiffness to increase, and resulted in amplifying the floor acceleration response spectra of the isolated test structure in the higher frequency ranges with a monotonic reduction of isolator shear displacement. Copyright © 2002 John Wiley & Sons, Ltd.  相似文献   

公路边坡工程监测技术评价与分析   总被引：1，自引：0，他引：1  

梁世华 《安徽地质》2002,12(4):245-247,251

结合公路工程、建筑工程等土木工程建设中经常涉及到的边坡工程,评价与分析边坡工程监测的作用、内容和方法,提出了边坡工程应该在工程项目开展的开始阶段就应进行和边坡工程监测的项目,选择原则,测点布置原则、监测周期等,对边坡工程建设具有重要的意义.  相似文献   

中朝板块元古宙板内地震带与盆地格局   总被引：34，自引：3，他引：34  

乔秀夫 《地学前缘》2002,9(3):141-149

地史中发生的强地震事件在地层中留下固定的记录 (图 1～ 3) ,这些记录在区域上呈带状分布 ,代表地史中的地震带。中朝板块元古宙目前可识别出两个板内地震带 (图 5 )。中元古代板内地震带 (170 0～ 12 0 0Ma)西起太行山北段 ,经燕山山脉、辽宁西部、穿越辽河平原至辽宁北部的泛河流域分布 ,即燕山—泛河地震带 ,现今呈NEE向延伸。新元古代震旦纪地震带沿吉林南部、辽东半岛、山东中部及苏皖北部现今呈NNE走向分布 ,即古郯庐地震带 (6 5 0～ 6 0 0Ma)。上述两个板内地震带是元古宙不同时期超大陆裂解的响应。中元古代与新元古代两个不同方向的地震断裂带分别控制着两个时期的盆地边界。燕山泛河地震断裂带构成中元古代海盆南界 (指现在的位置 ) ,形成向北开放的海域。古郯庐地震断裂带将中朝板块裂解为华北块体与胶辽朝块体。古郯庐地震断裂带构成震旦纪海域的边界 ,震旦纪海盆通过朝鲜半岛与当时的外海相连接 ,华北块体则为陆源剥蚀区。文内四幅古地理图 (图 6～ 9)是以地震灾变思想为指导 ,以新的地层研究、对比为基础编制的 ,侧重反映了盆地的格局及其变化。根据地震、同沉积断裂新的思路 ,可提供地质学家重新认识与解释某些沉积矿床的成因 ,它们的成矿元素均来自地球深部而非地表风化作用。文中编制  相似文献   

地震勘探资源频率域叠加方法研究   总被引：1，自引：1，他引：1  

邱春玲  邱东玲等 《吉林大学学报(地球科学版)》2002,32(1):92-95,99

在叠前共深度点道集内各地震道的动、静校正误差很小的情况下，地震资料时间域水平叠加方法有较好的叠加结果。但是，如果动、静校正的误差较大时，叠加效果将受到影响，即叠后振幅和分辨率都会降低。因此，提出一种频率域叠加方法。该方法既具有常规水平叠加方法能提高信噪比的优点，又能将共深度点道集内的走时时差消除，达到内相叠回的目的。几个比较叠加方法效果的有噪CDP道集叠加的例子证明了该方法的效果。  相似文献