Effect of Cyclic Loading Frequency on Undrained Behaviors of Undisturbed Marine Clay   总被引：2，自引：0，他引：2  

陈云敏  姬美秀黄博 《中国海洋工程》2004,18(4):643-651

Based on a series of cyclic triaxial tests, the effect of cyclic frequency on the undrained behaviors of undisturbed marine clay is investigated. For a given dynamic stress ratio, the accumulated pore water pressure and dynamic strain increase with the number of cycles. There exists a threshold value for beth the accumulated pore water pressure and dynamic strain, below which the effect of cyclic frequency is very small, but above which the accumulated pore water pressure and dynamic strain increase intensely with the decrease of cyclic frequency for a given number of cycles. The dynamic strength increases with the increase of cyclic frequency, whereas the effect of cyclic frequency on it gradually diminishes to zero when the number of cycles is large enough, and the dynamic strengths at different frequencies tend to the same limiting minimum dynamic strength. The test results demonstrate that the reasons for the frequency effect on the undrained soil behaviors are beth the creep effect induced by the loading rate and the decrease of sample effective confining pressure caused by the accumulated pore water pressure.  相似文献   

Elasto-Plastic Analysis of Tubular Joints of Offshore Platforms by Finite Element Method     

Chen Tieyun Zhu Zhenghong Professor  Dept. of Naval Architecture  Ocean Engineering  Shanghai Jiao Tong University  Shanghai Lecturer 《中国海洋工程》1991,(1)

The plastic node method is reformulated by the variational principle and is applied to elasto-plastic finite element analysis of tubular joints, eventually including the effect of internal and external gussets, stiffener rings, etc., if necessary. Four different joints are studied here in detail for the elasto-plastic behavior, the strain at the hot spot, the strain concentration factor around the intersection line, and the propagation of the plastic region with loading up to collapse in order to determine the ultimate strength, safety factor, and development of the plastic field. The present results are in good agreement with the experimental results.  相似文献   

Estimation of Uplift Capacity of Rapidly Loaded Plate Anchors in Soft Clay     

S. P. Singh  D. P. Tripathy  S. V. Ramaswamy 《Marine Georesources & Geotechnology》2007,25(3):237-249

Plate anchors are extensively used in civil engineering constructions as they provide an economical alternative to gravity and other embedded anchors. The rate of loading is one of the important factors that affects the magnitude of soil resistance as well as soil suction force. This article outlines the effect of pullout rate on uplift behavior of plate anchors (70 mm diameter) buried in soft saturated clay by varying the pullout rate from 1.4 mm/min to 21.0 mm/min. The variation of breakout force and suction force with embedment depth and rate of pull are presented. A correlation between the rate of increase of undrained strength of clay and anchor capacity with rate of strain has been established. Finally an empirical equation has been proposed that includes the rate of pull in the estimation of breakout capacity of anchors.  相似文献   

Discussion: A review on the behaviour of helical piles as a potential offshore foundation system     

Shah Neyamat Ullah  Yuxia Hu 《Marine Georesources & Geotechnology》2020,38(9):1121-1127

Abstract

Helical piles have emerged as an attractive foundation system for offshore applications with renewed interest from the offshore community. Significant research gap currently exists in transferring this technology offshore and this paper discusses how existing and emerging knowledge can be successfully used to bridge some of the gaps. We focus on the Coupled Eulerian Lagrangian (CEL) large deformation finite element (LDFE) modelling technique that is commercially available and can be used to model the three-dimensional installation process with consideration of strain rate and softening effects in soft offshore clays. A helical pile of L?=?7.5?m long is modelled with one or two large-diameter helices (D?=?2?m) attached to a central shaft of d?=?0.5?m in diameter.The net effect of strain rate and softening is to increase the installation torque. The measured torque is within the range of 200–400?kN.m for the offshore clay and the pile geometry studied. Additional helices increase the uplift force but to a lesser degree than that of the measured torque. Remoulding induced strength reduction is found to be within the range of 25–33% of the intact clay strength. Issues of extracting and reusing offshore helical pile foundations are discussed.  相似文献   

哀牢山-红河断裂带中段应变分析   总被引：1，自引：0，他引：1  

周勇  吴世敏  周萍 《热带海洋学报》2003,22(2):17-29

对哀牢山—红河断裂带中段和平—水塘剖面、墨江—元江剖面和其它地段的岩石应变及磁组构进行了分析，表明应变强度的校正磁各向异性度PJ从断裂带向西至三叠系明显降低，变形强度向西迅速减弱。磁化率椭球体主轴展布反映出剪切带内、外变形方式的改变。剪切带内，以水平走滑运动为主；向西则以水平缩短为主。在应变分析中，对断裂带内的S—C组构两组面理夹角、杏仁体和石榴石应变标志体进行了测量，结果显示，剪切带内的磁组构和岩石组构间关系较差。此外，还对这两条剖面中的三叠系进行了应变和磁组构分析，找出了它们与磁化率椭球体对应轴率间的相关性。  相似文献   

中国西部现今地壳形变与地震活动特征     

李金平 《测绘工程》2008,17(1):6-9

以1999-2004年间中国西部地区近650个GPS站点的观测资料为基础,采用二维“高张力样条”函数内插算法获得了连续地壳形变场。结果表明,相对于稳定欧亚参考框架,中国西部现今地壳运动西强东弱,北向运动从西向东逐渐减弱,东向运动逐渐增强,青藏高原东缘及附近地区是东向运动的消减区带;主应变从西向东由压缩应变转变为拉伸应变;最大剪应变主要位于喜马拉雅地块及其东部地区;中国西部地区地震活动在空间分布上似乎集中发生在印度板块北东向挤压欧亚板块的两条共扼带内,与地壳形变场有一定对应关系,地壳形变的高应变率区为中强地震多发地带。  相似文献   

水泥粉煤灰加固有机质土的试验研究   总被引：3，自引：0，他引：3  

邵俐  刘松玉  杜广印  顾明芬 《工程地质学报》2008,16(3):408-414

对于高有机质含量的泻湖相软土,单纯采用水泥不能有效提高该软土的力学性能,因此提出了采用水泥和粉煤灰作为固化剂的加固方法。通过不同水泥掺入量、粉煤灰掺入量和龄期下水泥土的无侧限抗压强度试验,分析了水泥粉煤灰固化土的强度规律和变形规律,探讨了水泥和粉煤灰加固高有机质含量软土的机理。结果表明,粉煤灰对于水泥试块的早期强度影响较小,对后期强度影响较大;粉煤灰最佳掺入量为12％,超过此掺入量水泥土强度反而会降低,粉煤灰水泥土的破坏应变、E50也在粉煤灰掺量为12％时分别达到最低值和最大值。水泥掺加粉煤灰可有效地提高高有机质含量软土的强度。  相似文献   

Strain localization due to structural in-homogeneities in the Central European Basin System     

Mauro Cacace  Ulf Bayer  Anna Maria Marotta 《International Journal of Earth Sciences》2008,97(5):899-913

The large-scale crustal deformations observed in the Central European Basin System (CEBS) are the result of the interplay between several controlling factors, among which lateral rheological heterogeneities play a key role. We present a finite-element integral thin sheet model of stress and strain distribution within the CEBS. Unlike many previous models, this study is based on thermo-mechanical data to quantify the impact of lateral contrasts on the tectonic deformation. Elasto-plastic material behaviour is used for both the mantle and the crust, and the effects of the sedimentary fill are also investigated. The consistency of model results is ensured through comparisons with observed data. The results resemble the present-day dynamics and kinematics when: (1) a weak granite-like lower crust below the Elbe Fault System is modelled in contrast to a stronger lower crust in the area extending north of the Elbe Line throughout the Baltic region; and (2) a transition domain in the upper mantle is considered between the shallow mantle of the Variscan domain and the deep mantle beneath the East European Craton (EEC), extending from the Elbe Line in the south till the Tornquist Zone. The strain localizations observed along these structural contrasts strongly enhance the dominant role played by large structural domains in stiffening the propagation of tectonic deformation and in controlling the basin formation and the evolution in the CEBS.  相似文献   

分布式光纤传感技术在滑坡监测中的应用   总被引：5，自引：1，他引：4  

史彦新  张青  孟宪玮 《吉林大学学报(地球科学版)》2008,38(5)

将分布式光纤传感技术引入滑坡监测,既可得到整个滑坡体的概要特征,又能提高监测效率。FBG与BOTDR是两种最具代表性的分布式光纤传感技术,FBG通过测量其反射光波长的变化获得应变或温度值。BOTDR通过测定后向布里渊散射光的频移实现分布式温度、应变测量。FBG传感器灵敏度高,但只能实现离散点的准分布式测量,BOTDR可实现分布式、长距离、不间断测量,但其空间分辨率不高。笔者提出FBG与BOTDR联合监测滑坡的方案。在巫山残联滑坡,在整个滑坡体上铺设监测光纤,利用BOTDR获得整个滑坡体的概要信息;在滑坡体变形的关键部位———变形缝安装FBG传感器,获得某些关键部位的应变信息,从而实现由点到线再到面的监测,获得滑坡体较完整的应变信息。  相似文献   

Strain analysis in Jurassic argillites of the Monte Sirino area (Lagonegro Zone,southern Apennines,Italy) and implications for deformation paths in pelitic rocks     

S. Mazzoli 《International Journal of Earth Sciences》1995,84(4):781-793

Analysis of strain in Jurassic argillites forming part of the folded and thrusted sedimentary succession of the Lagonegro basin (southern Italian Apennines) has been carried out using ellipsoid-shaped reduction spots as strain markers. Most of the determined finite strain ellipsoids are of oblate type and show a peculiar distribution of the maximum extension direction (X), with maxima either subparallel or subperpendicular to the local fold axes. Using the strain matrix method, two different deformation histories have been considered to assist the interpretation of the observed finite strain pattern. A first deformation history involved vertical compaction followed by horizontal shortening (occurring by a combination of true tectonic strain and volume loss), whereby all strain is coaxial and there is no change in the intermediate axis of the strain ellipsoid. By this type of deformation sequence, which produces a deformation path where total strain moves from the oblate to the prolate strain field and back to the oblate field, prolate strain ellipsoids can be generated and may be recorded where tectonic deformation has not been large enough to reverse pretectonic compaction. This type of deformation history may be of local importance within the study area (i.e. it may characterize some fold hinge regions) and, more generally, is probably of limited occurrence in deformed pelitic rocks. A second deformation sequence considered the superposition of pre-tectonic compaction and tectonic strain consisting of initial layer-parallel shortening followed by layer-parallel shear (related to flexural folding). Also in this instance, volume change during tectonic deformation and tectonic plane strain have been assumed. For geologically reasonable amounts of volume loss due to compaction and of initial layer-parallel shortening, this type of deformation history is capable of producing a deformation path entirely lying within the oblate strain field, but still characterized by a changeover, during deformation, of the maximum extension axis (X) from a position parallel to the fold axis to one perpendicular to it. This type of deformation sequence may explain the main strain features observed in the study area, where most of the measured finite strain ellipsoids, determined from the limb regions of flexural folds, display an oblate shape, irrespective of the orientation of their maximum extension direction (X) with respect to the local structural trends. More generally, this type of deformation history provides a mechanism to account for the predominance of oblate strains in deformed pelitic rocks.  相似文献